93000 miles 5 speed manual transmission only lets me use 2,3 and reverse gear. I took good care of that car and dont think transmission should go out that soon/
View 7 RepliesWhy does my engine rpms surge from 1k to almost 3k when i put it in neutral or push my clutch in ?
It's an 07 2.5 jetta with manual tranny...
My car is a 2003 Volkswagen Jetta GLI, I was on my way somewhere when slowing down i put my car in neutral and began braking. Going faster than i thought i shifted into first gear at about 40mph. At that moment i felt rattling in both the gear stick and the clutch pedal, i tried to shift again in case it was just a hiccup and my gear stick was stuck in neutral, i couldn't switch into any gears.Now when my car is off is the only time i can move the gear stick into the gear slots. And i also lost a lot of pressure in the clutch pedal but it does not stick to the floor it returns to normal position after a moment or so.
View 6 RepliesLong time listener first time poster. My wife has a 2009 Vw jetta 2.5 with a manual transmission that is very hard to shift. It has 80,000 on it and has had the clutch replaced once. She told me that she never had any problems shifting until she let it sit for two weeks while she went to cape cod. I have driven it myself and can confirm that there is an issue. Sometimes it just will not go into gear. No grinding noise at all and very very stiff when moving the stick shift laterally from first to fifth. Not actually shifting from 1-5 just moving the stick across the range it feels like cement. I have already changed the transmission fluid and used the Vw oem oil. I also removed the shift boot and lubed all the moving parts with a high quality grease. Tomorrow I am going to bleed the clutch slave and have a good look at the shift linkage. Is their something I am missing?
View 5 RepliesI went on vacation for a week and left my car at my parents house. I came back and now it has become extremely difficult to shift between gears. It's nearly impossible to get the car into reverse, extremely difficult to get it into first, makes a thud when pulling it out of first, is semi difficult to get into 2nd, but only a mild nuisance to get into 3rd through 6th.
For more information, the car is a 2012 Volkswagen GLI with just shy of 40,000 miles. The car ran just fine before I went on vacation and the car was not moved while I was on vacation. I did notice that a little ticking kind of sound when I had the car in neutral with no clutch. So the throw out bearing was starting to wear, but it was a very slight. But I haven't had any other problems.
I have an 04 Jetta 1.8T that I recently acquired and have a problem with a noisy manual tranny. Reverse is a bit noisy (more than usual) and when I get on it in 1st and 2nd gear it sounds like an awful whining noise. I have been told it could be either a bad throw out bearing or input bearing? BTW this thing shift perfect, like butter, no grinding at all.
View 4 Replies2004 Jetta 1.8T w/5 speed manual transmission. Bought the car this way, mostly for a parts car, but everything else runs and drives good, so if it wasn't for this issue it would be a decent driver.
Won't/can't select first gear. Seems like there is no "spot" for first, or that the shift mechanism has no where to go., locked out. All the rest of the gear selections work perfectly. Tried the cable adjust ritual, but it was fine-as I suspected. The shift assembly works/moves perfectly from the tranny end and the shift lever end. Not a synchro, it won't go in stopped, moving, running or shut off.
So, what's the probable best guess or best way to come to a diagnosis? Shift tower parts broken somewhere, or something like a shifting fork bent broken? Seems like if it was internal there would be other gear selections that would be affected. Any links to some diagrams?
I just picked up another GTi and knew the transmission was iffy when I bought it. I had to deal with the serpentine belt tensioner which is now new and also a new waterpump since it was wobbling.
I've already drained and replaced whatever oil was in there with VW G60 Gear Oil which is what my Dealer here told me to put in and it shifts smoother now but still has the same issue. I also did the Shifter Cable adjustment to see if that was the problem but that only made it easier to shift but it still got stuck.
Basically what happens is when driving I shift into 3rd gear and when I go to shift out of 3rd it comes out of gear but it's like it hits a brick wall and will not go into the home position. I was hoping the adjustment and new oil would work but it hasn't done anything.
I have a 2000 VW beetle with a fairly new clutch (2 yrs old). My boyfriend is new to a manual transmission and I can't say I know much about how it works either. A few times when he was driving he will reverse out of a parking spot and then shift to first and the car will make a deep rumbling noise. We turn off the car and turn it back on and its fine. Is the car stuck between gears? Why does it make this noise?
View 4 Replies97 Saturn SL with a 5 speed manual transmission only has 1st and reverse. Can usually not even put the clutch in and it runs in 1st gear without stalling like a 1 gear automatic transmission. Weird
The Shifter moves normally but there is no 2 thru 5. Can put it in reverse. Drove it 3 miles to my home.
