Jeep - Wrangler :: 1989 - Brakes Drag After Half Hour Of Usage
Jan 29, 2011
I have been having a brake drag problem with my '89 Jeep Wrangler. I posted this problem previously when I thought it was an E-brake issue. I did a rear drum spring set change. The problem persisted, so I asked the local auto parts store and they said it could be a faulty master cylinder which I just replaced. The brakes felt fine for the first 1/2 hour driving, then the pedal started feeling harder to push and the brakes were dragging again. I jacked the car up and removed the tires to find both front calipers tight on the rotor, the rears would spin. With someone pressing the pedal, I did not notice any caliper movement.
View 5 Replies
Advertisement
Just got done putting new clutch, master cylinder and slave cylinder in my 89 Jeep wrangler and it still will not go into gear while the vehicle is "turned on", however it shifts into all gears while the vehicle is turned off. After bleeding the clutch/getting all the air out, for over an hour it still would not go into gear while the vehicle is running, only when it is turned off.
View 2 Replies
I have a '89 Jeep Wrangler 2.5L with the AX5 transmission. I noticed over time I had to push the clutch pedal down more to make it work. I checked the hydraulic fluid reservoir and it was empty. I filled it but the pedal had no pressure. I looked at bleed the line protruding out from the clutch housing and noticed a fluid trail on it and inside the clutch housing. The rubber insulator at the opening was missing and suspect corrosion and any movement on the line cracked it where it connects inside. I am ready to junk this vehicle because it is rusted pretty bad, but thought I'd ask before I do.
View 3 Replies
My front disc brakes are creating a small amount of drag on the rotor. With the car jacked up and wheel off I am able to easily turn the rotor by hand, but there is a small amount of drag. I haven't had any problems with my brakes, they have never frozen or overheated, etc. I put new brake pads and rotors on the front about 6 months ago only because it was time for replacement. The question is: how much disc brake drag is acceptable? Looking around on the internet for answers there doesn't seem to be a consensus: some people say absolutely no brake drag, some say that a small amount is normal. What do you think?
View 6 Replies
I have narrowed down my starting issue to a faulty relay(409). When I pulled the relay and cleaned the contacts and reinstalled the pump primed and the car started. Car will idle for about a 1/2 hour and out of the blue it shuts off. If I try to restart, 9 times out of 10 it does not start. If i tap the relay, it starts right up. If the car is running and I tap on the relay the car stutters and if I tap it again it shuts off.
View 10 Replies
This happens not all the time, can cold start and the car runs fine but then once its shut off then started for use again later it will shut down, sit on roadside for 2 minutes with key off and then restart and good to go again...its a random thing...the check engine light does come on...
View 11 Replies
Yesterday I had my front end jacked up to adjust my coil-over's via spanner wrenches. After I had everything back on I lowered the car down and torqued the lug nuts. I got in to perform a test drive and maybe my parking brake was stuck, or my brakes were dragging. When I put it in reverse (Manual transmission) something was fighting me from moving. I applied the parking brake and then released it again. No luck, so I gave it some rev's and the car moved.
Now when going on sharper turns I hear a odd rubbing noise. It isn't from the wheels or tires. Today I checked my fender liners, because that is what it sounds like, they are ok. I though maybe somehow they were mis-aligned and it was causing the car the tire to rub. I sounds like it is coming from the right side. The car only has 500 miles on it and this problem started exactly after I lowered it down and the parking brake or a caliper was stuck.
View 24 Replies
Just replaced the starter and battery on my old but loved 4Runner. I drove it for an hour and a half last week and couldn't restart it. Just nothing - one click I think. A friend tapped on the starter and it started...but I'm not sure whether the car just cooled down at that point. Took it to the garage and they said they couldn't find anything wrong (no surprise, right?) Now I'm afraid to take longer trips.
View 2 Replies
My 2005 4.6 supercrew is worthless for short trips.....I am freezing and pick any other ford to drive.....my v10 heats up totally in 5 minutes so I know something is not right.....I have changed the thermostat....( its been like this since new ) the fluid levels are perfect....what is up ?
View 14 Replies
Well my car is back at the dealer, again. Last week they replaced the brain for the ABS and everything on the right rear. Well driving up to and back from Redding, Ca.the brakes started dragging again on the right rear.
This time the rotor had a orage tint to it from the heat when I looked at it. The gas mileage sucks and now this. If I have to take it back for a 3rd time, I am getting rid of it.
View 30 Replies
I have a 2006 4 cylinder JEEP Wrangler. Right around 50 mph the whole car starts to shake pretty violently. I have to slow down back to 40 to get it back to normal. I can seem to get past this most of the time by waiting to shift into fifth gear until after 50 mph but not always!
View 1 Replies
My GC is overheating. Started as occasionally but now increasing in frequency. I find it will being to overheat after driving on the interstate for half hour or so but I can "calm" it back down but turning on the heat. I've replaced the following:
1. coolant (no drips or leaks nor am I losing coolant over time)
2. thermostat (twice)
3. temperature sensor
4. serpentine belt and tensioner
5. radiator (last summer)
6. water pump (last winter)
I notice the fans run more often than they should. For example, after a 10 minute ride to work in the morning,. I notice the fans are running as I pull into my parking space.
