Isuzu - Rodeo :: 1992 - Only Bright Lights Work
Mar 7, 2011
I've replaced the relay and bulbs for my '92 Rodeo but only the brights work when I pull my dimmer switch. How do I fix this and what is the cause of this??
View 3 RepliesI've replaced the relay and bulbs for my '92 Rodeo but only the brights work when I pull my dimmer switch. How do I fix this and what is the cause of this??
View 3 RepliesI have a 1994 Rodeo that they can't seem to diagnose what is wrong with it. I love my Rodeo but lately when I start it (and it starts very quickly every day), the gas, battery and brake lights light up and remain on during the 5 mile drive to work. It is an automatic V6. I cannot use the power windows, wipers or the heat/air while these lights are on. Okay, I can use the windows and wipers but they move so slowly.
I have tried to sit and let it warm up thinking they would go out but nothing happens - the lights stay on.
The return trip home from work, the lights usually turn off as I turn into my driveway. I have had the charging system checked and the battery and everything says it is fine and charging just right.
Another odd thing is once in a while when I am on a long drive - Interstate or country roads with no stops - the check engine light pops on. Once I remove my foot from the gas or I stop and let it idle, the light goes out only to come back on when I depress the gas pedal.
Just started two days ago... My '01 Rodeo stutters and then the Check Trans and Cruise Control Lights come on and go out about 10 seconds later.
It seems like it only happens when at lower speeds between 10-30 Mph and when first starting out on a drive.
Vehicle Info : 2001 Isuzu Rodeo V6 3.2L Automatic 2WD with 108k Miles
My new battery was draining down overnight. Thinking it wasn't charging back up properly I replaced what I'm sure was the original alternator. Now sometimes the engine lights (battery,brake & oil) flash on and off when I accelerate. So far the battery hasn't gone dead again.I also had an oil change. They put 5.7qts in the 6 cylinder engine.
View 7 RepliesI have water in the oil. I want to use blue devil, sealant. Should I flush the cooling system, running the vehicle with milky oil? or should I change the oil?
View 3 RepliesHave a 2004 Dodge Sprinter. Headlights not working unless turning on the bright lights and also left blinkers are on. At this point if bright lights are turned off then the headlights working.
View 3 RepliesI am having to replace my 94 isuzu rodeo engine because after my oil was changed by a shop, the oil pan plug came out on the freeway and the engine seized up.
View 4 Repliesgot a 2000 rodeo that dies whenever I stop for light. I have replaced plugs.fuel filter and had fuel system cleaned, also ran seafoam thru EGR and brake booster but it still dies out.
View 2 RepliesMy 02 Isuzu Rodeo will over rev before shifting into 3rd. The problem is intermittent and only happens when shifting from 2nd to 3rd. Shifting is smooth in all other gears. The car will not accelerate while the motor is revving between gears. The fluid was recently replaced.
View 18 RepliesThe Rodeo runs great, looks great, and very clean, EXCEPT when I start to accelerate from stop lights, or just before it stops, it bumps, knocks or jerks a little. Feels like the noise is coming from the rear end. what is causing this noise and how to correct the problem?
View 2 RepliesMy Rodeo stalled after hitting a nice sized rain puddle on Friday. It was mainly on the passenger side. This happened to me about 10 months ago and I had it towed to a repair center and was told it was the timing belt. Few days and $600 later i got vehicle back. Ran fine till this puddle. Is it possible this could be the timing belt again? All the research I have done has not said this was an option. I need diagnosing this problem. The vehicle has been sitting for a few days and will crank but not turn over.
View 1 Replies1999 Isuzu Rodeo V6 3.2L MT 263,500 miles 2WD
I often, but not always, hear a loud "snap" when turning left, usually when executing a 90 degree turn.
It's been happening over the past few weeks. Seems to be coming from mid-vehicle but hard to be sure from the driver's seat.
