Jeep - Grandcherokee :: 1998 - Locating Power Steering Leak?
Feb 27, 2013
I drive a '98 Jeep Grand Cherokee Laredo, 6 cyl. engine, ~130k miles. I noted a slow loss of power steering fluid a while back and, after hillbillying it for a while (money was tight, and there was a sale on gallon jugs of PS fluid), I decided to address this problem properly and fix it. I added UV indicator dye to the PS reservoir and drove around for several days, hoping to pinpoint the leak. Well, what I found was wherever the fluid is leaking from, it's in a position to be blown by the radiator fan, turning the inside of my engine into an ultraviolet Jackson Pollock painting. (That, or I really am leaking power steering fluid from my #1 spark plug wire). Any tips on how I can pinpoint this leak?
View 6 Replies
Advertisement
I've got the feeling wire clothes hangers, duct tape, & screw clamps may be handy,;>). there appears to be a security cage around the fitting where the hose connects to the pump.
View 1 Replies
So, I have a 1995 Jeep Grand Cherokee (Orvis edition) with about 270,000 miles. It still runs great and has been really useful in the snow this winter. A couple days ago the power steering pressure hose blew. My mechanic wants to replace it, but I can get a replacement hose locally. Is there any reason I shouldn't just do this myself. Do I need to worry about the fluid sprayed around the engine? The serpentine belt is only a few months old and squeaked only a little on the three mile drive to get it home.
View 8 Replies
I have a 95' Grand Cherokee, V8 5.2L. Recently, it started overheating and was diagnosed as a head gasket issue at a shop. I ended up replacing the head gasket, thermostat, and water pump. (The radiator, top radiator hose, and radiator cap were replaced within the last year as well.) Despite the repairs, the coolant in the reservoir does not move. The Jeep overheats and there is a squealing noise coming from what may be the water pump. There is also a slight leakage of coolant near the water pump bypass hose, but does not seem to be coming from the hose itself. What else am I missing?
View 7 Replies
1998 Jeep Grand Cherokee, ~130k miles, 6 cyl. engine. Returning from a trip this morning, I glanced below my car and saw a small (~3/16 inch diameter) rubber hose dragging on the ground. I traced it back and found one end connected to the top of the front differential. (Photo below). There's at least 2 feet of hose before the break. Despite searching, I could not figure out where on earth the other end of this end connected to. It doesn't work for that what's left of the hose is long enough to reach just about anything on the driver's side of the block.
The hose doesn't leak fluid, even with the engine running. I checked oil level, transmission fluid, coolant, brake fluid, power steering fluid, and windshield cleaner (I was getting desperate, OK?)-all levels were normal with no signs of contamination. The car drives fine-I possible drove up to 200 miles before I noticed it, and made the last 20 back home with no issues. (I was driving in RWD mode though). Where this hose is supposed to run to? I'm assuming Chrysler meant it to connect somewhere.
View 4 Replies
I have a '98 Jeep Grand Cherokee 4w with a 5.2l, it has approx 145,000 miles. It leaks a little oil and when i recently checked it (level was good), it smelled of gas. It starts easy and runs great with no smoke and no knocking when shut down. I've read it could be anything from rings to a stuck injector. I drive it on short trips now, only occasionally going out of town. It is due for an oil change but I would like to have a solution before driving it more or getting the oil change.
View 11 Replies
I was driving my '98 Jeep Grand Cherokee Laredo (6cyl 4.0l 4 wheel drive) on the freeway when it, very suddenly, started shuddering badly. The check engine light came on and then started blinking. I pulled right over and shut it off. I stared it back up and the engine is misfiring badly. I had a code reader with me and it's showing three codes. A random misfire, a cyl #5 misfire, and a Cyl#6 misfire. It will sit and idle (very roughly obviously).
There was no drop in RPMs, oil pressure, voltage or anything when it happened.
