I get a noise from behind the radio of my Jeep wrangler 2003 that sounds like a vibrating spring that is hitting metal. I get it in the lower "harmonics" you get as you just shift into a lower gear. It doesn't last long and goes away as you rev up in the gear.
View 3 RepliesI own a 2003 Jeep Wrangler and for the past 4 months. I have had a squeal coming from the right side front of the engine when coming off the gas. However when I get below 25mph while slowing to a complete stop the sound goes away in most cases. My mechanic has replace the tension pulley along the the serpentine belt and the sound still persists...
View 5 RepliesThere is a whistling noise that is coming from under the hood of my Jeep. It is more noticeable on cold days. It temporarily disappears when my foot is on the accelerator or after I have been idling at a stop sign for 30 seconds. The noise starts again when I start driving.
View 6 Replies2007 Jeep Wrangler Manual Transmission: The radio turns off and then back on (shorts out?) when the engine is going really slowly. For instance, when creeping up to a stop light in second gear vice first. Why is this happening? How can I prevent the radio from continuing to do this. In the past I had a Hyundai Elantra, Ford Escort, and a Dodge Colt, all had a manual transmission and none had issues with the radio shorting out.
View 1 RepliesI have a 2005 Jeep Wrangler Sport with just over 58000 miles. It has a stock 4.0L in-line 6 cylinder with a manual 6-speed transmission. No lift kits or suspension mods. I have been noticing a strange rattle coming from up under the front end when I am cruising through parking lots or coming to a stop at an intersection. When I get down to around 10-15mph the rattle becomes audible and you can feel it in the floorboardYou just feel it. It doesn't matter if the clutch is pushed in or not. When accelerating or cruising at highway speeds (anything 20mph or up) the rattle goes away. Only when decelerating or coming to a rolling stop.
View 5 RepliesI have a 2005 Jeep Wrangler Sport with a six-speed manual trans and an in-line 4.0 6-cyl engine. I discovered a month or so ago a strange rattling sound coming from, what sounded like, the front passenger wheel area. It would occur when I slowed down to 10mph or slower or when coming to a complete stop, or when starting out from a stop, until surpassing the 10-12mph mark. The rattle is audible both inside and outside the vehicle. It's a low-pitched sound like an "aaaaaahhhh" you make when opening wide for the doctor to look down your throat, only with a metallic rattle thrown in. Best way I know to describe it is a voice saying "aaaaahhhhh" through the back of a fan.
I recently discovered, when I took it in for an oil change and tire rotation, that my front tires were wearing much faster than the backs and had a very noticeable "choppiness" to the tread. I have since installed new shock absorbers on both sides of the front suspension in hopes that would even the ride out for the front and eliminate the choppy tire wear. I originally thought that the tire wear and the rattle were related, but I took it to a mechanic who raised the front end and hand-spun both front tires and they made no audible sounds while spinning.
The mechanic said he believes that the rattle is coming from the front differential. Now, I am no pro mechanic, but I am not afraid to tackle a car repair job as long as I know I have the tools I need at hand to properly complete the job. First of all, does the differential sound like a good place to look? There's no change in the rattle when applying or releasing the clutch and it shifts smoothly, so I am pretty certain it's not in the transmission. Is the differential something that I could remove the cover and adequately diagnose a problem on my own? Just don't have funds available for a large car repair bill, so I am looking at trying to tackle the issue myself.
I own a 98 jeep wrangler. Love the little jeep. But....big BUT...at random it chooses not to start, not sluggish start, dead absolutely no noise. I have spent well over 1500. dollars on new starters, batteries, ignitions, ignition cylinders you name it I have replaced it. This last time it started every time for well over a month, then one evening it just didn't so I let it set for a couple of hours as usual and then it started and we came home. I love my mechanic he is patient and doesn't make fun of me when I ask dumb questions...but this he can't figure out.
View 2 RepliesVideo of Noise: [URL] .....
I am getting the above noise on startup, it goes away after 5ish minutes. It isn't exactly cold out. So I don't think its the oil viscosity. Its not a bad oil filter flow back valve, and its way longer than the oil lifters should make noises. I don't think it is a cracked manifold, I think the noise would be different.
