1990 Maxima. Last night the car started shaking after pulling up to stop sign, it kept shaking the whole way home. Acceleration was slow and difficult. Car started up fine this morning, started to shake again at first stop sign...then it was OK for rest of the day.
View 2 Replies1990 Nissan Maxima, i noticed that after changing the struts/springs on my car that when i make a hard right turn while accelerating the car makes a terrible grinding noise. I know this is a classic sign for a CV joint, but could it be anything else? It is definitely not tire rubbing, definitely metal sound. It doesnt seem to be getting worse.
View 1 RepliesI installed lowering springs (1.5 inches front and rear) on my car, 1990 Maxima, with new performance shocks, but the ride is a little bouncy at times. I know this is from the reduced travel the shocks have..even though they are stiffer than stock. Is there any way to give a little more travel? or how to give the shocks more dampening force? (besides putting the old springs on of course). Would lighter wheels/tires work? How about loosening the center nut on the strut a bit?
View 11 Replies'90 Maxima 256k.....recently I've noticed exhaust coming in through the vents when I have the AC on and have been idling or driving in slow traffic. I know I have a small exhaust manifold leak because I hear the clicking. The problem is this exhaust smell happens very intermittently. Usually on hot humid days when I have the AC on. I have tried to duplicate the issue to no avail. Sometimes I can sit in a parking lot at idle with the AC on for 30 minutes and I don't smell any exhaust (not even when I smell under the hood). How can this be? If it truly was an exhaust leak then it would leak all the time and I would smell it. Could my EGR valve be leaking? When the EGR valve is activated?
View 3 Replies'90 Maxima...A couple of my exhaust studs broke (it was a problem for this model) and now I have an annoying exhaust leak. I tried to put a new gasket, but it started to leak again. I am thinking of using permatex copper sealant....drilling out the broken bolts and replacing them would be very expensive I think.
View 4 Replies'90 Maxima...I've noticed coolant reservoir has been running low/dry and I also notice coolant dripping from the overflow hose. Why would it keep pushing more coolant out if there isn't an excess in the reservoir? Engine runs fine., no other issues.
View 13 RepliesIt is a '90 Nissan Maxima. I just replaced my drivers side axle (cv joint was clicking), and now my car vibrates at highway speeds when turning right. I am pretty sure I seated the axle correctly....could it be a bad axle? I heard that turning the axle 90 degrees and reinstalling may work? I got a new axle (Empi brand).
View 2 RepliesI've found a bad engine mount over the passenger front wheel I'm replacing (why they had to put the 5th nut holding the mount underneath the mount instead of on top like the rest, i'll never know. drilling that out and replacing with a bolt and nut on top to fix that and going to slap an engineer). There's no wheel balance issues or wobbly wheels when up on the lift. Recently replaced my spark plugs, could it be a misfire that causes this when the engine is being pushed past 3K rpms?
View 2 Replies1990 Maxima. The car hesitates/surges occassionally after warm start, but only surges for about first 1/4 mile, then its OK. Sometimes it idles low, especially when I come to a stop and apply brakes hard. I believe the two issues are related. This has been getting progressively worse over past few years.
View 3 Replies1990 Maxima..245,000 miles...car idles fine except when sitting at stoplight for more than 15 seconds, then idle starts to drop slowly and become unstable. Then there is a separate issue: After putting the car in Park (after warming up) the car will drop/surge from approximately 1500 to 1800 rpms three times and then go back down to normal (I am guessing transmission clutch).
View 3 Replies'90 maxima 245,000 miles.....over the course of a few days all three rear injectors (1,3,5) are stuck open and dumping fuel....lots of white smoke and fuel smell. Mechanic told me to replace the fuel injectors, that they are bad. I do not believe this since i recently replaced the injectors. I confirmed the Ohm on the injectors(10-14) and it is getting a spark....i heard that it could be the wiring harness is grounding out? how do i test this? could my ECU be bad?
View 6 Repliesi have a 2008 maxima with 30000+ miles. its service engine soon light came on recently. i disconnected the battery the light would go off, but would come back on again after a few days. it happened several times now. once i got a code P0011 from autozone while the light was on. the last time the light was on was a week ago and this time the light finally went off by itself yesterday. i took my car to a dealer today. a service advisor told me the reading on his code-reader is NO CODE and the car is fine!. so what have happened and what is wrong with it? could it be serious?
View 4 RepliesI just purchased a 2000 Nissan Maxima GXE with 219,000 miles. I've had it less than two weeks, and the Service Engine Soon light just came on. I live somewhere that requires emissions testing in order to register the vehicle. My temporary plate will expire soon, so I need to get the car to pass emissions.
This is my first Japanese car and first non-American vehicle. I didn't know until after I had given the check to the guy selling the car that he used premium gas. He said that Nissan recommends it. I've never driven a car that required premium gas before and wasn't keen on the idea since here, it is 40¢ a gallon more expensive than regular unleaded.
