Mercedes-benz - E-class :: 1992 Runs Fine For 15 Minutes, Then Sputter And Stalls
Jan 7, 2014
1992 Mercedes 300E with 160,000 miles that I've owned for 15 years. Car runs fine for approximately 10-20 minutes and then starts to sputter and cough and if I don't increase the RPM's it will stall. If I increase the RPM's it will smooth out for a little while, but after a couple of minutes with higher RPM's it will sputter again and finally stall. After it sits for awhile I can start it up again and it runs fine for another 10-20 minutes. No check engine light is on and the car is OBD 1.
This problem preceded the weather recently turning cold. Thus far I replaced the spark plug wires as the other ones were old, but this didn't work. The spark plugs themselves were replaced about 2 years ago. At this point I'm suspecting it needs a new distributor cap and rotor (when I replaced the wires some of the cap's posts had corrosion, which I cleaned off with a brush).
View 2 Replies
Advertisement
My 2000 Mercedes Benz ML 320 with 203,000 miles stalls when I stop at traffic signals. It restarts after a few minutes. Yesterday it would not restart for several minutes after I stopped for gas.
View 5 Replies
when the temperature is above roughly 60 degrees, I can drive the car for a short while, even a few miles, and it will start to sputter and eventually stall. At that point the car won't start, it turns over fine, but sounds like it's not getting any gas. If I wait 15-20 minutes it starts fine and will repeat the same process. Is there some temperature sensor or something that prevents the engine from starting after it gets hot, or is it something else. The temperature gauge doesn't indicate the engine is hotter than normal. I've taken it to my car shop twice and they haven't found anything. 1991 mercedes e300...
View 3 Replies
This 92 MB E300 has been sitting around for the better part of the last two years for various reasons (have another car with better mileage, don't drive much anyways, no insurance on it, etc), and we've been trying to get it going again with some mixed luck. I just replaced one of the window regulators (cable busted) and the battery (alarm drained it dry), but now we're having trouble starting it. It doesn't happen every time, but when we try to start it, the starter motor seems to get going no problem and it turns pretty good, but it just won't catch consistently. Its almost like there's no fuel in there, or maybe no sparks or something? Sometimes it will catch for a second, but it takes a while. Usually, once it's going its good, but if we have to stop and wait at a red light, it will sometimes just die when shifting to drive (I usually put it in neutral and give some gas while waiting). Also sometimes just when it's in a low gear and shifts up it will die too. Then, we have trouble starting it up again!
So what's going on, do you think? I was thinking maybe something along the lines of the fuel pump, spark plug, or injectors, but what do I know? (not much).
View 2 Replies
I've got a merc C230 Kompressor that has 174k miles on it. The car typically runs really well and is not underpowered or anything. Last weekend I took a road trip that was 400 miles or so. The car did fine for the first 300 miles but then began running rough and was underpowered. Was acting like there was a fouled plug. I pulled over and stopped the car where it sat for about 5 mins. When I restarted the car, it was back to normal, with a smooth idle and not underpowered. It ran fine for about 30 mins and then began running rough and underpowered. I find that when it starts running rough, if I stop the car and turn it all the way off for at least 60 seconds, then when i turn it back on it will operate normally again for a bit. This also only seems to be happening when its really hot weather, 90 degrees F or higher.
View 5 Replies
Car: 2000 Mercedes-Benz E320 (W210) 4matic
This car runs beautifully if the air temperature is above 60 degrees or so (maybe 65) Fahrenheit.
If the air temperature, however, is much cooler, and the engine has had enough time to cool to air temperature, it stalls. Here's the sequence:- Start the car. Car runs fine, sounds good. Initial idle speed about 1200-1500 RPM.- Wait for car to warm up for a few seconds so it settles into normal idle. Idle speed settles to about 800 RPM after 5-20 seconds, depending upon air temperature.- Shift car into gear (D or R - doesn't matter). Idle speed drops to 500 or so, then the car stalls.- Restart the car. Allow it to warm up significantly (how much depends upon air temperature). - Shift into gear (D or R). Engine idle speed drops a bit, then recovers to ~800 RPM. No problems after that.
If it's a little cool (55-60 degrees Fahrenheit), I can drive off once the engine temp gauge needle rises a few degrees (45-50 degrees Centigrade).If it's around freezing (20-40 degrees Fahrenheit), I can't drive off until the engine temp gauge reaches nearly 80 degrees Centigrade.
