Mazda - Mazda3 :: 2005 Making Clicking Noise
Apr 28, 2013
I have a mazda 3 and i just tried to start it but its just making a clicking noise. The radio works so does that rule battery out....
View 4 Replies
Apr 28, 2013
Advertisement
Mazda - Mazda3 :: 2008 - Fan Clicking Noise When Driving
Yesterday I just started noticing a clicking from my 2008 Mazda 3 sedan's fan. When the blower is set to "1" it is very quiet and inaudible when on the highway. As the fan speed increased from 1 to 4 the volume and rate of clicking increases. There is no difference with A/C compressor on or off or set to warm or cold. Is it the blower motor? Could pebbles be stuck in the fan? My repair expertise is almost non-existent (I changed the lightbulbs!) but I want to learn to do more with my car.
View 1 RepliesMazda - Mazda3 :: 2006 - Making Loud Creaking Sounds While Turning And Over Bumps
About a month ago my 2006 Mazda3 (35,000 mi) started making loud creaking sounds everytime I turned and went over a bump. I took it into two mechanic shops and they both said the struts in the front were leaking fluid and needed to be replaced, in addition to the mounts and the swaybar link. I had all of this done, but when I got my car back it was making a new, very loud, clunking sound that I could also feel on one side when I drove over bumps. The sound was similar to the noise your car makes when the undercarriage hits the ground over a bump. I immediately took it back in, and the mechanic told me that the set of struts he had installed were "bad" and that he would put in new ones. This was done this weekend, but now my car is making the original creaking and groaning sound it did before, except much more audibly now. My car groans and creaks even if I turn the wheel while motionless.
I've heard that cars need time to "settle" into new struts. Does my car just need time to adjust?
Mazda - Mazda3 :: 2005 - Sometimes Will Not Start
I have a 2005 Mazda3 with a 2.0 engine & a five speed transmission and 94,000 miles. Since June the car has twice not started, and so far three trips to two different Mazda dealers have not resolved the problem. The car had sat overnight, when I tried to start it the engine it turned over normally, and sounded normal, for just a second. Then it sounded like it started turning over much much faster than normal and the turning over sound changed to the sound of a high speed "whirl" (I don't know any other way to describe it).
In both cases the car just turned over and over and never sounded like it was going to start, resulting in a tow being needed. I've now found out that the dealer started the car by pushing the gas pedal to the floor, then cranking over the engine and then very slowly releasing the gas pedal until the engine started to fire. In the three months in between the non start days the car has started fine and it drives fine, lots of power, constant power with no surges or bogging down. The dealers have checked the compression, fuel PSI, and run computer diagnostics and everything appears to be normal. They also removed the value cover and say that as far as they can tell the fuel injectors seem to be functioning normally.
Mazda - Mazda3 :: Slight Clicking Sound Every While Coming Out Of Left Turns - CV Joint Failing?
My wife's 2007 Mazda3 is making a very slight clicking sound every while coming out of left turns. It's somewhat intermittent, only happening every few turns. I did a quick visual inspection and noticed that there was grease around the CV boot. The problem started about five days ago (or at least the noise started appearing five days ago). Three weeks ago I had the struts replaced, so I'm wondering if they could have torn the boot while replacing the struts, or if they didn't notice the issue.
Is the CV joint shot, considering this is only an intermittent sound, or is there something else that could be happening? Also, what is a typical repair cost for a CV joint (or half axle replacement) on a 2007 Mazda3?
Mazda - Mazda3 :: 2005 - Brakes Fading Halfway?
I have a 2005 Mazda 3, with ABS. Recently, the brakes on this car began to fade about halfway through the pedal travel, then firm up. This is while driving, (ie, with the engine running). When the engine is off, the pedal pumps up high and firm. I bled the brakes, eliminated the possibility of any hydraulic problem such as a leak, no change. I then reasoned that since the problem only appeared when vacuum was applied to the power assist, that must be the culprit. Replaced the power assist, problem remains. Next suspect is the master cylinder, but, as I said, with the engine off, the pedal is fine. Usually cars make sense to me, but this has me questioning my instincts.
