Mazda - Miata :: 1994 - Clunking Noise From Trunk On Bumps?
Mar 6, 2011
I've got a '94 Mazda miata which is in good shape, with among other things a fair number of suspension upgrades. It drives really well, other than the clunk. On the occasional bump it clunks as if something is loose on the driver's side rear. I've checked the shocks, springs, jacked it up and inspected everything I can think of. I'm looking for wisdom from your decades of experience (in your terms wasted time) on what it might be.
View 3 Replies
Advertisement
So i was cleaning my 2007 mazda miata and i noticed one wheel has some fairly deep scratched grooves inside of it. I inspected all the other tires and the other front tire has similar marks but they are way way more of a surface/barely there scratches. The rear wheels are not scratched. I am also hearing a rotational noise when i drive. It gets faster as I accelerate and slower when I brake. I don't know anything about cars.
View 6 Replies
So, something odd happened to me today while driving. I was getting off a highway after about 250 miles of driving, downshifted from 5th to 4th, and when I hit the gas pedal after shifting, nothing. No acceleration. I shift back to 5th. Still nothing. Try revving in neutral, also nothing. I come to a stop on the exit ramp and try to start the car up. It starts up, hits about 1k rpm and stalls. Gas pedal does nothing still. What's up with this? I had it towed to my shop.
Couple tidbits of info: just had the oil changed three days ago. Checked the oil and it seems fine. I have an aftermarket he's unit in the car and lately, it's been a little wonky. When I put use my automatic windows, sometimes the volume will mute for a sec.
My car is a 2006 Mazda Miata base model. 5 speed manual. Power windows but not locks. No traction control. No cruise control. 40,000 miles. Oil changed regularly with full synthetic.
View 6 Replies
My car often backfires on downshifts. It happens as I?m decelerating in gear, and then blip the throttle to match the higher rpm of the lower gear. The car runs well and is well maintained. The spark plugs, MAF sensor, O2 sensors, and cat are all in good order. I?m confident the air/fuel mixture is working as intended by Mazda (at least under normal driving), so I?m not looking for a mechanical culprit. I?m sure it?s my style and frequency of downshift/rev matching which causes the backfires.
It happens anywhere from 1-2 times a week to 1-2 times a day depending on my driving, or on something like 2-5% of all downshifts. Personally, I rather like excitement of the backfires and the exhaust burble which accompanies them, it makes me feel like I'm in a race car. My question is whether frequent backfiring is going to drastically reduce the life of my catalytic converter and O2 sensors.
I don't mind replacing the cat 5 years from now instead of say 10, but I don?t want to have to replace it within the next 10,000 miles or less. My Miata is a 1999 model with 130,000 miles on it. The exhaust system uses stock manifold and muffler but with an AEM performance intake and monsterflow catalytic converter.
View 6 Replies
Last week the shift got stuck in Park. I used the emergency release button to get into Drive. After this happened several times I took it to the mechanic who said the shift needed replacing. Got a new shift. The problem persists. I get stuck in Park about 1 in 6 times.
View 3 Replies
Problem: car cranks but doesn't start then randomly it will start. 2 different shops...first thought maybe battery (no it cranks) but said these cars are notorious for cam sensor problems they didn't have software to diagnose. Brought to dealership again battery (we were finally beat down and replaced battery) ...then brought home if car sat for a few days totally dead needed jumpstart....brought back to dealer they replaced cam sensor and timing belt...went to pick it up and you guessed it....cranked but didn't start....mechanic came out and it started....so after replacing several parts we are back to the same problem intermittent crank without start...
View 4 Replies
I have this vehicle, which keeps blowing out the catalytic converter, its been replaced 3 times in the last month, and the mechanic doesnt know why, he refuses to put another one on it, until he figures this out.
View 3 Replies
I have a Mazda Miata 2001, 152,000 miles. It's developed a metallic scrape from the right rear wheel. When I'm driving about 20 mph it sounds like a scritch every half-a-second or so, and if I'm going faster it just blurs into a metallic scrape. When I tap the brakes, it usually stops, and then it'll come back a little bit later (maybe when I hit a bump?) It comes and goes, but it seems to be more persistent now (or maybe I'm just always listening for it).
