Malibu - Chevrolet - Exhaustsystems - Classic :: 1983 Chevy Loses Power / Nearly Undrivable
Feb 26, 2011
I had an '83 Chevy Malibu Classic that slowly lost power until it was nearly undrivable. I rebuilt or replaced every fuel or spark related item I could think of. I finally had the catalytic converter and O-2 sensor replaced. It ran better, then the problem returned about 8,000 miles later. Disconnecting briefly the exhaust did not work. This suggested that I was sold a new converter for nothing, but the mechanic must have done something to get it to run better. The question is: what was the problem and what did the mechanic do to improve it? (hint: I had indications of coolant contamination in the valve covers, any connection?)
View 3 Replies
Advertisement
i have a 2005 chevy malibu classic. a few months ago it started sputtering when we would try to crank it and would take several tries before it would run, then it stopped. So far we have replaced the fuel filter, fuel pump, fuel pressure regulator, idle air control valve and crankshaft sensor, and it still wont stay running when you try to give it the gas, it dies....
View 4 Replies
I rebuilt my turbo 350 transmission. I drove it about two blocks and checked my fluids. Everything was fine. So I drove it down town....two or three miles and I lost all gears forward and reverse. I got a ride home and left the car for about three hours then I went back to get it. The transmission shifted fine as i drove it home. I have parked the car since i cant trust the trans not to break down. As I drove to town I noticed a slight vibration in the trans area.
View 7 Replies
My Chevy Malibu is having a bit of trouble.
When I drive on inclines my reservoir leaks. It did it way more when I lived up a hill, but since I've moved to a more flat area, I barely see it.
A more serious issue I am having is with my ignition/gear shift. When I try to turn the car off it will not go to the OFF position. If I wiggle the handle, it will then go off.
View 1 Replies
I have a 2007 Chevy Malibu with around 190000 miles on it. Recently, first thing in the morning then I start driving, that car will not shift into 2nd gear for a bit. The engine will rev up the 2000 RPM and stay there. After a while it will finally shift. The fact that the engine stays revved that high for that long makes me nervous.
View 9 Replies
I have a 2004 Malibu Maxx hatchback. It has been a solid car since we rolled it out of the showroom. Recently, I noticed when I raise the adjustable driver's seat after my petite wife has driven the car, the seat tilts to the right. After a survey of the power seat mechanics I found a broken front rail. It appears as if the end of the rail where it connects to the hinge is being peeled back as if I were removing the wraper of a crayon. I have only found one other post on the internet. Is this is a common problem?
View 14 Replies
The sound comes from under the dash. recently the blinkers stopped working all together so I tracked down the problem to the hazard light switch and replaced that and the blinkers are working now. However, the clicking sound remains and seems to happen more just after using the turn signal but the sound happens randomly as well.
I'm thinking it might be the turn signal assembly located on the steering column. So, I was thinking of replacing the unit (it has both signal lever and wiper/wash lever) .
View 1 Replies
Issue w/ my 04 Classic. At very slow speeds my car emits a groaning noise when turning hard left and also veers to the left at highway speeds. Tire pressure is ok. Didn't notice play in the ball joint or tie rod end when I checked.
View 3 Replies
I have a 1983 chevy k-10 with a 350 and a th-350 trans. Every now and then it will start violently shaking as I'm going down the road. Almost feels like it's trying to engage into 4WD. But if I pull over and stop it will quit and i can resume driving. It was like every couple of months and only when i hit a large bump but now it's becoming more and more frequent to where i can't drive it. I've replaced the u-joints on the drive shafts, the manual lockout hubs, wheel bearing etc. I had decided it had to be the transfer case but my gut keeps saying it's the ball joints even though they feel good when you check them. I want my truck back.
View 7 Replies
I have a 2004 Malibu Classic well maintained 2.2 L engine 20k miles. When the engine is warm in drive at idle, the engine shudders vibrates the dash and steering wheel. It idles smooth when cold. In drive it settles to a base idle about 575-600 RPM. When I raise the RPM with the peddle just a bit maybe 50 RPM it idles perfect. Otherwise the engine runs perfect, air cleaner and plugs are like new. Is there any way to adjust the idle up or identify what sensor controls the idle?
View 2 Replies
I have a 2003 Chevy Malibu, V6, 3.1, auto, 140k miles. Car started out with code 0420 with no noticeable symptoms, but then added code 0303 (miss fire cyl #3) with loud knock (mostly after warmup) and loss of power under load. Now internal loss of coolant (no puddles or external drips). Changed plugs and wires - no change - all plugs looked good with no sign of contamination. Questions - if this is a valve/piston/lifter problem (which would explain the knock, miss-fire and loss of power), why would I get the loss in coolant? If the loss of coolant is fouling plug #3 (which would explain the coolant loss, miss fire and loss of power), could that give me the loud knocking? I don't see how a valve/piston/lifter issue would cause a leak in coolant but I also don't see how a coolant leak into cyl #3 would give me such a loud knock. Do I have two different problems? If it is a leak into cyl #3, is there any way to tell if it is the intake manifold gasket (which leaked before and was replaced five-six years ago and which I could do again if I had to) or a blown head gasket (which I don't think I could fix or afford to get fixed)? Engine will occasionally get hot (but not overheat).
