Impala - Chevrolet :: 2000 - Starting After Lots Of Cranking
Aug 10, 2011
i've got a 2000 chevy impala 3.4 v6 E. runs great once it starts, but lately that takes a lot of cranking. it's getting spark. it's got a new alternator, battery, starter, plugs and wires (and i checked for spark already) I think it's a fuel issue but don't know where to start looking because it has no other problems. there's no smoke or noises, no misfires, or hesitations. i put in a new fuel filter. i have heard that it could be the fuel pressure regulator or maybe even a leak in the line that's causing it to not get pressure. i can't hear any sort of fuel pump sound (maybe i'm deaf) is there a way to check this without a gauge? i simply don't have one and don't have the money to take it to a shop. p.s. i recently replaced both o2 sensors, but i can't see how that would effect the starting. pump, hose, regulator, fuse?
View 4 Replies
Advertisement
02 Chevy Impala with 177,000 miles has re-starting problems for last 20,000 miles. New Battery, cleaned throttle plate, new fuel pump, check engine light on (emission problem was told to me by mechanic). Whats going on?
When the car runs it runs very well...to get the car started, just wait, sometimes 5 minutes, sometimes longer than an hour. All the time periodically cranking the engine...just does not start. But when it does start, it runs very well.
This problems occurs only after the car has started and is warm. Let it sit for a while then restarting the problem occurs.
View 3 Replies
My son has a 2000 Impala which will not start if it has been warmed up and then turned off for 30-40 minutes. If you turn it off and wait 15 minutes it will start every time - wait much longer and you are stranded. The starter sounds normal and you would think it is going to start but it won't. The car sat at the dealership for 2 weeks and they couldn't solve the problem. If the car is cold it starts every time.
View 10 Replies
My 2000 Chevrolet Impala doesn't want to start unless I tap on the throttle under the hood--battery seems okay, as the heater, radio, lights work, but starter won't even click unless I do this. Know why?
View 5 Replies
I have a 2003 Impala 3.4 with an intermittent starting issue. It starts perfectly every morning but after it is hot and I park it over 15 minutes or so it will sometimes not start. All the regular dash lights come on as normal but when the key is turned it does not even try to turn over, it is just silence, To get it started I have to hit the column shift lever upward several times and then it will kick right off with no hesitation. Sometimes I have to turn the key 10-20 times to get it started also. I had the battery, starter and alternator tested under load and they are all fine. It is not the security problem either that many impalas have. The only code I have is a PO 336 for crankshaft position sensors. Is there some kind of linkage in the column that could be worn that could cause this?
View 5 Replies
My 2004 Impala, 100+k miles, is occasionally not starting. The battery is fine, it's fairly new and we had it tested. When I crank it, I get all lights and electrics but it doesn't even make any crank noise or even try to start. I've read that the security system could cause this.
View 4 Replies
I have a 2002 impala that has occasionally not started. The problem started a couple months ago, once it started getting cold here in the midwest. Every few weeks when I turned the key, nothing would happen. It only happened occasionally, and after waiting a bit it would start normally. I did some reading and suspected it was the anti theft locking the car down. Today I tried jumping the car just to be sure it wasn't the battery, and all of the electronics were very dim. I heard a rapid clicking noise from the dash that continued even after I removed the key. The headlights were rapidly flashing, although also very dim. This continued for about a minute before stopping. I tried letting the battery charge from the jump for about 10 minutes, no change.
View 1 Replies
I have a 1982 Chevy C30 pickup with an ignition problem. When it's really cold out, 15 degrees or colder, it won't start. When I turn the key, it feels like I'm turning a piece of clay. There is NO cranking, clicking or any sound made. The accessories won't work either. The last time this happened, I heated the ignition tumbler with a heat gun and the truck started. It started one time after that. Then on a warm day it started once; then wouldn't restart. I turn the key and nothing. It had to be towed. I wondering if the problem is the ignition tumbler, where I put the key, or the ignition switch, which is located near the bottom of the steering column.
View 3 Replies
Have a 1996 Chevy Tahoe (305) Engine having engine cranking problems. It makes a slight grinding noise when normally starting. But sometimes it the noise is loud and seems to lock or seize during cranking. I tried shimming it without success, the gear even stuck in the flywheel. I had the starter rebuilt when the bendix stopped engaging the flywheel. I bought this PU second hand and the flywheel cover had been removed as if this truck has had existing starter problems. Also the flywheel teeth look ok.
View 3 Replies
My 2000 honda accord v6 wont start (150,000 miles). It feels like its cranking over just wont go anywhere from there. So it doesn't seem like an starter issue or battery issue. It has done this to me in the past a couple of times but after letting it sit there for a bit it started back up. The weather hasn't been an issue on the times it wanted to start or not start. I know a oil change is due and
The EGR valve needs to be cleaned/replaced but could those things make my car from not starting? When i put the key in the car and turn it to the II, the Maintenance required light comes on and the light for the key just keeps blinking.
View 1 Replies
i'm having a hard time starting my 2000 chevy impala. it orginal had a security plug on it. i had it removed. to start when i turn on the turn signal there was a noise, the odometer when blank, the air bag symbol appeared. the next time i tried to start the car it would do the same thing but wouldn't even turn over. sometimes you can turn the key on and wait 30 seconds, step on the brake and it may start. i have continued to try for up to 3 minutes. if you put on jumper cables sometime it will start. what is the problem?
