Nissan - Altima :: 2000 GLE Idling Rough - Motor Gone Because Of Oily Spark Plugs?
Mar 19, 2012
Nissan altima gle (2000) and for the past 3 weeks it has not gone over 55. The car was running ok before but was idling rough. A mechanic replaced the intake manifold gasket, the MAF sensor and the fan sensor. I decided to change my spark plugs when I noticed the idling was getting worse. The spark plugs had oil on them and now a month after the new ones are burned (like ashy tip, black thread) and dripping oil again. I think is the oil not letting my car accelerate in the highway. I considered changing the valve gasket, cables and cap for the spark plug. A mechanic told me not to bother because the motor is a lost. Is he right?
View 16 Replies
Advertisement
1997 Nissan altima se 5 speed... I changed valve cover gasket after the spark plugs where filled with oil Put to much silicon on gasket then fixed the problem it doesn't leak any more. But the car keeps burning out spark plugs it will start right up with new plugs but after running for about 5 minutes they burn out turn black.
View 4 Replies
Motor seems to burn out spark plugs every month. I was using non volvo sparks. I took car to Volvo dealers and repairers who gave car a diagnostic check but nothing showed up. They told me to use Original Volvo Spark Plugs which I did. The Car went great with no problems for about 3 months thinking problem was fixed. Low and behold the same problem came back.
I changed spark plugs again (original Volvo) and car only ran for 10 ks and then ran very very rough with no power. Motor felt like it was running on a few cylinders. It seem this problem happens mostly in hot weather. Motor also heats up but when cooled down runs well again. I intend to buy new rotor Bosch and Distributer cap and if needed coil.
View 2 Replies
OK, well i have an old toyota pick up, One of the spark plugs ( the third cylinder) has some oily residue on it, indicating a problem with the piston. How bad could this be? Is it worth it to try and have fixed? I also am rebuilding my carb right now, so i am wondering if i is even worth continuing if the engine is messed up.
View 6 Replies
In the past 4 months, I have had a issue with my car. I have had a miss in my car and I can't find out whats going on with it. I have changed the plugs, coil packs, crank sensor, but it still has a miss. One or two of my plugs looked like they had fouled out, when I changed them before putting new ones in it. I am really getting frustrated with it. I also changed the fuel pump. What to do with my car since it is my only means of transportation with getting my son to school.
View 8 Replies
I have a '63 Buick Wildcat that has been sitting for 17 years. It has 2 spark plugs stuck in the motor. I got the other 6 out with liquid wrench. The other 2 have been soaking in liquid wrench for 2 weeks and I have been using a 3/8 drive spark plug socket, but still unable to get them out. How to get them out?
View 9 Replies
The car crank up normally, but when idling it misfires on #3 cylinder. When start to drive it will drive at 45 mph at full revolution but when I stop at a light the engine begins to vibrate and shakes the entire car. When moving off again, it continues to vibrate and hesitate and will not get up back in speed 25-30 mlp and now start to backfire in to the manifold. While stepping on the gas it also makes a popping sound. If I try to get the speed up any higher it will violently makes a popping sound and backfiring constantly into the manifold and struggles to go. The engine is also getting very hot although the engine gage said it normal and not overheating. If the car is sitting in a grassy area while idling it will completely burn dry the grass underneath.
View 12 Replies
I have a 2002 Nissan Altima. When I am sitting at a light, there is sometimes a shudder that runs through the vehicle. If I put it in park while at a light, it doesn't happen. Also, when I'm accelerating, there is a sound like a rattling growl coming from the front right of the vehicle.
View 4 Replies
I have a 2008 Camry, 2.4L, and used the spark plugs change DIY sticky and it seemed to go painlessly. However, after the new spark plugs, the car seems to idle rough. It has 95k miles, and I did the following in the same tune-up:
1. Changed Oil
2. Replaced Air Filter
3. Changed Spark Plugs
4. Cleaned Battery Terminals
5. Cleaned MAF Sensor
6. Cleaned plugs connecting to ignition coils
I used OEM Toyota plugs, and even called the dealer to see if the gap needed to be set. And they affirmed me that the gap is preset on these plugs.
View 2 Replies
I have a 2000 Jetta 2.8 VR6 (the 6-cyl) with 128k miles and I have oil on my spark plugs, only on one bank of the motor (the bank closest to the bumper, if that makes any difference). I am aware that it is most likely a leaking or worn out valve cover gasket, and I have a replacement and am prepared to replace it. What I need to know, and I can't find this exact part anywhere, is do I also need to replace the spark plug tube seals??? The gasket I ordered did not come with any tube seals, I can't find this part on any auto parts website at all, nor have I been able to locate anything useful on this, or any other, website. I know the 1.8 has plug tube seals, and they come with the gasket, but does the 2.8 also require tube seals? I imagine it would, but I just don't know.
View 2 Replies
Here's the run down:
-bought 6 months ago for cheap because it wouldn't pass smog test
-changed Purge Control Valve (PCV) and it passed
-filled with gas, heard popping noises like a backfire, and coded it read the same "Bank 1 and Bank 2 running lean, like it did before the PCV and then also "Cylinder 3 Misfire" appeared.
-At this point the car started running rough, at idle, and through acceleration...sputtering uphill, and when climbing through the gears.
-Changed the plugs & wires
-NOW, it's cylinder 5 misfiring, and not nearly as bad. It's idling and running rough, acceleration has somewhat come back, but it's definitely not 100%.
Should I start with the PCV again, since it's not starting after I fill the tank, and climbing gears slow? Is there anything else I should be checking?