If I'm on a hill (pointing down), I can start at a slightly lower temperature by allowing the car to start rolling as soon as I shift into gear. In this case, there's less resistance, so the idle speed doesn't go low enough to stall the car. If I am on a level surface (or pointing uphill), 80 degrees Centigrade seems to be almost a magic number when the air temperature is below 40 Fahrenheit (near freezing). When the needle is showing about 78 degrees Centigrade, the car will still stall. When it reaches 80 degrees Centigrade, the car is fine, and will not even come close to stalling when put in gear.
ONE CONFUSING VARIABLE: When I took this to my mechanic, it didn't exhibit the problem for him. When I picked it up (about 30 Fahrenheit), it stalled. He came out and started it, put it into gear, and it idled without stalling. I got in and let him watch while I got in, started it, put it into gear, and it stalled. We have no explanation as to why this would be any different (we tried several times, varying techniques, brake pressure, etc., with the same confusing results).
View 6 Replies
Hot or cold car always starts,Idles perfect , then RPM drops, Idles rough and stalls. Econometer moves to Red area.car will easily restart and drives well,it also idles well. Once engine is shut down, even for a short while, It does the same thing again. Car is used for short trips. Ambient Temperature 80 degrees. Once running car is perfect at all speeds and idles smoothly. Hero 1987 MB 560 sel ....
View 19 Replies
I have a 2001 Mercedes E class, 4Matic. Over the last 7 years the ABS (Anti-lock Braking System)/EPS (Electronic Stability Program)/BAS (Braking Assist Program) warning light comes on and when I stop the car and start again, the light goes away. When this light comes on, only thing I noticed is the cruise control does not work, otherwise, no other problem. I took it to the service station one time, but that light did not come on and they did not do anything.The car has 105,000 miles. Now, when the light comes on it stays on longer and sometimes, I have turn the car on and off several times before light will go away.I am afraid to take it to the Mercedes dealer, as they might find a problem when no problem is there. Whether this is just glitch in the software or there is a real problem.
View 1 Replies
I have a 1989 Mercedes 300F, automatic transmission, with 175,000 miles (give or take). It runs great, starts well, we have no problem driving it 30 miles back and forth on back roads up to 60 mph. The problem seems to be when driving 40 miles at 75 mph. At that point, it will start to run rough, and then will not go over 40 mph without whining. The first time this happened, I had a leak in the transmission fixed and fluid put in. The second time, I had the fluid and filter changed, a new alternator, and a complete tune up. For a month after that we drove it for miles but not on the highway, with no problem. I thought I would chance it on a longer trip, got 40 miles down the highway at 75 mph when suddenly it started acting up and had to call a tow truck. When the tow truck arrived, we did not see any fluid under the car. It's been sitting in the driveway and now there are fluid leaks (appears to be oil). So, does it sound like something in the transmission, or maybe a bad alternator?
View 9 Replies
While on way to parts store car started acting like it was running out of gas. A half block from gas station it quit . I walked to station got gas put in the tank the engine would crank but would not start. I got towed home and still will not start. It will crank but that's it. 3.0 L inline 6 300 E ...
View 5 Replies
The check engine light is on. Yesterday twice I had the situation where when I turned the key to start. The starter motor was crankin and it was not firing. I pumped the throttle a few times to let air/gas into engine. I also opened the gasoline tank cover (where you insert the nozzle to pump gas) for a few mins and then shut it and started the car. It started. After running for 20 mins it happened again. The starter motor has to crank for some 10 seconds before it fires. Then no issues. What do you think it is??? Battery is fine, starter motor is fine since its cranking away. I am suspecting fuel pump ?
View 19 Replies
I have a 91 Mercedes with 153,000 miles thats terrific but the mystery leak in the hydraulic running the rear suspension is driving me nuts. Especially when the hydraulics call for factory spec fluid.
View 3 Replies
I have a '05 Mercedes CLK320 convertible that I purchased 3 years ago with about 29,000 miles on it. Two years ago the hydraulic lines in the top blew and I spent about $3,000 to have it repaired. Today, the lines blew again. What I'm trying to find out is: - Is this common in this car? Or in any convertible?- Did I just get a lemon?- If this isn't a common problem, should the dealer that repaired the hydraulics 2 years ago fix them again for free?
