Impala - Chevrolet :: 2003 - Gas Gauge Not Working Properly After Fill Up
Sep 15, 2016
I have a 2003 Impala with about 122,000 miles on it. On my recent fill up I by accident put in mid grade over the normal unleaded, now I now that won't cause any engine issues that I am aware of, but after doing this fill up my gas gauge is not working properly. When I start the car in the morning the gauge will go to where it should given the mileage I have driven to this point but as I drive the car the gauge goes up to almost full then down some but never back to where it should be. what might be causing this floating incorrect reading by my gas gauge.
View 19 Replies
Advertisement
When I'm sitting still in traffic or going up a hill the temp gauge will go up. But it goes up real slow. You can set and watch temp gauge and it will just jump up every minute or so. And it has 2 fans on it but they won't kick on till temp gauge gets up over the half way mark. But when temp goes up i can raise the hood and the motor does not feel hot at all. What could cause this?
View 1 Replies
I have a 2003 Chevy Impala LS with 120,000 miles, equipped with sentinel lighting. Recently, the instrument cluster lights along with the lighted controls on the door panels and steering wheel stopped working leaving me unable to see the speedometer while driving at night. All controls seem work properly. I did some internet research and it appears there are several causes and/or fixes out there. I would like to have one or two more probable approaches than just throw money and time at a trial and error approach.
View 9 Replies
I am trying to troubleshoot why my heater blower, cruise control and info center above my rear-view mirror has stopped working. I am trying to confirm power to an orange wire next to the driver-side fuse box. I have confirmed no power at the fuses. I am hoping the problem is the wire box below the fuse box and not the ignition switch. I have a wiring diagram and the power feed to these three fuses is via an Orange wire. There are two Orange wires in the box, I am trying to determine which one feeds the fuses for these three devices. I have a picture of the fuse box.
View 2 Replies
I have a 2004 Chevrolet Impala. The fuel gauge is not working properly and I'm not sure what could cause the problem. I'm not sure how to explain this clearly, but it seems like the whole gauge was tilted to the right, so that when the tank is full, the arrow reads way above the "full", and when the tank is empty, the arrow is in the middle between "empty" and "full". What could cause this issue?
Sometimes, when I turn the key on and off multiple times, the gauge gets reset to normal, but after a few days it goes back to being defective.
View 8 Replies
About 90% of the time, my gas gauge on my 2005 Impala works just fine. However, sometimes on hot afternoons it has problems & it doesn't read accurately. For example, I will have a nearly full tank & the gauge will show 1/4 to 1/2 full, depending on its "mood". If I drive the car somewhere & turn it off, everything is fine after I re-start it. I have to drive it somewhere though. If I start it, turn it off right away, and re-start it, it still reads inaccurately. The car runs fine & there no warning lights are lit on the dash.
View 1 Replies
I've had this problem a while but now i want to get around to fixing it.. my boost gauge is always at 0 now and sometimes when i drive the car it starts working but it starts like sticking... like when i didn't have my chip it would go up and down really fast between 10 - 15psi... i heard from a friend that you can take it apart and re-adjust some screws or something so it works like a charm... right now its just like frozen at 0 psi when i drive it doesnt go down or up.
View 4 Replies
I have a 2009 Prius. Last summer I noticed that the outside temperature gauge was not working properly. I asked at the wonderful dealership I go to and no one knew anything.
View 10 Replies
I have a 2004 Pontiac Montana with about 107500 kms on it (VIN: 1GMDX03E24D183870) and the coolant temperature gauge is not working properly. Sometimes when I start my van, the temp gauge is pinned at MAX temp and stays there the whole trip...other times it's pinned at MIN temp...and other times it seems to work OK.
When it's pinned at MAX temp, I check the actual temp that the on-board computer is seeing, by using my OBDII scan tool...and I get about 87 degrees C when I'm halfway into my trip (i.e. - when the van is at operating temp), which seems OK. All the other analog gauges are working perfectly.
I read a lot about the issues with "connector C305" on the Internet on the Montana vans...could this be the problem?
View 14 Replies
My fuel gauge is not working properly. I ran out of gas while going down the road with the fuel gauge still at 1/4 tank. What do I do to fix this problem?