View 7 Replies
I have a 95 chevy silverado. 305 with an automatic transmission. I was driving down the street at about 30mph when the power went out on me.
The engine stayed on and all lights stayed on. I could rev the engine but the truck wouldn't move.
I then had a friend tow to my house and i let it sit overnight trying to decide what to do next.
The next day I went out and started it and it and was able to drive it again for a short distance at low speed and then it did the same thing again.
View 5 Replies
So my Malibu overheated for the first time, and note it just won't start up..
View 16 Replies
Long story: I have a 2005 Chevy Malibu base. About more than a month ago I was driving home from work my car stalled about 3 times. I was able to finally get home I checked the oil and to my shock there was none. I quickly put some in and my car started just fine didn't stall again. I drove it the next day nothing. Then the day after that I drove it to Walmart on the way back it stalled like 7 times and after that last time it wouldn't turn on. I got it towed to a shop where my car remained for over a month. The crank position sensor was replaced, the battery, and the ignition switch. I was told it was fixed, picked it up drove it to a town 30 minutes away it was fine, then drove it back it started stalling every 5 minutes.
Managed to take it back to the shop, they couldn't figure out why it was shutting off so they got a second opinion at a Chevy dealership nearby and they replaced the ignition control module. I picked up my car drove it around for awhile and the check engine light came on I was near pepboys they checked the code which said I needed to get the catalytic converter check/replaced. So I drove my car home. Next day drove it all day it stayed on, thought my problem was solved. Then that evening turned it on and within a few minutes the engine shut off and now it won't start at all. The mechanics that I took it to obviously don't know what the issue is nor do the mechanics at Chevy. It is not the fuel pump that's one things that can be crossed out. Or is my car done and should be junked?
View 8 Replies
I have a 2002 Chevy Malibu. The passenger rear power window wont go up or down. Other windows are fine. I push the buttons from the rear door and the main control from the drivers door and nothing happens. I don't hear the window motor or anything going on while I push those buttons. I opened up the door panel and window regulator and motor seem fine. Connectors seem fine also.
View 4 Replies
My wife drives a 2004 Chevy Malibu and for the past year has had issues with the power steering periodically going out while driving. It has primarily happened when making turns at lower speeds <45 MPH and a dashboard warning will flash power steering when it happens. The temporary fix has been to pull over, turn the car off and back on and it corrects itself, but when taken to mechanic nothing registers as wrong. Was not as serious of an issue when it happened at low speeds, but the other day it happened at freeway speed. Nobody seems to have a solution, including Chevrolet.
View 3 Replies
2005 Malibu Maxx, automatic transmission, well maintained mechanically. About a year ago, while driving up a small hill, my display panel starting dinging and all of the lights came on and my steering felt like it was losing power. After I got to the top of the hill, all the displays went off and bells stopped dinging. I've had the codes checked at the local dealership and the only thing found was that one of the battery cells was low. We replaced the battery about 3 months ago and that hasn't stopped the battery light and bell from coming on when driving up any incline. It still feels like I'm losing steering in these instances. I also tend to accelerate when going up a hill, so I don't know why that would be a problem. A recall has been issued for my car, but I'm not sure if it has any bearing on this problem.
View 9 Replies
I have a 2010 Chevy malibu LT with 120000 miles. And today while I was driving my engine disabled and there was a message of reduced engine power. After letting it sit I turned the key and nothing happens all the lights and things come on but the reduced engine power and engine disabled shows up. The car won't crank up. Earlier that day I had my engine coolant temperature sensor replaced. What is going on or what needs to be done? I am getting so frustrated with this car.
View 3 Replies
2003 Chevy Malibu 3.1 temperature gauge stopped working last night, this morning having trouble starting, no check engine light fans do turn on have heat, replaced the coolant temperature sensor but gauge still not working?
View 1 Replies
I have a 2011 Chevy Malibu, with a little over 100k miles on it. A couple weeks ago it started acting a little funny when I would shift into reverse after starting it after sitting for a while. I thought it might have been due to temperature as it didn't do it after the car had warmed up or when it was warmer out.
Yesterday it started acting up really bad, will not shift out of first gear, and will not shift into reverse, and the check engine light came on. I was able to get it up to O'Reilly's to get the codes. It came back with 2 separate codes.
P0700 - Transmission Control Module (TCM) Requested MIL IlluminationP0776 - Clutch Pressure Control (PC) Solenoid - Stuck Off
The guy there seemed to think that the second code was probably caused by the first one, and most likely the TCM needs replaced. It makes sense to me, but before I head down this path I want to get some input, as it is a little over $300 for the part.
View 10 Replies
Car Stats: 2005 Chevy Malibu, Automatic
Just recently while driving my car at a normal speed...(Like 55mph wanted to speed up gradually to 60mph) ..I will push the accelerator and my car wont go any faster. It will act like it is switching to passing gear and then the engine will rev up, the car will lurch forward and then it will finally take off. The RPM's also will increase and then suddenly drop back down to normal.
Also I think this is related to the problem. .... but... when I put the car in the low gear to where I can manually shift it to first second and third. It used to automatically be in the 1st gear... but now it will show up in the third gear and you cannot shift into any other gear.
View 9 Replies
