Jeep - Grandcherokee :: 2003 - A/C And Heater Control Panel Switch Is Stuck In The Windshield Defrost Setting
May 6, 2015
I have a 2003 Jeep Grand Cherokee with about 240000 miles on the clock. Words cannot describe how impressed I am by this car. However, yesterday I noticed that the selector switch where one chooses to direct the air output has failed me. It seems to be stuck in the windshield defrost setting, unable to redirect the airflow to anywhere else. I am however still able to control the temperature as well as A/C settings. The switch felt strangely 'limp' almost as though it is no longer connected to whatever engineering or witchcraft it is attached to behind the control panel. What are your thoughts on this? Could it be as simple as some mechanical linkage that has snapped off? Just to recap: blower motor, heat and A/C are not affected by this.
View 2 Replies
Advertisement
There is always something.... I just drove my girlfriend's new 2003 ranger edge home from the seller. Real nice truck. I noticed the heater selector doesn't change the air flow. It is on full blast for the defrosters, and is also trickling out of the floor and dash vents. No matter where you put the selector, thats the only place the air comes out.
The temp control seem to work OK, when you turn it on cold, you get cold air and visa versa. Even on AC and MAx AC... air out the defrosters. It's cold when you turn the temp control to cold.
I did some searching here and gather some info on checking the vac lines etc. Everything looks in place but one detail. The vac ball under the hood under the air box has 2 ports on the front end, and only one grey line going into it. The other port has what looks like a rubber boot and part of a very short vac line broken off it.
I looked, I cant find any loose vac lines. I'd like to know if this second port is suppose to have a second line on it, and where does it go? What color is it? Is this the reason the vent selector isnt working?
View 2 Replies
I have a Gen II problem with my air conditioning. The air conditioning works; however, the air is stuck blowing in the defrost setting. I think there is some problem with the Air Mix Servo. In my non Prius cars they called the part a blend door actuator. Long story short, the air will not move to the front vents or anywhere else. That said, I can't hear the servo moving at all.
View 1 Replies
My wife's '02 Explorer has developed an issue with the heat/AC. As far as I can tell, the heat is hot when it's supposed to be hot, and the AC is cold when it's supposed to be cold. But, the problem is that everything only blows out through the defrost vents, no matter what setting it is on.
I know there are other threads on this type of subject, and I have read a lot of them. I thought I had identified that actuator gizmo as the culprit, but the more I read, it didn't seem like the symptoms for that issue are exactly like mine. I want to try and fix it myself, and I'd love to take the time to read everything on the subject, but warmer weather is here and my wife wants it fixed yesterday!
This problem reminds me of the time the vacuum pump went out on my F-350 and the defrost vents were all that would work. I wish this problem would be as easy to fix as that was.
View 5 Replies
What could cause my Instrument lights to stay on for a while as well as my gauges to malfunction when the temperature is cool.? It just started doing this.
View 3 Replies
How do I remove the passenger side rear door panel to gain access to the bottom of the window to jam it in the closed position, 2004 Jeep GC. Window regulator cable broke, window slid down, I pushed the window up & shimmed it with a door stop to keep it up. Replacing the regulator & cable is very expensive & I don't care if the window works or not. I removed a screw from behind the inside door handle & from the grip cup (used to close the door) & pulled the top of the panel about 2 inches away from the door. It appears that something beside the snap-in clips is preventing the rest of the panel from popping off.
View 2 Replies
01 Jeep Grand Cherokee. I just changed the water pump and the thermostat on the Jeep but the last two days when I drove it to work, the heater was blowing cold air and the engine was getting hot, almost to the red. What do you think that I should look into about getting the problem fixed>?
View 6 Replies
I need to know where is the radiator fan relay switch located on a 2000 jeep grand cherokee laredo. My check gauges light comes on. The temp gauge is on 260. I had it checked out. My radiator cooling fan isn't running.
View 14 Replies
Have a 2005 Grand Cherokee, problem when lites are on high beam & I switch to low beam the lites turn off.When I flick the switch they come back on. Also when signaling or wipers are on sometimes lites start flashingand or go out. Any clues?
