Mazda - B2300 :: 2003 - Sometimes Won't Start When Turn The Key All The Way
Jun 30, 2015
I have a 2003 Mazda B2300 pickup that sometimes won't start. When you turn the key all the way, it won't do anything, no sounds no nothing. However, if you try it a few more times it will eventually fire up and run normally. Last Friday, I must have tried to turn it on about a dozen times but nothing happened. So I tried the old hammer on the starter motor technique and it fired up immediately.
So I thought it must be the starter motor. But since then it's been turning on normally, except once when I turned the key and it did nothing. The battery is good, I replaced that about 8 months ago, and the battery cables look good. I'm hesitant to throw a new starter in. Could it be something cheaper, like a relay or some other electrical problem? Or could it be the starter and its on its way out?
View 8 Replies
Advertisement
My 2002 standard B2300/4cyl Ford Ranger sometimes idles very low on start up, and it will jerk as though it were coughing when i engage in 1st and give it a tiny bit of gas. the jerking stops if i give it proper gas. oh yeah and about the low idle, it's only after starting, not at stops, and once i give it a bit of gas it pops right back up to 1800ish and drops to 1200ish as it should. this happens less this summer but i'm afraid it will happen more often as the weather changes and i want to deal with this before winter hits. it feels like something is clogged.. but what do i know! My baby's got 119 000km and i bought it a year ago, no maintenance history.
View 4 Replies
Mazda B2300 2.3L 1995 model... About a week ago I ran my B2300 out of gas (or so I was convinced I was out of gas) because the engine quit running. After adding gas was unable to start it back up. It turns over but doesn't start.
Here's what we did to try and fix it:
1.) Replaced Fuel Filter
2.) Check the fuel pressure, and it was at 35 psi when the key was on
3.) Replaced all 8 spark plugs (4 cylinder truck btw)
4.) Checked spark of all 8 coil pack slots and 1st and 3rd slots (exhaust side) were not sparking. After replacing coil pack we received spark but truck still didn't start.
We're speculating on the possibility of it being the PCM (ECC).
View 2 Replies
I am working on a 96 Mazda b2300 auto 2wd for a friend. His son was driving it when a loud noise, it died and wouldn't start back up. He had it towed to my house, I started to tear into to it and found it slipped the timing belt. So a rebuilt head, gaskets, timing belt, fuel injectors, water pump, thermostat, plugs, and fluids; tried to start it and nothing. Started troubleshooting and found the primary coil pack was out of spec, replaced and still nothing.
Changed out the CKPS still nothing? I have spark, I have fuel, I'm going to check compression tomorrow but the way the cylinders and pistons looked I don't think that is the issue but I going to check anyway, rechecked the timing marks they all lined up. Checked the fuel inertia switch not tripped. Could the PCM, or ICM cause a no start, and still be able to get spark and fuel?
View 2 Replies
My son's mazda 6 will turn over but not start. the things I have done:
1. replace crank sensor
2. replace cam shaft sensors
3. it has spark
4. fuel pump works
5. sprayed starting fluid in still will not start.
What else should I check? Security system?
View 2 Replies
I have a 2004 mazda b2300 4cyl 5 speed that wants to stall on me sometimes when I engage the clutch and all most come to a complete stop. It does not happen every time i do this, but some of the time. I am able to instantly restart the truck and drive just fine. I am just confused at what might cause this. I did a tune up to it this weekend, and the cap from the clutch fluid did come off, I don't know if this would have anything to do with it. The truck runs great, just wants to stall some times.
View 19 Replies
I inherited a 1994 Mazda B2300 Pick Up 5 speed with just over 100K miles. Problem is the temp. gauge will just barely move off "C" at full tilt on a summer day. Confirmed the temp gauge was right. Replaced the thermostat and flushed out the system and heater core. Hoses are "warm". Cardboard over the radiator will push the temp. up to the middle after 20 minutes on freeway. Next checked the fan clutch. No dice. The fan spins free and can be stopped by hand. So, what else is "open" allowing too much coolant flow?
