have a 2003 infiniti m45...was showing the battery light; co-worker tested with a ohm meter and the reading was 12.5(before stalling); suggested the alternator was bad. Just replaced the alternator and now the ignition won't even turn over(dead as a door knob)...before the change, removed the battery(which is dead by now), followed the steps and now I'm dumbfolded...what could be wrong?
View 4 RepliesMy 2002 F150 Screw has been giving me issues when trying to start it for the last month. Sometimes it will start sometimes it won't. When I turn the ignition on the gauges all seem normal, the theft light turns solid then goes out, but engine will turn over but not start. Sometimes it will start if I leave the ignition on for 20 seconds then pull the key and try again. (this doesn't always work). I have disconnected the battery for about 2 minutes this usually works but not always.
Sometimes it will start first time with no issues. Once the the engine fires it runs fine. Another symptom is when I shut the engine off, pull the key and open the door, the chime telling me that the key is still in the ignition sounds. (but the key is in my hand)
I put a new battery in yesterday to rule that out and because the old one seemed to be getting weak. (starting issues didn't go away). I don't want to put 300+ into a fuel pump without being sure that's the problem.
I bought a 99 f350, that already had HID's in it, i found out i was running the wrong batters (weren't 800 cold crank) I just had to replace the alternator. Ever since the new alternator when i turn on my headlights my truck shuts off. IT fried my IDM and i just put a new IDM and 2 new batteries in it today. Thinking i had fixed the problem i drove around no issues, finally i was leaving someones house and turned on my lights, and truck shuts off!!! It restarts but now im trowing a code!!!! im guessing the HIDs are wired wrong and that's why its shutting down the truck but OEM IDM from ford is 1300$!!!!! brand new one installed today,
View 5 RepliesI am trying to change the alternator in my dohc but cant get it out, I am trying to remove the pulley on the crankshaft and cannot figure out how to remove it. How to get the alternator out???????
View 10 RepliesLooking for Instructions and pictures...
View 1 RepliesI have a problem with turning my key. It will not turn at all. I have taken the upper and lower part of the cover off to expose the switch and removed one screw from the ignition housing, but the internal part of the ignition switch will not come out. How do I completely remove this ignition switch. I have already removed the negative battery cable. It seems this is a continual problem with focuses. Oh, do I need a releasing tool to release the ignition switch.
View 7 RepliesI'm having a problem with my ignition switch. It won't turn and I have to turn the steering wheel for it to finally work.
View 4 RepliesI decided to change out my alternator to a high output. After researching I've decided to go with a DC Power...I'm planning more lights and a power inverter. Any recommendation on which one? I don't care what it cost just don't want to over do it, can too many amps hurt anything? Also, on my previous EX I did the big 3 upgrade. Is it the same on a 2 battery setup?
View 14 RepliesRecently my Infiniti G20's turn signals and hazard lights stopped working. I replaced the flasher relay and turn signal switch but it did not solve the problem. Here is the kicker or clue. The lights flash when locking or unlocking the car with the remote FOB.
View 7 RepliesIt was having trouble turning over for a few weeks, getting progressively worse, but we just didn't have time to look it over. Well, it finally died--now if I turn the key a couple times we got a grinding noise but mostly just nothing at all. The lights, radio, etc all turn on though so we were sure it wasn't the battery. Thinking it was the starter, we pulled that out and took it down to Advanced Auto Parts, but they ran a test on it and said it was still good. So we put that back in the car and brought them the battery instead--they tested it and said it was charging and holding voltage but not amperage, and that, that would mean the lights and things could come on but it wouldn't have enough kick to actually start the car.
So, we bought a new battery, went home, and popped it in. Still, nothing. My friend says it's not the alternator because with a fully charged battery the car would start even if the alternator wasn't right (and would just die in a couple days, at which point you'd know you needed to replace the alternator) and my car's still not starting. The last thing we tried before we gave up for the moment last night was checking fuses in the driver's side of the car and also under the hood, the handful we thought could be related to the starter, alternator, and/or battery, but they all looked good.
The only other thing I read about online with Infinitis was that if the security system was activated it wouldn't start, however, while I noticed the light for it is flashing which I'm not sure if that was normal before or not, I THINK if it is activated it would be solid red, and at any rate, I tried what I read online to unlock it (put key forward for 5 seconds, then off, repeat 2 more times, then try to start) and that didn't do anything either.
When I turn off the ignition and try to rotate the ignition switch/key to the steering column lock position it will not go all the way. It stops just before locking the steering column and I cannot remove the key. This is an automatic with a gearshift on the column. I have to reach up with my left hand to pull the gearshift lever up as if to pass the PARK position. While holding the gearshift like that the ignition switch can be rotated to lock and key removed.
I had the dealership attempt to fix this twice while under warranty with no success. After 10 years I am sick of it and would like to fix it. 2002 Ford F150 4x4 5.4L automatic on column.
I have am 1999 Infiniti i30t. My car will not crank/start up. When I turn the key there is only a clicking sound. But the car lights & hazard lights do work. What I think I'm hearing is the alternator when I try to start it. We have tried to jump start it, no success. Jump starting the battery got it going but it would only last about 5 minutes before it was dead again. When I turn the key there is just a clicking sound.
