Jeep - Cherokee :: Check Engine Light Came On And Oil Pressure Gauge Showing Low, Almost 0
Apr 19, 2011
I have a 1999 Jeep Cherokee Sport with 140K + and recently had an oil change. I went on a 8 hr road trip split up between 2 days (there and back). On the way home I noticed my oil pressure gauge acting funny, going up and down but not past 40. Today, I drove home from work (10 miles or so) and the check engine light came on and the oil pressure gauge was very low, almost 0. I made it home but was very nervous and noticed both today and this weekend there was smell, burning or burned type smell. What should I do? I don't really trust the garage that changed the oil and was skeptical taking it there but was in a pinch.
View 12 Replies
Advertisement
95 jeep cherokee. My oil pressure gauge sometimes jumps up to 80lbs or bobs between 40 and 80lbs. Could this be anything other than sensor or gauge itself?
View 12 Replies
I own a 2001 Jeep Cherokee with 104,000+ miles. It runs great and doesn't have any issues. However, i started it up this morning and the check engine light came on. Should this be concerning? I haven't done any real maintenance on it since it runs so well. And i guess that's my other question - what should i do to the Jeep to keep it running for another 100,000+ miles? Spark plugs? Timing belt??
View 2 Replies
My Jeep check engine light comes on man said it was a EVAC problem...is this a multiple sensor issue? yes I checked the gas cap
View 2 Replies
I have a 1998 Jeep Cherokee L6 4.0 Liter automatic with 223,000 miles.
The oil pressure usually runs around 1/8-1/4 when driving around town and now I am getting temperature spikes. I had the coolant and water pump replaced last fall when I was having similar idling issues then. My coolant isn't a perfect green color--it is a little bit grey, but it is full. I cleaned the entire throttle body last January, cleaned the IAC today, and redid the NSS this week (not that this probably matters, just being thorough in my explanation).
It seems to happen worst on hot days (of course) when idling in traffic for a few minutes and makes the air conditioned air run warmer than it should.
Is this a busted radiator? The mechanic said I did not have a leak when I had him check last week.
View 4 Replies
1999 Jeep Grand Cherokee 4.0. Check engine light will not go out. Took to Autozone , Orileys ,and Jeep Dealer. No codes found. Replaced cooling fan relay, when light first came on. Everything works fine now. Have tried myself to shut light off, disconnect batt. cables 10 min, 30 min. and other methods, no luck , still, on ? I have even traced the cooling fan relay wire to PCM, all OK.
View 3 Replies
I have a 2000, Jeep Cherokee 4.0L. The check engine light, keeps coming on, and the scan tool, shows P0300, P0301, P0302, P0303. Misfires in #1, 2 & 3 cylinder.
I replaced the Coil Pack & all spark plugs with genuine jeep parts from the dealer. What might be wrong or other things to check?
View 7 Replies
I am the second owner of a 97 Cherokee 4.0 2wd. My overdrive works now and then. my check engine light is on. I had it scanned it throws 2 codes. p0700 and p0705. It has 147k and we already replaced the entire cooling system including flushing the engine and system thoroughly . Now it has been sitting for nearly 2yrs. just not sure what direction to go.
View 3 Replies
I was driving when the truck made a terrible noise and while pulling over the check engine light went on as well as low oil pressure. I turned off truck and checked but no evidence of any leakage at all. Checked oil stick and was dry. Let sit for an hour and checked oil stick to find about 1/2" showing. Added oil to find that now it was overfull, drained oil back and stick showed proper level. Attempted to drive and it was fine until I came to a stop wherein it would stall with "low oil pressure" showing and check engine light on. Brought to shop and they said engine is very gunked up, they said they could try oil flush but probably will not work. They most likely will have to remove the valve cover and such to physically look at engine and take it from there... (I have always used type of oil stated on the cap, used synthetic and changed every 5-7k miles - showed diagnostic codes p0011, p0340, p0345 and p0021).
View 14 Replies
The tire pressure warning light has been on in my car for about a week. The dashboard computer says that the tire pressure in the front right tire is 17 psi, but when I use the pressure gauge, the reading is almost 40 psi. Is this something I should be concerned about? What could be causing this problem?
View 16 Replies
I have a 2000 Cherokee Sport and the Check Gauges Light has come on, it usually happens after during my commute and I have been on the freeway for about 10 minutes, I exit and at the first stoplight it comes on. Doesn't come on in normal around town driving, just in that situation each day. I took it in to my mechanic and twice and it still comes on, they said they replaced the oil pump. Anyway, could it be that the gauge light has to be reset? I don't see any leak after two days on the street now. I am at my wits end, before I take it to different mechanic, I'd like to see what the boards say.
View 3 Replies
Last week I was driving on the highway and noticed the oil pressure gauge showed no pressure. Limped a half mile to the mother-in-laws and called for a tow. As my truck was pulled onto the flatbed I could see oil all over the bottom of the engine, tranny, rear end, etc. Turned out to be a bad oil pressure sender, which was leaking enough oil to blow the plug off the top of it.
