I have a 2000, Jeep Cherokee 4.0L. The check engine light, keeps coming on, and the scan tool, shows P0300, P0301, P0302, P0303. Misfires in #1, 2 & 3 cylinder.
I replaced the Coil Pack & all spark plugs with genuine jeep parts from the dealer. What might be wrong or other things to check?
Brooklyn mechanic says "every Jeep Cherokee 2000 6 cyl. 4x4 has this problem--number 3 cylinder mis-fires because it can get too hot". When I return from the country to the city, unload Jeep at the apartment, then, after about 15 minutes, re-start Jeep, it bucks and rumbles and misfires with no power from motor. I pump the gas pedal, and after about a minute it settles down.
Country mechanic has done smoke tests, looked all over for any compression leak, replaced gas cap, put insulation tape over #3 cylinder, and reported that this problem is in the "data bank" of Cherokee problems, where ever that data bank is. The question is, can one live with this problem, or will it cause more problems? Why does the motor settle down after pumping the gas pedal for about a minute? I've had the starter coil replaced recently, as I was told it can get fried from too much mis-firing.
I own a 2001 Jeep Cherokee with 104,000+ miles. It runs great and doesn't have any issues. However, i started it up this morning and the check engine light came on. Should this be concerning? I haven't done any real maintenance on it since it runs so well. And i guess that's my other question - what should i do to the Jeep to keep it running for another 100,000+ miles? Spark plugs? Timing belt??
View 2 RepliesMy Jeep check engine light comes on man said it was a EVAC problem...is this a multiple sensor issue? yes I checked the gas cap
View 2 RepliesMy inline 6 engine softly stutters and misfires while driving and has the check engine light on whenever this happens. It's becoming more frequent now - 20% of the time I'm driving I'd say. The codes are 11, 12, 27, 34. I've looked up the meanings of the codes and I'm leaning towards its bad fuel injectors or a bad connector leading to the fuel rail. I have lots of bad wiring on my 93 Cherokee haha. I've fixed so far: a bad head light connector, and an exposed wire that connects to my distributor - it would swing and touch my engine block causing the engine to die.
But now I am struggling on how to fix my small stuttering engine problem. So the problem only occurs after I make a strong left hand turn such as a 90 degree or a uturn so that means a connection is being pulled to the right. It doesn't have an issue turning to the right though. I don't have sway bars on my 6" lift so there's a reasonable amount of body roll to pull on the wires etc. When I open the hood with the engine running smoothly I can touch and wiggle the front fuel injectors and sometimes I hear it softly misfire or sputter. What connectors lead up to the fuel rail?
1999 Jeep Grand Cherokee 4.0. Check engine light will not go out. Took to Autozone , Orileys ,and Jeep Dealer. No codes found. Replaced cooling fan relay, when light first came on. Everything works fine now. Have tried myself to shut light off, disconnect batt. cables 10 min, 30 min. and other methods, no luck , still, on ? I have even traced the cooling fan relay wire to PCM, all OK.
View 3 RepliesI have a 1999 Jeep Cherokee Sport with 140K + and recently had an oil change. I went on a 8 hr road trip split up between 2 days (there and back). On the way home I noticed my oil pressure gauge acting funny, going up and down but not past 40. Today, I drove home from work (10 miles or so) and the check engine light came on and the oil pressure gauge was very low, almost 0. I made it home but was very nervous and noticed both today and this weekend there was smell, burning or burned type smell. What should I do? I don't really trust the garage that changed the oil and was skeptical taking it there but was in a pinch.
View 12 RepliesI am the second owner of a 97 Cherokee 4.0 2wd. My overdrive works now and then. my check engine light is on. I had it scanned it throws 2 codes. p0700 and p0705. It has 147k and we already replaced the entire cooling system including flushing the engine and system thoroughly . Now it has been sitting for nearly 2yrs. just not sure what direction to go.
View 3 RepliesI have a 2000 Cherokee Sport and the Check Gauges Light has come on, it usually happens after during my commute and I have been on the freeway for about 10 minutes, I exit and at the first stoplight it comes on. Doesn't come on in normal around town driving, just in that situation each day. I took it in to my mechanic and twice and it still comes on, they said they replaced the oil pump. Anyway, could it be that the gauge light has to be reset? I don't see any leak after two days on the street now. I am at my wits end, before I take it to different mechanic, I'd like to see what the boards say.
View 3 RepliesEngine shutdown then starts after a few minutes....
Jeep cherokee 4.8L 2000 .....
