Recently my Infiniti G20's turn signals and hazard lights stopped working. I replaced the flasher relay and turn signal switch but it did not solve the problem. Here is the kicker or clue. The lights flash when locking or unlocking the car with the remote FOB.
View 7 RepliesI have checked the fuses for the Hazard and the Turn Signals. Both look fine. I tried replacing the turn signal flasher (which was a task in itself). After all of this it is still not working. What else could it be? Simple short?
View 2 RepliesMy 2007 F150's turn signals and hazard lights quit working. I checked the fuse and it was blown. Once I pulled the old fuse out the truck wouldn't start at all. What happened?
View 3 RepliesI just bought a 98 passat sedan v6 four days ago. When I purchased it the turn signals and hazards were working. I was driving yesterday and they went out all of the sudden. Thought it was the fuse at first, changed it, still not working. I bought a turn signal flasher relay, but the repair manual doesn't tell me which one it is so I can change it.
View 2 RepliesI have a 2006 F250 Superduty 4x4 that the brake lights hazards and turn signals have stopped working in the rear.. The middle cab brake light does not work either.. The running lights do work as well as the turn signal and all lights in the front.. I also checked the trailer plugs and both work for running brake and signal lights.. I have checked all fuses under the hood as well under the dash with a test light and i have nothing blown.. I have replaced the Brake switch as well as the flasher module under the dash and picked up a new multifunction switch (Turn signal/hazard) and that didn't work either.. I'm stumped at this point.. I have not checked the bulbs yet but wouldn't think they would all blow at the same time.. (will do this next)..
View 3 RepliesI was adding some more running lights today and tried to tie in to the front running/turn signal light. Next thing I know I hear a pop and now no turn signals, hazards or brake lights on my 99 F250 SD V10. My 3rd (center) brake light does work though when I press the brake, it's just the tail brake lights that dont work.
I can't find a blown fuse for the turn signals or brake lights (not really sure which fuse box it's in since the manual doesn't tell me what fuse is what)
I however did find what I'm guessing are the flashers behind the radio. What might have went wrong where before I start dumping money in to flashers and relays.
The next question is, can I jump in to the marker/turn signals and add another single LED light to them off the front? If I can which color wire does what?
Recently, I lost function of brake lights, turn signals, and hazard flashers. All happened at the same time. Some threads discuss flasher relays, short steering column wiring (position of steering wheel), and fuse failures.
I checked #18 fuse and a few others. All had continuity. I assumed my bulbs were all good. My hazard push-pull switch did not feel right. There didn't seem to be engagement. At this point, there was a good chance that the multi-function column switch had failed so I decided to try replacing it. I'm happy to report that this switch was the cause of all the light function failures and now, all is well again.
Removal is done by prying the key lock switch cover off,, removing three 1" Philips head screws that attach the lower column shield to the upper shield. At that point the upper shield can be completely removed. The lower shield was not totally removed because the tilt lever was left on. The switch is attached to the column with two 3/4" Torx 20 fasteners. The upper is easily accessible and the lower fastener can be removed by pulling the lower column shield down so access can be achieved. The two wiring harnesses have a conventional harness lock to depress and the connectors pull outward from the switch. Installation is the reverse of removal, noting the dowel locator and small plastic dowel on the lower shield.
The turn signals and hazard lights on my nissan sentra are working some times and all of a sudden they stop working. The problem is occuring almost every day. What could be the problem?.
View 4 Replies3 weeks ago my father (who died 2 weeks ago) gave me his 1991 Infiniti G20 which he has kept in great condition over the years with the last few being the exception. He's the original owner and I have paperwork from every repair and service it's had. Unfortunately the issue it has now started happening after he passed so I'm not going to get info about how it's been running the last couple years. Now to the good stuff.
When I got the car it was outside under a carport like always (lives near Seattle). I drove the car about 200 miles and then a couple days later I noticed the turn signal stopped working, but not only that there were several things not working. The turn signals (yet hazard lights work), the seat belt motor will not let it roll back across my chest, the blower won't work but the AC and heat still works, the rear defogger stopped, the ABS stopped, and the warning lights and sounds for doors open and seat belts were undone don't work.
Then while driving everything just "clicked" back on for about 5 minutes, then "clicked back off the rest of the drive. The next day I started the car, everything was fine but after waiting a couple minutes for the windows to get defogged everything shut off again. Driving around with foggy windows, no turn signals, and no seat belt across my chest is starting to scare me. Oh, and the problem can turn on and off without the engine on. If I just put the key into the "on" position it will sometime switch between working and not working.
I have unplugged and replugged the fuses and relays on the left side under the steering wheel, I've checked the voltage of the battery (2 years old with 7 year warranty and alternator was replaced 18 months ago) and it was about 12.4. I've tried reading the wiring diagram in the service manual without any luck figuring it out. When I took it to the Nissan dealership they did their scans and couldn't recreate the issue and charged me $100 just for doing the electrical tests.
