Mercedes-benz - C-class :: C240 Car Seems To Be Gasping For Breath And Attempt To Stall When Come To A Stop
Sep 12, 2013
Mercedes Benz C240 ... Every time I come to a stop, the car seems to be gasping for breath and attempt to want to stall. Occasionally the battery/alternator light comes up. It has not stalled yet and seems to catch its breath and continues once I step on the gas after the shake and after there was an air rush through the vents (I called-Caching its breath). I took it in to the dealer and the electrical was checked and they found nothing.
View 6 Replies
Advertisement
3 months ago, my 2003 C240 Mercedes made a high pitched whine and would not accelerate more than 15 miles per hour and if I did go faster the whine got louder and higher in pitch. I took it to the local “foreign car” auto shop (I have had the car serviced there in the past) and they replaced what I believe that said was a “contact plate” something that controls the transmission is what I think I remember. Yesterday (just 3 months later) the exact same issue is occurring. Again I had it towed back to the auto shop and now they tell me the transmission is shot and they will need to replace it. They added it has nothing to do with the plate they replaced/installed 3month ago and they will give me a credit on the plate that installed 3 months ago. Are they correct?
View 2 Replies
Car: 2000 Mercedes-Benz E320 (W210) 4matic
This car runs beautifully if the air temperature is above 60 degrees or so (maybe 65) Fahrenheit.
If the air temperature, however, is much cooler, and the engine has had enough time to cool to air temperature, it stalls. Here's the sequence:- Start the car. Car runs fine, sounds good. Initial idle speed about 1200-1500 RPM.- Wait for car to warm up for a few seconds so it settles into normal idle. Idle speed settles to about 800 RPM after 5-20 seconds, depending upon air temperature.- Shift car into gear (D or R - doesn't matter). Idle speed drops to 500 or so, then the car stalls.- Restart the car. Allow it to warm up significantly (how much depends upon air temperature). - Shift into gear (D or R). Engine idle speed drops a bit, then recovers to ~800 RPM. No problems after that.
If it's a little cool (55-60 degrees Fahrenheit), I can drive off once the engine temp gauge needle rises a few degrees (45-50 degrees Centigrade).If it's around freezing (20-40 degrees Fahrenheit), I can't drive off until the engine temp gauge reaches nearly 80 degrees Centigrade.
If I'm on a hill (pointing down), I can start at a slightly lower temperature by allowing the car to start rolling as soon as I shift into gear. In this case, there's less resistance, so the idle speed doesn't go low enough to stall the car. If I am on a level surface (or pointing uphill), 80 degrees Centigrade seems to be almost a magic number when the air temperature is below 40 Fahrenheit (near freezing). When the needle is showing about 78 degrees Centigrade, the car will still stall. When it reaches 80 degrees Centigrade, the car is fine, and will not even come close to stalling when put in gear.
ONE CONFUSING VARIABLE: When I took this to my mechanic, it didn't exhibit the problem for him. When I picked it up (about 30 Fahrenheit), it stalled. He came out and started it, put it into gear, and it idled without stalling. I got in and let him watch while I got in, started it, put it into gear, and it stalled. We have no explanation as to why this would be any different (we tried several times, varying techniques, brake pressure, etc., with the same confusing results).
View 6 Replies
when the temperature is above roughly 60 degrees, I can drive the car for a short while, even a few miles, and it will start to sputter and eventually stall. At that point the car won't start, it turns over fine, but sounds like it's not getting any gas. If I wait 15-20 minutes it starts fine and will repeat the same process. Is there some temperature sensor or something that prevents the engine from starting after it gets hot, or is it something else. The temperature gauge doesn't indicate the engine is hotter than normal. I've taken it to my car shop twice and they haven't found anything. 1991 mercedes e300...
View 3 Replies
1999MB 320 Automatic trans .... Stopped at a light went to start heard a loud bang car became motionless? Trans has 60k and never a shifting issue.
View 1 Replies
OK, so this is a 2012 ML350 Blue-tech with around 31,000 miles on it. Lately when it is warm (either by driving for 30 minutes or more, or by outside temperature of 80 plus), it has been making the strangest front end groaning noise when coming to a stop and when pulling away. It sounds like the front end suspension is "groaning". It doesn't have to be a hard stop, gentle will do just fine. The car comes to a halt, the front end dips slightly - "groooaaan" (perhaps more on the rebound than the initial dip). You start up again, the front end unloads, and "groan".