I got it home and replaced the distributor cap/rotor, all six spark plugs, and the plug wires but there is no improvement. I cleared the Codes and re-read them and got the same errors again.
View 4 Replies
My mother's 1998 Jeep Grand Cherokee (60 k miles!) has developed an annoying slow drip at the rear main bearing (6 cyl). Are there any additives that are safe and might slow this? She just had the oil changed, so it's not a good time to be talking about high-mileage oil.
View 9 Replies
I drive a 1998 Jeep Grand Cherokee, 6 cylinder engine, with about 120,000 miles on it. I used a code scanner and pulled a P0138 code-bank 1 sensor 2 O2 sensor high voltage, if I'm correct. First of all, it looks like this sensor is after the catalytic converter, right? So I think I either have a bad 02 sensor or a bad catalytic converter. What are the consequences of driving around without fixing this? Will I see any reduction in fuel economy, or any potential long-term problems elsewhere?
View 2 Replies
I have a 2009 Jeep Grand Cherokee. One of the tire valves has a slow leak. I figured I could get a new valve. But, instead, the guy reminds me that the valve has the pressure sensor built in. He could put in a regular stem, but then the light on the instrument panel would never go out and I'm assuming I couldn't get through inspection like that.
View 17 Replies
I have a 1998 Gr Cherokee with an automatic tranny. It is slow to shift when cold and the overdrive shifting works reasonably well but I have been told by a reputable mechanic that the tranny needs a new tranny filter at over $1000. My latest check of the tranny fluid and the level and quality indicates both are good. Should I replace the tranny filter?
Also, for the same above vehicle, when I put the vehicle into a moderately hard turn (right and left), the front wheels audibly click and you can feel the click vibration in the steering wheel when happening.
View 3 Replies
I have a 1996 Jeep Grand Cherokee Laredo. While driving the other day the steering wheel totally locked up. It was not like just losing power steering; you could not turn the wheel at all. I had the same thing happen 3 years ago and knew that if I turned off the car and restarted it the steering would unlock. I did that, it unlocked, and I continued on my way. A few blocks later, the wheel locked up again and this time the engine died after the wheel locked up. A few blocks more and it locked up a third time, the engine died, and I could not get the vehicle to restart for several minutes. The engine would turn over but it would not start. After finally getting it to start I pulled into a parking spot and called a tow truck. The mechanics have had it for several days and can not find anything wrong. It will not repeat this behavior and no codes come up on the computer. When this happened 3 years ago the same thing happened. The mechanics had it for several days and could never find anything wrong. I've been lucky so far in that this has only happened at low speeds and at places where there was not a high volume of traffic.
View 4 Replies
I have a 99 jeep grand cherokee. Started car up and there is a shrieking loud noise. the car worked fine when i drove it yesterday. the steering wheel will not move. i looked under the hood and the steering wheel fluid is completely drained. do i just need fluid? what is the shrieking noise?? It's sunday so i'm unable to contact dealership or get the fluid that i was told i can only buy from dealership.
View 1 Replies
I've replaced fuse underhood and fuse inside door panel. I've read about in the glove box there may be a fuse there for power windows? I removed the glove box panel to find 4 relays. Nothing is marked on these relays or panel. I read the numbers off these four relays inside the glove box to the clerk and she did not show any such thing on her computer for my vehicle. can a person pop out the main driver door switch and replace that?
1995 jeep grand cherokee 4x4 6cyc
View 4 Replies
1999 Jeep Grand Cherokee Laredo, 4.0 in line 6 Cyl misfires when driving. I bought this about 2 months ago (200,000 miles), and when i first got it it was acting like it was misfiring when driving above 60 mph( did get codes P0301 cyl 1 misfire, and P1391 CPS) . it started to act the same way just driving in my small town. so i ended up changing the ignition coil pack and changing spark plugs, i also replaced the CPS (camshaft position sensor). and was still acting the same way. I located a TSB that said there might be a carbon build up problem preventing valves from rotating and seating.
