Jeep - Oil - Pump - Cherokee - Noises :: 2001 - Clunking With Gear Grinding Sounds Periodically Between 15 - 35 Mph?
Jan 24, 2012
My 2001 jeep cherokee sport had a transfer case boot replaced a few months ago where the "oil spinner?" is near the rear portion. Before that went out i had periodic noise that i narrowed down to the transfer case using a mechanics stethoscope. Now i have a cluncking noise with gear grinding sounds periodically between 15-35 mph. I have annecdotal evidence from another forum that it may be the oil pump in the transfere case related to a TSB, yet i cannot find this TSB. Am i on the right track? It appears that i can get an oil pump for $60 but i have to consider dropping the case myself and pulling it apart.
View 3 Replies
Advertisement
I drive a 1998 Jeep Cherokee 4x4. I lifted it with a Rubicon Express 3.5" lift and had some drive line vibrations. So, I decided to purchase a slip yoke eliminator and use a rebuilt front drive shaft for the rear. I also starting having steering issues. The pump was leaking and the gear box was shot. Other than it leaking PS fluid all of the time, it wasn't a huge issue and was steering perfectly fine. I had a friend install the SYE, new steering pump and gear box in the same day.
When I drove away, there was a slight rumble from the rebuilt drive shaft and my steering was all screwed up. I could barely turn into a parking space. U-turns were completely out of the question. I assumed the issue was that the new gear box was off center and have been waiting for my friend to have the time to redo the job.
In the mean time, I decided to investigate the rumbling drive shaft on my own. So I removed the front driveshaft and swapped it with the rear. Problem solved! The rumble is gone! I am going to rebuild a different drive shaft for the rear and in the meantime, drive without a front driveshaft. Interestingly, my steering issue has completely disappeared. I can now do tight u-turns and park without a single issue. What the heck is causing the issue?
View 16 Replies
I've a 1998 Jeep Cherokee SE 4.0In the morning when it's cold the motor sounds like it's in high rev but the jeep isn't really moving all that fast - just more noise than speed. After it warms up it has plenty of pep and can leave rubber. What is the problem with it?
View 10 Replies
1990 Cherokee 4.0 ... Well I've got a minor clunking somewhere under there that seems to vary with speed. now I have to figure out what it is. my working theories are wheel bearing, or one of the three hundred odd universals under there. perhaps a brake shoe or the transfer case. This is my first 4wd, so I don't know about transfer cases.... there is also some kind of weird double universal under there, I can t remember the name off the top of my head.
View 10 Replies
I have a low-mid pitched chunky clunking sound/feel in the front end of my jeep. It MAY be there because I drove over a cattle guard (auto gate for some of you) and one of the iron pieces popped up and hit the under of my car. on the right front underbody. Not sure what it hit. No body damage. A few days later I felt/hear clunking. Not so much on highway. Worse at slower speeds and on more irregular surfaces, bumps in streets/gravel roads.
There is a scratch on one of the stabilizer bars where it loops down near the wheel. The one on the right will move slightly when you give it a good shake. The left one is solid.
View 3 Replies
We were flagged down on the highway by a very nice fellow motorist because we were gushing coolant. It was gushing. My passenger was a guy friend who used to work as an aircraft mechanic and works on his own vehicles, so I deferred to his supposedly greater automotive knowledge when he said I didn't need to call a tow truck. We got to within 100 feet of my mechanic (about 5 miles away) when my poor Jeep conked out after losing power and making an increasingly loud clunking noise for the last 500 or so feet. We pushed it in to the auto repair bay. The engine was smoking and would not start. The mechanic replaced a worn out radiator hose, which had become disconnected from the radiator (due to swelling, I think he said?), and the truck runs. There isn't a discernible difference in the engine performance after driving it around town for the day. My question is this: is the engine likely to be FUBAR and am I just playing a waiting game until it croaks?
View 8 Replies
I have a 1999 Jeep Grand Cherokee which I bought used. Last oil change they told me that the power steering pump was leaking. The leak was not enough to be seen, but it did seem to make some noise every once in a while so I took it in to get a new power steering pump at the dealer. Two days after they put the new pump in, power steering fluid was pouring out on the driveway, it was a really big puddle of fluid. I had to put new fluid in to drive it five miles back to the dealer. They said that it needed a new line, they were not sure why it needed a new line, they guessed because of the high mileage, 164,000 miles.
I told them that my Mercury has 287,000 miles on it and has never had the power steering pump replaced or the line either. I have driven most every car I ever owned 300,000 miles and have never replaced a power steering pump or line. But anyway, when the Jeep was supposed to be ready, they told me that the new line blew up spraying fluid all over the shop as soon as they started the Jeep and they had to get new parts so it would take another day or two. My question is what caused the new line to blow? My thinking is there must have been something wrong with the new pump or with the installation, somehow it was outputting too much pressure, anything that could blow a new line, would blow the old line.