Very disconcerting on a car as smart as this. Tom and Ray know this car - this is the one with the "smart radio" (switches channels at voice command…) The dealer is stumped. They have the car for the third time now and even though both a mechanic and the shop foreman have been shown the problem (taken for a test drive ), they have been unable to come up with either a diagnosis or a fix. They replaced the front sway bar links once to no avail.
View 5 Replies
My 2003 E320 (131K miles) had been intermittingly flashing a red "Battery/Alternator Stop Vehicle" light and annoying alarm sound as well as a "Malfunction Electrical Consumers Turned Off" sign. Then three days ago the "check engine" light came on; went away the next day. Then yesterday the engine completely shut down on me.
The car started the today; took it to mechanic who says it could be alternator or wiring problem. Suggested I take it to MB dealer to get diagnosis before shelling out 800 bucks on an unnecessary car part. My question: should i take it to MB dealer or just replace the part? (I am not original owner; don't know if alternator's ever been replaced).
View 4 Replies
I have my second 1999 as class Mercedes and both have the same problem. The door assist system stop working on the passenger door in the trunk. The only way to get it working again is to remove the fuse associated with that system and reseat it.
View 1 Replies
A few months ago I bought a used 2007 Mercedes C280. Overall, I've been very happy with the car. The first month or so was heavy on longer highway driving, and it seemed to be getting decent gas mileage. The last couple of months have been mostly short range city driving, and the mileage seems significantly less. I wonder about the idle speed, on the assumption that it may be wasting a lot of gas sitting at stop lights and in traffic. The tachometer reading isn't always consistent at idle, but fairly often it's up close to 9,000 rpm. What should I be seeing, and does this need attention?
View 6 Replies
I have a 2001 Mercedes E class, 4Matic. Over the last 7 years the ABS (Anti-lock Braking System)/EPS (Electronic Stability Program)/BAS (Braking Assist Program) warning light comes on and when I stop the car and start again, the light goes away. When this light comes on, only thing I noticed is the cruise control does not work, otherwise, no other problem. I took it to the service station one time, but that light did not come on and they did not do anything.The car has 105,000 miles. Now, when the light comes on it stays on longer and sometimes, I have turn the car on and off several times before light will go away.I am afraid to take it to the Mercedes dealer, as they might find a problem when no problem is there. Whether this is just glitch in the software or there is a real problem.
View 1 Replies
I have a 1989 Mercedes 300F, automatic transmission, with 175,000 miles (give or take). It runs great, starts well, we have no problem driving it 30 miles back and forth on back roads up to 60 mph. The problem seems to be when driving 40 miles at 75 mph. At that point, it will start to run rough, and then will not go over 40 mph without whining. The first time this happened, I had a leak in the transmission fixed and fluid put in. The second time, I had the fluid and filter changed, a new alternator, and a complete tune up. For a month after that we drove it for miles but not on the highway, with no problem. I thought I would chance it on a longer trip, got 40 miles down the highway at 75 mph when suddenly it started acting up and had to call a tow truck. When the tow truck arrived, we did not see any fluid under the car. It's been sitting in the driveway and now there are fluid leaks (appears to be oil). So, does it sound like something in the transmission, or maybe a bad alternator?
View 9 Replies
While on way to parts store car started acting like it was running out of gas. A half block from gas station it quit . I walked to station got gas put in the tank the engine would crank but would not start. I got towed home and still will not start. It will crank but that's it. 3.0 L inline 6 300 E ...
View 5 Replies
The check engine light is on. Yesterday twice I had the situation where when I turned the key to start. The starter motor was crankin and it was not firing. I pumped the throttle a few times to let air/gas into engine. I also opened the gasoline tank cover (where you insert the nozzle to pump gas) for a few mins and then shut it and started the car. It started. After running for 20 mins it happened again. The starter motor has to crank for some 10 seconds before it fires. Then no issues. What do you think it is??? Battery is fine, starter motor is fine since its cranking away. I am suspecting fuel pump ?
View 19 Replies
I have a 91 Mercedes with 153,000 miles thats terrific but the mystery leak in the hydraulic running the rear suspension is driving me nuts. Especially when the hydraulics call for factory spec fluid.