For those of you who have not purchased a new car for a while and are considering doing so in the near future I want to share the recent service experience I had for my 2015 Jeep Cherokee. I don't know if my experience was typical but I suspect it is.
I took my Jeep to the dealer for a routine service (LOF and tire rotation). The total time at the dealer was about 4 hours. Of that time, about 2 1/2 or 3 hours was spent in updating the software for the various computers. It had never occurred to me that computers were that pervasive in new cars.
Attendant to that, my Jeep has the 3.2L V6 engine, which comes with start/stop technology (when you stop at a stop light the engine shuts off and restarts when you take your foot off the brake). After the service was completed I noticed the start/stop function had stopped working. I contacted the dealer. The customer service representative spoke with the service technician, who contacted Chrysler. It seems that all of the software updates (there were a total of 6 of them) may take 3-7 days to become fully integrated into the system. I was told to wait a few days to see if the problem rectified. Sure enough, when I drove it today it had.
My daughter has a 2003 Passat Turbo. Two weeks ago it started to run like crap with a check engine light on. I pulled the codes and it said multiple misfires. My buddy owns his own shop and said bring it down. He pulled the plugs and the spark plug holes were filled with oil. He changed the valve cover gaskets and replaced the plugs. Still ran rough with low fuel pressure so he replace the fuel pump and injectors. Still runs rough, when he pulled the air intake off there was oil in it. Could this have happened do to the valve cover gasket? The codes still read misfires. He said the turbo was full of oil also. Could the turbo be bad causing it to run like crap? Can it be rebuilt? I really don't want to go to the dealer.
View 5 RepliesI have a 2004 Accent GS. It is an automatic. I have had it for almost a year.
In early November, the check engine light came on when the temperature dropped drastically and it went off when it warmed up a bit about 3 days later. Since then it seems to come on randomly and stay on for a few days then go off (usually around once-twice a month). Then in late December I noticed that the car had trouble starting after I refueled it, the first two times I though it was because I had let the fuel get down too much. Now every time I fuel up it does this. But just the first time turning on the car and no other time after that.
The check engine light had not come on again for almost a month, and then about a week ago it came on again. I double checked all the fluids and the gas cap but that's about as far as my knowledge of cars goes. When the light has come on I have not really noticed any handling differences. However since I need to put the car through an inspection very soon it is now concerning me a bit more. What could be causing the check engine light to go on and off?
I live on a boat access only island, so desperate. This jeep has over 230,000 km on it. Runs well, but this year started this thing where it won't start first time crank, but always starts second or third go. Bought new battery last year, so doesn't seem to be that kind of issue.
View 3 RepliesI have a 2000 jeep grand cherokee that yesterday the key got stuck in the ignition and i cannot remove it. At the same time i used to have to press the brake to shift from park to any gear now it just moves freely without using the brake.
View 14 RepliesThis past week when I went to leave work my jeep would not start. It would turn over once, and then die....but if I kept my foot on the gas and kept the RPM's up it stayed running. So, I drove it home with one foot on the gas and one on the brake so it wouldn't stall out on the road. The next 2 days the same thing happened when I went to leave work. It starts fine the rest of the time, even first thing in the morning when it's cold..
View 1 RepliesLast fall I had my mechanic replace the broken air compressor on my 2000 Jeep Cherokee with a by pass. I didn't have money to replace it at the time and I still don't. I want to pick up one at a junk yard. How to do this? Where and how to learn more about maintaining and repairing my vehicle.
View 14 RepliesI have an '89 Jeep Cherokee and it idles way to high. In park it idles at from 1500-3000 after being warmed up. In drive it idles at 1300-1500. It idles at 2000 at 35 mph. We've replaced the O2 censor, the throttle positioning censor, the coolant temperature sensor, and a few other parts. None of this worked.
View 14 RepliesIn the really cold weather after I start my Jeep and it goes in Drive and it's driven for several miles when I go to put it back into Park the shifter gets hung up. It will go into all of the other gears except for Park. If I wait a while it goes back in but it can still feel like it's not smooth.
View 2 Replies2000 jeep cherokee brake lights will not work.changed the bulbs, brake switch, checked fuses, ripped the effin panels out and checked wires and grounds, ripped up rugs found the mouse nest-no mouse, no chews in wires. the parking lights work, hazard lights work?
View 2 RepliesI have tried all the tricks on the internet and still can't get the key unlocked, so I am ready to just replace the part. Is this something my son can do or is it very complicated?
View 1 Replies