Nissan - Maxima :: 1995 - Dies After Sitting And Idling For Around Ten Minutes
May 7, 2014
I have a 1995 Nissan Maxima that dies after sitting and idling for around ten minutes. It also has been dying at stoplights, etc. It runs fine if I get the rpms above 1000. When it dies it restarts but often I have to push the pedal to the floor for a few seconds, then it seems to catch and run as long at the rpms are up. I have taken it to a place and due to it's age they couldn't do a diagnostic check on it. I've had the exhaust system replaced (it needed it), the spark plugs replaced, the coolant temperature sensor replaced but still no luck.
View 2 Replies
Advertisement
OK so my 2003 Nissan maxima is hard to start all the time after its been sitting for a few minutes like 30min or more also I'm getting a CEL light.
See the video : [URL] ....
View 12 Replies
95 GMC Sonoma SLS 2.2L 5 speed distributorless ignitionStart cold, engine purrs, runs for 20-25 min, idling in drive, then dies as if you shut it off. All fluid levels correct. Will not restart until cools off. Have replaced: coils and ignition module, fuel pump and sending unit, ignition cylinder and ignition switch, oil pressure switch. Engine light does not come on. (bulb is not burnt, comes on when starting). Have checked all grounds.
View 5 Replies
What would make brakes sqeak? Especially when car has been sitting awhile.
View 5 Replies
I bought a 2003 nissan maxima with 135k and it had a p0300 it had a performance k&n filter on it so i though someone might have installed it wrong or what ever so i bought the car cheap. i have replace the k&n filter with a stock 2000 nissan maxima air box with new filter i got from the junkyard it worked for the misfire calm down a little then i bought the car to a mechanic and he said because of my hard starting it could be a cam senor or crank senors so I've replaced that still no luck then he pulled out the spark plugs and they were sooty black but when i bought the car i checked and they were brand new so i swap them out with ngk platinum spark plugs then work a little but still same problem. i had a p0302,p0304,p0306 when i clear the p0300 but usually its all ways a p0300, its been a month and I am still driving like this.
SYMPTOMS:
Hard starting after 20 mins of sitting
I can smell gas from the driver seat when i start the car and open the window
Exhaust air isn't smooth but in pops
Getting like 14-15 mpg in city
When stopped at a stop light i can feel the car misfiring
WHAT I HAVE REPLACED:
Front bay 3 ngk spark plugs cylinders 2,4,6
Cylinder 4 coil
Air box
Cam sensor and crankshaft senor
Coolant temperature sensor
Battery
[URL] ....
View 19 Replies
The switch for CC works fine and will turn green and say 'on' when switched on, but it will not actually work (will decrease speed as soon as you let off gas, just as if it were not on). We replaced the whole gauge panel with one that had CC in working condition (exact same model) and this did not solve the problem.
View 3 Replies
The car has always had an issue with randomly stalling and dieing. It could be coming to a stop, driving down the st or just in idle. No warning, usually except once in a while the RPMs will drop pretty low before it cuts out. Other times it will "stutter" if you wonna call it that while I'm driving rev up and down around 2k.
Now while it's doing that, I noticed if I give it more gas it'll act like it's gonna cut out until I let off the pedal then it revs back up and sometimes if I catch it at the high point and hit the gas again that will occasional "catch it" and it will run okay for a bit. Anyway - recently I found that if I just let the car warm up before I drive it seems to run great. If I just start and go, it dies as soon as I put it in gear.
Note: Maintenance up to par, no engine light, don't smell gas, new filter, MAF, IAC, no vacuum leaks I can find.
View 4 Replies
I have a 1995 Nissan Maxima. The starter will not engage (no noise at all) when the outside temperature is below 60 degrees. All of the electrical is functional, but when I turn on the starter, there is no click sound or any indication that the starter attempted to engage. The car is a manual transmission, so I push start the car, and there is no squeal when the car starts so the starter gear was not touching the flywheel. Above 60 degrees, everything works normally. I have replaced the starter motor and solenoid, replaced the battery, but the problem persists.
View 5 Replies
My 95 Nissan Maxima just failed smog because the MIL light would not come on Everything else passed. The light was working. I last noticed about 2 weeks ago after I had the car washed. I'm reading it can be a bulb or the computer? What can I expect in repair costs?
View 14 Replies
diagnose a problem with their 1995 Ford Windstar. The van slowly dies when idling. It runs for a few seconds after being jumped and then the dash lights slowly dim after which the van stops running. We replaced the battery and the van ran for about a day or so without issue. However, the problem is back. I suspected the alternator was faulty, so we pulled it and took it to a parts store to be bench tested. It was tested twice and passed both times. Does this sound like an alternator problem? Could there be an issue with the battery cables? What else might be causing this?