I took the wheel off and sprayed brake cleaner everywhere and I thought that had fixed it, but it came back again after a week maybe.
View 4 Replies
I have a 1990 Mazda Miata, and the AC is not working. It has been switched over to R134a. I took it to a mechanic to have it recharged a few weeks ago. He said that one of the o-rings was cracked and so it was leaking around that. He filled it up and put some stop leak in it and for awhile it seemed to work fine. Then it stopped blowing cold air. I took it to a jiffy lube just to have the level of coolant (correct term?) checked. The person there told me that it was very low and was leaking around the valve stems. I tightened the valve stems and re-filled it. After 24 hours it had stopped blowing cold air again. I got a price quote on a new compressor and it is about $500.
So - my question is this - should I just put a new compressor in or is there something cheaper I could try first?
View 10 Replies
For the past maybe 10 months, my car has been giving me new AC problems. The AC runs just fine when I'm driving normally or on the highway (basically without stopping for long periods of time and out of traffic). But when I stop for a long time (traffic, drive-thru, long light), my AC begins to run hot. To be more specific, the car actually begins to feel like it is running with more difficulty, as the engine starts running loudly and then I know that it is game over and it begins spitting out hot air. I generally just turn the AC off and put the windows down until I can get moving again, and then the AC is colder when I turn it back on.
Now, about 5-6 months ago I took it to my Mazda guy and he checked it out. Of course, it did not do what I wanted exactly, showing him what really happens when it sits for too long. Anyways, he said that everything seemed to be fine & both fans were working, but that the freon (r134) was low and he charged up the system and added some freon. After this, the AC was running MUCH cooler than it was before and the problem stopped.
That brings me to the last couple months; the problem has returned. This indicates to me, perhaps, that the freon has leaked out at this point, so it needs some more r134, but with dye, so that they can get a sniffer and pick the leak. Additionally, the engine is not overheating or anything of that sort, so I don't think it has to do with the radiator or coolant. I have essentially replaced almost every other part of the AC system in the car within the last 3 years. I have replaced the condenser, one of the fans, the water pump, hoses, everything you could imagine that isn't the compressor or the second fan.
View 6 Replies
Car recently acted like it was running on two or three cylinders and cel came on and continued to flash. The shop that did the repairs is no longer a Mazda dealer, but has a factoy trained tech. Don't know the code #, but was told that there was a low voltage code, and a misfire code. The battery was replaced, throttle body cleaned and a new fuel filter installed. The cel came back on about 25 miles later. They rechecked the codes. Said it could be the converter, and cleared the code again. After about 150 miles, the cel came on again but the car ran normal. Talked to the shop again and was told the the converter problem would have to be serviced at a Mazda dealer. The engine did the running on three cylinder thing again. Since then, it seems to run ok but the light is still flashing. If the OEM converters are fragile are there better options for replacement? The car has 30,000 miles.
View 4 Replies
I have a 2007 Mazda Miata that I just found standing water under the passenger seat. Took it to dealership the drain is plugged if I had brought the car in when under warranty they would have done the retrofit it needs to fix their lousy design problem for free. I am trying to talk to Mazda and the dealership about them fixing the problem for free. They issued a in house service bulletin but not to the public.
View 6 Replies
My Miata stalls out on the highway but not on residential streets. If I open the gas tank ,it starts up again. This has happened with a full tank, 1/2 tank and 1/4 tank. How can I fix this?
View 9 Replies
I am losing my mind over this. I bought a 2013 c63 in May and the last few months it has been making this clunking noise. I have taken it to the dealership 3 times so far and each time the noise goes away for about a week only to return worse than it was. It used to only make noises when I turned right on incline changes at low speeds. Now it makes the noise going over any bump at any speed.
The first time I took it in they replaced the front left strut. The second time they replaced the front right strut. The third time they replaced the lower control arm.
