My 1999 Jeep Grand Cherokee sprays a very weak stream of windshield fluid for the front and back windows. Fluid reservoir is full. Where are the fluid pumps for the front and back windows? Is it hard to replace or is it a job for the professionals?
View 5 RepliesI need to know where is the radiator fan relay switch located on a 2000 jeep grand cherokee laredo. My check gauges light comes on. The temp gauge is on 260. I had it checked out. My radiator cooling fan isn't running.
View 14 RepliesI've got the feeling wire clothes hangers, duct tape, & screw clamps may be handy,;>). there appears to be a security cage around the fitting where the hose connects to the pump.
View 1 RepliesThe ambient (outside) temperature sensor on my 04 jeep grand cherokee is now stuck in the open position (it reads -40 constantly) after having body work done to it. Could this be a fuse, loose wires, or is the senor broken? Also could this have been damaged by the body shop?
View 8 RepliesI have a 2005 F-250 6.0 Powerstroke.
My washer fluid pump is not working, it was a few weeks ago but now it is broken. The Owner's Manual only has the listing fuse 33 for "cluster, 4x4, wipers". It looks like some of the older models have an actual fuse for the "washer fluid pump". I checked fuse 33 under the dash and it is ok. What fuse controls the washer fluid pump?
The pump does not make noise when activated, so I'm starting at the fuse but I don't know what the hell is going on.
I have a 2003 Jeep Grand Cherokee with about 240000 miles on the clock. Words cannot describe how impressed I am by this car. However, yesterday I noticed that the selector switch where one chooses to direct the air output has failed me. It seems to be stuck in the windshield defrost setting, unable to redirect the airflow to anywhere else. I am however still able to control the temperature as well as A/C settings. The switch felt strangely 'limp' almost as though it is no longer connected to whatever engineering or witchcraft it is attached to behind the control panel. What are your thoughts on this? Could it be as simple as some mechanical linkage that has snapped off? Just to recap: blower motor, heat and A/C are not affected by this.
View 2 Replies1968 C-850 Super Duty. Cannot find the brake fluid reservoir on this Hahn Firetruck.
View 1 RepliesSo recently I decided to add some fluid to the windshield washer tank, but when I added some, a clump of slime fell right in. Needless to say I couldn't do much about it. Now I have no fluid running through the system. What could I do to purge the junk out of the system? And where is the pump that drives the system?
I figured out I would have to remove the bumper to get to this part. In theory I could take it up to the dealership ...
Got a problem with my wifes 2016 Elantra... The washer fluid pump stopped working.
The wipers work, and their is no blockage in the fluid lines from the tank to the nozzles. I used my compressor to blow out the lines in both directions. I've done some research, and someone said if the wipers work its not a fuse issue.
I saw a video on you tube for an older Elantra, that showed the pump behind the headlight... Does that hold true for the 2016? And if so, how do I get the headlight assembly out?
I have a 2003 Explorer Sport and the windshield washer pump is not getting power. Owners manual does not show fuse or relay locations.
View 2 RepliesI have a 1999 Jeep Grand Cherokee Laredo. Some of the gears are intermittently "sticking". When I get up to 60 m.p.h., it's supposed to shift into the next gear, but sometimes it won't and the vehicle starts lurching as it comes up against the "shifting wall". Other times it won't downshift, so I leave a stop light in 2nd or 3rd gear. The lurching only occurs for the gear at about 60 m.p.h., unless I put the gear selector into "2", then it sometimes lurches there too. Several mechanics, including a transmission specialist at a local Jeep dealership (who charged me for 2 hours of "diagnostic time"), couldn't determine what is wrong. I did a transmission fluid flush, but that didn't work.
View 1 RepliesJeep grand cherokee 1999 stalls while driving. Replaced crankshaft sensor. Check engine light indicates oxygen sensor issue. After 5 to ten minutes car starts again, most of the time. When the car fails, engine cuts out and gas gauge points to empty. Only starts when the gas gauge functions properly. still having this problem.
View 2 RepliesLooking for info from Bentley manual which relay is for the blower motor, washer fluid pump and 12v outlets? They all went out on my brother's Passat. I'm thinking it must be the relay as we have tested each fuse and they all test fine.
View 1 RepliesI bought my jeep about a year ago, and have had major problems with the computer system. My car wouldn't start for days on end, and then one day would start right up. I just went ahead and replaced the whole computer, wiring, ect..and it ran fine for about 4-5 months. Once and a while the check engine light would come on, but nothing happened. Then one day my car died right in the middle of the street when I was driving it. All the lights in the dash go off and it just stalls.
