When I fill up gas at the pump, the pump continually cuts off as if the tank is full. I spend about 10 minutes at the gas station filling up the tank, and I can never tell if the tank is full or if the hose is just cutting off. The car mechanic told me the replacement vent line cost $200 to $300 to replace (with labor). Is there any cheaper solution?
View 1 RepliesI have a Mazda Tribute with a manual transmission. About two years ago a sporadic issue started occurring. I would drive somewhere with no problems. Stop the car and park. Then when I would go to drive off the car would stall. It stalls and stalls and stalls. Start up the engine, it cuts out. Weird thing is that I can limp home. I give it gas and I back up. Then when I stop it stalls. I shift into 1st and drive, I can get up to highway speeds no problem, then drive (the most I have had to go is 45 miles) on the highway, but when I get off and get to a stop or a light, the car stalls. Start it up and keep this going all the way home.
Two hours later, get in the car... like NOTHING happened. I have brought it to my mechanic, the dealership and asked countless friends to no avail. They always say "bring the car to me when its doing that." The one time I had a shot at that, I got it to the dealer, and then it didn't stall. It stalled the whole way to the dealer, but not when I got there.
both wiper fluid jets on my 2003 Mazda Tribute have been weak, I'm guessing they're not BOTH blocked or obstructed, so would the community surmise that it's time for me to replace the wiper pump? And if so, is this a difficult repair?
View 2 RepliesCan't fill the tank in my 1981 Chevy 1500 Truck; pump cuts off after 7 gallons. I took the vent tube and the fill hose off and there are no blockages.
View 8 RepliesThis has happened to me 4 times now in the 7 years I've owned my car. It happened so infrequently I thought the problem was the pump's sensor was not working properly. However now it's happened twice the last two times I've tried to fill up. On Friday my son was supposed to fill the car and could only get 1 gallon in and the fuel pump kept clicking off as if the car is full of gas. The bars never moved and I thought the problem was the pump. Then today, Sunday 2 days later, I decided to go ahead and fill it up. I have 250 miles to drive and want a full tank of gas. The tank shows 3 bars. I started fueling and it clicked off at 1 gallon. So I pulled the pump trigger again and tried to force more fuel in and it stopped and wouldn't add anymore than 1.7 gallons.
So now I have a long drive tomorrow and I can't figure out why the pump is clicking off as if the tank is full yet it can't be because I drove 250 miles since my son tried to put gas in and it's showing I have 3 bars.
I was filling up the Phaeton tonight when the gas pump malfunctioned. Instead of shutting off when the tank was full, it just kept on pumping until gas came spewing out of the tank. The side of the car (and my best pair of pants) got drenched in gasoline. I immediately went home, threw my clothes in the laundry, took a long shower, washed and waxed the car, and cleaned the seats with leather conditioner for good measure. The car still smells of gasoline, but not so badly now.
My question is this: Is there harm in filling the tank completely to the brim? Because my tank is now as full as it possibly can be. Is there anything I should do before I drive it again?
My car is a 2003 Hyundai accent . When getting gas, the gas pump often shuts off several times( almost every $0.50 of gas) well before my gas tank is full. Also, I have to fill the tank VERY SLOWLY to prevent spills and it takes a long time to fill up the tank. After Im done the car takes gives a bit of problem to start. Could it be the fuel filter?
View 6 RepliesI had less than half a tank and went to fill up before a long drive. At the gas station, the pump wouldn't let me put any gas in the tank , it kept clicking stop. I gave up and was going to try again later, however when I turned my car back on, it said I had a full tank all of a sudden.
The gauge on my dashboard isn't going down at the right speed either.
I have an 02' Blazer 2Door 2WD 4.3L vortec. Great truck - very low miles. About a month ago the fuel pump went out. She was showing signs / not starting on the 1st/2nd try and finally wouldn't start. It's a 12 year old pump and I was also that guy trying to make til Friday on a quarter tank - so no complaints so far. I checked the relay and fuse, all good there - so I bought a new AC Delco and fuel filter. Drained and dropped the tank, cleaned and dried the tank and installed the new fuel filter. The pump came with a new pigtail - so I wired in the new pigtail, attached the hoses and re-attached the tank. Not bad for 6 hours of work ( first time - don't judge ). She fired right up and ran like a champ / about a week later I stopped and filled up the gas tank. Next day - no start / no whine from pump / 0 psi at the schrader valve.