I replaced the sensor, cleaned the engine and under-carriage, checked oil level (which showed no loss of oil) and drove around for a week without an oil pressure gauge while I waited for a new pigtail. Put the pigtail in yesterday and drove it today for the first time since. Gauge was working, got to the bank and it was reading zero pressure again. Limped home and watched the gauge go back up quickly and then back down. This happened twice and was showing pressure when I shut it off. Checked under hood, no oil leaks and plug is still secure.
View 9 Replies
For the first ten minutes after my car is started (until it warms up), the oil gauge drops to 0 while accelerating. When I take my foot off the gas, it goes back up. After the car is warm, the gauge works fine and unless the car cools completely down, it gives me no more trouble until the next morning. We have tried:
1. Changing the sending unit (twice);
2. Changing the oil;
3. Working on the electrical contacts;
4. Cleaning all of the parts around it.
View 10 Replies
My Lexus was working fine till yesterday, but today when I started (button press) it, it started giving me a Check VSC error and Check engine light along with Slip Indicator started showing up
Took it to Autozone for the codes and got
P0015
P0304
C1201
B2799
View 7 Replies
I have a 2006 Jeep Liberty 2wd (V6-3.7L) that is showing an overheat on the temperature gauge on the dashboard. I replaced the radiator (which I noticed had pin hole leaks), the water pump, thermostat, and the temperature gauge sensor. The car is no longer running through coolant, but the temperature gauge on the dash still reads an overheat. I do not have any bubbling when the engine is cool, no white smoke, the fan turns on just fine, a/c and heater work, no visible leaks, equal heat from both rubber hoses to and from the radiator and fluid seems to be passing through them.
There is also no smoke and no weird sounds from the engine. The overheat on the gauge comes after about 10 minutes of operation and happens whether I am driving on the highway or stopped at light.The only thing that causes the temperature gauge to go down to normal is turning on the heater full blast.Is this issue just a short in a wire somewhere? Should I start thinking head gasket? If yes to head gasket, should I use the "sealants" that are out on the market as a temporary fix?
View 1 Replies
For those of you who have not purchased a new car for a while and are considering doing so in the near future I want to share the recent service experience I had for my 2015 Jeep Cherokee. I don't know if my experience was typical but I suspect it is.
I took my Jeep to the dealer for a routine service (LOF and tire rotation). The total time at the dealer was about 4 hours. Of that time, about 2 1/2 or 3 hours was spent in updating the software for the various computers. It had never occurred to me that computers were that pervasive in new cars.
Attendant to that, my Jeep has the 3.2L V6 engine, which comes with start/stop technology (when you stop at a stop light the engine shuts off and restarts when you take your foot off the brake). After the service was completed I noticed the start/stop function had stopped working. I contacted the dealer. The customer service representative spoke with the service technician, who contacted Chrysler. It seems that all of the software updates (there were a total of 6 of them) may take 3-7 days to become fully integrated into the system. I was told to wait a few days to see if the problem rectified. Sure enough, when I drove it today it had.
View 16 Replies
The Oil Gauge on the Instrument panel of my '99 Jeep Cherokee Classic is pegged fully to the right (TWICE the normal reading) when the vehicle is Stopped at a Light or stop sign. As I accelerate the needle drops down to NEARLY normal but pegs again as I decelerate to a stop. The engine sounds normal, operates like normal, no smells, oil level on dipstick is OK. What's up with this?
View 3 Replies
After having my oil changed at a local place, the oil pressure gauge showed "high." hoping it would go away, i drove for a week. it didn't... took it back to the shop and they said it was a little full which would cause it to show high pressure. That was earlier today. The gauge however has not changed. Still shows high oil pressure. I need to drive 400 miles tomorrow and am not sure if it is safe? Perhaps just a bad sensor??? I need to know if i can hit the road or not.
View 5 Replies
I purchased a 1990 Jeep Cherokee Laredo at a steal . . . I've already replaced the head gasket sealant. My biggest current concern is the fuel pressure. The car either starts up beautifully or sputters and gurgles for a good 5 seconds before finally idling normally (either occur during cold or warm starts).
The sputtering at start-up has become more commonplace as of late. If I drive away without providing a good three-to-five minute warm-up, the car will drive as normal while applying gas pressure to the peddle, then once gas pressure is no longer applied, the car dies silently; The battery stays on, but all power steering and engine power disappear and the car coast into nothingness. If I allow the Jeep to warm up significantly, it will drive as normal for hours, except for it's struggles to compensate long upward hills.
The fuel regulator has a slight leak. Worse at start-up, lessens up over time. The seal may be improperly seated, but is in physical working condition as I can tell. Spark plugs were replaced. Battery was replaced. Injectors have been tightened. There is a slight oil leak (it seems to move around a bit), but is far better since the Head Gasket was replaced. Could this be a bad fuel regulator or something else that I have missed?
View 1 Replies
The check gauges light on my 1988 Cheyenne 4x4 is coming on and the oil pressure gauge is erratic back and forth from low to high pressure.
The vehicle is a 4.3L manual. Any likely cause or where to start with troubleshooting?
View 2 Replies
I have a 2001 Chevrolet Prizm with check engine light showing PO420 and PO446 codes, what could be the problem?
View 1 Replies