I keep getting this message on information center " service for wheel drive switch", I own a 95 jeep grd chero. 4.0.. Can I do this one myself or do I need a pro in shop to service? Where to start.
View 9 RepliesWhat is the solution to the "Service 4WD Switch" error message. My 1994 Grand Cherokee Laredo(4WD ALL-Time) keeps displaying this message every 2 minutes and it's so distracting. My mechanic doesn't seem to have a clue.
View 14 RepliesI bought a 1998 Jeep Grand Cherokee Laredo about 3-4 months ago. One problem i have is that the heat wont switch from the floor. I've heard the motor that does this is called the mode actuator, which moves a flap to direct air to different ducts, etc. I've checked all vacuum line that i could see, nothing. It is quite hard to work on as everything is literally jammed under the dash. It is also quite dangerous as I cannot defrost my windshield in the winter. I get a tiny bit of heat up to the defroster, but not a lot. Heat works very well, but cannot switch from floor. Cant even hear the little hiss that you get on other cars when you switch. I just have the basic 3 knob fan speed, directional flow, and temp knobs, as well as an A/C button.
View 6 RepliesThe problem is that my headlights on my 1996 Cherokee Jeep XJ switch off unexpectedly. I can get them to come back on for extended periods by fiddling with the control knob in certain ways. This is the kind where you pull out of the knob to turn the lights on, and can rotate the knob to brighten or dim the dash.
If I pull a bit harder on the knob, the lights come on; if I twist this way just so, then off they go; that sort of thing. The fuses are fine and the contacts in the fuse box are clean. High beams work great no matter what (these are controlled from the steering column). I think the problem is at the control knob.
Now, how can I keep my headlights on when I turn them on every time without having to fight the gremlins? I think my next move is to remove the bezels and so on as best I can and get in there with some proper contact cleaner to see it's just built up gunk causing havoc. If that fails, or if that's a bad idea, what's next?
I am about to begin servicing my new/old jeep. I am unfamiliar with fuel inj.
it is beginning to run a bit rough idling in drive with brake applied. It is beginning to start less easily, turning over longer before firing...
A year ago I replaced radiator, long job in the winter in an unheated garage. After radiator was successfully replaced Air bag warning light started to come on intermittently. More so in cold weather, less so as it warms up. I know you have to be very careful working on air bag system, disconnect the battery and wait 10 minutes. I have heard that this is a known problem on Jeeps, this is a 1999 Grand Cherokee with 150,000 miles. I think ti ha something to do with connector in a dash, what can I do, a car is on its last legs, will not spend money on a dealer to fix, ripped off too often during life of car. I am afraid it will not pass an Ill environmental test (not related to pollution control) I suspect it is setting a trouble code but have not checked as of yet, hasn't warmed up in Illinois yet this year.
View 2 RepliesI have a 1999 jeep cherokee 4 liter in line 6.tilt steering wheel is lock in one position. The handle that you release to move the steering wheel up or down don't have any tension on it.
View 1 RepliesOur 2007 Chevy Tahoe 4 X 4 recently displayed a "Service Four Wheel Drive" panel light a couple of days ago (upon ignition on a sunny, dry day). The light had been steady which, when we read the owners manual, indicates a problem but no immediate service required. One of the possible solutions was to remove and close the gas cap in case it had been incorrectly closed during the last gas-up. That did not work. Yesterday, during a snow storm, I tried using the 4WD. The dial would move to the different settings, but no 4WD activated and no light illuminated indicating which gear it was in (2WD, Auto, 4H, 4L). We checked the fuse for the 4WD but it is OK.
View 5 RepliesMy selector switch does not light up when engaging four wheel drive on my 98 f150,could this be my GEM module gone bad ?
View 6 RepliesI made a big mistake, I was cleaning out my truck and accidentally switched my 4 wheel drive to the 4 low position. Not knowing this I started the truck and just drove it all day. Then I noticed my mistake and now the truck will not shift into either 4 high or 4 low!
The truck drives just fine, I feel no pull when I turn to the left or right so it seems that it never did any shifting into 4 high or 4 low, so I'm looking for recommendations on maybe how to fix?
I have a 2001 f250 7.3 powerstroke it is an automatic. It has the switch on the dash to engage the 4 wheel drive. When I turn the switch nothing happens.. no lights come on or anything. it has warren locking hubs. What my problem is???