View 9 RepliesMazda - Mazda3 :: 2005 - Gear Selector Won't Click Into Position
The gear selector on my 2005 Mazda 3 with automatic transmission is difficult to move between P, R, N, and D positions. It does not "click" or fall into position like it used to. It has gradually gotten worse. When the car is in Park, it seems to not want to go all the way up into the Park slot. Even though the car actually parked, the P will not light up on the dashboard, which sometimes causes the car not to start when the key is turned. So sometimes I have to put it in Neutral to start.
Now the problem is that when it is in Drive, it will "fall out of gear". I put that in quotes because it is still in drive, but it was shift up to a higher gear if i don't physically pull the gear selector knob back. For example, if i'm driving and the car is in 4th gear going 60mph, and the shifter know slides up an eight of an inch, the D light will go off and the car will move into a higher gear (not sure which one, feels like 2nd or 3rd) and the engine will rev up. It doesn't feel like neutral.
Is there anything I can do myself? I plan on trading in the car in the next couple months, but I'd prefer to not have to get it worked on until then.
Mazda - Mazda3 :: 2005 - Vibrates Intermittently - Change The Mount?
This past weekend, however, I took it out on the highway and found it has a pretty bad vibration. The vibration is coming from the body, not the steering wheel, so i initially suspected the real wheel balance. Next I varied my speed betwn 50-75 mph expecting to feel the vibration intensity vary, but it did not. While doing that however I realized that when I let off the throttle, the vibration stops. Given it some gas and it comes right back.
I got off the highway and pulled in to a parking lot. Driving at parking lot speeds, accelerating or not, there is no vibration. Come to a stop either in gear or neutral, and the engine is rock solid steady. Then got back on the local streets and the vibration returned but only while accelerating, even gently.
At this point I should mention that we replace a bad motor mount a yr and a half ago when we bought the car, the upper passenger side. The mount damage was easily so it was an easy diagnose. Replacing it eliminated the vibration the car had at the time. We had also planned to replace the lower rear mount at the same time but the one we bought was defective, and the one we removed from the car looked fine, so we put it back in.
So now I am wondering if the rear mount has failed, but it is not possible to see the rubber unless you removed it. Could it be an issue with the engine itself, or do all these symptoms point to the mount?
Mazda - Mazda3 :: 2005 - Winding Sound At Highway Speed
For the last few weeks my car has been making a winding sound at highway speeds. It sounds as if it is winding out at high rpms but it isn't. When I let off the gas, the sound doesn't decrease until the car begins to slow significantly. It also seems not to make the sound if I am going around a right hand curve. The car is a 2005 5-speed mazda 3.
What the problem might be? And is it safe to drive 600 miles back home before having it checked out. With the holiday, I don't have many options.
Mazda - Mazda3 :: 2005 - Take Longer To Reach Normal Operating Temperature - CEL?
Our 2005 Mazda 3 appears to have a problem with the thermostat. My mechanic read a check engine light code connected with a thermostat problem. My wife has noticed that the car seems to take longer to reach normal operating temperature than it used to (close to 15 minutes of driving). Other than probably diminishing the gas mileage and having to wait longer for nice heat is there any down-side to this problem? Is it likely to get worse and fail altogether? The shop guesstimates it will cost around $150.00 to replace.
View 15 RepliesMazda - Mazda3 :: Loud Noise When AC Is On And Accelerating
I have a 2004 Mazda 3. I just had it inspected and cabin air filter replaced. Now, my car makes a loud noise when the a/c is on and I'm accelerating. The noise sounds like a fan is vibrating /something is blocking it or like a motor is rev-ing that shouldn't be. There definitely is something wrong that wasn't there before the filter/s replaced. I watched a Youtube video on it... a real pain to replace them, but it looked like the fithad to be pretty tight... Could the filters have been installed incorrectly or some part not put back together correctly?