View 2 Replies
while at stop in netural, reve engine, it seems to want to stall after it hits higher rpm?
View 1 Replies
I have 2000 chevy impala with a 3800 series 2 engine with 170,000 miles on it. I have major oil leak which starts leaking when the car is running, i cannot see from the top and when i am underneath the car , I cannot see far enough up in the there to see where it is leaking, It is not coming from the seneding unit or the oil pan,,when the car is running it just pours out oil.
View 3 Replies
My Impala hesitates at 2,000 RPMs At every speed level. My mechanic and the Chevy dealer can't figure this out.
View 1 Replies
How do you shut off the CHANGE OIL LIGHT on a 2000 Chev Impala?
View 5 Replies
I have a 2000 Accent with 90k miles. The last week or two, it takes about 5- 6 seconds of cranking to start when the engine is cold. Having had the car since new, I know that it's not normal.
The engine seems to crank strongly, and once started idles and drives well. This occurs once about every 4 starts when engine cold. Warm engine starts normal.
Changed plugs - no difference. Maintenance current per owners manual schedule.
View 4 Replies
I just replace the engine in my car and I had new plugs and wires put in as well. Ever since the new engine, the car doesn't go up hills well and it is very sluggish from a stand still position. As long as I am driving on a flat surface I am good once I get up speed. I went to autozone and I got a P0300 code. Is this a bad ignition coil or maybe a clogged catalytic converter?
View 10 Replies
My 2000 impala starts when cold, runs for 10 min and dies, i found its losing spark when warm, i changed the coil packs, control module and cam sensor and have had no changes, it dies, and doesn't start, only turns over, i leave it for 30 min er so and it starts , runs for 10 and dies....
View 4 Replies
Why does my 2000 chevy impala whistle when i accelerate? it also seems to shift hard.
View 10 Replies
I have a 2000 Impala with a 3800 V6 series 2 with 165,000 miles. The only code I had was a P0300 Multiple random misfire that occured off and on at first, Worse in the city Better on Highway. It would start running on half the cylinders and bogged down, with the check engine light flashing, after getting onto the highway it would straighten itself out at first. I thought i had water in the gas so i ran some heat through it. straightened out for a day then happened again so I thought maybe a should run some premium gas in it, The car ran like total crap until the premium was gone, so i thought maybe it's running too rich, I put 87octane in it and it ran great for a day or two, then it gradually got worse to where it would not straighten up on the highway, tried to die at stoplights and i had to drive it with 2 feet to get it home and park it. I've replaced the battery, spark plugs, wires, ICM checked good, coil packs are good, replaced fuel Pressure regulator, looked for arcing on the spark plug heat shields and it will not start. It turns over but doesn't try to ignite and when I get the slightest rumble of ignition, it backfires up through the manifold and I see a puff of gas or light smoke by the exhaust manifold.
The car had a vacuum leak around the intake manifold cover gasket and a leak on the fuel rail. I pulled the fuel rail off my impala, snugged up the rest of the intake bolts then disassembled the fuel rail, flushed it out and cleaned the injectors the best i could, then reassembled it. before i re-installed the fuel rail I hooked it up to the fuel lines outside of the engine and tried to start the vehicle. all injectors had a nice spray pattern. So i installed the rail and it still didn't start but it had more combustion than before although it's still backfiring like before. Checked the fuel pressure by turning the key on and the fuel pressure went to zero very fast. I blew the rail out with air so to make sure i didn't damage the regulator I replaced it with the old one, ran the test again with same results, so i reinstalled the new regulator. I performed the fuel pressure test a few more times while moving the fuel hoses and when i moved the back supply line the vacuum loss stopped then dropped to zero when i let off of it. So I replaced the fuel line connector and O-rings on the injectors. It no longer has a vacuum leak.
I cleaned the EGR Valve out and had no luck there, then I removed the Idle Air Control Valve-pushed the pintle in, re-ionstalled it and WooHoo! it started! Although it still ran like crap with the same random misfire I was still happy to hear it start.I pulled the plugs on it to do a compression test and all 6 cylinders have between 180-190psi so the engine is in good condition mechanically. I installed new plugs before getting the car restarted and when i removed them for the test they were covered in thick black soot after running for roughly 15 minutes max.
I have (2) 2000 Chevy Impala's so I've swapped sensors from my wifes car to see if it would fix it. I've tested the following MAP, MAF, IAC, coil packs and ECM. None of these made the car change. I believe it is a timing chain because the car has never had a new timing chain and is way overdue, but I haven't had a code for a crankshaft position sensor. Can the timing chain be bad without throwing a code? It's not out of time enough to change the valve timing because I had a good compression test but its not firing right and still has the multiple random misfire. I have not checked or received a trouble code for o2 sensors, crankshaft position sensor or cam sensor. Something has the timing retarded and is dumping extra fuel into the engine because my new plugs looked like they were in the engine for a year.
View 4 Replies
I have a 00 impala w 4t65e tranny I believe I have a p1811 code of hard and long shifting. I also need both cv axles replaced. If i replace the axles and have then dropped. Is it possible with the pcs going out, i would be able to drive 600 miles both way to a family thing without getting stranded.
View 3 Replies
