Impala - Chevrolet :: Grinding Sound From Driver Side Front When Braking
May 4, 2015
I have a 2003 Impala. Over the past couple of months I have had an occurance every so often, very random with my front driver side brake. In both rain and dry conditions, braking hard and just slowing to break I will hear what sounds like grinding when I brake, like you do when the pads are gone. Well, I have had the car in and the pads and rotor are fine, the place I took it to even test drove it and tried but couldn't get the sound. I posted here a while back on this issue and the view was that it might be the ABS, but when this occurs the ABS light doesn't come on and the sound is just coming from the driver side front. What my next move should be?
View 7 Replies
Advertisement
Back in December i purchased a 2003 Impala LS. It has about 103,000 miles on it now. Overall the car runs and drives great. However on very rare occasions I have noticed if I have to slam on the brakes or really break hard I hear a grinding sound. Now I have only heard it maybe 3 times in the time since buying the car and never hear anything under normal braking. I had the brakes checked and was told they didn't see anything wrong, but what might cause this grinding sound I have heard a few times?
View 6 Replies
I have a 2003 Impala, total mileage little of 122,000 miles, I bought the car back in Dec 2014. When I bought the car I got all the paper work on the work the dealership did on the car prior to me buying it. One of the things they did was put new brakes and rotors on the front. Since then I have replaced the backs. However after about 4-5 months I notices that from the front passenger side when I had to slam on the brakes or was braking from high speed I would hear a grinding sound coming from that area. I have taken it to two places and both have inspected both the wheels and rotor's and say they are fine, they commented that the pads were not the best but more then adequate for this car. Of course when they drove it around it didn't happen and it doesn't always happen. Both places said it could be the pads or rotors but without replacing them there is no real way to tell. How can they both be viewed as good and in good condition and I get this grinding sound from the one front wheel from time to time when I break.
View 12 Replies
About 3 months ago I started having a grinding sound from the front driver side hub area. I replaced it and it fixed the problem. I read where you should do both because he other one is soon behind it but I waited. Now I started hearing it from the passenger side too. So I replaced it today and all was good until I tested it from 4 wheel back to 2 wheel. Once I went back to 2 wheel the clicking that sounds like bearings going out to me, was back. What is it?
View 1 Replies
Alright so I'm having a problem with my 2003 Ford Explorer. I've recently noticed that when I get to above 40 mph, if my steering wheel is straight, I hear a loud kind of grinding or humming sound coming from my left driver side front. If I am going about 65 mph, it gets even louder and if I crank the steering wheel to the left, that's when it really gets noisy but as soon as I crank it to the right, the problems gone. When I do hear the hummin sound, I can feel it in the steering wheel. I have replaced al of the tires and it didn't work. Also, the car slightly pulls me to the right.
View 10 Replies
I noticed while driving my car there was a unusual rumble or grinding sound coming from my drivers side front wheel well. I get out and look I see a bunch of Fluid all over my wheel well. I look around turn my wheel around and see this fluids all on my rotors and suspension. Ive noticed couple weeks back the boots on the struts were ripped in two pieces from deteriorating or dry rotting (this was on both sides) and ive also been hearing some odd squeaking sound for over 15k miles every once in a while going over big bumps or train tracks. Struts go out at only 80k miles on their corolla? Yeah struts do usually lose their life around 60-80k miles but I've never seen them leak around that many miles. Is this a common issue?
View 5 Replies
As of late I am hearing a sound coming from the front end of my 2003 impala. It doesn't occur all the time but sounds the same each time. The sound has the sound of what a bolt that is loose hitting against a piece of steel. At first I only heard it when I excelerate from a stop. It was a quick sound and didn't always happen. Then yesterday I drove over a pair of rough train tracks and now itore often. However it continues to be a sound that does mot happen all the time.
View 12 Replies
I am having a problem with rough starts/ normal starts. This issue is intermittent. Once in a while when turning on the car I'll get white smoke and a pop noise from under the hood on the driver side. It smells electrical in nature. Other times like 80% of the time it starts normal. Also I have an issue with some of the cluster panel being lit while other are dimmed slightly. What is the cause of this problem? Where should I start to look to fix these issues? 2001 Impala LS 3.8L .........
View 4 Replies
My 79 year old father put fuel additive in his 2010 Chevy Impala. Don't ask me how much, or for how long... The Check Engine light came on. I never got a clear answer from him on what his mechanic said about it. Five to Ten fill ups later the Check Engine light went out on its own. Engine seems fine. Could this have caused damage to the engine or emissions controls? Would a computer diagnostic from a mechanic pinpoint any problems? Would you recommend a computer diagnostic be performed?
View 6 Replies
What's that noise coming from the front end driver side. About 2 months ago Firestone replaced my 06 Vibe 5 speed manual base brakes, rotors, calipers, brake line & fluid replaced. The car is still making a noise when braking at low speeds. It generally happens after the cars been driven awhile or when warm. It sounds like metal on metal scraping. I can also feel vibration in the steering wheel when braking, is it possible that the hub bearing is going. I had the bearing replaced on the passengers side 2 years ago. Doesn't quite sound like the first bearing replacement. I took it back to shop and they replaced the brakes again when they replaced and flushed the lines. The problem is by the time they get to the car it's cooled down and they don't hear the sound. Should I have the hub wheel bearing replaced or is it something else.
