Kia - Sephia :: Stalling Out And Running Very Rough - Catalytic Converter Replacement?
Feb 23, 2014
I was told that my 1997 kia Sephia needed a new catalytic converter by a very reliable shop. My car had been stalling out and running very rough. They did replace the distributor cap which seems to have increase the overall performance and that same day i had a smog check and passed with flying colors! Why would I still need to replace my converter if I passed smog. My car has only 36k on it.
View 19 Replies
Advertisement
My husband,who is an engineer and has done all of our car maintenance for decades is stumped by our 2000 Mazda MPV. He replaced the catalytic converter and put every thing back together, but the car won't run. Will start, but dies right away. Took off new cat,and runs with that off, but not sure why it won't run with the cat on.
View 4 Replies
94 Ford Ranger 2.3L
I started to have a slightly rough idle a while back, but not severe. I figured she was just aging a bit.
Changed plugs. Check engine light came on. Changed plug wires. Then I had a couple of episodes where it started to lose power and idle really rough (stalling). Both times it stopped after a few minutes. Had code read- they said it was coils. Replaced ignition coils. Check engine light still on, but it went a few weeks without power loss.
Tonight the loss of power returned and didn't leave, and I had a glowing red catalytic converter after I limped home 20 miles (hope I didn't do any serious damage, I was stranded.)
Found this post : [URL] .... But there's no resolution.
So, I'm probably dealing with a misfire, and I'm sure I torched my cat after tonight. So any other easy diagnose/fixes for a misfire? I'm a shade tree mechanic- so I know just enough to get myself in trouble. If I can't get a resolution soon it will be off to the mechanic (which, maybe I should have done 1st...)
View 2 Replies
Car is a 2001 MK4 Jetta with 2.0 Auto Tranny and 120k miles, stock exhaust
A little over a year ago I was getting a cel and the code that was being thrown was a DTC 16804. I changed the cat and both o2 sensors and the light went away for almost a year. The other day I was driving and the light came on again. Scanned the car and its the same 16804 code. I replaced the front o2 sensor thinking it was bank 1 but it didn't solve the problem. I clear the code and it comes back the next day. I'm finding it hard to believe that the cat is bad after only a year. I checked for vacuum leaks, faulty MAF and nothing under the hood looks out of whack. My mission is up next month and the car won't pass with this code.
View 5 Replies
My wife's car is a 2002 Prius, 149 k miles. Lately the check engine light has been coming on. I took it to the dealership, and their assessment is that the catalytic converter needs to be replaced. They are recommending about $2,000 + of repairs. While I am contemplating the practicality of investing that much in keeping this car going I'm wondering if it harmful or dangerous to continue operating this vehicle.
View 12 Replies
After hearing some loud noise coming from my exhaust system, it was determined that there is a hole (from rust) in part of the cat. assembly. Three shops advised for replacement, there are no aftermarket products for this unit. I have NOT gotten any error codes, the only problem is the noise. What to do? The car is 10 years old with 86000 miles. I have been reading about some of you getting just the one piece and having it welded on, but I do not believe any of the shops here will do that, and indicated that it would be a very temporary fix.
View 17 Replies
Yesterday my 1995 Toyota Corolla (which runs well otherwise) started making the loudest rumbling exhaust sound I've ever heard whenever I stepped on the gas pedal. It also felt like it had trouble accelerating when I would try to get going after a stop. I took it to a mechanic right away, who says it needs a new catalytic converter and resonator pipe.
My boyfriend says this is a repair he could do. He has done some car repair and worked with a mechanic before, so I am considering trusting him on that, but I don't know what types of repairs he's done before and I know he has never worked on this model. What would you take into consideration whether or not it would be safe to attempt this repair at home?
View 19 Replies
My Kia just started stalling when I turn on the heater or air....?
View 1 Replies
I have a 2001 Kia Sephia that quit running as I was driving down the road. The car has a little over 150,000 miles on it and was running fine prior to the incident. The car was responding fine and then suddenly acted as if it lost power and shut down as I was driving. I put a code scanner on the car and retrieved the following codes: 342, 460, and 713, which I understand are the camshaft sensor circuit low input, fuel level circuit malfunction, and transmission temperature circuit high input. Is this a computer that has failed or just all the sensors at once failing? If it is the computer, which one(s)? I was trying to do research and if I saw right, there are more than one ecm's now on cars.