View 2 Replies2000 Jeep Cherokee Sport: Sometimes the directionals shut off after a few blinks and sometimes they don't work at all. I think I identified the area where the blinker noise comes from. It is to the left underneath the steering wheel column.
View 7 RepliesI have had no problems out of my jeep except my check engine light came on and it was a bad 02 Sensor and I was told I didn't need to replace it. Well I was driving down the highway and all of a sudden my jeep died. The radio cut off my air and I put it in neutral and I tried to start it and it would not crank. I coasted in a drive way and it cranked and them died. Now it acts like it wants to start but it wont. Replaced the fuel filter. I am getting fuel to the fuel rail. It will not start with starter fluid. I took the crank sensor off and it replaced it and it still wouldn't crank. My fuel pump makes a whinning sound. My lights come on..My windshield wipers won't. My radio doesn't work and the inside lights well I couldn't get them to go off before I before my vehicle died on me, about 3 weeks before I just took the bulbs out. Would the 02 sensor make it not start?
View 14 RepliesI am so darned sick of that lousy BUZZER in my Jeep Comanche ! Where is it and how can I TURN IT OFF ?
View 8 RepliesI live on a boat access only island, so desperate. This jeep has over 230,000 km on it. Runs well, but this year started this thing where it won't start first time crank, but always starts second or third go. Bought new battery last year, so doesn't seem to be that kind of issue.
View 3 RepliesWhat would cause a 1999 jeep cherokee 4 liter inline 6 to backfire every now and then.
View 1 RepliesJust bought a 1996 Jeep Cherokee Sport 4.0 Auto trans. The other morning my jeep wouldn't start. Power everything works, lights work, back up lights work. Starter had been sluggish so I had it tested. Tested fine. Hook the starter back up and when I attach battery it turns over and runs constantly.
I removed the ignition wire from the starter solenoid and hooked it back up and the same thing happened. So I deduced the starter solenoid was stuck. Bought a new starter and replaced my old. Old starter was tested at autozone and it worked properly there (didn't run without ignition).
I just bought the new starter anyway. Hook up battery and same thing happens--starter turns over. How would just the cable from the battery be able to turn the starter over if it is all good?
'95 Jeep Grand Cherokee Laredo 4x4 (bought used 3 years ago), The Jeep sometimes dies while we are driving it. Most of the time we can restart it right away, but others it will make the turning over sound and not "catch" & go vroom.
Other times we'll be driving down the freeway (for example) and it will do a little shutter, like it's going to die and if we push on the gas it kinda skips over the dying part.
We thought it was the fuel pump, so my father-in-law took it to a mechanic and he checked it out and said the fuel pump is fine. His assistant drove it around for a while & it never died on the (of course). So he said it was fine and suggested we got some bad fuel and told us to put in some Chevron, but later that night we drove it close to home for 20min & it worked just fine. Ate some dinner at Mom & Dad's then it wouldn't start up again.
We've changed the Fuel Filter, it has a new Radiator, New Brakes and Just got an Oil Change, we filled it up with Regular Chevron and added 'HEAT' (additive to get rid of moisture)... We are at a loss...
92 Jeep Cherokee 4wd, 4.0 motor, automatic. Several things have been done recently, new timing chain, coil, distributor and cap, map sensor, computer, cam shaft timing sensor. motor now will start and run. It runs well at idle, but the timing gets all out of whack as the RPM's increase. Is there a knock sensor on this motor, and could it cause this? If so, where is it located?
View 1 RepliesI have a 96 grand Cherokee Laredo, and the other day it just wouldn't start. The jeep will not turn over, so i started checking some things out and determined that it was not getting a spark. Since i replaced the distributor cap recently i figured it had to be the ignition coil, so i replaced that. Still no go, i tested to see if the ignition coil was getting a spark by using an ohm meter, and nothing.
So something is preventing the spark even getting that far. I do not know much about vehicles, and i have to think it is something in the electrical system (like a chip or something),possibly security system, or NSS.
Transmission not shifting into overdrive, running high on RPM's, BUT not all the time. Sometimes it does, sometimes it doesn't. Could it be an electrical Module that is causing the transmission not to shift into high gear? Had the transmission checked out several times without going inside it and they say it is fine???
View 14 Replies