Jetta - Volkswagen :: 2010 - Check Engine Light Came On?
Jan 19, 2012
I have a 2010 Jetta with the 2.5L 5-cylinder that recently threw on the check engine light for 2 days, then the light shut off. It began once I started the car on a coldish (~20F) morning after it had been sitting curbside for several days with the passenger side wheels sitting on about 6 inches of snow so the car was listing to the side. The car fired up immediately but ran extremely rough for about 10 seconds (the engine throbbed sharply about 2-3 times per second, which could be felt through the steering wheel & seat, accompanied by a muted clunk) before I turned it off.
During this time the CEL flashed on and off and then stayed on. I popped the hood, peered stupidly at the plastic engine cover, and restarted the car about a minute later and it ran normally, but the CEL stayed on. I drove it for two days (~50 miles) with the CEL on, but on the third day (today) the CEL did not turn on. The car has been running normally for all three days. What might have caused the rough idle/CEL and whether I can pretend it never happened since the car seems to be running normally for the third day in a row and the CEL has turned off on its own?
View 12 Replies
Advertisement
Whenever I fill up my VW bug it has trouble starting .... Starts fine in the morning or if just sitting BUT when I stop and put in new gas it has trouble starting AND then when it does finally start the check engine light comes on and the code says "misfire" which I am sure is a correct code since in fact it has such a hard time starting but why? Why only after filling up with gas ? And what can I do about it ????
View 6 Replies
I have 2001 Wolfsberg Edition 4D jetta (gas) with 180,000 miles, manual transmission. The engine light has been on for years and years. Usually what I do is take it in for an oil change just before a smog. They re-set the codes. I drive it to my office and back and the light would stay off and I could smog it. Until recently. In April, I took the car in for an oil change. And when I picked it up, it ran terribly. It was lurching like crazy. I had to keep slip the clutch to drive it until it warmed up and the it would mostly start running OK. I took it back to my mechanic and he thought it was a timing belt. I had already changed the timing belt at 119,000 miles.
It seemed odd to me that this procedure needed to be done again after 60,000 miles, but I went ahead and had it done. That did not fix the problem. Then the mechanic replaced the air mass meter. That didn't work. Then he replaced the coils. That didn't work. My mechanic has had the car for a month and can't seem to figure out what to do. He keeps getting different error codes - codes that don't seem to make sense to him. The car needs to a smog (my registration date is June), but he can't smog it because we can't get the check engine light to stay off long enough.
View 9 Replies
It's a 2010 vw jetta. Check engine light is blinking and the epc light is on the car is not paid off yet have no.
View 19 Replies
a 2011 jetta. brake pedal is hard no pumping action. The car show check engine. The idle is not smooth.
View 2 Replies
My engine is in trouble. A few weeks ago, my check engine light came on. The diagnostics revealed that my Mass Airflow Sensor was done for. I replaced it, and everything was working fine for a week. Then a couple of days ago, my Electronic Power Control (EPC) light came on. The car is really dragging. It have to gun it to make it go above 60 MPH. It's become scary to drive on highways. Are the two issues potentially connected?
View 1 Replies
I have a 2003 VW Jetta TDI and the check engine light has been staying on solid (not flashing) for a couple of months. I took it to my local dealer who tested the computer and said that it was the thermostat and a related sensor. That answer didn't seem to make sense, and unfortunately I didn?t get the code from the dealer at the time. I did though have the code read recently at another shop and it said: "Code P0674 which is #4 glow plug circuit - Q13 - electrical fault sporadic." What this means?
View 6 Replies
Last night I was driving in my 2003 jetta on the intersate at 65mph with the cruise control on. As I came into a turn I had to tap the brakes. As soon as I did the check engine light came on. The car was doing fine so I drove home from school. Today I drove the car to work which is a five minute drive, and back with no problem. I later went to grab lunch and bring it home and then I noticed the check engine light started flashing. I then felt the engine start to stutter, as if it was misfiring. We had the windshield defrost when we started to smell a rotten egg smell. Luckily we were pulling into our drive when we smelled the odor. I immediately turned off the car and got out. I couldn't smell the rotten egg smell, but I did smell burning plastic. I didn't see any smoke and could not pinpoint the cause of the smell.
View 4 Replies
VW Jetta SE 2.5L... Took my car to the dealer for a check engine light, the code came back P0106 which states I need my throttle valve cleaned and the dealer also said I need my brake vacuum pump replaced.. Do these go hand in hand? How should I proceed with the dealer? I have only 60,000 miles on my vehicle was there a recall on this issue? The dealer already updated the software in the technical bulletin.
View 2 Replies
Friday, May 13 I brought my car to the shop because the Check Engine light came on and the engine started loosing power. $540 later they had replaced both O2 sensors. A day later the light was back on. Brought the car back on Monday and they replaced one of the sensors that was defective according to them. One day later the light was back on. Brought the car back on Wednesday and they replaced the sensor again, telling me the brand was not compatible with my car. One day later night the light came back on. Brought the car back in Friday May 20 in the morning and they have my car since. They can't figure out whats wrong. A week before all that happed I had an oil leak and they replaced the oil filter and a seal. Could that be it?
View 2 Replies
Recently I bought an 01 Passat with a V6. Intermittently, when I go to start it, it cranks and cranks and doesn't catch. When this happens, the EPC and check engine light come on.
