Nissan - Altima :: 1997 - Piece Of Wheel Cover Popping Off With Metal
Dec 18, 2011
It's Nissan Altima 97. My friend need to take her road test so I let her borrow my car this weekend to do some road practice (I was in the car with her). Besides all the heavy braking, and sudden acceleration. She did alright. Because she is from VT, so she was practicing this VT Turn Around (I have never heard of it before today). She turn the wheel all the way to the right and back up.
I heard a small popping noise, and didn't pay too much attention to it at that moment. However, After she finish that VT Turn Around, we started to driving down the hill, and heard this metal-on-metal noise. It lasted for 10 ft, then went away. The noise is coming from my driver side front wheel. When I got off the car, I found the center of the wheel cover pop off.
(see this link for the pictures) [URL] .......
Now here are my questions. What just happened? and do I need to get it look at immediately, or can I wait until the next oil change?
View 9 Replies
Advertisement
When it's cold and the car heats up, you can hear the hood sheetmetal make an 'oil-can' buckle sound. Happens frequently while running in cold weather. It's not the hood itself, but perhaps the metal underneath. It's noticeably loud.
View 2 Replies
I went to a big box store to have new tires put on the rear of my 2002 Nissan Altima. They told me I had a stud broken from the inside of the wheel. The lug nut is still attached, and they can't get the wheel off. Both the stud and the nut turn freely within the socket. Is there any way to get this off without having to pay the $70 a tire place will charge me to fix it? I don't know how long its been like this. I currently have three new tires and one old.
View 2 Replies
I had new tires put on my 2011 Altima around 35,000 miles. I started noticing a hum, so I checked the mechanic notes and they said I had a bent right rear rim. So, I had them replace it immediately. The hum (which only happens specifically at 40mph and at 75 mph) remained so I attributed it to new tires and breaking in.
I took my car to a shop around 45k miles for a check engine light, which ended up being an ECM issue that required a dealer service. I also had him check the tires as the hum was still there. He just rotated the tires and sent me on my way. This is when the steering column started shaking, so I had the dealer check it out and they told me I had a bent rim! Go figure, I've been driving on this thing for about 10k miles.
So, I ordered a new rim and had a local tire place put it on and they showed me the bent rim. Now I thought this would solve things but I was wrong . I still fee the vibration in the steering column at high speeds and the annoying wah hum is still there.
I'm a little lost as to what the problem could be so I'm looking for some insight? Should I start with having the other 3 tires balanced? Could it be that the bent rim caused uneven wearing on my tires over the 10k miles and it may take time to even out? There's no noticeable wear on the tires to my seeing but I could be wrong. These tires are 50k mile tires. Could the bent rim have caused other unseen damage? Keep in mind the wheel they replaced is now on the rear.
I know another cause of shaking could be the rotors but as far as I know they're in good shape and breaking is still smooth. so if they were the issue causing vibration at high speeds I would surely feel it in the breaks.
View 19 Replies
I THINK my wheel bearings are going on my 2003 Nissan Altima. It has about 95k miles on it and it has been making what I would call a mid-toned rumble or a low pitched rattle (imagine shaking a metal box full of rocks). The noise is coming from the front driver's side. It's more subdued when driving in really wet weather. I am more aware of it when I drive at slower speeds. It doesn't seem to change when I turn the wheel either way, and it definitely gets more pronounced when I go over a bump or a rough patch. I recently had my front rotors and pads replaced, naiively hoped that might fix it - wishful thinking - and stupidly forgot to ask my mechanic about it then. I need to call to schedule a repair, but I would like to be prepared and to know if anything else might make this noise. (and I don't want to jack it up and shake the wheel or anything).Approximately how much does it cost to have this fixed?