View 13 Replies
I have been beatingy head against the wall for the last month with this car. It started out by just running really rough and stalling out. Found out that I had a bad clamp on the air intake that attaches to the throttle body. Replace that after I already replaced the MAF. Everything was great till couple days later then the car just crank crank crank no fire....
I cleaned the grounds pulled the plugs and coils, had perfect spark. Put everything back come to find out after going thru my Bentley manuals I jumped around the fuel pump relay fuel pump kicked on perfect started great! Replaced the fuel pump relay BAM! Ran great!!!! For 2 days..... After that right when I pulled into the drive way the car would not start.... So I tried everything again.... To no avail..... Check the codes again, now I'm throwing these codes which yes I did cross reference in my Bentley manual.
P1117- O2 sensor heater circuit bank 1 sensor 2 short to ground
P1198- O2 sensor heater circuit bank 1 sensor 2 electrical malfunction
P1472- EVAP emission control LDP circuit short to ground
P1516- Intake manifold changeover valve circuit open
And the dreaded same code I've had the whole time........
P0102- Mass or volume air flow circuit low input.
I have also tried tracking down any bad wires, and testing resistance...
View 3 Replies
I recently had my catalytic converter replaced with a non-OEM cat. The check engine light came on and a different shop (different from the shop that replaced the cat) said that it will keep coming on because I had the cat replaced with a non-OEM cat.
View 3 Replies
I have a 2001 VT GTI with 155K miles on it. It is in very good condition. I have loved the car except for the high maintenance costs that typically seem to be associated with VWs.
I found out this week after my check engine light came on that the car needs a new catalytic converter and a new new secondary air pump.
Let's assume that this diagnosis is correct and the repair is accurate for the sake of this posting (and I have no doubt it is). In other words, I don't want to get my question derailed on that issue.
The car has new Michelin tires on it and runs well. The problem is that it will fail the state emissions test I am required to take next December, and I will either be forced to have the car repaired or will not be able to get updated license tabs (isn't that sweet?!).
It seems that I have a few options:
1. Get the repair done (ouch) and keep driving the car for a few more years. Repair cost is about what the market value of the car is (from what I have seen).
2. Sell the car "as-is" between now and December and see what cash I can get out of it. Any buyer will discount the value of the vehicle based on the repairs needed. Of course, then I'll need a replacement vehicle of some sort.
View 16 Replies
See related guides and technical advice from our community experts:
How to Replace a Catalytic Converter
Step by step instructions for do-it-yourself repairs
Browse all: Air Intake and Exhaust Guides
View 9 Replies
1996 / 2.2 L4 / 186k / Upper engine rebuild 30k ago
Car was driven on a errand by my mother. Upon trying to leave for home, the car started running very rough, and stalling. From the description she gave on the phone, it sounded like a plugged up exhaust. I told her to get some fresh gas and ease it home after.
When I checked the car for codes, I got 2. A P0300 and a P0122. Okay, so the throttle position switch has taken a dump, that's easy enough. The car has 186k miles, but my constant nannying usually soothes her, so surely that's all, right? God, I wish that turned out to be true.
I pulled the plugs, and #4 was gas fouled and sooty, #2 and #3 looked lean, and #1 was partially wet fouled. There was also gasoline in the oil. When the car would run, it would run the gambit from idling semi rough then stalling out and refusing to restart, almost like it was flooded, to idling scarily bad and no pedal response, to running too high of an idle and idle searching.
Since I have:
Replaced the TPS
Replaced the IAC
Replaced the CTS
Replaced the MAP
Replaced the ICM
Replaced the FPR
Replaced both ignition coils
Replaced plugs and wires
Replaced the fuel injectors
Replaced the PCV
Replaced the fuel filter
Checked the pintle on the EGR (looked good, cleaned)
Checked for Vacuum leaks (as best I could)
Checked the Fuel pressure (40 PSI) (drops to 20 after shutoff)
Checked for exhaust restriction (ran open exhaust manifold)
That brings us to today. New injectors just in, and the engine will run, but rough and loud. It almost sounds like the firing order is off slightly (I am using 1342 or from L to R 4132) and throttle control is almost non existent. It also shuts off when its warm almost like its flooded. No codes are showing. (despite discovering a sensor in back being unplugged and the O2 sensor being unplugged at times).