Anyway this is clutch related or some relatively cheap adjustment? The car is not worth the price of a new Xmission. Other alternative like replacing with an automatic xmission?
When you sit in the car and put it in reverse it wont go in.
If you stick your hand in the engine compartment, push down on the golf club looking linkage and shift it into reverse it goes right in and you are able to back up the car.
So my question is which linkage may need fixing or replacing or adjustment. The shifter linkage in the car? the linkage on the golf club thing or any parts in between.
My Mk4 Tdi Golf has a couple of times lost reverse gear. It has the 5 speed manual box, and I found that the gear change mechanism on top of gearbox seemed to have a plastic channel to keep a vertical shaft inside a round housing.
I'm finding it difficult to describe, but I have managed twice to push it back down after quite a struggle, and reverse gear change worked for a while.
Yesterday while backing up, my Prius made a very weird noise that I have never heard it make before- it sounded like the "winding" noise a car with a manual transmission makes when its in reverse It was going wa-wa-wa and once I stopped the car, it stopped and hasn't done it again.
View 2 RepliesMy transmission has recently locked itself up in reverse. The shifter can easily shift through 1st-5th but if i attempt to drive forward it is still in reverse and works against each other. If shifter is left in neutral position it is still in reverse. If i push the clutch in the truck will move freely. I have taken the cover off of the tranny and all of the gears appear undamaged. It was dry however, and i replenished the trans fluid but it still is stuck in reverse. baffled.
View 2 RepliesI have a 2011 Jetta 5 spd, was driving today and suddenly I could not shift in 4th, 5th or reverse. This is the first time this as happen, I have never had any issues with the far. I don't know much about transmissions. The clutch seems to be working fine as I can shift with ease from 1st, 2nd, and 3rd.
View 3 RepliesWhy my vue manual tranny only goes in first third and fifth . Can't get it in second fourth or reverse . Bought it like that .
View 1 Replies1997 Saturn SL ... It's like 3rd gear is where 1st used to be and 4th is where 2 used to be. 5th and reverse work but are more towards the center. It's as if the stick shifted over to the left.
Is it possible for the shift stick and it's linkage to become displaced? The temp did drop today about 40 degrees and it snowed but the car stays in the garage and was only parked at my work for a couple hours after a 2 mile uneventful drive.
No warning lights that I can see but the check engine lite has never worked. The engine is a 96 rebuild but the transmission should be a 97 like the rest of the car.
Great mileage and otherwise drives fine.
My 14 year old Jetta, 119,000 mile will manually o into reverse ,but will not allow me to reverse the car? Could this be a clutch problem, or transmission. Is it worth repairing it, or purchasing, leasing car? Car also had new engine 3 years ago.
View 1 RepliesMy 1997 Saturn SL2 with 5 speed manual transmission won't shift into first or second gear. When I shift into the location where first would be the car is in third gear. It shifts into 4th, 5th and reverse just fine, though the shifter is in the wrong position for those gears. I can wiggle the shifter in neutral and get it to move into the position where 5th and reverse are normally found, but it is stiff and makes a clunking noise when I move the shifter over to the far right side.
I have removed the center console and the bushing appears to be intact. Both cables are in their proper positions inside the vehicle and at the engine. One of the cables (the top one in the engine) has some wear and tear on the boot, but does not appear to be binding. Other than the stiffness and the clunking noise, the shifter seems to be working fine too.
I am loosing gear oil through an odd place . There appears to have been a rubber boot or cover over this area that got cooked by a hot exhaust (whole other story there). This is left (passenger side) just above where the axle enters the gearbox. Not sure what this is and how I can resolve the issue. I have temporarily used silicone to stop the flow and have topped off the gear oil, but am still leaking a little. I have already done some damage to the bearings I fear, as the tranny really whines when I get up into 4th and 5th.
View 4 RepliesWhat RPMs do you see in 6th gear, say at 60mph or 80mph? Consumer Reports claims the RPM at 60mph is 3020!
So I went to vw.com to look at the gear ratios for a reality check. The site lists two final gear ratios for the manual. "Final I" is 3.94 and "Final II" is 3.09. When do you get one versus the other? With a final gear ration of 3.09, I get roughly 2400RPM at 60mph. But with a ratio of 3.94, I indeed get about 3000RPM at 60mph or 4100RPM at 80mph!!! That's absolutely insane.