Jetta - Volkswagen :: 2003 - Manual Transmission Stuck In Neutral
May 11, 2011
My car is a 2003 Volkswagen Jetta GLI, I was on my way somewhere when slowing down i put my car in neutral and began braking. Going faster than i thought i shifted into first gear at about 40mph. At that moment i felt rattling in both the gear stick and the clutch pedal, i tried to shift again in case it was just a hiccup and my gear stick was stuck in neutral, i couldn't switch into any gears.Now when my car is off is the only time i can move the gear stick into the gear slots. And i also lost a lot of pressure in the clutch pedal but it does not stick to the floor it returns to normal position after a moment or so.
View 6 Replies
Advertisement
I have a 2000 VW beetle with a fairly new clutch (2 yrs old). My boyfriend is new to a manual transmission and I can't say I know much about how it works either. A few times when he was driving he will reverse out of a parking spot and then shift to first and the car will make a deep rumbling noise. We turn off the car and turn it back on and its fine. Is the car stuck between gears? Why does it make this noise?
View 4 Replies
93000 miles 5 speed manual transmission only lets me use 2,3 and reverse gear. I took good care of that car and dont think transmission should go out that soon/
View 7 Replies
Why does my engine rpms surge from 1k to almost 3k when i put it in neutral or push my clutch in ?
It's an 07 2.5 jetta with manual tranny...
View 2 Replies
Long time listener first time poster. My wife has a 2009 Vw jetta 2.5 with a manual transmission that is very hard to shift. It has 80,000 on it and has had the clutch replaced once. She told me that she never had any problems shifting until she let it sit for two weeks while she went to cape cod. I have driven it myself and can confirm that there is an issue. Sometimes it just will not go into gear. No grinding noise at all and very very stiff when moving the stick shift laterally from first to fifth. Not actually shifting from 1-5 just moving the stick across the range it feels like cement. I have already changed the transmission fluid and used the Vw oem oil. I also removed the shift boot and lubed all the moving parts with a high quality grease. Tomorrow I am going to bleed the clutch slave and have a good look at the shift linkage. Is their something I am missing?
View 5 Replies
I went on vacation for a week and left my car at my parents house. I came back and now it has become extremely difficult to shift between gears. It's nearly impossible to get the car into reverse, extremely difficult to get it into first, makes a thud when pulling it out of first, is semi difficult to get into 2nd, but only a mild nuisance to get into 3rd through 6th.
For more information, the car is a 2012 Volkswagen GLI with just shy of 40,000 miles. The car ran just fine before I went on vacation and the car was not moved while I was on vacation. I did notice that a little ticking kind of sound when I had the car in neutral with no clutch. So the throw out bearing was starting to wear, but it was a very slight. But I haven't had any other problems.
View 13 Replies
I just picked up another GTi and knew the transmission was iffy when I bought it. I had to deal with the serpentine belt tensioner which is now new and also a new waterpump since it was wobbling.
I've already drained and replaced whatever oil was in there with VW G60 Gear Oil which is what my Dealer here told me to put in and it shifts smoother now but still has the same issue. I also did the Shifter Cable adjustment to see if that was the problem but that only made it easier to shift but it still got stuck.
Basically what happens is when driving I shift into 3rd gear and when I go to shift out of 3rd it comes out of gear but it's like it hits a brick wall and will not go into the home position. I was hoping the adjustment and new oil would work but it hasn't done anything.
View 2 Replies
my 2000 Subaru Outback Manual Transmission is stuck in neutral. I thought it might be the clutch so I pulled it out of the car and checked the clutch linkage etc. With the transmission fully removed from the car the shift lever does not move at all. My question is, if the transmission is fully removed from the engine should the shift lever function?
View 6 Replies
It's been going on for awhile now...shifter hangs up to one side or the other instead of self recentering when put in neutral. I have checked the interior and there is no dirt of grime on the white nylon ball that the shifter floats on and it was also lube with some white lithium spray (liquid wrench). Checked under the hood. All connections are good and solid and free from any obstructions. Trans fluid was changed 10k miles ago. Not sure what else to check.
View 3 Replies
I have a 2005 Elantra GT hatchback that I love with a 5 speed transmission. Lately every time I'm in 2nd gear, the transmission will pop out of 2nd into neutral. This only happens in 2nd gear. I heard it could be the shift collar (i.e. teeth?) that aren't grabbing in that gear.
View 5 Replies
2000 Passat GLS V6 Manual Transmission 102k miles
I was stopped at a light tonight making a left hand turn, I had the car in 1st gear and the my foot on the clutch. I slowly released the clutch and proceeded to make my left hand turn, halfway thru the turn the car made a noise that sounded like a pop (almost as if something came apart underneath the front end of the car and was loose) and then my manual transmission went into neutral. I slowly coasted to the side of the road and had the vehicle towed.
After I had coasted to the side, I tried putting the car into gear and the engine would rev up but the vehicle would not go forward or reverse. I tried all 5 gears and reverse. While sitting there the car would beep and the screen would say "hand brake on" and if I put the car into first this message would go off. The message only came on about 2 times in 5 minutes and never stayed on.