No other symptoms. No vibration, no steering wheel shake, no noise while driving. I don't feel anything when I hear it.
I originally thought it may be a U-joint, but now that I found it happens only when turning left, that seems less likely?
It's a loud snap, could it be an engine or transmission mount?
I've got a question about my 1998 Isuzu Rodeo LS. I've owned it for about a year and a half and I haven't had any complaints so far. However, about six months ago (you can see how quick I am to get on these things!) the car developed this little quirk. Whenever I get in the car and turn the key the car will try to start up but fails about half the time. It always starts on the second try but only sometimes on the first try. It seems to start easier right after I've filled up and is noticeably worse when I'm close to empty.
View 8 RepliesI have a 98 Isuzu Rodeo 3.2 V6 2 wheel drive I don't know where the crank shift position sensor is located. I don't have 310.00 to pay someone to replace this.
View 4 RepliesI have a 99 Isuzu Rodeo V6 - Auto Trans. The car operates fine, however when driving long distances - say 150 - 200 miles if I stop and try to restart within 5 minutes it will not start. It will attempt a start but choke out - and sometimes not even that - it just has the low click of the starter. Temp. gauge registers normal - not sure if it's an overheating issue - but nothing indicates that. Car will eventually restart (or at least has to date) after a 15-20 minute rest period. I had some issues early last year - had the EGR valve replaced, thought that had solved it..
View 9 RepliesI just recently acquired a 2000 Isuzu rodeo. The last owner said their girlfriend drove it with low oil, and it damaged the engine. On starting the car, there is a somewhat loud clicking/tapping noise from the engine. It speeds up if you step on the gas, and seemed to be louder with the camshaft cover off. I believe it to be an issue with a valve or cam or some other part in the head, but the person I am working ont his car with thinks the problem lies in the lower end, and wants to rebuild that.
View 1 RepliesRecently I replaced my front rotors, brake pads, bearings (inner, outer, seals, races).....all on the front. I replaced these d/t the fact that the shop told me my rotors were warped (plus the pads were worn and it's recommended that you replace the bearings at 60,000).
When braking the vehicle starts shaking and it feels like the brakes slip on and off when gripping the rotors. I thought replacing the rotors would solve this(since the old ones were warped), but it hasn't. It still does this even though all of the above mentioned are new......and I had a shop look over my work after replacing all of this and it was fine.
Neither place I've had my brakes looked at noticed any other problems....so could it be something outside of the brakes, perhaps dealing with the wheel? I do not feel any shaking when driving, even at high speeds....only when braking.
1999 Isuzu Rodeo V6 4WD
I have a 2000 Isuzu Rodeo with 230,000 miles. The A/C is cold when first turned on after start up, warm or cold engine. After about 5-8 minutes running on a sunny day, driving or at a stop, it starts blowing warm. If I shut the A/C off and leave it off for 30-45 seconds, it will blow cold again. On an overcast day it will blow cold for 15 minutes or more.
View 1 RepliesI have a 1999 Isuzu Rodeo LSE, 110, 000 miles that shakes/vibrates, A LOT, when I go over the smallest bump on the road. I purchased new tires last winter and it ran smooth for about a month then back to shake/vibrate.
View 1 RepliesI have a 1996 Isuzu Rodeo 3.2L V6 with 114,000 miles. Last night when I turned on my headlights, the left half of my instrument panel did not light up. This includes the tachometer, voltmeter, and engine coolant temperature gauge. These gauges are working properly; they are just not lighting up. The rest of the gauges on the instrument cluster are working correctly; only the left half is not lighting up. Could this mean that an instrument cluster light bulb has gone out? If so, any directions and information on replacing that light bulb.
View 8 RepliesI just changed the fuel pump on my 98 Isuzu Rodeo and now it wont start. The pump is getting power because i can hear it humming. Fuel is getting to the fuel rail, I checked the the shrader valve. I tested the battery and its fully charged but it wont start.
View 19 Replies