View 4 Replies
Replaced the front oil seal on a 1992 mazda B2200 an it starts leaking again after running for about 20 minutes? Is there any where else oil can come from near there?
View 2 Replies
I had my clutch replaced about a year ago in my 2003 mazda b2300 truck. Recently, it's been showing some of the same symptoms that popped up about a year ago. Such as, it's having a hard time going into first gear, and it seems to be generally clunky while switching the lower gears. The first clutch was replaced at 130k so I was alright with that. However, I find it hard to believe that I burned out this new one in a year. I do live in Boston, so traffic is pretty bad, but I try to not ride the clutch in traffic.
View 12 Replies
I have a 1995 Mazda Truck, B2300 series that is a 4 wheel drive. Recently I had the front brakes replaced, new clay disc brakes. Not so long after that I started to hear a noise as I was braking as well as squeaking. I thought, of course it had something to do with the new brakes. The sound happened occasionally at first and now is every time I brake.
I can hear it as I'm coming to a stop, sounding like it's coming from the rear. It's a rubbing type noise, like a wa, wa, wa, wa that happens until I have stopped. After 2 mechanics I now have a $700 estimate to replace the u-joint, and they aren't even sure if that will fix it.
The front brakes are new. The rear drums have been replaced and machined to fit properly (they thought that was the issue). Is this common or something that I have to fix every such and such miles?
View 1 Replies
Recently I took my 2003 Mazda Protege5 with 150k miles to a mechanic because It would not start after over heating. I had a new Radiator put in it and still didn't fix the problem. The mechanic told me I now need a new cylinder head gasket. That didn't fix the problem. So he told me I now need a new engine. The total would be around $3,000.00. Or he could just take the car from me and give me a digistream box for my Tv that would save me "hundreds of dollars" from a cable bill. (it streams live tv) I was so fed up- and on top of moving out of state I gave him the car in exchange. The box doesn't work for beans and I still have the title to my car. He told me he sold the car to a nice family and needs the title asap. I feel so ripped off. I had just put in a new Cat. converter which was 2k. plus it was just registered. It had new rims, tires, tinted windows and a blue tooth stereo. It was in great condition minus this "engine" part. How much do you think I should have gotten from this? Was it fair.
View 19 Replies
I have a 2003 Mazdaspeed Protege that is having a stalling problem. The motor has about 30k miles on the block with around 3k miles on the internal components (rods, pistons, cams, etc.). Cylinders were bored 20 over and head was machined.
This stalling, or almost stalling, problem occurs when I start the car after it's been warm for awhile. For example, if I were to drive for an hour, park it for 45 minutes, and then come back out to start it up. It'll fire up, drop to idle, and then the idle will dip, stalling 50% of the time. The rough idle lasts anywhere from 5 to 20 seconds, and then usually fixes itself.
Giving it some gas does nothing to alleviate the problem; sometimes making it worse. Cleaning the idle air control valve solved this for a few days, and then it was back to its old ways. These symptoms do not occur on cold starts or if I restart the car after 5 or 10 minutes of it sitting. We couldn't find any vacuum leaks and there are no codes being displayed.
View 4 Replies
This has happened 3 times now in the last couple of months. After driving on wet roads, our 2003 Mazda3 won't start. It won't even crank or turnover (primary vs. secondary ignition). All of the other electronics come on when you turn the key, but nothing from under the hood. After a while of presumably drying out... anywhere from 15 minutes to hours, it starts again. I'm thinking something is shorting, but what.
Mechanic can't figure it out... but he's only had it for a day, and it's been dry, and starting fine.
View 1 Replies
My 2002 F150 Screw has been giving me issues when trying to start it for the last month. Sometimes it will start sometimes it won't. When I turn the ignition on the gauges all seem normal, the theft light turns solid then goes out, but engine will turn over but not start. Sometimes it will start if I leave the ignition on for 20 seconds then pull the key and try again. (this doesn't always work). I have disconnected the battery for about 2 minutes this usually works but not always.