View 3 Replies
I have a1997 Nissan Altima 140k miles with the manual transmission. I have a fuel problem that I can't seem to solve. every 1-2 days and only intermittently and unpredictably my car starts to idle up and down and occasionally if I don't give it enough gas they car may stall but the stalls only happen when I am not pressing the accelerator, meaning only at resting idle. since I am fanatic on washing my engine, I initially though that spark plugs were dirty or not working, I changed the spark plugs the distributor cap and the wires but the symptom continues. then I check the resistance of all the four fuel injectors and all of them read at around 12.8 ohms. I have also treated the fuel system twice with injector cleaner, the kind that you find at a gas station but still, the problem persists.
if it is not too much trouble I have another smaller questions. if the car sits overnight or for a couple days, the shift is really easy but as the car warms up the shifting becomes harder. could the transmission fluid need to drained and replaced?
View 3 Replies
on 1997 Nissan pickup 2.4-liter engine do you have to take off the valve cover to clean out EGR ports.
View 1 Replies
This summer I replaced the inner and outer tie rod ends on a 97 Nissan Altima, had a bent wheel replaced, and had an alignment done. Everything worked smoothly for the last 5,000 or so miles. I had my tires rotated and balanced recently which created a new problem, a shaky steering wheel most noticeable at slow speeds. I've had a similar problem before and had it fixed by balancing the tires. I took it back in to have them rebalanced, thinking they may have forgotten to do it the first time. They rebalanced them and the problem has not changed at all.
View 3 Replies
I've got this 02 Nissan Altima 126,000 miles. I did a front brake job on my self, new rotors and ceramic pads. Immediately after the brake job, I started hearing this horrible grinding noise when weight is shifted to the driver side. It happens when I take apply the brakes or make a right turn. When making a right turn I don't need to apply brakes to hear it. I can sometimes hear it faintly when driving normally.
I took it to my mechanic. He first inspected my brake job, disassembled the rotors and pads, applied brake grease, and reassembled everything. The problem continued. He lifted the car, and had me get in, put it in gear, accelerate, then applied brake, no noise. There is no sign of anything rubbing or grinding in the wheel assembly.
After inspecting the tie rods ends, he replaced the inner and outer on both sides. No Luck. He then replace the ceramic brake pads with regular pads which has reduced the noise but it is still there. I asked around and two other mechanics have suggested the wheel bearings, my mechanic believes this is unlikely.
View 1 Replies
I drive a 1999 Nissan Altima GXE and when i turn the a/c on or turn my steering wheel the car makes a rattling noise towards the belt. I have replaced the belt and i check all the electrical components that are runned on that belt. But i cant figure it out. I think its something to do with my pulley system because my power steering/ac are runned on the same belt along with my alternator and other components. What to check.
View 7 Replies
1997 Nissan altima se 5 speed... I changed valve cover gasket after the spark plugs where filled with oil Put to much silicon on gasket then fixed the problem it doesn't leak any more. But the car keeps burning out spark plugs it will start right up with new plugs but after running for about 5 minutes they burn out turn black.
View 4 Replies
Question: after replacing rear shocks on 2009 Altima, does in need a rear wheel alignment? After shocks were replaced on my Altima (without wheel alignment), I drove about 4500 miles. After that the tires were rotated and the back tires installed in front. I immediately noticed loud road noise, mechanic says it is uneven tread wear and I think - this is too much of a coincidence. So should they have done the alignment when they replaced the rear shock absorbers or not?
View 6 Replies
1997 200 SX SE coupe. It has the 1.6L engine and is a 5 speed.
I recently purchased this car and it had the CEL or check engine light on. The part store stated the codes were: P0304 X 2 and P1445.
Here is my problem that occurs mainly once the engine is warmed up- it started bucking and hesitating whenever I push the gas pedal. It doesn't do it when the engine is cold- at least it is very slight and hard to notice. On the highway at constant cruising speeds the car rides and purrs great. While I'm idling at a red light the rpm is constantly dropping about 100 rpm every second.
I have tried the following:
-Replaced distributor cap. The cap was slightly corroded.
-Tested spark plug wires by applying then to metal and looking for spark.