View 2 RepliesI drive an Infiniti i30. When I bought it, the guy who sold it to me told me that the car runs great but that I would have to turn the key kind of hard to get the car started. Over time, this problem has progressively gotten worse. There have been times where I'd be stuck in a parking lot for over an hour trying to get the car to start. When I turn the key, I can hear the starter clicking, and all of the dash lots and radio will come on but the car doesn't sound like its cranking or even trying to start. The weirdest thing is that the first time I drive my car in the morning it starts up just fine. It's once I turn the car off after driving somewhere and try to start it again that I have problems. I'll have to turn the key 100 times or more sometimes to get it to start if its not the first time of the day. What this could be?
View 4 Replies97 F150 4.2 auto with Simple trans pan gasket change because it was leaking and now the ignition fuse blows every time I turn the key to the on position. Ran fine before now what? can't pull code with reader with key on or off.
View 4 Replies3 weeks ago my father (who died 2 weeks ago) gave me his 1991 Infiniti G20 which he has kept in great condition over the years with the last few being the exception. He's the original owner and I have paperwork from every repair and service it's had. Unfortunately the issue it has now started happening after he passed so I'm not going to get info about how it's been running the last couple years. Now to the good stuff.
When I got the car it was outside under a carport like always (lives near Seattle). I drove the car about 200 miles and then a couple days later I noticed the turn signal stopped working, but not only that there were several things not working. The turn signals (yet hazard lights work), the seat belt motor will not let it roll back across my chest, the blower won't work but the AC and heat still works, the rear defogger stopped, the ABS stopped, and the warning lights and sounds for doors open and seat belts were undone don't work.
Then while driving everything just "clicked" back on for about 5 minutes, then "clicked back off the rest of the drive. The next day I started the car, everything was fine but after waiting a couple minutes for the windows to get defogged everything shut off again. Driving around with foggy windows, no turn signals, and no seat belt across my chest is starting to scare me. Oh, and the problem can turn on and off without the engine on. If I just put the key into the "on" position it will sometime switch between working and not working.
I have unplugged and replugged the fuses and relays on the left side under the steering wheel, I've checked the voltage of the battery (2 years old with 7 year warranty and alternator was replaced 18 months ago) and it was about 12.4. I've tried reading the wiring diagram in the service manual without any luck figuring it out. When I took it to the Nissan dealership they did their scans and couldn't recreate the issue and charged me $100 just for doing the electrical tests.
I want this car to keep going since it has 174,000 miles and runs great (manual trans) so need to figure out whats going on. It doesn't seem like it's a loose wire because the car doesn't have to move for it to go back and forth between working and failing. It sometimes works more often if the car is kept in a garage but even then I'm not sure. At one point in the last year a couple mice got into the trunk but they have since left and I don't see anything in the manual that says they could have effected anything all the way back there.
I have a 01 f250, I've only had it a couple of months. It has 300k miles on it and has its share of problems. I knew that going in and I just bought it for a work truck around the farm and honestly I don't expect it to work perfectly. But since I have had it there are times where it will not crank, it will only click under the dash and then a second click under the hood. It will do that in the mornings a lot and by the afternoon it will crank. I found that jumping the 2 larger wires on the starter solenoid bypasses the problem and it will turn over and crank. So I replaced the solenoid thinking that was the problem, but it still does the same thing. I know the batteries are good.
View 5 RepliesMy G35 has around 115,000 miles and it slows down when driving, particularly when driving uphill. RPMs reach 2-3 and car begins to drag with an occasional jerking. I've replaced all spark plugs (don't think I've ever replaced them since I bought the car used with 40,000 miles) and I notice one of the coil packs and its spark plug was oily, but then I also notice it was not connecting to the spark plug like the rest the rubber tip was ripped. I replaced the coil pack, but the issue still exist. I just got back from a test drive and this time it doesn't lose speed so much, but still trembles, especially when going uphill.
View 6 RepliesRecently noticed a hissing noise coming from the passenger front-side of the engine compartment (alternator area). The noise only appears when the car is warmed up and revved to over 2k rpm. At that point the hissing starts and does not stop even when idling. As soon as the engine is turned off (even when warm) and re-started the noise is gone (until 2k rpms).
View 2 RepliesMy 2008 Honda Accord grinds when I start it up, not every time, but usually when it's been sitting for hours. I used to think that I needed an oil change, because after I got one, the grinding went away. When it came back "Time for an oil change!" But I just got an oil change last week, and the grinding started again the next day. My dealership said it was no big deal and I could drive the car that way, it wouldn't hurt the car. What this might be and what I should do about it?
View 10 RepliesI have a 93 subaru impreza manual that when I turn the key on and push in the clutch it wont turn over. The coolant fans kick on and stay on and so i retrieved the codes and the coolant temp sensor was the dtc so I replaced the sensor and cleared the code but the fans still come on and the engine still does nothing. Also I can gear clicking noises throughout the engine compartment and dont know where its coming from.
View 8 RepliesWe have a 2004 2.4L 4 cyl Santa Fe. Turn ignition key get a click and engine will not turn over. Push key in harder and engine may start fine. If it is the key ignition switch or something else. is there somewhere I can look to see how to remove the ignition switch?
View 4 Replies