View 3 Replies
Every time I brake I hear a clunking noise, it happens right before I stop completely. For some reason it does not make the noise when it has recently rained or the car is wet, the noise is coming from the front drivers side. I had a mechanic check out my suspension, and he said everything was fine. I am thinking it could be a bushing, but am not sure.
View 10 Replies
At this point I'm baffled. I've been hearing a grinding/rattling noise from the driver side wheel well for a couple months now. I was positive it was being caused by a bad hub, but the problem persists. Here is what I've done so far:
replaced brake pads and rotors -- twice; once before the hub went bad and once after. The bad hub warped the driver side rotor and afterwards passenger side would not stop squealing for some reason. replaced faulty wheel hub -- The bearing was totally shot, nearly 20* of play in it, should be totally rigid replaced faulty CV axle -- I suspect vibration from the bad hub destroyed the outboard CV joint, making popping/grinding noise while turning or going over bumps filled front differential -- it was a bit low on gear oil The grinding/rattling noise shows up when driving at freeway speed (around 55mph) and gets more pronounced as speed increases. The truck does not do this under acceleration but after speeding up, the rattling is the worst at light throttle (around 2k-2.5k RPM, in 4th gear/overdrive above 55mph).
I noticed that if I shift into neutral at freeway speed, the noise continues until the truck decelerates.
So at this point my thoughts are that it could be a bad differential, but I doubt it because the noise is almost imperceptible in the passenger seat. It could be a bad differential bearing on the drivers side (sounds like a worn out bearing to me). It could be any number of things in the transfer case or transmission.
View 5 Replies
Whenever I applies a brake and the was almost stop, I always heard a strange sound from the front passenger side. What is happened?
View 8 Replies
I have a 2002 Ford Explorer Sport and after a brake job I noticed that while under braking at slow speed there would be a grinding sound on the front left. I replaced the brakes and wheel bearings the first time. After a while I ended up replacing the caliper itself but it still grinds. I don't notice any wheel shaking, pulling and it hasn't locked up although once I did notice a some smoke under hard braking but only once. I also don't hear any grinding while not braking.
View 5 Replies
I have a 1996 Honda Accord (automatic) with just over 149,000 miles. In the 5 years since I've owned it it's required little more than some new spark plugs and tune up. I currently drive about 30 miles a week, but starting tomorrow I'll be driving much, much more to a new job. Living in Chicago with awful potholes, salt, and traffic, I'm concerned about what may happen in the near future...
I've been getting a grinding noise on the front driver side for years and have never fixed it and never noticed a change...I know it's the tie rod ends/ball joints. I've been warned that the wheel could come off, and as much as I believe them and don't want this to happen, nothing has ever happened. Is this something to do since there has been no change in symptoms or car performance in a couple years?
Other than that, any tips for keeping the car in good, working order? I do oil changes, but are they really necessary every 3000 miles? I have to make it last as long as possible and actually love the car anyway!
View 9 Replies
First off I have a 2009 F150 4wd 4.6L truck...we have noticed a grinding noise on the front driver side wheel...we have replaced the auto locking hub acuator and the hub assembly but the noise is still there....it has us puzzled now not sure what it could be. I have read many different threads on this issue an it seems that it might be something to do with the vacuum. The noise is only on the driver side and only in 2wd, when its in 4wd it doesn't make the noise at all. Also while in 2wd the noise seems to go away when we let off the gas.
View 5 Replies
Driving home yesterday I noticed a grinding sound from the driver side rear of the truck. Had a look at the drum brake today and found that the cable to the adjusting lever had snapped and pieces had jammed making the grinding noise. I need to replace the cable and probably have that drum surfaced, but the pads look good.
On the passenger side the hardware is all intact but the shoes look as if they have "spider" cracks everywhere, still lots of shoe left though. What might be causing the cracks on the shoes, and do these need to be replaced? How to do rear drum brakes? (1997 4x4)
View 1 Replies
A year ago I heard occasional metal grinding noise coming from the front, sounding like front driver side. Sounded like CV joints that I heard before. The mechanic said it's transfer case/transmission problem, so I replaced the transmission but the noise came back a few days later. The mechanic said to drive it for a while and the noise may go away, if getting worse he can fix it since it has 2-year warranty.
Now a year later the noise becomes predicable and easily reproducible, I went back and asked them to check. They said it may be passenger side axle. I am feeling being manipulated.
View 1 Replies
My wife's car has a grinding type noise (like a key being burnished on a grinding wheel, but lower in pitch). We've had our regular mechanic check the braking system and he finds no irregularities and also says that he didn't see any loose items underneath the engine area. The sound wasn't one of the ones on your excellent 'noises' list, however. The noise comes from the driver side at the front of the car. The car is 2002 Honda Accord LX with 135,000 miles on it. The transmission was replaced under warranty at 70,000 miles.
View 4 Replies
I have a 2013 Elantra. There is a rubbing type noise in the driver front when braking and turning right. It only rubs(catches) in one spot. Almost like a pulsation, however doesn't pulsate. Hard to describe. Has a new wheel bearing. There are new pads and rotors (two sets of rotors). Took to my Hyundai dealer today. They can't find anything visible. They said only option is to start adjusting/replacing parts as trial and error.
View 3 Replies
I have a 2000 Impala with 215000 miles and it keeps on running. It has developed a side-to-side shutter and only happens during accelleration. It smooths out once I stop accellerating. I have had a left rear wheel bearing replaced hoping this would solve it. Not so much. It feels like it is coming from the rear of the car. There is no movement in the steering wheel. Could this be motor mounts?
View 2 Replies
