Mazda - Mazda3 :: 2009 - Check Engine And Traction Control Lights On
Jan 24, 2011
I've got a 2009 Mazda3 hatchback, 31,000 miles. As I'm sure you know, it's very cold in the Northeast today. It was -12F on my drive in to work! I went out to lunch with a coworker today, and it had warmed up quite a bit to about 25F. As I was driving back to work - 40mph on a dry, straight stretch of road - my check engine light and traction control/stability control light came on. They aren't flashing, just steady. The traction control light will flash if I hit a particularly bad patch of slush, but it's never lit up on a dry road before.
Right after the light came on, the automatic transmission started feeling...funny. It was shifting hard, although downshifting felt okay. My coworker even noticed before I said anything. I don't think it was the traction control - it was specifically as the automatic transmission was shifting, not at any other time. I've read through the TSBs and didn't see anything relevant, and I've already made an appointment for tomorrow at the dealer. I've only got 5,000 miles left in my warranty so I'm a little nervous - the car has been terrific so far.
I would think the traction control light would be unrelated to the transmission, so I'm a little confused. Also, just to rule out a few other things - the last time I got gas was about a week ago and I still have a third of a tank. I don't think this is a gas cap problem or frozen gas, both of which I've experienced before (in other cars).
View 10 Replies
Advertisement
I have a 2009 Pontiac Vibe with 43,000 miles. Recently the check engine light, the vehicle stability control light and the traction control system light all came on simultaneously. Since then they have all come on or all gone off several times. Usually once they come on, they stay on for the remainder of the trip. Sometimes they will still be on when I next start the car, sometimes they will be off. What might be causing this?
View 17 Replies
I have 4 lights that came on simultaneously on my 2009 Pontiac Vibe. My check engine, AWD, Traction Control and my VSC Off is blinking. I had the codes read at Advance Auto and 2 codes came up and they are C1201 Engine control module performance and P0456 Evaporative emission system leak detected (very small leak).
View 6 Replies
I have multiple O2 codes on my '02 gti. It is giving me a check engine lights as well as the traction control light on. I received 6 codes all but one of them had to do with the O2 sensor and a short except for one that came in as the MAF. Both O2 sensors have been replaced and the codes still won't clear. I bought it in this condition, it runs really well so i wasn't to concerned about it, but the lights are starting to get annoying.
View 2 Replies
2010 camry. Check engine and traction control lights came on at 48K. Took to dealer for diagnostic scan. Came up w/ code p0037. Told me it was bank 1 position 1 oxygen sensor.....$455 to replace. I want to do it myself but am having trouble finding the part. Where exactly the location on vehicle this is? Will I run into trouble getting at this? Its a 2.5 L.
View 1 Replies
I have a11 isf with 38k on it. The other day the check engine and traction control light came on along with a weird Oder in the cabin. secondly I was short the quarts of oil.... I see no leaks.
View 2 Replies
Alright i have a 05 1.8t GLI I just installed a 42 draft designs full 3inch turboback, and a eurojet turbo inlet hose, after I put the stuff on my check engine light came on which I thought was gonna happen and is normal but my traction control light came on as well, the cars running better then ever and pulling harder then ever, but when i hooked it up to the computer I'm throwing 18 codes? Ive triple check to make sure everythings tight and in the right spot? What could be wrong?
View 5 Replies
My car just turned 85k miles. The day it turned 85k, I recieved a message from dealer saying their records indicate car is due for 85k service. Coincidence? Note: I do not have my service done at the local toyota shop. They have not seen car since last warranty work probably 2+ years ago.
Also at about this same time, the service engine light came on, (oil change needed). Since I only use mobil 1 in the car with genuine Toyota filters, I am not to concerned if the car gets another 500 miles on it while scheduling a service. However, this time, returning from a short trip on Sunday, the VSR (traction control) and the check engine light came on. Only Code is p0015 left bank. Monday, warning lights are gone, and oil change is scheduled for Wednesday.
Is the VSR and the P0015 related.
View 4 Replies
So yesterday at night i take the isf for a boot, everything is going great and then i rip it off the lights, as soon as i do the traction starts acting weird and so do the rpms for a few seconds, rights after that the light show started. Check vsc, abs off, traction control off, afs off. all came on at once. i didn't turn anything off.
View 6 Replies
My 2010 Subaru Outback recently surprised the hell out of me by simultaneously turning on the brake warning light, the traction control light, the check engine light and (just for a bonus!) disabled my cruise control while flashing the cruise control light. I pulled over, quickly surmising that all of those systems could not have failed at 70 MPH without instantaneous death to either me or the vehicle. Both apparently still being alive, I tried turning the car on an off to reset the lights. No go. Subaru was not going to miss this chance to get me to the dealership! (who I had avoided to this point!) As I was far away from home and the car being very healthy, it seemed, I decided to drive on. I proceeded to put a couple of hundred more miles on the car before I got back to town.
My car had 39,000 miles on it, 3,000 miles beyond the warranty end. I learned that I have an error code of P0171, "Fuel Trim Malfunction (Air/Fuel too lean)". So I guess I'm wondering about a few things...why would this sensor set off every light on my dashboard and disable my cruise control? Seems a bit overblown for running a bit lean. My gut tells me Subaru has a sensor/software problem they are not owning up to. I'm a big fan of conspiracy theories and this really smells like one...
Second, jeez, I'm only 3K miles over warranty, don't you think they'd cut me some slack. I mean I love my Subaru, or did anyway, until this happened. Now it's just another POS car that breaks for no apparent reason...