I want this car to keep going since it has 174,000 miles and runs great (manual trans) so need to figure out whats going on. It doesn't seem like it's a loose wire because the car doesn't have to move for it to go back and forth between working and failing. It sometimes works more often if the car is kept in a garage but even then I'm not sure. At one point in the last year a couple mice got into the trunk but they have since left and I don't see anything in the manual that says they could have effected anything all the way back there.
Checked bulbs and fuses: not blown.... Is there a recall?
View 3 RepliesI just found a nice Prius C for sale with little damage to the front right corner, no frame damage or anything, just some bodywork needed. So, after it was fixed up. I brought the car back and there is weird issue that I have - turn signals and Hazard lights dont work. When I turn it on, i can hear clicks from it, but I dont see lights blinking on the dashboard and my head/tail lights dont blink as well.
View 5 RepliesThe right turn signal on my 1998 Ford Explorer recently stopped working. The flasher was making a horrible buzzing sound when I tried to signal right, but worked fine signaling left.
I just replaced the flasher, which has cleared up the buzzing noise when trying to signal right. The flasher clicks like it's supposed to, but the lights still do not flash.
Here's a summary of the current symptoms:
-Hazard lights work fineFlasher clicks; interior indicators flash; exterior lights flash
-Left right signal indicator works fineFlasher clicks; interior indicators flash; exterior lights flash
-Right turn signal does not work
-Flasher clicks
-Interior indicator stash off; exterior lights stay off
What to check next???
Car is 2000 Corolla with 58k miles. Today, I had my hazard signals on while parked when suddenly....they stopped blinking. The signal lights in the dash just stay on...they do not blink. I also verified that both front and rear lights also turns on...it just doesn't blink.
The corolla has a fuse box under the hood in the drivers side. Here is the schematic for the fusebox: [URL] .....
From what little I know about mechanics/electricity, can I just pull the wiper fuse and put it into the turn signal fuse while I wait for a new fuse? Do I need to disconnect the battery?
How to confirm this is the part I'm suppose to install: [URL] ....
I have had an ongoing issue with my 2010 Santa Fe Limited with the battery randomly being drawn down and would not start the vehicle.
I saw a post somewhere on the internet to remove the Negative connection on the fender and grind it down to the bare metal so that it has a good ground connection.
I have done that last week, but last night before turning in for the night i looked out the window and saw lights in my driveway. I went out to investigate and found that the Santa Fe's turn signal/hazard lights were all on front and back and not flashing.
I got in the vehicle and turned the lights on and off with no keys and they all went out.
I got the schematics for the Santa Fe and i believe it could be the Hazard relay that seems to be located inside the I/P Junction box or could be the Hazard Relay Control in the BCM.
Well, on our way home during my leave, the wife made the comment about halfway home that the blinkers had quit working. I assumed it was probably a fuse or relay, so we came on home. I have been looking at it for a few days now (too hot to spend too much time out crawling around under the dash ) and I am still having some trouble. My brake lights, and hazards are not working, and neither is the cruise, which was working fine while I drove before the blinkers went out.
I have no power at all to the flasher relay. I replaced the brake light switch because it was definitely worn and looked a little burned inside when I pulled it out and inspected, but still nothing. Have not found any fuses blown. Brake pressure switch fused link harness seems good with my test light. Wipers, brights, everything else on the turn signal switch works fine. Can't even get the cruise to go into diagnostic mode, it only blinks once when I try.
A friend of mine has a 2004 F150. The tail lights and the 3rd brake light are working but the rear brake lights, flasher and turn signals have stopped working. What could be wrong? I googled the problem and did find one person with the same issue in a 2001 F150. There apparently was a recall (#05S28) of the SCDS (Speed Control Deactivation Switch) but that vehicle kept blowing fuse 13. My friend checked his fuses and they were all ok,
View 14 RepliesMy brake lights, turn signals, and flasher are not working in my truck. Is it a fuse and what fuse? Could it be a relay?
View 2 RepliesI'm having problems with my front marker lights. The turn signals work but when I turn on the parking lights or headlights they don't work. They only work with the turn signals. And I can't get the front side marker lights to come on. I've tried everything...
View 2 RepliesI have a 2003 santa fe and the blinkers are not functioning but the hazard lights are working fine. I checked the fuse and that is fine. Is there someway I can take apart the handle assembly where the switch for the blinkers are? Also, sometimes they would work and other times they wouldn't so that seems like a loose connection somewhere. The indicators for the blinkers on the dash do not work either so there has to be a problem giving power to the switch.
View 8 RepliesI've got a 2001 f150 supercrew 4x4 with the 4.6. I plugged in trailer lights and now I have no brake, turn signal, or hazard lights. I've checked fuses and none are blown.
View 8 RepliesI have a 1998 Ford F150. The turn signals do not work nor the hazard flashers. When I trun on the hazard flashers(they do not come on) the turn signals will then work. Checked all fuses both under dash and in the engine compartment. With flashers turned on and using the turn signals, the relays located in engine compartment are working. It appears that the only way for the turn signals to work is to recieve power through the hazards.
View 2 Replies