Jeep - Wrangler :: 1998 - Sputters A Bit When Driving In Higher RPM Close To Redline
Jun 29, 2016
I have a 4.0 6 cyl. Jeep wrangler manual transmission. When the jeep is driven in higher RPM close to redline the jeep sputters a bit (doesn't have full power at or close to redline). Is this a governor or does the jeep have a problem? I do not redline often at all. however i live in the mountains and need to travel up steep pass for 1-2 miles every few months.
View 10 Replies
Advertisement
I own a 98 jeep wrangler. Love the little jeep. But....big BUT...at random it chooses not to start, not sluggish start, dead absolutely no noise. I have spent well over 1500. dollars on new starters, batteries, ignitions, ignition cylinders you name it I have replaced it. This last time it started every time for well over a month, then one evening it just didn't so I let it set for a couple of hours as usual and then it started and we came home. I love my mechanic he is patient and doesn't make fun of me when I ask dumb questions...but this he can't figure out.
View 2 Replies
I have a '98 Jeep Wrangler with various problems, but the most recent one has to do with the turn signals. When I intentionally use them, they seem to be working, but when I haven't signaled I still hear the ticking sound, only double-time. The sound is normal when I turn the signal on, and only stops when I apply the brake. I recently took the top off and left the Jeep uncovered in a couple of storms. Could this have caused electrical damage? Also, the left turn signal has required some finesse for as long as I've had the car--I've always needed to fiddle with it to get it to turn on--so I'm wondering if it's a wire connection that has deteriorated over time.
View 3 Replies
Jeep runs fine for days and then it will have a bad day. Loses power for a minute or two and then revs back up. If you stay on the gas it acts like it wants to stall something makes a loud banging noise under the jeep and then it takes off only to do the same thing in 2nd gear 3rd gear etc. Would o2 sensors try to shut it down? Throttle position sensor?
View 7 Replies
My daughter and I are driving from Winston Salem, nc to Birmingham, al about 400 miles. We re driving in an automatic 2008 jeep wrangler. Last night we were outside Atlanta when the car started shaking. For a moment we thought we had a flat but the car was not shaking that badly and I was able to maintain steering control when driving. The shaking stopped spontaneously after about five minutes. We stopped later to look at the tires and they looked fully inflated and overall in good condition. Our questions are what could have caused it and is it safe for us to continue our drive the rest of the way to Birmingham ?
View 2 Replies
I have a 2001 Jeep Wranger (4cl) automatic that has hated highways. When i drive on the highway, after about 4 hrs, my jeep decides to slip into neutral. So i initially have to hit the gas pedal to make it down shift and then it seems okay but of course after about an hour it does the same thing. Hence a long ride becomes much longer. I usually pull off and let it the engine cool down and that seems to work and i can resume the highway once again. I have had the transmission looked at and a transmission flush done. I have been told that i do not need a transmission but the mechanic has no idea why this occurs.
View 3 Replies
I have a 2006 Rubicon Wrangler 4.0 (automatic) with 15K miles, excellent cond. When I drive up to the mountains my Jeep loses power to the point I have the gas pedal pushed to the floor, whereas I can jump out of the jeep and run along side of it. When I step on the gas on the freeway going at high speed it dogs down. It runs fine driving around town. I never had this problem before. I don't think its a transmission problem because I have no engine light coming on. I just checked the Catalytic Converter and that's ok. I'm lost, I have no clue what it can be.
View 1 Replies
I still drive the '88 Wrangler I bought in Oct '87. She has 171,000 miles. Recently I had a rebuilt motor,transmission, etc... installed. I had the existing carb rebuilt. This summer, while driving at any speed, the tach would drop to zero and the whole car would lurch. Sometimes so violently my seatbelt would lock up. After a couple miles of lurching it would backfire several times. This is very scary.
Here's the really bizare issue - now that the weather is cold, the issue has substantially (not completely) diminished. On a warm day in the 50's it will act up again. I live in Watkins Glen, NY. Yes, I'm a (Indy Car) racing fan. What can I do?
View 10 Replies
I purchased a 1990 Jeep Cherokee Laredo at a steal . . . I've already replaced the head gasket sealant. My biggest current concern is the fuel pressure. The car either starts up beautifully or sputters and gurgles for a good 5 seconds before finally idling normally (either occur during cold or warm starts).
The sputtering at start-up has become more commonplace as of late. If I drive away without providing a good three-to-five minute warm-up, the car will drive as normal while applying gas pressure to the peddle, then once gas pressure is no longer applied, the car dies silently; The battery stays on, but all power steering and engine power disappear and the car coast into nothingness. If I allow the Jeep to warm up significantly, it will drive as normal for hours, except for it's struggles to compensate long upward hills.
The fuel regulator has a slight leak. Worse at start-up, lessens up over time. The seal may be improperly seated, but is in physical working condition as I can tell. Spark plugs were replaced. Battery was replaced. Injectors have been tightened. There is a slight oil leak (it seems to move around a bit), but is far better since the Head Gasket was replaced. Could this be a bad fuel regulator or something else that I have missed?
View 1 Replies
I have a 2006 4 cylinder JEEP Wrangler. Right around 50 mph the whole car starts to shake pretty violently. I have to slow down back to 40 to get it back to normal. I can seem to get past this most of the time by waiting to shift into fifth gear until after 50 mph but not always!