I spoke with my landlord about it, as he is a certified Honda mechanic. He told me to first try getting half a tank of regular unleaded and putting it in with some fuel injector cleaner. He said if I didn't notice any decrease in performance or knocks, to then just add a bottle of of fuel injector cleaner to every other tank of gas.
I got a half tank of regular unleaded with a bottle of fuel injector cleaner and didn't have any issues. I then filled the tank with regular without any fuel injector cleaner. I used about ¾ of that tank when the service engine soon light came on. I took the car to Valvoline to get the codes read, and while they couldn't give me any code numbers, they said it was something to do with emissions.
Here are my questions:
Is it possible the light came on because I switched from premium to regular unleaded or perhaps because I would need to add fuel injector cleaner to every tank of gas I get and not every other tank as my landlord said he does with his car?
Should I try either adding fuel injector cleaner to every tank of gas or just switch back to premium? If I try either of those, and one of those was the problem, how long would it take for the Service Engine Soon light to turn off?
Fix one thing, something else goes wrong. I replaced the resistor or HVAC power module(nissan's term) on my maxima and fixed the problem. Easy job. Put everything back together and now the air bag light blinks constantly when car is running. I did disconnect an electrical connection for easier access to the resistor and plugged back in. I've read, I just need to reset. None of the reset procedures I find on line seem to work.
View 2 RepliesMy ABS light stayed on after driving home in slippery conditions last night. I also noticed a burning smell when I parked in the garage.
View 2 RepliesI recently bought a 2003 nissan maxima 134k and i bought it with the p0300 check engine light on a looked at the engine and though it was an air box problem because they had previously installed a K&n filter so I went to the junk yard and got a 2000 nissan maxima air box and new filter i changed the oil and checked the spark plugs they look new and the dates on the coils are 2012 and 2013 and still its misfiring. i bought it to a mechanic and he discovered a vacuum tank had previously broke and they glued back together so i replace that with a factory one today same problem still misfiring but it got better but now its a p0306 then i erased the code and p0304 came back i erased it then p0302 came back then i change the cam sensors, and the crankshaft sensor and now it get a p0300.
Symptoms:
*when sitting for a long time HARD TO START ( takes multiple cranks to start it ) but once i leave it off for short time like 30 min it starts right up no problem
* when stop at a stop light in drive i can feel small little explosions sounds like my car is beat boxing
*performance is strong good acceleration no problem on that i just don't want it misfiring
I keep failing my emissions because my check engine light keeps coming on. I was told that the problem was the catalytic converter rear and needed to buy one for both sides. The problem I am having that I don;t know which Catalytic Converter I should buy. I know without it is causing my car to stutter. Which I should get?
View 8 RepliesI have a 1998 Maxima with 57K miles on it. I just bought it about a month ago. Anyway, a week ago I noticed It felt very "choppy" when I shifted into Drive or Reverse. It felt like it was going to stall but it never did. The Service Engine Soon light has been on for about 3 weeks but now, when I go up hills especially, that light blinks. I can still drive it but I shift into Neutral at stoplights to avoid hearing the rough idle while in Drive. Went to Pep Boys yesterday - they had the car for about an hour and then informed me that they would need to keep the car for a full day because of the "complex issues involved" - especially concerning the codes. The codes they read were:
p0300 random misfire
p0325 knock sensor
p0440 evap emission
My car passed smog test abut 3 months ago. I can drive it OK it just is very choppy and so there's not a lot of power, especially going up hills.
My 95 Nissan Maxima just failed smog because the MIL light would not come on Everything else passed. The light was working. I last noticed about 2 weeks ago after I had the car washed. I'm reading it can be a bulb or the computer? What can I expect in repair costs?
View 14 Replies1998 Nissan Maxima had a check engine light come on and started running very rough. I took it to get a code read and came up with P0320 and P0325. I'm not worried about the 0325 since that's a knock sensor. 0320 is a misfire on cylinder 2.
With the car idling, I pulled the power connector from coil pack 2 to see if it made a difference in the idle - nope. I did the same for the other cylinders, and each responded with a noticeable change in the idle, which was remedied when it was reconnected.
I moved the coil pack from #2 to #4 (swapping them) and the same problem existed - idle was rough and didn't make a difference when I pulled the power on 2, but it did on all other coil packs. So, it seems the coil pack ins't the problem since multiple packs don't seem to make 2 work, but they work on other 4 and 6.
I then pulled the spark plug from cylinder 2, it was very black and looked in bad shape. I replaced it. Still no love.
I then put a spare plug in the coil and was able to see spark as the engine ran, so it seems that the coil pack at 2 is getting juice.
So, I have gas (big odor when the car is running - seems super rich) I have spark. Still running very rough and the 0320 code remains.
2000 Maxima - I just changed the head gaskets, got it back together and no start, no spark, solid security light and linking error to ecu. 50 miles to a nissan dealer. I have 12v to the injectors but no ground, I just checked spark last night and have none. I tried all three keys, will no battery for a month or two cause key security issues? I hate to drag it to Nissan and have them tell me I need a new ecu for a few thousand dollars. Does a security issue cause a linking issue?
View 13 Replies