View 2 Replies
I changed my spark plugs now I got a miss and rough idle .#2 and 6 seem to be the ones that miss the idle don't change when I unplug the coil , I take coil off and put it next to the motor it sparks ! I put everything 3 plugs and got about 200 miles on them and 3 out of 8 had melt downs and left me on the side of the hwy. I got autolights in it now but it got a miss and rough idle ! Did I not do something right ?
View 7 Replies
I have a 1995 Nissan Altima GXE 4cyl and it has been rough idling for a while now but now I have this new problem. While I drive the car and after it has warmed up, the car shuts off when I'm at a stop. When I'm at speed, it runs just fine and smooth and I only have problems at stops. I then restart the car just fine and continue driving. I'm having to keep doing this over and over. What could be the cause or causes for this?
View 4 Replies
My 2002 Altima A/C won't blow cold air. Took it to my mechanic who says all switches, fuses, relays, compressor clutch are OK and system has pressure, but the compressor is shot. In order to get a replacement that's guaranteed I have to get a receiver/dryer with it. Also says not to get a compressor from the salvage yard. I'm wondering if there are any other testing procedures that could be used to be certain it is the compressor....
View 4 Replies
I own a 2000 nissan altima GXE, and recently i have had a lot of problems, it would stall out randomly and OBD2 scanners said knock senor, EGR, and thermostat. I changed the knock sensor, cleaned the EGR valve and the EGR valve gasket, and haven't touched the thermostat. I changed other things like the crankshaft sensor, fuel filter, fuel pump is fine, alternator, valve cover gasket, and spark plugs. It started stalling all the time after I changed the rotor in the distributor cap, it stalled before but less than after we changed the rotor.
The car would stall randomly when the RPMs would go below 1000. I took it to my friends dad who is a mechanic and he was the one who changed the PCV valve and the EGR valve gasket and cleaned the EGR, he also cleaned the intake and changed the knock sensor. The SES light finally went away but the car would stutter when i would be stopped with the A/C on and i go to press on the gas. once the RPM hit 1000 it would stutter. It didn't stall until a week and a half later. I was told it could MAYBE be throttle position sensor, computer, thermostat, oil loss from valve cover gasket, and idle speed control.
View 3 Replies
I am the original owner of a 1993 Nissan Altima. My mechanic states that the air intake (part # 165751E400 "air duct")has dry rotted. He put some silicone hoping that would seal it but it did not work. The part is no longer available from Nissan. The car runs very rough and wants to stall when coming to a stop. It also smells like gasoline in the cabin and the gas mileage is terrible 17 mpg. I have tried to find someone who could custom make a new hose with no luck. My mechanic stated that pulling one from a used car would have the same problem. What other options are available? The hose is about 8 inches long and about 3-4 inches diameter. It has other small hoses that attached to it. Do I throw away an otherwise reliable car?
View 4 Replies
So I am working on my 5.4 I pulled and discovered that is is very oily behind the freeze plugs. The motor is on a stand and has been upside down a few times. There was still a little oil in it as I can see a decent puddle under it where I didn't tighten the drain plug entirely. Why would there be oil built up there? I have the two from the back of the heads out and the two on either side closest to the rear of the block. What kind of issue am I looking at? Here is the build thread that I am doing about the truck and this motor.
DH-Rear of Driver Head
PH-Rear of Passenger Head
PRBS-Passenger Rear Block Side
PMBS-Passenger Middle Block Side
DRBS-Driver Rear Block Side
DMBS-Driver Middle Block Side
View 1 Replies
I am changing my own spark plugs for the first time. I have a spark plug wrench, dielectric grease, anti-seize compound etc.
I have a Haynes manual for my 2002 Toyota Corolla. The book was written before Irridium plugs were used. Should I tighten the spark plugs to the same torque specifications as regular plugs? The book says 158 inch pounds. How do I know I have tightened them to the right amount?
How do I avoid cross threading the spark plugs? What happens if you cross thread the spark plugs (assuming the car seems to be running fine)? Would I need a new engine or expensive repair when it is time to replace the spark plugs again?
View 19 Replies
I have a Nissan Altima 2000 with about 98,000 miles. The "check engine" light has been on. This happened once before and eventually the light went off, but now it is on again. I read the manual and it said that the gas cap isn't on tight enough. Checked that and it is fine - but the light never went off. Should I bring it in to a mechanic?
View 5 Replies
Started my car the other morning to go to work (4:45 AM) with no problem and drove about one mile. Not wet weather. The engine dies, all lights that come on at start up (engine, alt, etc.) come on and I glided to the side. Tried starting it again - engine tried but did not catch. Tried a few more times and called AAA.
Towed it to a mechanic. Waited about 2 hours for them to open. They were able to drive it the rest of the day with no problem but they had the same thing happen the next morning (yesterday). Then it didn't happen to them today. One more try tomorrow and I hope they can identify it then.
2000 Nissan Altima w/150K miles, gas was less than 1/4 mark, no system lights on.
View 4 Replies
I have a 2004 Nissan Murano. Recently I noticed that the motor is noisy while running and idling both - no difference. I can't really hear it outside of the car, but I sure can inside. It's even worse when it's cold. Is this something to be concerned about?We took it to a local mechanic who could hear the noise, but what was causing it.
The last time we had several trips to mechanics with no answers, we wound up replacing a transfer case that went kaplooey. We had at least three mechanics on that one. No one knew why it smelled like burned oil, or leaked a little. Until it went out completely.
View 1 Replies