-Did a dry compression test and all cyl ranged from 150-160 psi. (Good levels??)-
-Sprayed carb cleaner around manifold to see if idle changes - nothing
I am fairly a novice at mechanics so I'm still learning. Perhaps the car has stale gas? Not sure how long it has sat, or even if it has been sitting. bad injector? Bad fuel pump/ filter?
View 5 Replies
Passenger front seat belt - the buckle will not go in the groove. When I look in the groove, there is a piece of metal. I press the orange release button and the metal does not move. So the buckle can't fit in there.
I don't know what is involved, I know it isn't body work, not sure who I can take it to.
View 5 Replies
I've noticed a creaking sound coming from the left front wheel when I go over a couple of particularly large speed bumps. I have had a lot of problems with the suspension in this car, and have replaced the front struts, the front right control arm, and the sway bar links and bushings. My best guess is that this noise is coming from the front left control arm, as it has not been replaced, although my current mechanic says that the front left control arm is fine. Also, it has been under 10 F here the past few days, so this could also just be a result of the cold weather.
Video of the noise: [URL] ....
View 7 Replies
I get two codes both p0325....
View 4 Replies
I have a 1997 Nissan Altima that I just barely got and it has started to show signs of trouble.
Sometimes when I put the vehicle into drive and step on the gas the car will not move and instead the engine will rev.I'll put the car back into park and then into drive and it'll work fine.
I checked the ATF, which was incredibly low and refilled it. The engine oil was also very low, which was refilled. The problem still persists. So I decided to add a bottle of Fuel Injector Cleaner to the gas tank.
I took the car for a short drive and nothing happened aside from the fact that the Check Engine light now comes on and off. The car also idles between 1000-1500 rpms.
View 19 Replies
I've got a 1997 Nissan Altima (automatic, GXE). Recently it has started stalling. Usually this happens when the engine has warmed up to normal operating temperature (though last night it happened when the engine had just started).
Usually when it stalls it will start right back up, but sometimes it takes a few minutes. Sometimes it will start back up and die right away, other times it will turn over and over but not start. After a few minutes it will start back up. Sometimes it will stall momentarily and then restart right away, but not usually.
The rest of the time the car runs smooth as ever, no surging, no stalling, no erratic idling, no sputtering or anything. Usually the check engine light will come on after a stall, but I get a "no code" code when I check.
This started about two weeks ago, it did it once on a Saturday and then didn't do it again until Wednesday. Since then it has happened at least once a day, and yesterday it happened a lot while I was driving home, but not at all when I headed to work. Today it was fine for about 15 minutes and then started doing it a lot, but the last 3 or 4 miles it was fine again.
What may be the problem? I'm going to check the MAF and throttle position sensors, though I would assume if they were malfunctioning I'd either have more symptoms or I'd be getting a code.
View 10 Replies
I have an 97 Altima. When I hit on the brakes, it seems to be okay, but once I let the pedal go, there are clicking noise coming for the front wheels.
View 9 Replies
So for a couple months now, my ride has been making some weird noises.
When I start the car up after anything longer than a couple hours of use, it sounds as if I have a piece of loose metal banging/moving around. I hear it sporadically on shifting through the gears, and when I'm at a stop.
Car has been in to the dealer three times, and I took the foreman on a test drive...of course it wouldn't make the sound at all.
I took a look under the hood today and noticed that the coolant level is low...filling it back up tomorrow. That got me thinking about the transmission fluid....I looked and looked, and can't find the transmission dipstick anywhere.
Any clue where I can find some way to check the level?
View 6 Replies
I have a 2007 hyundai sonata, this car is my daily driver. I put 180 miles on it a day around trip. Currently has 180,200 miles on it. Last Friday on my trip home when i turned right I heard a metal on metal sound. I slowed down went straight and it went away. Talked to a few people and I think it may be the wheel bearing. Even if I hit a road reflector it starts up. It's the front left wheel. Get on the breaks it goes away.
So my question is... Wheel bearing??? And can I replace the whole hub and fix the problem or do I have to try and press the bearing out?
View 1 Replies