View 2 Replies
My 1999 Jeep Grand Cherokee sprays a very weak stream of windshield fluid for the front and back windows. Fluid reservoir is full. Where are the fluid pumps for the front and back windows? Is it hard to replace or is it a job for the professionals?
View 5 Replies
My 99 grand cherokee's heater is broken - fan blows but only cold air. I've had two mechanics tell me its probably the blend doors and will be quite expensive to repair because it requires removal of dashboard. Looking for after market repair kit which allows for a DIY fix going through the glove box? Is this a good bet to try?
View 5 Replies
My heater/AC blower quit working. Does not work with either heat or AC. I suspect a blown fuse but cannot find one for the blower.
View 2 Replies
Got an 01 f150 excab with the 5.4 as of lately sometimes when i turn the 1-4 blower control know it wont do anything on heat or ac than other times it will work like it supposes to?
View 2 Replies
My '01 Grand Cherokee Limited is overheating. I have changed the thermostat and ran a leak test. I am not having a leak. The temp drops when I turn on the A/C or heater. I went back to the shop that changed the thermostat and leak test. They said it was the fan control and I have to go to the dealer to reflash the program for the fan control. I made the mistake of asking the dealer to reflash, instead of having them check on the overheating problem. I'm planning on going back to the dealer to have them diagnose the issue.
View 16 Replies
1998 tahoe LT .. My truck selector switch has been acting up. when i turn the switch from defrost to AC mode it takes time before it moves the doors to the correct position. does something need lubed or do i have something that needs (or will need) replaced?
View 6 Replies
My 99 Monte Carlo LS has a problem with the ac and the heater being stuck in the defrost mode. The heater and the ac work fine but it won't switch to anything else. I heard this could be a vacuum prob. I found a hose that runs from the top of the upper intake manifold. It goes to a T then one end to the firewall and the broken end is by the battery. I don't know where the broken end goes.
View 5 Replies
I own a 1996 Jeep Grand Cherokee Laredo V8, and there has been an ongoing problem with it stalling. The check engine light is on and it reads codes about idle control sensor and 02 sensor. I spent a lot of money having both replaced, along with an processor. I had to bring my Jeep to a dealership so they could "marry" the processor to the car. The check engine light went out for about a day, then once the computer reset, light went back on. The codes still read bad O2 and idle sensor despite them being replaced.
The problem is when the car starts cold I have to keep my foot on the gas for a couple minutes or it will stall out. Once it has warmed up the car runs good. I turned the idle pin on the front of the throttle body to try to keep from having to put my foot on the gas but it still stalls. It seems like it is working better in the cold weather. My mechanic says that I may have turned the idle too far trying to fix it and that is why it is stalling.
I just want my car to run without having to warm it up every time. It wastes time and a lot of gas. Could it be something other then what I've already replaced? I don't want to keep replacing the same things and not have it fix the problem.
View 2 Replies
My wife's 08 mountaineers heater has stopped working on every setting but high it has the dual climate control with rear heat and ac I've heard there's a control module behind the glove box. Is this true and how hard is it to replace?
View 2 Replies
I was driving today and had my heater on.. and after a while the control panel went out.. no lights no nothing.
View 2 Replies
I bought a 1998 Jeep Grand Cherokee Laredo about 3-4 months ago. One problem i have is that the heat wont switch from the floor. I've heard the motor that does this is called the mode actuator, which moves a flap to direct air to different ducts, etc. I've checked all vacuum line that i could see, nothing. It is quite hard to work on as everything is literally jammed under the dash. It is also quite dangerous as I cannot defrost my windshield in the winter. I get a tiny bit of heat up to the defroster, but not a lot. Heat works very well, but cannot switch from floor. Cant even hear the little hiss that you get on other cars when you switch. I just have the basic 3 knob fan speed, directional flow, and temp knobs, as well as an A/C button.
View 6 Replies
2000 Blazer LS 4X4. 186k miles. It would seem that my heater control will only work for defrost and face-vent operation. (Just happened yesterday) When I move the controller from the off position to defrost, I can hear the system moving the flaps into position. But it no longer moves for defrost/floor or just floor control. Would changing the heater control solve this problem, or could it be a bad vacuum line?
View 12 Replies