View 19 Replies
I have a 2010 Equinox with about 52000 miles on it. At about 48,000 I took it in for the 50G maintenance. The car ran with a fluttery sound that I did not really notice until it was brought to my attention. Recently the car began running rough and stalling when idling. there were no warning or indicator lights lit. I had OnStar run a remote diagnostic and they said there were no codes. The day after the diagnostic the check engine light went on , while at the same tie the rough idle and stalling went away.
I brought the car in for service at the dealer. They said that the car had several codes indicating low oil and the car was down 2 quarts but there was no leak. They also said the noise I heard was the timing belt. The noise is gone after the service and the car is running smoothly. Coincidentally, or not, I got a notice from GM saying they were changing the oil monitoring software on the 2010 Equinox to recommend me frequent oil changes.
1) What could cause the car to loose 2 quarts of oil over less than 6000 mile? Is this normal or an Equinox problem.
2) Would low oil cause the timing belt to make a noise.
3) Do I have a lemon and am I being ripped off y the dealer?
View 19 Replies
I have a 2000 Lincoln Town Car with a single exhaust system, part of/attached to the frontal area of the exhaust "Y" pipe are two lumps with heat shields, the muffler is obvious in the mid-section of the car, but are those "lumps" the catalytic converters, and if so, why two when the older cars had only one?
View 2 Replies
Someone put sugar in my gas tank so I had it worked on at the Dodge place they replaced my fuel pump..fuel filter cleaned the tank..flushed the lines cleaned my injectors and replaced the plugs..I went to pick it up I barely made it a mile down the road I had no power and a lady flagged me down to tell me to pull over because I had sparks coming from the bottom of my van I looked under the van and the catalytic converter was red like hit coals the Dodge place is telling me its my flex plate? I think they are misdiagnosing the issue because before the sugar issue I had no problems with my van?
View 14 Replies
I have a 2002 Toyota Prius that is currently in limp mode...
Took it to the dealer for diagnostics and they said the Catalytic Converter has failed...So I went online, bought a new one and replaced it. The symptoms prior the Cat replacement were still there...mpg loss, power loss, and exhaust air was not exiting the end of the pipe but actually leaking out the connection point where the Cat and the manifold met.
View 7 Replies
So this morning (Kind of Cold) I went out site and started my car. I heard some noise under the car and I noticed that the noise bad been coming from the Catalytic Converter area and there was water dripping off of it.
My guess is that it was just warming up and the water was from the cold. Is it normal?
I have a GLX V6 ...
View 2 Replies
I own a 2004 Acura RSX that I purchased new nearly 10 years ago. The car currently has 182,000 miles on it. Two years ago (approx. 130,000 miles), I had to replace the catalytic converter and both O2 sensors. This lightened my wallet to the tune of $1,200 (aftermarket franchise, OEM replacement). A few weeks ago, the "check engine" light came on. I used my scanner, and got the dreaded P0420 code, and had it verified by another shop. O2 sensors were OK. What REALLY shocked me was that replacement catalytic converters are only warranted for 5 years/25,000 miles (50k in CA). The first replacement piece lasted 52,000 miles (less than half the miles/years of the original part)
Here are THE QUESTIONS: What killed this catalytic converter? What can I do to prolong the life of this part? My car has the base powertrain that (according to the owner's manual) recommends 87 octane fuel. That's all I've ever used. The mechanic suggested moving up to mid-grade fuel, though he admitted that he wasn't sure.
View 19 Replies
I have a 2000 Chevy Camaro. Two years ago my catalytic converter went out and I had it replaced. 20,000 miles later my mechanic says that I need to replace it again. Is this accurate? I thought the life of a Catalytic Converter was much longer.
View 2 Replies
