Nissan - Frontier :: 5 Speed Manual Transmission Started Making Loud Whine Or Growl Under Power
Dec 24, 2012
My wife and I recently moved to Panama and we bought a 4 wheel drive 2007 Nissan Frontera diesel pick-up. Great little truck so far, 27 miles per/gal! However, the 5 speed manual transmission has started making a loud whine or growl under power. Down hill, gas pedal up, no noise. Clutch in, no noise. Gas pedal down, growling .Growl is related to ground speed as it stays the same when I shift gears.
View 3 Replies
Advertisement
I have a 2005 Nissan Frontier with a manual transmission (~6500 pound towing capacity). I rented a large wood chipper this weekend. On the ride home from the rental pickup, the transmission started shuddering when shifting. It is most noticeable when shifting into first gear from a standstill, and less noticeable on each successive shift. Once the gear is fully engaged, there is no shudder - it is only when letting out the clutch that there is the shudder. The truck only has 50k miles on it.
View 14 Replies
I have a '99 Chevy Lumina 3100 V6 with 54k miles. There is a loud, high-pitch buzzy whine that changes pitch with engine RPM/transmission speed. The whining noise is only evident while the car is accelerating (forward or reverse), and above 5 mph. I removed the serpentine belt and drove it briefly (500 feet) - the noise is still there without the belt. I figure it's safe to assume it's not the power steering pump, alternator, H20 pump, idler or belt tensioner. The transmission has had regular service, and shifts smoothly in all gears (fluid is clean and level is full). There is only a slight raspy "scraping" noise in park or neutral, which becomes almost undetectable when shifting to drive or reverse with the brake still applied.
View 1 Replies
my 2001 nissan frontier xe is making squeaking, slipping sounds past couple months. getting more frequents, scaring me to drive and felt like has brief loss of power couple days ago while parking.
someone told me power steering fluid is orange rust colored and gunnky and needs replaced which i dont know how or have tools for.
Video of it here. At around 1 minutes 54 second, and 2 minute mark, among others, the sound is audible. [URL] ....
View 1 Replies
i have an 04 f-150 with a 5.4 motor. about 2000 miles ago the power steering pump started to whine really loud. I sucked out the power steering fluid and started it up and the fluid that back into the tank looked like it was gritty and rusty. I replaced it out a few times and no change. I then did the job of replacing the power steering pump which was about a 5 hour job.
It was quiet for about 5 miles and the new one started whining. Every week I have been sucking out the old fluid and replacing it and it still seems to be gritty. What could I do to quiet it down? the steering works perfect btw. I am looking at selling this truck and buying an 09 or newer ford and want to quiet it down before selling it. The truck has 88,000 miles on it and i am the original owner.
View 3 Replies
I drive a 2008 Nissan Frontier, bought new in Nov. 2007 with 53,000 miles on it. A few months ago, at about 50,000 miles, an annoying clattering noise started coming out of the dash. The noise was coming from the vent area of the passenger side dash and occurs when I start the vehicle or adjust the AC from Max to norm. I went online and found that the noise occurs in many of the full size Nissan SUVs, and is a failing Vent Actuator part. Doing further research, I learned, the part is fairly cheap, but buried in the dash and difficult to get to.
Of course that means that labor is very expensive to replace this part. Nobody seems to want to take the time to replace the part, except the dealer who wants $500 labor to do it. I have found dash diagrams and since it is cooling off lam thinking about taking on the project myself. With the vehicle having such low mileage, and little stress being put on the part, I feel that the part is of low quality and replacement should be covered on some kind of warranty. Nissan probably feels it is not a safety issue, but the noise is very annoying, and certainly lowers the value of my vehicle, that has otherwise been pampered and in like new condition.
View 1 Replies
I bought a 2003 Nissan Frontier XE that is in really good condition. The only noticeable problem is that the knob that controls the fan speed of the heater and A/C only works in the 3 and 4 positions. I can here the belt engage when I turn the knob to 1 and 2, but no air comes out. So basically, July in Tennessee, it's either very hot in my truck or very cold.
View 1 Replies
I have a '99 Frontier (3.3L V6) just had the radiator, hoses, fan clutch and 3 exterior belts replaced. Car's not overheating anymore, BUT, now I hear intermittently a "clack" (which sounds similar to a loud compressor when it shuts on and off). Car never made this sound before the repairs mentioned above were made.
I took pictures and could use finding out what the part is called that is making the noise. I see the 3 discs on the front side of one of the belt pulleys (i think?) spinning, then they will stop, making the clack sound. It seems to me that sometimes the sound is loud and then other times it is extra loud --are there two sets of these discs and the other set is somewhere I can't see?
View 6 Replies
I have a 2005 Nissan Frontier that recently had a new transmission and radiator installed due to a defect where coolant leaks into the transmission and destroys Nissan transmissions. After I got my truck back it ran fine for about 2 days, then on the third day I started it and the gauges all started going up and down at a speed of about 72 bpm. I shut it off let sit for a few minutes started it and it did this again. I repeated that about 4 times. I let it sit for about 4 hours started it and it was fine for a very short drive (1/2 mile). After about another 2 hours of sitting I tried to start and the battery was dead, my friend jumped it and it drove fine. So it sat for a few days until I had my brother jump it so I could drive to get a new battery. Once it was jumped the moving of the gauges started again.