View 10 Replies
1995 pickup truck 2.4 liter 4 cal 4WD. I have a new problem- I drove out to a favorite spot in the mountains (up a dusty road) and when I got to the end of the road my truck was suddenly idling REALLY rough. I was able to drive it home and it runs "OK" as long as you stay on the gas (I say OK but it does want to die and especially wants to die after it warms up and then harder to restart until it cools)- as soon as you let off the gas the idle is on the extreme side of rough. It did not act like a fuel filter has historically (hesitate when giving gas), but I had a filter so I replaced the fuel filter anyway.
I also pulled the air duct work and cleaned it all out, put a new air filter in and used CRC MAF sensor cleaner on the MAF sensor. I did pour in a Chevron fuel system cleaner but it would likely take a tank full at least to work and it does not run good enough to run a tank full through. I put in all new plugs (gapped) and checked resistance on the plug wires and cap- all seems to be acceptable. I checked all the vacuum lines and did replace a couple that were dry and crumbly. I am now at a loss,
View 7 Replies
Why is it that after 15 minutes of idling the coolant starts to boil up and spill and the car begins to overheat?
View 2 Replies
So I have a 95 Legacy sedan, FWD. It's been a kind of problematic car, and the engine was replaced about 5 years ago (I assume with an old unit, but I'm not sure though because though I was in the family I wasn't driving it then). But, it's held up and has continued to be at least roadworthy. But recently, it's developed an issue where the engine will just randomly die while I'm on the road. All/most of the dash indicator lights come on, but if I shift it into neutral and turn the key, it'll come right back up. Occasionally it'll die again almost immediately, but usually it'll be fine for at least a while. And anecdotally, It seems to happen more frequently at lower revs such as idling at a red light (though will occasionally happen while I'm moving), and when the engine is cold - generally once I've driven around for a while, it's not a problem anymore.
View 3 Replies
I have a 2011 Nissan Maxima SV that has poor gas mileage. I took it to Nissan to get checked out but they said there's nothing they could do because the car is showing no codes or no check engine light. I got my spark plugs changed, it seemed like it worked but a week or so later, it went back to how it was (the gas mileage). 2 weeks later, my mechanic checked the spark plugs in front of me, no rust or leaks on them. I burn a half tank of gas every 2 days and that's just driving local to work and back.
View 16 Replies
The ac compressor on my 2003 Maxima keeps going out. Mechanic says the replacements are refurbrished, as the new ones are hard to find and expensive. 143,000 on the car.
View 1 Replies
I have a misfire on the number 2 cylinder on my 97 Nissan Maxima 5spd. The computer has been changed 3 times, and it'll work for a short time after the new computer is installed, but then the problem resumes. What would cause this to happen? The coil has also been changed.
View 7 Replies
my car won't start. It would try to turn over occasionally, The battery checks out. i tried to jump start it bypassing the battery with no results. multimeter reads current though cable going from battery to alternator. what is wrong with my car??
View 2 Replies
I have a 1998 Nissan Maxima, and when I brake or am moving very slowly in stop and go traffic, my car sounds like a foghorn. I am thinking maybe I need new brake pads, but I thought brakes were supposed to squeal when they are bad. I remember them squeaking a little bit, but nothing major. Then all of a sudden I'm starting to get this foghorn sound.
View 2 Replies
Keep getting the P0420 code on this vehicle. Have changed air filter, spark plugs, run fuel injector cleaner through the tank on Shell 93 octane fuel. Drove 430 highway miles to clean out the carbon and the SES light is still on and when we check the code it says Catalyst system effiency below threshold bank 1. How do i get this fixed?
View 1 Replies
2002 Nissan Maxima with 118K miles. Heating and A/C buttons that turn the fan on different levels doesn't work. It will cut on/off but the setting can be on low and it always blows on high. The temp. is correct(heat or cold) on what we set...it just always blows on high no matter what we set. It is a bush button kind of setting not a dial that you turn.
View 1 Replies
I have a 2007 Nissan Maxima and after changing the oil added Lucas Oil Stabilizer and when I went to start the car the engine shook for about 3 seconds and I was unable to start it again. Towed it to Nissan service and they said codes came up as the camshaft sensors were bad and engine was flooded and need to dry them out before testing it out. So on Monday I received a call from the service manager and he told me that they tried replacing the camshaft sensors but it would not start. He then said that his technions working on the car believe the timing chain jump causing vavles to get bent. Cause the engine has 107k the will not repair my car and recommend a new engine. I informed the service manager I find it hard to believe that any vavles could have gotten bent with the engine running only 3 seconds and had my car towed back to my house. I tried replacing the crankshaft shaft sensor and it still will not start. So before I attempt to open the timing chain cover wanted to see if the timing chain could have jumped only running for 3 seconds and to see if it might be something else? Still don't understand why after adding the oil stabilizer to the oil it would had stalled out like that when it was running so good and starting up with no problems. I read on line that Nissan has had many issues with their timing chain guides wearing out but can't see how the oil stabilizer would effect the guide.
View 4 Replies