So I used seafoam and clean up the Top, and drove it in low gear at 4500 rpm for 15 seconds or so 6 times.. initially when doing this it was cutting out (jerking) when rpms got up there. after doing this twice with about 3 weeks in between never had a problem in town with it acting up running like it should from what i can tell..
Then i took a road trip, and a 60 mph was fine, 70 mph it was fine.. so i thought it fixed the issue and all good.. but about an hour into the drive it started acting up again.. unexpectedly cutting out for a second here and there, and usually when going up hill, and when got to destination about another 40 minutes, coming to a stop light i noticed it when stopping it was running pretty rough like it wanted to die out but never actually did. never got any more check engine lights either. I'm kinda at a loss at what the issue might be, and what i need to do to fix it as i really like the vehicle
View 4 Replies
1994 Grand Cherokee Laredo, 100,000 miles:
Driving out to see my BF this afternoon I noticed when I accelerated it hesitated a bit. I didn't think anything of it so I let it go. Driving home was another story. I was about 5 miles from home coming up to a red light and I started to brake, the light turned green and I hit the accelerator and I got no juice, I got across the highway and started to brake and the brakes locked up, the steering wheel locked up and then I lost all power. I got the Jeep to stop (right at the exit to a train station ) I tried to turn it back on and got no juice. I just got a new battery about 3 weeks ago. I called 911 since I was stuck in the middle of the road right outside the railroad station. Officer asked me to try to crank the engine again, asked if I had gas (have 1/2 tank) and then got me pushed into a spot until I can get a tow to my house in the morning.
The car has been fine, I never put "off" gas in, try not to let the gas get below half a tank.
View 1 Replies
My jeep will randomly just loose engine power the rpms just drop off completely. Sometimes the whole car goes off but not always sometimes just engine power then it wil kick back in after a few secs...... I have been looking everywhere see that it looks like a common problem but whole bunch of fixes.
View 19 Replies
I'm wiring up some COB LED strips like dowdogg did, mounted them in the same location in the lower grill (although I put mine at the top slot, not the bottom).
I've got them mounted and wired up and grounded. I went to grab my Fluke and find an ignition wire (I want them to be on all the time, as long as the ignition is on), and my 9v battery is dead for my Fluke. I don't feel comfortable using a test light on a newer car (stories of fried ECU, BCM and deployed air bags, etc) - so I figured I would ask here.
I'm really looking for a wire in the fuse box, coming off of the junction plug (ECS or BCM, I forget). I fused the power to the lights, so that isn't much of an issue.
View 29 Replies
I've a 1998 Jeep Cherokee SE 4.0In the morning when it's cold the motor sounds like it's in high rev but the jeep isn't really moving all that fast - just more noise than speed. After it warms up it has plenty of pep and can leave rubber. What is the problem with it?
View 10 Replies
I have a problem with my jeep grand Cherokee Laredo 5.2v8 losing oil pressure when the engine reaches normal operating temperature. the jeep sat for 2 years but we got it to run. when normal engine temperature occurs, the engine drops oil pressure and stalls. I have changed fuel pump,oil pump and oil pan gasket. also ran a cleaner through the engine. it doesn't matter if its winter or summer. the only way I can keep it running is to keep my foot on the gas pedal. if I don't do this the jeep stalls. a mechanic said it was the bearings. I don't believe this because there is no knocking noise when the engine is running. it has 103663 miles on it. it has just city and highway miles on it. never has been off road.
View 18 Replies
My wife says our 2002 Grand Jeep Cherokee very rarely hesitates as it moves from first to second gear (once every week at most). I've never felt the problem, but she says its happens when from a dead stop into 2nd gear. And she said there are no other times when the vehicle hesitates (fine in every other gear). No other weird noises and the power seems fine. Its an automatic transmission and I've had the fluid and filter changed recently. What it is? Transmission? It is due for some new spark plugs... any chance it could be that?
View 4 Replies
