Jeep - Wrangler :: 1995 - Won't Start - Power Isn't Getting To Fuel Pump?
Jun 15, 2016
So last week something happened that I've never had happen before. I was dropping my daughter off at school and I noticed that my dash lights weren't on. My headlights still worked and the blinkers did to.
When I got home and parked it, I checked out all the fuses. There was a 20 amp fuse that was blown, so I replaced it and then checked the relays under the hood. I turned on the key to check the dash lights and they still didn't work. The 20 amp fuse blew again, so I replaced it again. Now the dash lights work again.
However, when I tried to start it, it would turn over, but the fuel pump isn't turning on.
Long story short, I've replaced all 4 relays under the hood, installed a new fuel pump and also replaced some bulbs in my taillights and sides over the front tires. It turns over when I try to start it, but the fuel pump still isn't "kicking" on and it won't start. I feel like somehow, power isn't getting to the fuel pump.
View 12 Replies
Advertisement
Jeep runs fine for days and then it will have a bad day. Loses power for a minute or two and then revs back up. If you stay on the gas it acts like it wants to stall something makes a loud banging noise under the jeep and then it takes off only to do the same thing in 2nd gear 3rd gear etc. Would o2 sensors try to shut it down? Throttle position sensor?
View 7 Replies
I have a 1995 Jeep Wrangler Rio Grande named El Burro.I have replaced the shocks and am awaiting an alignment next week.The Jeep doesn't shake or jump all over unless I hit a bump and then it jumps all over the place.
View 15 Replies
Geo won't start. It has a new battery and air filter. Just replaced the fuel pump and fuel filter. I don't hear the fuel pump "whirring" when I put the key in the ignition (to on position). All the dashboard lights come on when the car is in on position.
I suspect the relay or the fuse, but having trouble finding the correct one of each. What does the relay look like? i.e. part number? What is the spec for the fuse? 20amp 30 amp? This has been a great car.
View 5 Replies
My 1995 ford ranger with a 3.0 will not start. It acted like the fuel pump was going out so I replaced it. I also replaced cmp sensor and the camshaft synchronizer due to old cmp sensor broke and messed up the synchronizer. My truck is getting fuel and spark but still will not start. Where do i go next?
View 4 Replies
I have a '95 Chevy Caprice Classic 4.3L Sedan, and it cranks but does not start.This started happening after about a year of the car just sitting in the driveway. Before she sat for that year, she ran just fine.
I am under the impression that the problem is the fuel pump, it is NOT running when the ignition key is turned to the "on" position,this is very confusing because a volt meter placed on the connectors going directly into the pump motor shows 12+ Volts when the key is turned, for about 2 seconds, as it should, however the pump motor does not run. Also, I have already replaced the pump relay AND the entire pump assembly (though the pump I used as a replacement was also pulled from a junkyard vehicle).
The MOST confusing part is, when either of the fuel pump motors that I have are plugged directly into the car battery, they run just fine.
View 8 Replies
My issue. 95 short Aerostar, Vulcan engine, A4LD trans. Just got it last week. Bought a new trans and when I went to pull the van into the shop, it wouldn't start. Cranks but won't run. First thing I checked is fuel pressure, got zero. Pulled the kick panel and found the inertia switch, but the harness for the switch is getting 1.8 volts with the key in "ON" and the same with it in "START". IIRC it should be zero in RUN after a second or two (if the engine isn't actually running, that is), and 14 in START.
Checked all fuses in the panel by the steering column, they're good, and switched around the 3 relays by the battery. No good and I don't hear the FP relay when I turn the key. For now I'll run wires directly from the battery to the pump, just til I get the trans done, but it needs to be fixed anyway because I plan to make this van a DD. Here are my questions:
-Is there a second fuse panel I didn't find?
-Could this be a computer issue? If it is, would the computer fuse be blown?
View 2 Replies
I own a 98 jeep wrangler. Love the little jeep. But....big BUT...at random it chooses not to start, not sluggish start, dead absolutely no noise. I have spent well over 1500. dollars on new starters, batteries, ignitions, ignition cylinders you name it I have replaced it. This last time it started every time for well over a month, then one evening it just didn't so I let it set for a couple of hours as usual and then it started and we came home. I love my mechanic he is patient and doesn't make fun of me when I ask dumb questions...but this he can't figure out.
View 2 Replies
I tried starting my 2005 Jeep Wrangler yesterday and there wasn't enough charge to get it started. I got a few slow revolutions and that was it. I gave it a jump and it started fine. Drove it for an hour or so and then went to restart it 3 hours after I shut it off and it was dead again. Another jump and I drove it for an hour (home). I was able to start it a few hours after that on its own, though it struggled to a bit.
Tried again this morning and it was dead from sitting overnight. A few other bits of info:
With the key in the ignition, the charge indicator is hovering just above 9V (it is a 12V battery) before I try to start it. When engine is running after start, it jumps to around 12V.
I am pretty sure I didn't leave the lights on or door open overnight. I haven't noticed the engine struggling to start leading up to the dead battery.
After I jumped it again this morning, it seems to be idling very low. In fact, the engine shutoff when I let it idle in neutral with my foot off the gas for a few seconds.
When I got in the Jeep this morning before trying to start it, it had enough charge for the radio and dashboard. When I turn on the lights/highbeams it struggled and the high beam indicator on the dashboard (blue light) was flashing. Battery is not too old. I don't have the receipt with me, but I think I bought a new one 3-4 years ago. The +/- connections are clean with no corrosion. I didn't look too closely, but I didn't notice any obvious connection issues from the battery leading into other components.