Assuming it must be an electrical issue - I dropped the tank and tested the gray power wire / 12 volts. But to be thorough / in case I made a mistake / I stripped and re crimped all the connections, heat-sealed the sleeves and wrapped in all in electric tape. Tested the pump - she hummed like a kitty. Re-installed the tank and she fired up like a champ. Drove around a couple of days - stopped and filled the tank with gas. Same thing - wouldn't start right there at the pump. i poured fuel in the intake - she would start and run until the fuel burned up.
No hum from the pump. had it towed home ... again ... began to siphon my now full tank of fuel to drop it yet again. At about 1/2 way , I tried her and the pump primed and she started right away. For the past two weeks I have been unable to make it NOT WORK - but i am worried to go very far , less i be stranded again. on the gauge I get 60 with the key on and 56 running. With the engine off the pressure holds for quite a long time - well over an hour+. So what would cause a brand new AC Delco pump to not work only when the tank is full - then start working when some of the fuel is removed?
I am a proud owner of a 06 Mazda tribute 3.0, 6 cylinder, 2 wheel drive, automatic. That is not the problem. The problem is on long drive 100 miles or more when we take a pit stop, to stretch our legs, we exit and when we come to a stop the suv stalls out. Its like we are driving a manual and forgot to push in the clutch. We can start it right back up and when we put it in drive it does it again. If we start it in neutral it will ideal but as we shift to drive it stalls out. We are not seeing any other problems. The MPG are the same and haven't gotten any worse. What should I look into fixing?
View 11 RepliesI have a 2008 Mazda Tribute with 93k miles on it. These last few years have been a nightmare. The car is constantly in the shop. I’ve been trying to diagnose and repair front end problems. Recently, I had my tires rotated and balanced. New sound: Now I’m having loose play in my steering wheel and a loud clicking/creaking sound when I turn the wheel at low speeds or attempting to parallel park. Ongoing sound: the car makes a tight creaking noise when I stop at low speeds. This sounds like something is tightening or screechy brakes. Here’s all of the repairs that I’ve done to the vehicle:
46,000 (11/16/12) Replaced entire right-front CV axle.
52,201 (3/10/13) Replaced front brake pads and rotors. Replaced both front sway bar links.
58,602 (7/10/13) Replaced both front control arms, serpentine belt, and tensioner/pulley for belt.
66,257 (3/23/14) Transmission fluid changed, leaking value seals replaced, spark plugs + wires changed.
81,258 (8/16/15) All four tires replaced with new ones.
84,797 (9/12/15) New front brake pads (ceramic), rotors serviced.
86,391 (10/5/15) Both front struts replaced, both outer tie-rods replaced, wheel alignment performed.
91,308 (1/12/16) Both front ball joints replaced. Both front wheel bearings replaced.
93,744 (3/5/16) Tires rotated and balanced.
I’m running out of things to fix on the front suspension of this vehicle it’s extremely frustrating. I’m nervous to drive on freeways at high speeds because the steering is wobbly but I don’t know how to fix it.
Here's a youtube video where you can hear the noise. Note the "play" in the wobbly steering wheel when the video first starts. [URL] ....
I was backing out of the driveway a day ago and my gear got stuck in neutral,can not move the gear shifter and just don't know what to to do. This has never happened before.
View 9 Repliesi have a 2005 mazda tribute v6. it has been knocking for about a year slowly geting worse. no check engine lite on, so i think it may be the egr valve. just wonder how to check it.
View 7 RepliesI have an 08 mazda tribute 2.3litre 5 speed. The truck started losing power and bucking really bad about 2 months ago. If I shut the truck off and let it sit for a few minutes, then start it back up, it runs fine for maybe 10 minutes or maybe a week then it eventually starts missing and bucking again. It throws the code p0191 which is the fuel rail pressure sensor. I have replaced the sensor twice and put new plugs, wires, coil packs, fuel filter and even replaced the pcm. The truck is still doing the same thing and throwing the same code. My Mechanic and myself are stumped.