View 2 RepliesMazda - Mazda3 :: 2008 - Noise While Shifting Between First And Second
I hear a noise- what I can best describe as a metallic plucking sound - like a low metallic chord being plucked- when my automatic transmission 2008 Mazda3 shifts from first to second gear. It only happens the first time. I don't hear it after the car ihas been driving and is warmed up. Any thoughts on what could be happening?
View 2 RepliesMazda - Mazda3 :: 2010 - Makes Noise When Stepped On Clutch Pedal
The noise sounds a little like a baby Road Runner, a soft little "meep" sound. I usually notice it after the car has warmed up, when I come and go from a stop sign. In lieu of strapping somebody to the hood with duct tape, I've been trying to think of a tunnel that I could drive through fairly slowly with the window down while I attempt to replicate the sound.
View 3 RepliesMalibu :: 2005 - Constantly Making Turn Signal Clicking Noise
My 05 Malibu classic is making the turn signal clicking noise constantly which then causes the warning chime to start going off. I have replaced the turn signal assembly three times and each time it fixes it for a short time then it starts again.
View 4 RepliesHonda - Odyssey :: 2005 - Engine Making A Freaky Clicking Noise
This is hard to believe but...the engine was making a freaky clicking noise. It started to getting a little louder and then the car suddenly lost acceleration on us. We took it in and the mechanic said that a spark plug broke off inside the cylinder and chewed things up badly. The threads in the block are bored out also. He states he can "band aid" it with some kit, but then recommends selling in and buying new. My question - Should I go that route or is engine replacement a better option? 90K miles, 6 years old. Not sure what engine replacement would cost...
View 12 RepliesMazda - Mazda3 :: 2008 Engine Noise At 1400 - 1700 RPMs When In Gear
I have a 2008 Mazda3. The car has a replaced engine with 24,000 miles on it. The engine was put in before I bought the car.The car and engine run like a top; except at certain RPMs and when in gear. When I have the car in any gear (auto), the engine makes a rougher noise at RPMs 1400-1700. As I apply more gas, the RPMs seem to get stuck at 1700, then it will break through and run smooth 2000+ RPMs. The engine sounds perfect at all RPMs except 1400-1700 when in gear. When I have it in park and rev the engine, the engine sounds perfect at all RPMs.
View 8 RepliesMazda - Mazda3 :: Steering Wheel Vibrates A Lot
I have a 2006 Mazda3 with about 112K miles on it and what I have noticed recently is that the steering shakes a lot. I looked up online for a possible cause and have found that wheel balancing could be a reason. I got wheels balanced and aligned but still there is still some vibration in the steering, so what do you think could be the reason? I have got rotors machined once before, like a year ago.
View 10 RepliesMazda - Mazda3 :: Cutting Out While Driving / RPM Loss
My mazda 3i is cutting out while driving. I added fuel injector additive to gas and it still cuts out. Battery check is fine. What the issue can be. RPM loss
View 5 RepliesMazda - Mazda3 :: Heater Only Works Using Recirculation
I've noticed this winter that my Mazda 3's heater is barely working using fresh air. It definitely gives out warmer air than the outside temperature, but not by a whole lot. If I turn on air recirculation, then the air becomes appropriately warm. What would cause the heater to work one way and not the other?
View 3 RepliesMazda - Mazda3 :: How To Test If Clutch Is Going / Slipping
I own a mazda 3 6 speed and im curious as how to test my clutch for slippage. I read on a old forum that to put the e brake up and put the car in 1st gear and release the clutch. When i did that my car tried to move but after a couple seconds i put it back in neutral. Another forum said to do the same but put it in 3rd as i released the clutch it stalled right away.
View 5 RepliesMazda - Mazda3 :: Leaking Strut / Need To Be Replaced?
My mechanic told me today that one of my struts on my 2006 Mazda3 (with 110k miles) is leaking and that the strut needs to be replaced. Is this something that has an impact on safety, or is it something I can stretch for a while longer? Is the strut going to break if it is leaking? Also, wouldn't I have to replace both of them?
View 19 Replies