It only has 70,000 miles on it now and I was under the impression that I could drive a Mercedes for a couple hundred thousand miles without a too much mechanical problem. But if this is going to be an ongoing issue, I'm going to get rid of the car, even though I absolutely love it. It's ruby red, of course!
View 5 Replies
My brakes squeak from time to time, particularly backing up, but also braking forward. My mechanic said I have plenty of brake pad and nothing is being damaged. He said he has often seen the "squeaky brakes" problem in Mercedes and it is often difficult to pinpoint which wheel (or wheels) would be the cause of the squeaking (sound like metal on metal). Why this is happening?
View 2 Replies
My 1994 mercedes C220 stalls at idle. the local mercedes dealer told me that it is caused by the alternator overcharging. can this be true??
View 2 Replies
Car starts intermittently, have heard this is common on Mercedes Benz cars, whats the fix? I do my own maintenance on my cars have tools ect.
View 9 Replies
I own a used 2004 Mercedes C320 4Matic. I bought it with 57k miles. I drive it about 150 miles per week. The reseller told me i needed engine mount replacements at 67k. The car did have a vibration, which I was sort of ignoring, so I had the work done. Now, the vibration persists.
It is most noticable in the morning upon start-up, at an idle. But it is also noticable when the car is warm and I am stopped at a light. It can also be noticed as a subtle vibration in the steering wheel at highway speed.
I am very sure it is not wheel balance or rotors (hey, I can feel it at a stop). I brought it back to the dealer, who said after 5 hours of diagnosis, they could findind nothing wrong.
View 2 Replies
Last week I noticed that my engine (2006 ML350 33,000 miles )was not sounding as it normally does. I called my foreign car repair shop that normally maintains my car but could not get an appointment for several days.
My husband thought that it was possibly a bad bearing in one of the belt pulleys near power steering pump. The noise was getting louder so my shop looked at it sooner and determined I needed a power steering pump, reservoir, gasket, fluid,accessory belt tensioner and belt.
I had no choice but to get the repair.When I picked up my car it still didn't sound right. I was told it would take a little time to break in. Well all week my car was making a lot of different sounds until it got so loud I wouldn't drive it. I took it in today and got the call that it needed what I think was called a/c tensioner pulley. I just want to know if this seems possible. (Car drove fine and no problems with steering before first repair).
View 3 Replies
I have a 1996 Mercedes C280. The outside ambient air sensor has gone bad and now reads about 30 degrees F high. There are two types of sensors for this model and year. One is a plug-in sensor that looks like a small pointy cone. The other is a long cable with a metal cylinder at the end that looks like an old-style stereo headphones jack (the thick kind). I have this second type.
I would like to know whether, instead of replacing the whole wire and sensor combination, which involves taking out the instrument cluster and rerunning the wire, I can simply cut off the wire at the sensor end and solder in a new sensor (cut off from a new part).
I am wondering whether it would be possible to just cut the existing cable near the sensor end and then solder in one of the pointy cones. There is a youtube video that shows replacement of a similar type of pointy cone sensor on a BMW, and it looks like the assembly that accepts the sensor is the same, so if I couldn't find a Mercedes plug-in receiver assembly for my old car, I could maybe use the BMW one and then plug in the Mercedes sensor. That would let me do another plug-in later without resoldering.
Since this sensor has gone bad once before, I have to think that a replacement won't last more than five years or so.
I am not sure whether the outside temperature has an effect on other aspects of the car, such as injection mix. I presume it has to go through the on-board computer, because it must be the signal for the little snowflake that appears on the dash when the outside temperature drops to freezing at the road level. Whether leaving the sensor alone and just living with a high reading will cause problems? Right now when the outside temp is around 70 degrees F the sensor reads about 105 degrees F.
View 8 Replies
Last summer my air conditioner (cooling) stopped working. However the heat has remained on and is very high, even though it is not turned on. How can I turn the heat off?
View 5 Replies
I have about 25K miles on tires that are expected to last for 60K miles. The tred is fine. But I have experienced occasional serious shaking of the car when going at high speeds. Not every time. And it has only happened when I am alone in the car (of course did not happen with mechanic in the car). My mechanic says I need an alignment and new tires, claiming that by being out of alignment the tires are ruined. Says it is heat and road conditions that cause the effect and there is steel belt damage within at least one of the tires. Curiously, the car does not do the classic out-of-alignment thing of pulling to one side. Not at all. Is it an alignment and tire issue or something else? The car has 175,000 miles on it and otherwise run great!
View 6 Replies