View 1 Replies
Jeep Wrangler Owners excessive engine oil consumption [URL] .... Caused engine failure with my Jeep. Chrysler aware of problem. Local dealership stating Chrysler may not honor 100,000 mile warranty due to 1missed oil change.
View 5 Replies
Vehicle will not exceed 20mph. Vacuum leak can be heard coming from around the intake area on the driver side. Cannot detect where it is coming from. All vacuum hoses seem to be connected.
View 3 Replies
I have a 1995 Jeep Wrangler Rio Grande named El Burro.I have replaced the shocks and am awaiting an alignment next week.The Jeep doesn't shake or jump all over unless I hit a bump and then it jumps all over the place.
View 15 Replies
I have a 01 Jeep and the AC is not blowing cold air. When I went to get my oil changed they did a check over and said that it is in working order just lacks any freon to get it cold. So I went to get a bottle to do it myself. Doing what it said to do on the bottle I got nothing. The meter says that there is pressure in the system, but no cold air coming out. I noticed that it would engage and then stop after a second, but still will not fully engage or blow cold air.
View 5 Replies
We have a 97 Jeep Wrangler that I have serviced regularly since I purchased new. It only has 97,000 miles since my wife and children drove it locally. During winter, the Jeep drives fine. As the weather warms up and especially when using the air conditioning system, the engine heats up within 10 to 15 minutes of driving. Once, when my daughter was driving in warm Spring weather, the Jeep engine seized up on a highway. We had it towed and the dealership flushed the coolant and it drove OK for a few days. We have noticed that the coolant is burning up in Spring and Summer needing replenishment frequently. We also had the thermostat, water pump, belts, and hoses replaced. The overheating problem (needle moves to red zone) still persists in Spring and Summer. If we switch off the A/C, the vehicle drives OK for about a 1/2 hour but Atlanta summer can be brutal without A/C.
Except for this issue, the vehicle is well maintained and in fact every time I get the oil changed, the mechanics ask if I would sell the vehicle as it is in such great shape.
View 6 Replies
when the jeep warms up the transmission wont shift out of second gear.it is an automatic.had solenoid packs replaced and no mechanic has an idea.external cooler has been mentioned along with replacing pcm.
View 2 Replies
I've been researching and trying to find an answer to the "death wobble" on my 2005 Jeep Wrangler. I've had it in to the dealer and two other repair centers and no one can identify the culprit, other than to say we can change out each piece of the front end a part at a time to see if that will solve the problem. I could buy a new Wrangler for that. I constantly have the tire balanced or checked for balance. The front and rear shocks have been inspected. The bushings in the front end have been inspected. The wobble is very subtle from 40-45ish. At about 52mph it is the worst. Above 55 and it returns to almost nothing. Braking does not increase the wobble. I've not modified anything on the vehicle. From what I've read on blogs this is a common issue for the Wrangler starting somewhere around 2000.
View 8 Replies
I have a 2006 Jeep Wrangler Unlimited w/ 33k miles on it...4.0 engine. Have had it a little over a year. Last Fall, it started having issues whenever we had a lot of rain. Would not crank at all. Replaced the battery and clutch switch, which seems to worked, but is now doing it again. I turn the key and all of the lights come on, but there is not even a click. If I coast it off and pop the clutch, it starts right up. Once it dries out, will start w/ the key without an issue. Have an appt w/ the dealer, but they cannot get to it until Thursday, but I have to drive to work until then.
View 4 Replies
My 2008 jeep wrangler x 6 cyl pings upon acceleration. 62000 miles.
View 6 Replies
I tried starting my 2005 Jeep Wrangler yesterday and there wasn't enough charge to get it started. I got a few slow revolutions and that was it. I gave it a jump and it started fine. Drove it for an hour or so and then went to restart it 3 hours after I shut it off and it was dead again. Another jump and I drove it for an hour (home). I was able to start it a few hours after that on its own, though it struggled to a bit.
Tried again this morning and it was dead from sitting overnight. A few other bits of info:
With the key in the ignition, the charge indicator is hovering just above 9V (it is a 12V battery) before I try to start it. When engine is running after start, it jumps to around 12V.
I am pretty sure I didn't leave the lights on or door open overnight. I haven't noticed the engine struggling to start leading up to the dead battery.
After I jumped it again this morning, it seems to be idling very low. In fact, the engine shutoff when I let it idle in neutral with my foot off the gas for a few seconds.
When I got in the Jeep this morning before trying to start it, it had enough charge for the radio and dashboard. When I turn on the lights/highbeams it struggled and the high beam indicator on the dashboard (blue light) was flashing. Battery is not too old. I don't have the receipt with me, but I think I bought a new one 3-4 years ago. The +/- connections are clean with no corrosion. I didn't look too closely, but I didn't notice any obvious connection issues from the battery leading into other components.
I'll probably go buy another battery, but wanted to check with the experts out there to see if there is anything else I should be checking. If I do get another battery
View 7 Replies
I have a 85 cj7 with a 258 straight 6 and recently when I have been refilling the gas tank she won't start right away and I end up waiting 1 to 2 hours before she will start up and then she drives fine until you have to put more gas and the cycle happens all over again. What the problem could be?
View 7 Replies