View 14 Replies
I've had this checked out twice by the dealer and once by another mechanic and they say there's nothing wrong ....
First symptom: the heater will start out hot but about a half-hour into my trip into work it significantly cools down. I'm not sure if it's starting out too hot and cooling down appropriately but I think not ... it gets downright cool at 70 degrees.
Second symptom: I sometimes smell coolant in the passenger compartment, usually while I'm operating the heater. However, in these last bitter cold days I've smelled it when I get into my cold car in the garage in the morning.
Third symptom: I have a film on the inside of my windshield on the lower one-sixth or so ... it gets very cloudy, particularly when I circulate air to the windshield or turn on the AC to defog. I've asked three times to have the heater core checked and they all say it's fine.
View 3 Replies
I have an 02 Passat 1.8t that drags the brakes when I am driving to the point that they start smoking when I get off the interstate and my gas mileage is terrible. When I first observed this dragging I popped the hood and found that the check valve on the hose that connects to the end of the intake manifold had a chunk missing and was hissing. I did some research and found that this hose leads to the brake booster so i bought a new valve at the stealership and installed it and I am still having the issue.
I checked all the other hoses around that area and underneath the manifold for leaks and the only thing I found was a hole in the small hose that connects to the very front of the intake manifold that leads to the N249 thingy which i fixed but i haven't tested the brakes yet. When I start my car after it hasn't been on for a while my car does alright for about 10 minutes before the brakes start dragging again. Also pumping my brakes doesn't seem to work much.
View 3 Replies
Jeep Wrangler Owners excessive engine oil consumption [URL] .... Caused engine failure with my Jeep. Chrysler aware of problem. Local dealership stating Chrysler may not honor 100,000 mile warranty due to 1missed oil change.
View 5 Replies
Vehicle will not exceed 20mph. Vacuum leak can be heard coming from around the intake area on the driver side. Cannot detect where it is coming from. All vacuum hoses seem to be connected.
View 3 Replies
I have a 2003 rav4 with about 100000 miles on it. Over the last 4 months I have noticed that, whenever I drive half hour or longer on the highway the car starts to smell like burning rubber or burning antifreeze or something like that. I live close to work, play, and groceries, so I don't drive it that long very often. I have not noticed decreased levels of any of my fluids. No change in performance either. I've had the oil changed regularly and no problems there. I am about to drive it a thousand plus miles and would love to get this figured out before I go.
View 7 Replies
I noticed through careful investigation that my 03 GTI 1.8T (180,000 KM's or 111,850 miles) will grind 3rd when in these conditions:
1. When the car has been driving for more then half an hour and everything is hot
2. When the car is over 2800 RPM's while hot (ie. getting on a highway)
Now I know lot's of people blame syncro's and yes I could see that my car has had 8 previous owners so I can't say they all shifted perfect. But what I do know is that when I downshift from either 4th or Neutral it will never grind even when I don't Rev Match or "Blip" the throttle. So it can't be syncro's in my opinion.
So what I've done to the car to rule out some problems were:
- Change the gear oil from what ever it was before to Royal Purple 75W-90 (NO luck.)
- Then I added a short shifter and adjusted my cables properly (still No luck)
- Finally I noticed my shifter was sloppy and one of my bushings were torn so I bought 42 DD's metal bushings and the shifter did stiffen up a lot, however!!! (No luck)
I know it's not my driving technique because I watch my foot depress the clutch fully and then I gently push it into third. I also know I'm shifting correctly because I can double clutch and normally shift through every other gear properly without any grinds or clunks. Just the devilish 3rd gear.
I would like to hear the solution. I'm going to change the oil one more time to Redline MT-90 and see how that goes, but if that doesn't work I might just tear apart or get a new tranny.
View 3 Replies
I have a 1995 Jeep Wrangler Rio Grande named El Burro.I have replaced the shocks and am awaiting an alignment next week.The Jeep doesn't shake or jump all over unless I hit a bump and then it jumps all over the place.
View 15 Replies
I own a 98 jeep wrangler. Love the little jeep. But....big BUT...at random it chooses not to start, not sluggish start, dead absolutely no noise. I have spent well over 1500. dollars on new starters, batteries, ignitions, ignition cylinders you name it I have replaced it. This last time it started every time for well over a month, then one evening it just didn't so I let it set for a couple of hours as usual and then it started and we came home. I love my mechanic he is patient and doesn't make fun of me when I ask dumb questions...but this he can't figure out.
View 2 Replies
I have a 01 Jeep and the AC is not blowing cold air. When I went to get my oil changed they did a check over and said that it is in working order just lacks any freon to get it cold. So I went to get a bottle to do it myself. Doing what it said to do on the bottle I got nothing. The meter says that there is pressure in the system, but no cold air coming out. I noticed that it would engage and then stop after a second, but still will not fully engage or blow cold air.
View 5 Replies