I am posting 2 videos of the noise. This video is between the first and second visits and the noise can be heard around the 24 second mark.
[URL] ....
This second video was taken today, 2 weeks after my third visit. You can hear the noise continuously throughout the video on any slight bump.
[URL] ....
View 11 Replies
I have a 91 Miata Auto. I bought it from someone that (I think!) never drain auto trans fluid during its 145K mile life. So last year I replaced all the gaskets/filters and tuned up the car. It runs fine except shifting harsh in cold weather. I have to mention that it seem to have no power and goes very slow on first few minutes.I used a pump to suck trans fluid out. It was so dark (even I dropped the trans pan and replaced filter/gasket). Then I pumped Lucas trans fix fluid in and it seem to improve. What should I do more to reduce the harsh shift condition in cold weather? Or is there a booster module need to be replaced?
View 6 Replies
I have a 2001 Miata. It's been over 100 degrees daily lately. The AC will blow sort of cold for about 30 minutes and the temp gauge will move towards the H hashmarks. If I turn the AC off, the gauge will slowly drop. I've also noticed that the amount of cold air is decreasing as time passes. In fact, the other day, the system was blowing air hotter than the outside temperature after about an hour drive.
The viewing glass has bubbling stuff flowing thru it. The recently flushed radiator is full as is the overflow reservoir.
View 2 Replies
When i go over bumps at slow speed (such as speed bumps) i hear a rattle in the trunk like something is loose. Its a deep sound like ceramic plate or a brake rotor kinda flopping around back there (not plastic creaks). Sounds almost exactly like a loose spare tire or something. So i checked it, and it was tight. Sound still there. so then i jsut removed everything, jack/tools and spare tires. Sound still there. So then i ran with both the seats down, and up in the locked positions. Def more noticable with the seats down.
It doent seem to make the noise on small sharp bumps when im on the freeway. Usually only rolling slowly (less then 15mph) over large bumps and when the suspension comes back down in rattles. I plan on bringing the car in when my work weeks over, but im wondering if theres anything else i can check in teh trunk area that might be rattleing around.
View 14 Replies
Have a 2011 SE with just over 21k miles on it.
Problem #1: When ever I go over bumps, go down my drive way, I hear this rather loud noise coming from either the roof or right rear. It sounds like someone is hitting metal with a hammer.
It happens when I'm turning the wheel or just driving straight.
Problem #2: Also when I am going over a speed bump, when the rear of the car goes over it, the suspension gets squeaky. Speeds are about 2-3 mph~
Unfortunately, it is no longer under factory warranty so taking it to the dealer is my last option.
View 5 Replies
I got a few questions. First one is how hard would it be to swap the auto trans out for a manual and what would I need. Secondly, have some weird boost issue, boost gauge use to read 5 psi with front mount now its at 2 psi and their are no leaks in the IC system.. can't figure out what it is (turbo only has 3k miles on it) final question what causes a clunking noise every time i go over bumps and curbs?
View 4 Replies
What is causing this noise. When the rear of my truck goes over bumps it makes a rattle/clunking noise but I can't find where it is coming from. Here is a video of the noise. [URL] .....
chevrolet - silverado 1500
View 11 Replies
There is a clunking noise coming from the rear of the car. Not a metal on metal sound. Sounds like its more on the passengers side. I replaced the swaybar linkage ends since they were a little loose and thought it was that. Nope...I have H&R coilovers, they are about 5 years old. Can't imagine they be shot this soon. Had someone drive my car while i was behind the R and the rear wheels aren't dancing at all, a common sign of a blown shock. Push down on the car, shocks still respond like they did from day one. I've put the car up on a lift, both sitting and wheels dangling. With the wheels dangling, I grabbed onto the shocks to see if there was any play in the upper shock mounts, solid. Looked under the whole car for loose plastic covers. Can not see anything loose. I made sure everything inside the hatch, including the battery is sitting snug.
The clunk happens over bumps, with or without the brakes on and is loud enough that if the radio is on, it can still be heard.
View 3 Replies