I'll probably go buy another battery, but wanted to check with the experts out there to see if there is anything else I should be checking. If I do get another battery
View 7 Replies
I have a 85 cj7 with a 258 straight 6 and recently when I have been refilling the gas tank she won't start right away and I end up waiting 1 to 2 hours before she will start up and then she drives fine until you have to put more gas and the cycle happens all over again. What the problem could be?
View 7 Replies
Video of Noise: [URL] .....
I am getting the above noise on startup, it goes away after 5ish minutes. It isn't exactly cold out. So I don't think its the oil viscosity. Its not a bad oil filter flow back valve, and its way longer than the oil lifters should make noises. I don't think it is a cracked manifold, I think the noise would be different.
Jeep wrangler 2005. 4.0L, ~99k Miles
View 9 Replies
Have replaced distributor, spark plugs, coil, and still have very weak, erratic spark. Plugs getting plenty of fuel, won't start. What else I should do?
View 7 Replies
1995 Ford Explorer, 4 ltr. engine, pushrod. Will not start. Replaced fuel pump, fuel filter, every relay, pressure regulator, and the crank position sensor. I realize there's a whole bunch more parts under the hood, but I am ready to give up. Before the fuel pump would not run. Reason for replacing the parts. Now it won't stop running and you can feel the fuel by-passing at the pressure regulator. When checking the pressure at the rail I get zero !! I used a tire pressure tester for this. And, like I said no pressure. This vehicle has around 170,000 miles on it.
View 8 Replies
I have a 2003 Jeep Wrangler (4 cylinder) that seems to be having a fuel problem.... about a month ago, it started lurching, having a hard time starting, it would lose power on drives and once or twice it has stalled on me while I'm driving on the freeway. I've had to restart my car going 60 mph... if I feel it lurching or surging, I have been able to keep the car going by shifting into a lower gear or taking my foot off the gas.
I just took it into the dealership and spent 1300 to get it diagnosed and fixed. I got a new timing belt, and a whole bunch of other stuff and on the way out, it stalled at the first stop light. Although it seems to be running better, it obviously didn't fix the issue. I took it right back and now they are going to have me bring it back on Monday to 'try to figure it out’. Where should I tell them to look?
Oh, and - I had to get a short fixed from the ignition key (I was able to pull the key out while the car was running) and they fixed it. But now, I can't get any reception on my radio...
View 2 Replies
My 2004 Rubicon has been having some idling issues. It idles kind of rough (+- 200 RPM) and is hard to start. I tried to start it recently and after 4 cranks, it started then the CEL came on, and has been on ever since. I have recently moved from Washington state to Houston Texas, and the problem starterd here in Texas. I checked the code and am getting a P0505 code. I had a mechanic replace the IAC valve, Checked for vacuum leaks, and cleaned the throttle body. The mechanic says the output from the main computer appears to have burned out, and needs to replace the main computer(for $1000). The mechanic can clear the CEL, but after turning the jeep off then back on it reappears. The mechanic says he verified the computer was the problem by installing a known good computer and it cleared the problem. Does this sound right to you? If my computer is bad, wouldn't my whole operation be affected?
View 4 Replies
I have a 2006 Rubicon Wrangler 4.0 (automatic) with 15K miles, excellent cond. When I drive up to the mountains my Jeep loses power to the point I have the gas pedal pushed to the floor, whereas I can jump out of the jeep and run along side of it. When I step on the gas on the freeway going at high speed it dogs down. It runs fine driving around town. I never had this problem before. I don't think its a transmission problem because I have no engine light coming on. I just checked the Catalytic Converter and that's ok. I'm lost, I have no clue what it can be.
View 1 Replies
2007 Jeep Wrangler Manual Transmission: The radio turns off and then back on (shorts out?) when the engine is going really slowly. For instance, when creeping up to a stop light in second gear vice first. Why is this happening? How can I prevent the radio from continuing to do this. In the past I had a Hyundai Elantra, Ford Escort, and a Dodge Colt, all had a manual transmission and none had issues with the radio shorting out.
View 1 Replies
01 7.3. Cranks, won't start. Tank was at 1/4 but is full now. The lift pump runs, I can feel and hear that the motor is spinning when I cycle the key. I removed the fuel filter and cycled the key and get no fuel into the bowl. It looks like the lines are stainless from the pump to the tank so I doubt it is sucking air. I pressurized the tank with a shop vac and I get fuel coming into the filter housing. Am I missing something obvious? I have never seen an electric pump that would run and not pump fuel. I removed the suction line at the pump and don't feel any suction there.
View 14 Replies
My 2000 Hyundai accent gl will not start. I have realized it is the because its not getting fuel. the fuel pump is new but not getting power.. there are 5 wires coming from the pomp which is the ground wire?
View 2 Replies
After my 95 GCL wouldn't start and was towed to Jeep dealership, the problem was diagnosed has the fuel pump. I went to pick up my Jeep. Started and ran beautifully..but I noticed the air bag light was on, and wasn't that way before it wouldn't start. Went back into dealership and told'em..they told me nothing they did would have any bearing on the air bag or the dash warning light. What could have happened to cause this problem? I have re-booted the electrical system (more than once) by disconnecting the battery.
View 1 Replies
I'm working on one of our fleet vehicles here, a 1995 Explorer. about 2 months back, it stalled out. Got it back to the shop and turned the key on .... I couldn't hear the fuel pump. I replaced the fuel pump and the fuel pump relay. Vehicle started right up and seemed to run O.K. About 2 weeks ago, it stalled out again, same symptoms, acts like it runs out of gas and can't hear fuel pump.So, I have been playing with it and find that it starts up great in the cool mornings. In the afternoon when the temps are hotter, it won't start (can't hear fuel pump). The following morning when temps are cool, it will start right up and can hear the fuel pump. I almost wrote this one off as a defective fuel pump, but I'm not sure on this one.
View 7 Replies