Other than that it is a fine car, I'm the second owner, and it was thoroughly maintained at VW dealerships and specialist. Recently there was a new oil pan and starter put in (w/in a month--previous owners).
View 3 Replies
We have a 2003 VW Passat 1.8, front wheel drive. The check engine light is on. The code is p0778. When we start the car the gears light display lights up in red for all gears . We put the car in reverse, back out the garage and when we stop, we get a bump. And we shift to drive the car moves slowly with some hesitation.
Sometimes after the car runs for 10 minutes, then turned of for a few second then started up again, the problem goes away. Before this problem started, we would start the car in the mornings, and put in "R" , and only the reverse gear would light up. (which is the way it is suppose to work).
View 3 Replies
2004 Golf, manual transmission. The yellow check engine light comes on when it's driven on the highway for more than 10 miles or so (60-70 mph).
The light goes off on it's own after about 36 hours of suburb driving - 1-2 miles at a time on suburb roads, lots of lights and not going over 40 mph.
1) Why the light is coming on? No other signs of trouble occur - oil looks good, temp stays fine, no smells, etc.
2) Why the light goes off after 4-6 miles/36hours?
View 4 Replies
I bought a certified pre-owned VW Jetta 2012 in August of 2013 that had 4,500k miles on it.. I currently have 60,000 miles on it. (I drive a ton)... but ever since I bought it my engine makes this jolting feeling when I slow down. it comes and goes and gets worse when I am due for an oil change. I have taken it to the dealer several times about this issue and they say that german engineering...I think differently. My engine light constantly comes on and my problem is still not fixed. What the issue is??? I am clueless about cars.
View 12 Replies
I drive a 2001 VW Jetta and have had many issues with this car but have had this particular issue many times. It starts when all of a sudden my car feels like it's going to stall when idling. When I go to drive it in this state the car has difficulty excelerating, bucking and sputtering (like the engine isn't getting enough fuel) and the engine light comes on. I have taken it to many shops and they usually replace an oxygen sensor saying that it is clogged etc. I have also had a couple of tune-ups because of it but after about a year the issue comes back and I shell out more money. I was told by one mechanic to use only super gasoline and that it should prevent it from happening again which I did and it held it off from happening again to about a year and a half but now it's back.
View 5 Replies
Car dumbie back again with another question.The diagnostic for my check engine light indicates numerous cold start misfire codes. The cylinders are OK. That was checked during the diagnostic.The fuel intake is carboned up. It is recommended that I clean the intake manifold. Does this mean cleaning the fuel injectors, the throttle body or both? 2006 Passat VW....
View 1 Replies
I know a few days ago all of my blinker lights were working properly since I had the car serviced at the dealer and they made me test all the lights before I dropped it off. But yesterday my "check the lights" yellow lightbulb indicator came on, so I thought, ok, probably one of lights burned out. But then, when I needed to turn left, I saw my blinker on the dashboard blink with twice the usual frequency, but the only turning light I could see from behind the wheel, on the left mirror was blinking normally.
So, I stopped, got out of the car and looked around to find that neither of my front or rear left blinkers were working at all. So, here come the questions. How likely is it for BOTH lights to burn out at exactly same time? If they did, would this cause the dashboard blinker to blink at twice the usual rate? And if so, why is the mirror blinker blinks at normal rate? By the way, the right blinker is not affected by this strange affliction. Continuing, what is the best way to find out if this is
(a) capacitor problem,
(b) burned-out light(s) or
(c)(worst possible case)problem with a very expensive control board.
View 2 Replies
So for the past few weeks my check engine light has been on. I have a mechanic friend that scanned the computer and says i have a running lean code.... says it could be anything. So i have been driving the car since and now the epc light and drive train lights are coming on... car revs up and down and sounds like is going to die... got the car scanned and says something about the throttle position sensor... before all the lights started coming on i got my fuel pump replaced..... could a faulty fuel pump be the cause? I had my mechanic, clean the throttle body and it ran good for a few days... now the problem is back... I have a 2004 1.8 gti. Do i have to replace the throttle position sensor? Fuel pump again? New throttle body again? I read somewhere on here that a guy replaced some wires near the ECM and the problem went away...
View 7 Replies
So I get back from being stationed in Korea for the past 2 years. I get my car out of storage and the check engine light is on. I scan it and get P0601. I do some searching on the Tex and see that it's the ecu. I'm tuned on APR. the question is can I take it to a local APR dealer here in Houston and get the ecu looked at?
View 6 Replies
I'm new to the VW world and just bought a 2002 Jetta 1.6SR about two weeks ago. I just realized that when I turn the ignition on before cranking, all the lights come up except the CEL and traction control light. There are no codes stored when we checked it with a scanner. I took apart the cluster today to check if someone had taped in front of the LED but there was nothing, and the LED was intact, it just won't light up! I put everything back together and when I turned the ignition on.
I realized that the traction control light came on for the first time but still nothing for the CEL. I turned ignition off and on again, this time both the traction control and CEL didn't come on. Whenever I unplug the cluster and install it again, the traction control light will come on once, then if I turn the ignition off then on again, it will stop working. I even removed the MAF sensor to test the CEL but it never came on! All the fuses are intact as well... So my question is, is this a faulty cluster, LED, or is something wrong with my ECU?
View 1 Replies
Getting an emissions code. I deleted the emissions with the delete kit. Used the plug in resistors that came with the kit that is supposed to keep the cel off. Here's the code.
P1426 evap emission system purge control valve circuit open .
View 3 Replies