Jeep wrangler 2005. 4.0L, ~99k Miles
I've got a 2004 Jeep Wrangler SE 5-speed with 83,000 miles on the 2.4l PowerTech engine in it, and it's making a very strange noise that I can't pinpoint.
So first, the noise itself. It sounds like a metallic tapping or ratcheting, like the sound of raising of a large chain hoist. Fairly high-pitched, audible inside and out. Not incredibly loud (I have to point it out to passengers) but loud enough to bother the hell out of me. The closest I can come with location is "somewhere under the hood."
However, the noise is only present under certain conditions:1. The transmission must be in gear. Forward or reverse doesn't matter. Revving engine at idle does not produce the noise.2. The transmission must be under load, i.e. when accelerating or releasing the clutch in 1st to begin driving. Letting off the gas stops the noise.3. The noise only exists somewhere between 1k and 2.5k rpms. Application of throttle at any road speed in any gear with the engine in that RPM range produces the noise. 4. The frequency of the tapping increases with engine speed. 5. Ambient temperature appears to have no effect, but as engine temperature increases the noise tends to disappear. Not always, though, as it shows up sometimes when the engine is completely up to operating temperature. 6. I don't notice any kind of performance issues related to the noise. Power's normal (for a 2.4l Chrysler 4-banger, that is) and gas mileage is within the EPA estimates.
Things I've investigated:1. I'm pretty sure it's not lifter noise. A bottle of Seafoam made it run better, but the noise persists. 2. I've checked the catalytic converter heat shield. It's on tight. I found the flange where the exhaust manifold meets the downpipe was a bit loose, but tightening it down didn't eliminate the noise. Getting underneath and shaking the hell out of every component of the exhaust system I can reach produces no results.3. Engine mounts show normal wear. Transmission mount appears fine. 4. No check engine light, and all gauges read normal. Hooked up a code reader for fun and it came back with nothing.
As the noise only shows up while driving, I can't just crawl under there and poke around. The best I can do while driving is feel for related vibration, which gives me nothing. Whatever causing it, it's not transferring up through the stick.
In the may-or-may-not-be-related category, I've got a bit of oil consumption and a clunky transmission, but according to the various Jeep forums I've found, those seem to be fairly normal.
We got some snow the other day, and as I cleared it off I allowed the car to warm up for about 20 minutes. When I got in and drove it, the noise was greatly reduced. Not gone, but barely perceptible.
I spent a couple hours on YouTube the other day, trying to compare my noise to videos of other Jeeps with drivetrain issues, and found nothing even close to similar. Whatever's making this noise, it's not common.
So as I was parking my car and I accidentally stalled it. So anyway I return to the car 20 minutes later to leave and when I start it up I notice the engine is idling at 2000 rpm and is making a loud hissing noise from the drivers side on the engine (I think). When I rev the engine it is slow to come back down to the 2000 rpm idle. When I put the car in gear and drive it, it likes to stay at 2000 rpm.
The car will accelerate without me pushing the gas pedal until it reaches 2000 rpm. Also when I shut the engine off, it sputters and coughs, almost like a backfiring motorcycle but rhythmically slowing down until it finally stops (around 3 seconds or so from when I turn the key off). The check engine light is OFF and the car is still "driveable" (I got it home) and typically idles around 900 rpm I think..
I have a 2003 Jeep Wrangler (4 cylinder) that seems to be having a fuel problem.... about a month ago, it started lurching, having a hard time starting, it would lose power on drives and once or twice it has stalled on me while I'm driving on the freeway. I've had to restart my car going 60 mph... if I feel it lurching or surging, I have been able to keep the car going by shifting into a lower gear or taking my foot off the gas.
I just took it into the dealership and spent 1300 to get it diagnosed and fixed. I got a new timing belt, and a whole bunch of other stuff and on the way out, it stalled at the first stop light. Although it seems to be running better, it obviously didn't fix the issue. I took it right back and now they are going to have me bring it back on Monday to 'try to figure it out’. Where should I tell them to look?