Sometimes it will start first time with no issues. Once the the engine fires it runs fine. Another symptom is when I shut the engine off, pull the key and open the door, the chime telling me that the key is still in the ignition sounds. (but the key is in my hand)
I put a new battery in yesterday to rule that out and because the old one seemed to be getting weak. (starting issues didn't go away). I don't want to put 300+ into a fuel pump without being sure that's the problem.
View 1 Replies
Why my key would not turn in the starter, although an hour previously and up to yesterday it has always worked just fine. Again, this morning, the key turned just fine. Is this a warning that I'm heading towards disaster?
View 10 Replies
I have an '87 Mazda B-2000 pickup. How to turn off the EGR light? I think it comes on at set intervals when it wants you to check the EGR system.
View 1 Replies
As the title states, I have a 2002 Mazda B3000 series Pickup and while everything is working great, the a/c is driving me insane!
Here's how it goes:
- Start the car, turn on the A/C, hear a click
- As I drive, after 10-20 minutes, the A/C would just either switch to (what I think is) vent; it blows humid, warm air.
- Another way to turn it off is to accelerate quickly; Note: these two scenarios are sometimes inconsistent
- Sometimes, it would occur, while other times it would just randomly turn itself off
- A solution I've found is to switch over to vent, leave it on there for a few minutes, then switch back to A/C; works for another 10-20 minutes
What I have done to fix it is to replace the freon (even though, it was never really empty; still isn't empty) and have replaced the fuse associated with the A/C.
View 2 Replies
I have a 2000 Mazda B4000 with 2 little problems I don't know anything about. First is when I go to start the truck it takes a long time to turn over. A friend of mine said that a valve is not maintaining fuel pressure so the fuel is not sitting ready for the starter when I go to start up. But if i engage the key for a few seconds and time it right it will turn over easily (apparently allowing the fuel pressure to build to the appropriate level). Is this a little valve or gasket or something I can replace to maintain the pressure?
Second, when I'm coming from a stop or accelerating out of a slow roll there is a 'shudder' or 'shiver' in the drivetrain that almost feels like the shift from 1st to 2nd is just kinda lumpy. It also happens if I come to an abrupt stop, so gearing down into 1st. It doesn't feel like something that is getting worse, but I don't want it to be causing damage or have my driveshaft snap or something.Other than that this truck seems really well maintained by the previous owner, and a mechanically inclined friend of mine said everything else looks.
View 2 Replies
My car is a 2003 Jetta GLS 1.8t. It has 223000 miles, yet other than normal maintenance it has never had any real issues since I have had it. However, maybe a week and a half ago when I got up to go to work the car wouldn't start. It would turn over, but would never actually start. When I got home from work later in the afternoon I tried again and it was fine. It's been doing this and progressively getting worse ever since.
If I go to start it in the morning, nothing. Wait until 10-11 or so and it'll run in one attempt. What's strange is that temperature does not seem to affect this issue. Some nights I will go out to drive after it has cooled down outside (70 degrees or so) and it will start no problem. Some mornings it's already 80 degrees and I still have no luck.
I have pulled the following DTCs, which keep reappearing after I clear them, making me believe this is an electrical issue:
P0261, P0267, P0270, P0264, (all 4 cylinder injector circuits low) P0445, P0037, P0418, P0010, and P0414.
So far I have replaced both the Secondary air injector relay and ECM relay, pulled and checked every fuse in the car, cleaned the battery terminals, and am about to go out and check every ground.
View 5 Replies
So the car has 160K+ miles on it and in the past week I jumped in it and tried to take off and the steering wheel was rock hard to turn, so I assumed the power steering fluid was low and filled it up with lucas stop leak and within an hour all the stop leak leaked out the bottom of the car. The leak is normally leaves a puddle around the passenger front tire but is actively leaking out of the middle bottom of the engine. Could this be a bad power steering pump? Is it gonna cost me an arm and a leg to fix?
View 7 Replies
2003 Sable, 70K miles, doesn't make a sound when we turn the key to start it, sometimes. When it does start it runs fine, has a new battery, and the starter looks good.
View 6 Replies