View 1 Replies
I just installed a replacement Hazard Switch because the directional "blinker" light stopped working (after only working sporadically for a while). This particular switch is probably made in China. Hazards now working normally (with a blink rate of a little better than 1 Hz .. just like it used to work). Directional "blinker" lights - however - are also working, but at a very fast rate: probably 3+Hz. Why this might be? I'm pretty sure the directionals and the Hazards blinked at the same rate with the original switch. Maybe a side-effect of a cheap Chinese switch? I did check both tail lights and they're working for both Directionals and Hazards, but can't get over the difference in flash rate between the two. Doesn't give me a good feeling that this switch will last.
View 6 Replies
I have a 2003 Impala LS with around 114,000 miles. I noticed today that the control switch that turns on the AC or heat is not fully working right. My switch has 5 levels, and on levels 1 and 2 nothing happens. But when I switch to levels 3-4 or 5 it works just fine.
My question is is fixing this going to involve removing the entire dash from the car? My guess it's a contact issue, and figure it might be pricy to get repaired.
View 5 Replies
My remote controls just stop working. 2006 Chevrolet Impala LTZ .
View 10 Replies
I inherited this car from my parents a couple years ago with about 80,000 miles. It ran great for awhile, then the air conditioner and the gauges would quit working while driving. After a few minutes they would resume working and everything would go back to normal. Now it will start sometimes and will not start at other times. I have replaced the battery two times and it seemed to work for a short period. I have had several mechanics look at it. After checking the code and replacing a fuse or sensor and replacing the ignition switch the car is still doing the same thing and no one has a clue what is going on. It seems to me that it may happen more often when going over a bump. What could be causing this?
View 2 Replies
2003 Ford Explorer fuel gauge does not show full after fill up. The Ford service stated that it can take up to 17 minutes (of running time) for the fuel gauge to show full after fill up.
View 7 Replies
My a/c recently is not blowing the same amount of air thru the cabin. Thought it was the cabin air filter because I was recently in some really dusty conditions. The compressor under the hood (and both lines) run very cold, but cabin blows cold air just low volume compared to before my dusty trip. Am told the 2004 does not have a cabin air filter. If that is true how and where is the air filtered or input? Think something is restricting my air flow causing me problems.
View 8 Replies
On my newly purchased 2003 chevy impala i believe my starter is going out. Outside of turning the key and nothing happens how does a mechanic test or verify its the starter?
View 10 Replies
My 2007 Chevy Impala has developed a brand new problem today. Driving down the block to the store, the speedometer started fluctuating wildly. I was going a consistent speed of about 10 mph in my parking lot and when I braked to a stop the speedometer started swinging all over the place, from 10 to 35 mph. It then gave me a message on the dash saying "Speed Limited to 107 MPH" and somehow killed my accelerator because the gas pedal no longer did anything. I restarted the car and the accelerator worked again for a bit and then pulled the same problem again. The speedometer is now fluctuating wildly the entire time I drive, including while stopped, but so far the message seems to have kicked on and disabled my accelerator only when slowing to a stop and accelerating out of a stop (it happened three times).
I know that the Impala's governor is set to 107 mph so I can guess why that message exists, but I wouldn't think a governor would actually kill the car even if it kicked in at the right speed.
It wasn't that long ago that we had to have our pedal position sensor resynchronized and the mechanic had mentioned that it was possible the sensor was going bad, but I don't think that would be the problem here as it seems like the car would actually have been accelerating sporadically, whereas in my case just the speedometer is swinging around despite an even speed.
View 1 Replies
Bought a 2003 impala recently and all has been great, but most recently there just is no power and when you press on the gas it boggs down lifters rattle and no forward thrust. check engine light starts flashing and if you find the sweet spot you can ease it up to speep. Fuel filter clogg? new pumb needed? or worse trans problems. Car has 161,000 miles
View 9 Replies
I have a 2003 Impala 3.4 with an intermittent starting issue. It starts perfectly every morning but after it is hot and I park it over 15 minutes or so it will sometimes not start. All the regular dash lights come on as normal but when the key is turned it does not even try to turn over, it is just silence, To get it started I have to hit the column shift lever upward several times and then it will kick right off with no hesitation. Sometimes I have to turn the key 10-20 times to get it started also. I had the battery, starter and alternator tested under load and they are all fine. It is not the security problem either that many impalas have. The only code I have is a PO 336 for crankshaft position sensors. Is there some kind of linkage in the column that could be worn that could cause this?
View 5 Replies
I replaced the thermostat, flushed the radiator and have the same problem. it can idle just fine but it gets hot driving less than 15 minutes. There are no visible leaks.
View 7 Replies