View 2 Replies
I have a 1997 Honda Civic 5-speed with about 200,000 miles. It is making a low-pitched whining noise when I let the clutch out in neutral. I took it to a mechanic who immediately diagnosed it as the throw out bearing. Being mechanically inclined, I dropped the tranny and changed the clutch and bearing, but started it back up, and the noise is still there - as if I did nothing at all. It is not constant volume - sometimes it is louder than others. It is usually loudest first start of the day. I live in Houston, so its not like it is "cold", just not hot. To be fair to the mechanic, the bearing was quite corroded, but everything else seemed to be working properly.
View 13 Replies
On a manual car, I know it's not the best thing to go from neutral, completely bypass 1st gear, and shift to 2nd gear. As well as 3rd to 5th bypassing 4th. However, is it the same for downshifting into neutral or another gear? Will it hurt the transmission to go from 3rd to neutral (bypassing 1st and 2nd) when coming to a stop? I do know that shifting from 4th to 2nd gear and bypassing 3rd will harm your tranny. I just want to double check if I'm right...
View 24 Replies
2007 V6 Mustang Manual Transmission. I recently got stuck in my drive way due to a poor plowing job by the plow guy. I had to turn the traction control off and aggressively shift transmission between reverse and 1st to rock the car and spin the tires. I eventually got unstuck but now the transmission doesn't feel right.
I thought it was the clutch but the issue seems to occur only shifting from 1st to 2nd. The higher gears all seem relatively fine. There is just a catch between 1st and 2nd now that sometimes causes me to not be able to shift into second gear without forcing the shifter down roughly.
Is it possible that I just threw something out of alignment inside the transmission itself? It doesn't make the car undriveable but i get ticked every time i drive it knowing that it was fine before the poor plowing job.
Should I even bother having it looked at? I know transmission repairs are expensive.
View 1 Replies
I've had my 03 VR6 6-speed for 12 years. It's been a second car for the last 5 or so, but regularly used. Friday morning the car got stuck in 3rd gear. The stick will only move from neutral position and down towards 4th gear. I've inspected the short shifter under the hood and the bushings under the shift boot. I did not find anything that diesel geek (the short shifter company) had me check for.
I brought the car into a local shop I have never used before (my usual shop closed), and today they called me saying its a transmission issue. I have not given them permission to open anything up. I am going to take the car home for now.
I have had to repair a broken 1-2 gear fork before. And at that time I had the 3-4 gear for replaced as well.
I should also mention, I similar issues on a quick drive i took the car on the night before. I thought it was just me acclimating to the shifter/lower power of the car as I hadn't driven it for a while. The point is, it drove fine afterwards and it drove fine for a 40 minute city drive to work the next morning.
View 5 Replies
My transmission is manual, front wheel drive, 4 cylinder motor, plunger has come disconnected from shifting forks, car is stuck in 3rd or 4th gear. Would it be easier to change transmission or is replacing the plunger mechanism a viable option?
View 3 Replies
My transmission has recently locked itself up in reverse. The shifter can easily shift through 1st-5th but if i attempt to drive forward it is still in reverse and works against each other. If shifter is left in neutral position it is still in reverse. If i push the clutch in the truck will move freely. I have taken the cover off of the tranny and all of the gears appear undamaged. It was dry however, and i replenished the trans fluid but it still is stuck in reverse. baffled.
View 2 Replies
last night I was on my way to work and had the car in forth traveling about forty-five. A light ahead of me turned red and I held the clutch in until I had stopped. I shifted into what I thought was first. I discovered that regardless of the shifter position, the transmission left it in forth gear. Barely got it moving from a stop and brought it back home.
Looking under the car, I don't know exactly what the linkage mechanism looks like. I'm not sure how to tell if it has been disconnected or misaligned. I don't know if the problem is in the transmission itself either. The shifter moves to other positions freely, but in actuality it stays locked in forth gear.
View 3 Replies
My manual transmission got stuck in 4th because of a melted oil trough sticking between the gears. I got all the plastic out, and the dog clutches/collars are "free." But, I don't know how to put the gears back into neutral. When it's reassembled, the stick doesn't work to change the gears. How can I get the gearbox back into neutral?
View 19 Replies
I had been waiting to fix my explorer for a long time. The "previous owner" I will call him knowingly sold me a vehicle with a bad tranny without disclosing it... long story. To get to the important part, it had the common 2/3 shift flare. I dropped the pan, filter, and valve body, making sure to use a template and put the bolts where they go. Then i took the valve body to the work bench and replaced the gasket, which was surprisingly not blown. After more looking around, I realized the previous owner had already had the fix done. I tightened the EPC 1/4 turn and reassembled the tranny. When i started it, it was stuck in first gear. PRN21 all went forward (park just revved a bit due to the park lockout.)
I tore it back apart and found that the plunger on the side of the valve body was stuck in the 1st gear position. I pushed it back out and cleaned it up so it moved freely. Then I reassembled the tranny using new fluid again.
After that the tranny was stuck in neutral. I dropped the pan again today, and tightened the valve body bolts and made sure my solenoids are tight. Filled it back up slowly with the engine running. It shifted into gear for a second (tried to go forward while it was in reverse though). Then it was again stuck in neutral in all the gears again.
View 2 Replies
Just got my 2013 Elantra Limited last weekend. It appears the car is having some issues with the transmission shifter. I am not sure if its tranny related, but I highly suspect it is. Dealer gave me the usual bs not being able to duplicate the symptoms.
1. Intermittently, gear selector would get stuck in neutral, when I try to put the car into P, after a long or a short drive.
2. I would have to wiggle the shifter to get into P, or I would have to shift to D, and then I am able to shift back into P.
View 22 Replies