View 3 Replies
When cranking, i have to give it gas and rev it til it smooths out. Eventually it will run smoothly. When i throw it in gear, it wants to sputter and die out. If I put in D, i have to give it gas or it dies, but I can only barely touch the gas or it dies out. There is a vacuum leak in brake booster, but ive been told the headgasket could be blown.I want to know if the head gasket could be a problem and if its worth replacing the booster.
View 2 Replies
I thought my transmission was not going into 2 gear, but it is. But it ain't going into 1st gear. Just found out today.
View 2 Replies
I have a 96 Jeep Cherokee, 2wd, 4 cylinder, manual transmission, I have had some work done on it. Recently, I had the clutch redone, then I had a tune-up and the motor mounts replaced.
After the motor mounts were done, I was unable to get the vehicle into gear. My mechanic adjusted the clutch pedal and it was running as long as I did not put it into reverse. I had driven it about 3 miles from my house, parked it.
Came out to start it a couple of hours later and it would not turn over. It wanted to start but no engagement. I had to have it towed to my house where my mechanic could check it out.
Since that time, we have determined that it is not the fuel pump, we changed out the fuel injectors, replaced the coil, replaced the crankshaft sensor and it is still doing the same thing. Have gone through all the suggested remedies.
View 9 Replies
My manual transmission 1995 Jeep Cherokee today refused to go into any gear after I had stopped for a light. After pushing it to the side of the road I was about to call AAA when it went into gear and worked perfectly thereafter. This happened once before about a month ago. What could be the problem and how likely am I to get stuck for good?
View 5 Replies
Dashboard lights out, on 1999 jeep cherokee. seem string because transmission gear level lights is also out. on the floor.
View 10 Replies
I have a 1995 jeep Cherokee country that has 130k miles. I have notice that when I shift from park to drive, park to reverse, drive to reverse or vice versa It makes this thud noise after placing it in gear. Is this a sign that the transmission is about to go out ? What action should I take? By the way its a automatic transmission
View 1 Replies
Just got a 1996 Jeep cherokee with right hand drive, 73,000 miles. Drove it less than 2500 miles when had problems with it shifting out of first gear. Would rev up the rpms to 3500 to 4500 and then a large jolt before going into next gear. Took to transmission specialist who was able to get it to act up., Now he tells me that the transmission is an import??? (was manufactured here in states and sent to Japan) Can't get the codes on the machine to tell him what is wrong with the tranny., says the codes say it is ok. Now what do I do. I need this car as I am a mail carrier and it was bought for that purpose.
View 8 Replies
Is it normal to experience a distinct clunking noise when downshifting into first gear? My dealer indicates this is normal but I don't want to risk damage to the tranny if it is not normal.
View 3 Replies
My wife and I just bought a pre-owned 08 Jeep Grand Cherokee with about 60,000 miles that just started to make a whistle sound on initial acceleration and deceleration when the engine is warm and the transmission is in gear and moving. The sound does not happen with a cold engine, when the transmission is in park, or neutral. A local mechanic checked it for vacuum leaks and didn't find any. He thought it may be a dirty throttle body, so I cleaned that out really well, but the whistle didn't go away (it did make the jeep run a lot smoother!). It's difficult to pinpoint the noise since it only happens when the vehicle is actually moving.
View 8 Replies
There was one message that I found like my problem, but a little different. When I turn the key it won't start, just sounds like it is going to start. I turn the key the second time it will usually start. sometimes it takes 3 times.
View 14 Replies
I own a 2001 Jeep Cherokee with 104,000+ miles. It runs great and doesn't have any issues. However, i started it up this morning and the check engine light came on. Should this be concerning? I haven't done any real maintenance on it since it runs so well. And i guess that's my other question - what should i do to the Jeep to keep it running for another 100,000+ miles? Spark plugs? Timing belt??
View 2 Replies
I have gear noise in my 2007 Liberty 4 X 4. It sounds like it is coming from the rear axle and is more pronounced under acceleration or decelleration.
View 5 Replies
After I start up and drive my jeep around town and then shut the engin off. Then I get back inside the jeep, start it up the engin idels rough. Some times the engin light comes on. I had a coil pack installed and still the same symptoms. What do you think?
View 2 Replies
I figured out what was causing my small clunking noises in the front end.. They were faint, but you could hear them at low speeds..
Front sway bar bushes and end links.. Replaced mine with auto7 bushes and moog endlinks.. They didnt "feel" loose or wobbled but replacing these parts got rid of my clunks..
Only downside was the bushes are really hard to replace, need to remove the rack, subframe, etc..
My car has about 150k miles, and the bushes were a little oval..
View 8 Replies