Oh, and - I had to get a short fixed from the ignition key (I was able to pull the key out while the car was running) and they fixed it. But now, I can't get any reception on my radio...
2004 Jeep Wrangler Sport 5-speed Bought used 2yrs ago. 76,000 miles Only seems to happen after driving for more than an hour. When I either back into my driveway or turn sharp into a parking sport, mostly to right, I get a bumping sound, like something rubbing. My mechanic has replaced the sway bar links, front rotors, axle yoke, had a front differential leak so seal was replaced, and am still getting the sound. Tires Bf Goodrich All Terrain Do not do off road.
View 4 Replies2003 Jeep Wrangler LOUD squeal when coming off the accelerator. I've had changed the Tension Pulley, The Belt, Checked the Power Steering, Removed the belt from the AC unit..smaller belt now....Tested the Alternator, it's working like a champ. I have a 4.0L 6 Cylinder. My mechanic wants to check the intake gasket and another intake which he spoke of and I can't remember at the moment however with no guarantees these or one of the two could be the problem. He expects it to be a 5 hour job. The sound seems to be generated from the lower backside of the engine...
View 2 RepliesI have a '98 Jeep Wrangler with various problems, but the most recent one has to do with the turn signals. When I intentionally use them, they seem to be working, but when I haven't signaled I still hear the ticking sound, only double-time. The sound is normal when I turn the signal on, and only stops when I apply the brake. I recently took the top off and left the Jeep uncovered in a couple of storms. Could this have caused electrical damage? Also, the left turn signal has required some finesse for as long as I've had the car--I've always needed to fiddle with it to get it to turn on--so I'm wondering if it's a wire connection that has deteriorated over time.
View 3 RepliesI have a 2006 4 cylinder JEEP Wrangler. Right around 50 mph the whole car starts to shake pretty violently. I have to slow down back to 40 to get it back to normal. I can seem to get past this most of the time by waiting to shift into fifth gear until after 50 mph but not always!
View 1 RepliesJeep Wrangler Owners excessive engine oil consumption [URL] .... Caused engine failure with my Jeep. Chrysler aware of problem. Local dealership stating Chrysler may not honor 100,000 mile warranty due to 1missed oil change.
View 5 RepliesVehicle will not exceed 20mph. Vacuum leak can be heard coming from around the intake area on the driver side. Cannot detect where it is coming from. All vacuum hoses seem to be connected.
View 3 RepliesI have a 1995 Jeep Wrangler Rio Grande named El Burro.I have replaced the shocks and am awaiting an alignment next week.The Jeep doesn't shake or jump all over unless I hit a bump and then it jumps all over the place.
View 15 RepliesI have a 01 Jeep and the AC is not blowing cold air. When I went to get my oil changed they did a check over and said that it is in working order just lacks any freon to get it cold. So I went to get a bottle to do it myself. Doing what it said to do on the bottle I got nothing. The meter says that there is pressure in the system, but no cold air coming out. I noticed that it would engage and then stop after a second, but still will not fully engage or blow cold air.
View 5 RepliesWe have a 97 Jeep Wrangler that I have serviced regularly since I purchased new. It only has 97,000 miles since my wife and children drove it locally. During winter, the Jeep drives fine. As the weather warms up and especially when using the air conditioning system, the engine heats up within 10 to 15 minutes of driving. Once, when my daughter was driving in warm Spring weather, the Jeep engine seized up on a highway. We had it towed and the dealership flushed the coolant and it drove OK for a few days. We have noticed that the coolant is burning up in Spring and Summer needing replenishment frequently. We also had the thermostat, water pump, belts, and hoses replaced. The overheating problem (needle moves to red zone) still persists in Spring and Summer. If we switch off the A/C, the vehicle drives OK for about a 1/2 hour but Atlanta summer can be brutal without A/C.
Except for this issue, the vehicle is well maintained and in fact every time I get the oil changed, the mechanics ask if I would sell the vehicle as it is in such great shape.
when the jeep warms up the transmission wont shift out of second gear.it is an automatic.had solenoid packs replaced and no mechanic has an idea.external cooler has been mentioned along with replacing pcm.
View 2 Replies