As I was driving, the gauges kept coming on the going off. I got it to advanced auto and they replaced the battery, it started up drove it for a matter of minutes, then the gauges died and it wouldn’t drive faster than 1 MPH, then engine would rev when I hit the gas. I got it to a parking lot shut it off tried starting it the gauges would come on but as soon as I hit the gas pedal it would rev up but instantly the gauges would shut off and the engine would rev anymore. So I was stuck, got it towed to where the transmission was put in. They couldn't fix it but had to jump it to start it, so the new battery was dead. They towed it to a Nissan dealer and the mechanics are now saying it’s just a bad battery, but this just doesn't make any sense to me.
View 4 Replies
I have a 2002 Accent with a manual transmission with just over 100K. It has for some time had a low whine, which is getting worse. Not wheel bearings. The whine increases with speed, and seems a little louder when decelerating. Makes the sound in every gear and when in neutral (coasting at speed). Brought it into a mechanic and he thought bearings in the transmission (though I don't know why it would make the same sound when in neutral . . .). Shifts through all of the gears fine, no other odd sounds. Can't find any information out there that sounds like my situation.
View 4 Replies
Every day I make a u-turn around the median in order to get to our driveway...which means I turn the steering wheel all the way to the left. As I turn the wheel and drive, there is a clannnngKK sound on the driver's side from somewhere near the front. I wondered if there is something getting hung up/caught "under there" but have no real working knowledge (obviously) of my truck's anatomy. It only makes this noise when I make this u turn. I've not heard it any other time.
View 1 Replies
So ive been having issues with my trans 6 speed manual making noise and took it to the dealer. They more or less told me the trans is done, something with the linkage, need a new trans and clutch. They also told me my warranty was void because there was indication of a cold air intake before i bought the car and have reason to believe it's due to abuse. I've only driven this car 3,000 miles and have taken care not to beat or sport shift the car to avoid this very problem. I can't argue the fact that the previous owner could have very well driven the car hard and the problem might have been a ticking time bomb. I guess my best bet is to find a used trans and install myself but really dont know where to start.
View 24 Replies
I let my son take the 07 nissan frontier out 4x4 off road driving. When I use 4x4 I try to not get stuck. When he uses it ,it involves splashing through deep mud holes and creating as much splash as possible. Now the power windows grind, and stick. Clearly the mud and sand has washed down into the mechanism.What can be done to salvage the windows before they fail entirely?
View 2 Replies
I turned the key and it started to crank and slowly started to whine down. Tried it a 2 more times and it did the same thing only with less strength and on the third try all I hear is the starter clicking. Both batteries read 12.57 on my multimeter while not cranking. Does this sound like an alternator? All my electronics seem to have plenty of power.
View 14 Replies
My 2005 Accord V-6 makes a howling (actually a loud whine) when started in very cold weather (e.g., below 25 degrees). The sound goes a way after a few miles driving. It appears to come from a small "pump" looking thing at the top and on the left (facing the car) of the engine, which is attached to a pulley. My mechanic - although he did not actually hear it - says it's nothing to worry about; it's just the cold.
View 3 Replies
The power steering fluid in my 2004 Nissan Frontier crew cab leaks as the weather turns cold, the colder it gets the worse it leaks.
View 4 Replies
My car started making a weird like shhddddhshdshhhdddshhddd when I press on the gass. I am super paranoid bc last year they replaced the lower engine block bc of my oil mixing with the coolent. I need to replace my tires, could that be a factor? Iam a girl who knows nothing about cars.
View 1 Replies
On my mk7 manual, I'm getting a slight growly noise when I shift upwards, mostly noticeable from 1 to 2, a bit less from 2 to 3, and almost none from there up. Nothing when I downshift.
It's almost like a DSG fart, but much subtler. Happens for like a split second, just when I release the clutch, as if it the engine is revving up right when the clutch is engaging. But I know it's not engine related, because my RPM remains steady. Can it be the clutch slipping a bit before it fully locks? Not even sure if that's even a thing.
View 23 Replies
A co-worker drives a 1999 Ford Taurus with the 3.0L DOHC engine. The transmission makes a strange whine only when it is decelerating. It is quiet and smooth as it accelerates and drives, but let off the gas, and the whining begins. The whine changes pitch and intensity as the car slows down, and eventually fades away once you stop. Stranger still, the whine goes away if you shift to neutral and continue to slow down. It also goes away the instant you begin to accelerate again without stopping.
Someone told him it sounds like a torque converter going bad, but that doesn't seem right to me. The whine starts as soon as you let off the gas, and has a steady decrease in pitch and intensity for speed to stop. It doesn't matter if you slow down easy or quickly. I was thinking a bad bearing in the transmission somewhere in the final drive.
View 4 Replies
I have a 2002 Nissan Frontier that a had a buddy perform a tune up. Now my buddy has disappeared and my truck miss fires on start up and occasionally looses power when you drive it. I also noticed that It consumes more gas. I went from 305 miles on a 17 gallon tank to 230 miles.
View 12 Replies
My 1997 Saturn SL2 with 5 speed manual transmission won't shift into first or second gear. When I shift into the location where first would be the car is in third gear. It shifts into 4th, 5th and reverse just fine, though the shifter is in the wrong position for those gears. I can wiggle the shifter in neutral and get it to move into the position where 5th and reverse are normally found, but it is stiff and makes a clunking noise when I move the shifter over to the far right side.
I have removed the center console and the bushing appears to be intact. Both cables are in their proper positions inside the vehicle and at the engine. One of the cables (the top one in the engine) has some wear and tear on the boot, but does not appear to be binding. Other than the stiffness and the clunking noise, the shifter seems to be working fine too.
View 8 Replies