Sometimes it starts back up immediately,and others I have to sit for a god 15 minutes. Sometime it'll do this 5-6 times in a day, others it won't do it at all. I noticed it does it more often when it's hotter outside. I got the check engine light checked (it comes on only once in a while) and the code said it was a cylinder 6 misfire. I took it into the shop and the checked my spark plugs and said they were fine, and they couldn't find anything. Could this be related to the new computer? What I should have checked on it?
It was running on 7 cylinders and had not been tuned in probably 50,000 miles or more. I recently bought it at auction. Changed spark plugs and 1 coil for the dead cylinder. Rear cylinder on passenger side was not firing. Compression test shows 150 psi that cylinder. Fairly loud mechanical pecking from that area which was isolated with a stethoscope. I suspect a flat cam lobe or broken rocker arm.
View 5 RepliesI have a 1999 Jeep Grand Cherokee that when you start and put in drive, it will feeling like it is stalling and sometimes backfire. It does this until I step on the gas and go fast for a couple of seconds. After that it is fine until I start again alter in the day. There were no codes when the garage checked.
View 2 Replies1999 Jeep Grand Cherokee Laredo, 4.0 in line 6 Cyl misfires when driving. I bought this about 2 months ago (200,000 miles), and when i first got it it was acting like it was misfiring when driving above 60 mph( did get codes P0301 cyl 1 misfire, and P1391 CPS) . it started to act the same way just driving in my small town. so i ended up changing the ignition coil pack and changing spark plugs, i also replaced the CPS (camshaft position sensor). and was still acting the same way. I located a TSB that said there might be a carbon build up problem preventing valves from rotating and seating.
So I used seafoam and clean up the Top, and drove it in low gear at 4500 rpm for 15 seconds or so 6 times.. initially when doing this it was cutting out (jerking) when rpms got up there. after doing this twice with about 3 weeks in between never had a problem in town with it acting up running like it should from what i can tell..
Then i took a road trip, and a 60 mph was fine, 70 mph it was fine.. so i thought it fixed the issue and all good.. but about an hour into the drive it started acting up again.. unexpectedly cutting out for a second here and there, and usually when going up hill, and when got to destination about another 40 minutes, coming to a stop light i noticed it when stopping it was running pretty rough like it wanted to die out but never actually did. never got any more check engine lights either. I'm kinda at a loss at what the issue might be, and what i need to do to fix it as i really like the vehicle
I am trying to use a ford pump to power a Hydro-boost off a diesel pickup, took everything off same truck. Started it up, ran ok for 5 mins & PS pump fluid boils. No PS box in the system, just the Hydro. Seems like the fluid is not getting out of the pump & circulating either. I figure a blocked pump discharge or blockage in the Hydro. I can shoot air backwards thru the hydro, too hot to touch the pressure side. I had the outlet nut off the pump, could I have blocked the discharge when I put it back?
View 6 RepliesMy 99 grand cherokee's heater is broken - fan blows but only cold air. I've had two mechanics tell me its probably the blend doors and will be quite expensive to repair because it requires removal of dashboard. Looking for after market repair kit which allows for a DIY fix going through the glove box? Is this a good bet to try?
View 5 RepliesI own a rear-wheel-drive 1999 Jeep Grand Cherokee. I recently had both rear axle seals and bearings replaced. At the same time I had the mechanic check U-joints, shocks, etc. The noise from the failing bearings is gone, but now I have a loud "howl" that gets louder the more I accelerate. If I take my foot off the accelerator, the sound is gone. As soon as I accelerate, the sound returns. It is barely noticeable at speeds less than 35 mph, but the howl gets increasingly louder as the speed increases.
I returned to the mechanic the same day I picked up the Jeep. We went on a road test and I was given a story about gears in the differential and that despite the noise everything was mechanically sound. Even though the sound was not present before the seals and bearings were replaced, the mechanic assured me that nothing is wrong. This howling is giving me a headache!
I have a 1999 Jeep Grand Cherokee that, upon starting in the morning, has a knocking noise coming from the front passenger-side wheel area. It only knocks when the car starts moving, and stops once I get up to 15-20 miles per hour. It ONLY does this when the car is cold. The noise does not occur throughout the day, only when I start it each morning. Is it something to do with the wheel bearing, but that does not seem to be the case.???
View 2 Replies