View 8 RepliesI have a 2002 Mazda Tribute V6 with 151K. My check engine light has come off and on for quite a while now, mostly it would come on when it rained and then go off when the weather cleared. When it was on, the engine would sputter or misfire. I first had Auto Zone hook it up and they said it needed its plugs and wires changed. No problem. I took it in to a repair place and was informed that I don't have plugs and wires, but something with coils and that since it was impossible to determine which coil was bad, all would have to be replaced at a cost of $1500. I then took it to another repair place and they said the same thing. Now I have seen some discussions regarding this same thing and apparently some people have been able to identify a specific coil. At this point my check engine light is now on all the time and I'm really worried about doing terrible damage.
View 19 RepliesI'll be driving the car fine, but after driving for maybe 10+ minutes and then stopping for 20-30 minutes, my manual 2002 Mazda Tribute DX (about 126K miles) won't start. It doesn't act flooded at all, all I hear is a click. The lights and radio and air conditioning and everything come on perfectly, but it won't start. About half of the time, it won't work at all with repeated attempts but after about 5 min. it'll just start normally. I've towed it to a shop 3 times now, on the first the alternator was replaced, and after about a week the same problem occurred, etc.
My mechanic then thought I might not be pressing the clutch all the way down since it worked right after towing but after about a week (I removed the floor mat and even made a video of me, a relatively large male, pressing as hard as safely possible on the clutch) but it still wouldn't start. It was towed, and now the car is at the shop again but the mechanic can't reproduce the problem yet again. Its battery and clutch were just replaced about a year ago, the connections don't look corroded, and my mechanic's tests on the alternator seem fine. Steering wheel isn't locked, and (supposedly) the shop's tried looking at the starter.
The engine in my 2006 Mazda Tribute seems to have developed a knocking noise. I am not sure what causes it or how to determine where it is coming from.
View 11 RepliesI have a 2003 Mazda Tribute that seems to have a bit of an idling issue. When my heat on my car is off, everything is fine as far as the idle speed. When I have the heat on, even when it is low, and I am stopped, the rpm's rise a bit, then go back down to normal idling speed. The car also gives a little jump when I come to a stop. I think all of this is related to turning the heat on and off, as it doesn't happen when the heat is on.
View 11 RepliesI was on my way home suddenly the acceleration of the trib went sluggish.... low idle especially when you put it on drive and with the a/c on. It can rev but it feels like you are revving a 1.1L engine.
What could be the cause? I already had the sensors etc cleaned 6 months ago.....It has NO check engine light.
When I am slowing to a stop, my engine idle gets really low (like 500rpm or less) and sometime stalls. At the same time, the oil light comes on. It does this all the time, and yes I've had my oil changed recently and actually I just checked it the other day and it was fine (along with all other fluids).
I've had the mechanic take a look at this three times and every time something gets fixed but this problem remains. They now say it's a ghost. It is not the air intake (I've had all of the hoses checked and a bad one replaced). It's not the electrical (I've had the spark plugs and cables replaced about a year and a half ago).
I've pretty much had everything that a car of a certain age needs done fixed/replaced in the past year or so, and I still can't figure out what could be causing this. A recent show had a similar problem, but the gal didn't mention the low idle/stalling. In that show they mentioned that she should have the oil pressure gauge checked or replaced, but would that cause the low idle/stalling? I don't know what to do and I'm very reluctant to go to a dealer.
I have a 2002 Mazda tribute, and I was driving down the road yesterday when I heard a loud pop. After, the check engine light started blinking, the lights and electricity started struggling, and I hear a loud thwack thwack thwack sound when I step on the gas. This sound gets louder and faster the more I hit the gas. When I checked under the hood, the serpentine belt looks fine, and there is no visible damages but when the car is running it sounds like I have no exhaust system it is so loud.
What could have happened and where I should start working? Family and friends have thrown out a few things but I do not want to start taking things apart if If they are not the problem.