View 3 Replies
I have a '05 Mercedes CLK320 convertible that I purchased 3 years ago with about 29,000 miles on it. Two years ago the hydraulic lines in the top blew and I spent about $3,000 to have it repaired. Today, the lines blew again. What I'm trying to find out is: - Is this common in this car? Or in any convertible?- Did I just get a lemon?- If this isn't a common problem, should the dealer that repaired the hydraulics 2 years ago fix them again for free?
It only has 70,000 miles on it now and I was under the impression that I could drive a Mercedes for a couple hundred thousand miles without a too much mechanical problem. But if this is going to be an ongoing issue, I'm going to get rid of the car, even though I absolutely love it. It's ruby red, of course!
View 5 Replies
My brakes squeak from time to time, particularly backing up, but also braking forward. My mechanic said I have plenty of brake pad and nothing is being damaged. He said he has often seen the "squeaky brakes" problem in Mercedes and it is often difficult to pinpoint which wheel (or wheels) would be the cause of the squeaking (sound like metal on metal). Why this is happening?
View 2 Replies
My 1994 mercedes C220 stalls at idle. the local mercedes dealer told me that it is caused by the alternator overcharging. can this be true??
View 2 Replies
Car starts intermittently, have heard this is common on Mercedes Benz cars, whats the fix? I do my own maintenance on my cars have tools ect.
View 9 Replies
I own a used 2004 Mercedes C320 4Matic. I bought it with 57k miles. I drive it about 150 miles per week. The reseller told me i needed engine mount replacements at 67k. The car did have a vibration, which I was sort of ignoring, so I had the work done. Now, the vibration persists.
It is most noticable in the morning upon start-up, at an idle. But it is also noticable when the car is warm and I am stopped at a light. It can also be noticed as a subtle vibration in the steering wheel at highway speed.
I am very sure it is not wheel balance or rotors (hey, I can feel it at a stop). I brought it back to the dealer, who said after 5 hours of diagnosis, they could findind nothing wrong.
View 2 Replies
Last week I noticed that my engine (2006 ML350 33,000 miles )was not sounding as it normally does. I called my foreign car repair shop that normally maintains my car but could not get an appointment for several days.
My husband thought that it was possibly a bad bearing in one of the belt pulleys near power steering pump. The noise was getting louder so my shop looked at it sooner and determined I needed a power steering pump, reservoir, gasket, fluid,accessory belt tensioner and belt.
I had no choice but to get the repair.When I picked up my car it still didn't sound right. I was told it would take a little time to break in. Well all week my car was making a lot of different sounds until it got so loud I wouldn't drive it. I took it in today and got the call that it needed what I think was called a/c tensioner pulley. I just want to know if this seems possible. (Car drove fine and no problems with steering before first repair).
View 3 Replies
I have a 1996 Mercedes C280. The outside ambient air sensor has gone bad and now reads about 30 degrees F high. There are two types of sensors for this model and year. One is a plug-in sensor that looks like a small pointy cone. The other is a long cable with a metal cylinder at the end that looks like an old-style stereo headphones jack (the thick kind). I have this second type.
I would like to know whether, instead of replacing the whole wire and sensor combination, which involves taking out the instrument cluster and rerunning the wire, I can simply cut off the wire at the sensor end and solder in a new sensor (cut off from a new part).
I am wondering whether it would be possible to just cut the existing cable near the sensor end and then solder in one of the pointy cones. There is a youtube video that shows replacement of a similar type of pointy cone sensor on a BMW, and it looks like the assembly that accepts the sensor is the same, so if I couldn't find a Mercedes plug-in receiver assembly for my old car, I could maybe use the BMW one and then plug in the Mercedes sensor. That would let me do another plug-in later without resoldering.
Since this sensor has gone bad once before, I have to think that a replacement won't last more than five years or so.
I am not sure whether the outside temperature has an effect on other aspects of the car, such as injection mix. I presume it has to go through the on-board computer, because it must be the signal for the little snowflake that appears on the dash when the outside temperature drops to freezing at the road level. Whether leaving the sensor alone and just living with a high reading will cause problems? Right now when the outside temp is around 70 degrees F the sensor reads about 105 degrees F.
View 8 Replies