View 10 Replies
My check engine light keeps coming on sporadically and giving me a PO101 error code...then I'll reset it after making sure my MPG hasn't dipped a significant amount (which is my "concrete" way of gauging if it's performance is impaired) and it'll come on 1-600 miles later. There's no consistency in environment or conditions that are triggering this sensor, at least it's not obvious to me. I finally looked under the hood at the filter and it's a little dirty, but not nearly dark enough for it to be the problem.
View 4 Replies
Just purchased a 2009 Matrix XRS Manual transmission with 67,000 miles on it. I can't get the VSC Off and Traction lights on the panel to go out.
During our test drive, I had turned the system on and off to make sure it was working, and didn't seem to have any trouble with it.
I went to have it inspected yesterday. During the test, they hook up to the ODBII port to check emissions. The tech had trouble getting it connected the first time, saying the connection was going in and out. Eventually, they were able to get it connected properly and passed the inspection.
After they pulled the car out of the bay, the VSC Off and Traction lights were solid on, and they have been every time I've started the car since. Checking the manual, all I should have to do to turn the system back on is press the traction button, but that doesn't seem to be working at all. I also tried holding it down for 30 seconds or so with no luck.
The lights aren't flashing, so I don't think this is an error, I'm wondering if the computer got confused somehow with the ODBII port issues.
Stuff I've tried:
1. Followed these instructions for the Highlander Hybrid thinking maybe Toyotas will generally do this. That just caused most of the lights to flash on the panel and didn't bring up any VSC diagnostic messages.
2. I pulled the panel from the dash out to check to make sure the button was working, and I do get connectivity between the two outside pins while the button is pushed in.
how to get this to reset, or what the problem might be?
View 2 Replies
So a week ago i needed to change my mass air sensor due to every time it was raining it would almost stale and my check engine light was on. Now this week both my traction and engine lights are on always. When i start my car u. The morning it turns over but almost dies due to The rpms so low basically it's almost stalling if i give it gas usually it kicks it over then stays on no problem. ALSO if i reev high i hear a little grind or moan noise as well.
View 12 Replies
I have a 2010 camry and I am coming up on 15000 miles so i know im going to be due for another maintenance. accordingly, the "maintenance required" flasher started going off, so i thought it was all good and i should just take it to the dealership soon. well this morning when i started it up, it started flashing the "maintenance req" but once i backed out and put it in drive, the check engine light popped up as well as the traction control light (car with squiggly tire marks behind it).
View 4 Replies
2009 F-150 FX4 5.8 .... Had a couple days of 20's temps, started truck last night and I have the brakes symbol and ABS light staying on, with the message "Check brake system" and the traction control symbol alternating back and forth. On a 16 mile trip, they all went out just once, for about ten seconds when I restarted at the gas station. Then came back on. Brake job done within the last two years by previous owner at the dealership.
View 2 Replies
2009 Mazda 3 Since a nasty cold snap in Northeast, instrument panel has gone crazy. The meter showing RPM's works but 0 on the speedometer- dead. Gauges have been all on for a couple weeks. Just noticed now the power steering is gone. All lights seem to work normally and heat/defrost works. Radio works. Haven't noticed if odometer is working or not.
View 3 Replies
I was driving home and all of a sudden my rpms are at 3.5 4k rpm wont shift to next gear. I put in in tiptronic mode and shift it to 8 it works fine. Then about 10 minutes later check vsc shows on dash traction control light is on check engine light is on and the light next to the check engine i think it is the abs light. I havent pulled the code yet.
View 1 Replies
I need to troubleshoot a problem with the ABS & Traction control lights on a 2006 Mountaineer Premium with 126,000 miles. During the year that I have owned the vehicle this problem has occurred every time it is driven on a long trip. The previous owner never drove on longer trips so has no experience with this problem.
When you drive the vehicle around town and on shorter trips (less than an hour) there are no indications of problems. The ABS and Traction control lights come on as part of the start-up check cycle and go off. The ABS and Traction control work in low traction conditions and the lights function correctly when either one is activated.
The unusual behavior occurs on trips longer than an hour. Typically after about 1 1/2 hours at highway speed both the ABS and Traction control lights come on as well as the Wrench symbol in the message panel. It you hit "Reset" the Wrench symbol goes away but the ABS and Traction control lights stay on. The brakes work normally. I do not know if the ABS and Traction Control will work. I have never been in a low traction condition when the lights are on.
Both lights stay on until you stop the vehicle and turn off the ignition. When you restart the vehicle the ABS light is on but not the Traction Control light. When you start to drive the vehicle the ABS light goes out immediately.
After about 1/2 hour of driving both lights come on and the Wrench symbol displays in the message panel. Whenever you stop the vehicle and restart during the trip the cycle repeats. The day after you finish the long trip everything is normal for driving around town and on short trips.
View 3 Replies
One day my VSC, Traction and check engine lights came on. Nothing seems wrong with the car. Took it to a mechanic, they said many things popped up on their computer (emissions, etc, including replacing computer). The car has 48k on it, the warranty ran out at 39k.
View 15 Replies
I've struggled all day in my tiny inspection pit fitting the catback, un-resonated A'pexi system which looks and sounds fab. Problem is the engine light and trc off light are now on?
I don't know why given the cats are still there? Have I upset the lambda sensors somehow? How to clear it? Can the fault codes be cleared a certain way?
View 14 Replies
2014 es350 with a bit over 5000 miles, today suddenly my malfunction indicator lamp and TRAC OFF lights both came on at once... What the causes may be since I can't get to the dealer until Monday. And is it still safe to drive the car???
View 11 Replies
