Impala - Chevrolet :: 2000 - How To Shut Off Change Oil Light
Oct 17, 2011
How do you shut off the CHANGE OIL LIGHT on a 2000 Chev Impala?
View 5 Replies
Oct 17, 2011
Advertisement
Impala - Chevrolet :: Change Oil Light Coming On At Odd Time
Car needed a new battery, second year in a row--beside the point. But it had been smelling hot and smoking like for ever since I could remember even on short drives. The mechanic said oil was all over and had to wash it all inside. It doesn't use much oil, but I did add some occasionally when I used to drive a lot. In Nov., he changed oil and overfilled about 1/2 qt at least. He thought all ok and no problem--no major leak or anything, but it still smells hot and the oil looks black and I have driven it very little and oil is at fill still as overfilled. I am estimating maybe 500 to 1000 miles driven would be TOPS. Should it be so black? The CHANGE oil light comes and stays on. I know time wise, it is time to change the oil, but it is hardly driven. Is the light controlled by time and not usage (mileages)? Should I be concerned with the black color and change light since I hardly drove it? Is it ok to drive a couple hundred till I can get it in to change? I have a trip to take.
View 2 RepliesImpala - Chevrolet :: Wheels Rubbing / Thumping Sound From Front - Couldn't Change Rotors?
My 79 year old father put fuel additive in his 2010 Chevy Impala. Don't ask me how much, or for how long... The Check Engine light came on. I never got a clear answer from him on what his mechanic said about it. Five to Ten fill ups later the Check Engine light went out on its own. Engine seems fine. Could this have caused damage to the engine or emissions controls? Would a computer diagnostic from a mechanic pinpoint any problems? Would you recommend a computer diagnostic be performed?
View 6 RepliesImpala - Chevrolet :: 2000 - Hard To Start?
i'm having a hard time starting my 2000 chevy impala. it orginal had a security plug on it. i had it removed. to start when i turn on the turn signal there was a noise, the odometer when blank, the air bag symbol appeared. the next time i tried to start the car it would do the same thing but wouldn't even turn over. sometimes you can turn the key on and wait 30 seconds, step on the brake and it may start. i have continued to try for up to 3 minutes. if you put on jumper cables sometime it will start. what is the problem?
View 2 RepliesImpala - Chevrolet :: 2000 - Starting After Lots Of Cranking
i've got a 2000 chevy impala 3.4 v6 E. runs great once it starts, but lately that takes a lot of cranking. it's getting spark. it's got a new alternator, battery, starter, plugs and wires (and i checked for spark already) I think it's a fuel issue but don't know where to start looking because it has no other problems. there's no smoke or noises, no misfires, or hesitations. i put in a new fuel filter. i have heard that it could be the fuel pressure regulator or maybe even a leak in the line that's causing it to not get pressure. i can't hear any sort of fuel pump sound (maybe i'm deaf) is there a way to check this without a gauge? i simply don't have one and don't have the money to take it to a shop. p.s. i recently replaced both o2 sensors, but i can't see how that would effect the starting. pump, hose, regulator, fuse?
View 4 RepliesImpala - Chevrolet :: 2000 Stalling After Hitting Higher RPM
while at stop in netural, reve engine, it seems to want to stall after it hits higher rpm?
View 1 RepliesImpala - Chevrolet :: 2000 - Major Oil Leak When Car Is Running?
I have 2000 chevy impala with a 3800 series 2 engine with 170,000 miles on it. I have major oil leak which starts leaking when the car is running, i cannot see from the top and when i am underneath the car , I cannot see far enough up in the there to see where it is leaking, It is not coming from the seneding unit or the oil pan,,when the car is running it just pours out oil.
View 3 RepliesImpala - Chevrolet :: 2008 Hesitates At 2000 RPMs
My Impala hesitates at 2,000 RPMs At every speed level. My mechanic and the Chevy dealer can't figure this out.
View 1 RepliesImpala - Chevrolet :: 2000 - Intermittent Starting When Warmed Up
My son has a 2000 Impala which will not start if it has been warmed up and then turned off for 30-40 minutes. If you turn it off and wait 15 minutes it will start every time - wait much longer and you are stranded. The starter sounds normal and you would think it is going to start but it won't. The car sat at the dealership for 2 weeks and they couldn't solve the problem. If the car is cold it starts every time.
View 10 RepliesImpala - Chevrolet :: 2000 3.4L - Sluggish From Standstill Position And Does Not Go Uphill
I just replace the engine in my car and I had new plugs and wires put in as well. Ever since the new engine, the car doesn't go up hills well and it is very sluggish from a stand still position. As long as I am driving on a flat surface I am good once I get up speed. I went to autozone and I got a P0300 code. Is this a bad ignition coil or maybe a clogged catalytic converter?
View 10 RepliesImpala - Chevrolet :: 2000 - Dies When Warm After Running For 10 Minutes
My 2000 impala starts when cold, runs for 10 min and dies, i found its losing spark when warm, i changed the coil packs, control module and cam sensor and have had no changes, it dies, and doesn't start, only turns over, i leave it for 30 min er so and it starts , runs for 10 and dies....
View 4 RepliesImpala - Chevrolet :: 2000 Chevy Whistle When Accelerate / Shift Hard
Why does my 2000 chevy impala whistle when i accelerate? it also seems to shift hard.
View 10 RepliesImpala - Chevrolet :: 2000 3.8L V6 - Code P0300 Multiple Random Misfire
I have a 2000 Impala with a 3800 V6 series 2 with 165,000 miles. The only code I had was a P0300 Multiple random misfire that occured off and on at first, Worse in the city Better on Highway. It would start running on half the cylinders and bogged down, with the check engine light flashing, after getting onto the highway it would straighten itself out at first. I thought i had water in the gas so i ran some heat through it. straightened out for a day then happened again so I thought maybe a should run some premium gas in it, The car ran like total crap until the premium was gone, so i thought maybe it's running too rich, I put 87octane in it and it ran great for a day or two, then it gradually got worse to where it would not straighten up on the highway, tried to die at stoplights and i had to drive it with 2 feet to get it home and park it. I've replaced the battery, spark plugs, wires, ICM checked good, coil packs are good, replaced fuel Pressure regulator, looked for arcing on the spark plug heat shields and it will not start. It turns over but doesn't try to ignite and when I get the slightest rumble of ignition, it backfires up through the manifold and I see a puff of gas or light smoke by the exhaust manifold.
The car had a vacuum leak around the intake manifold cover gasket and a leak on the fuel rail. I pulled the fuel rail off my impala, snugged up the rest of the intake bolts then disassembled the fuel rail, flushed it out and cleaned the injectors the best i could, then reassembled it. before i re-installed the fuel rail I hooked it up to the fuel lines outside of the engine and tried to start the vehicle. all injectors had a nice spray pattern. So i installed the rail and it still didn't start but it had more combustion than before although it's still backfiring like before. Checked the fuel pressure by turning the key on and the fuel pressure went to zero very fast. I blew the rail out with air so to make sure i didn't damage the regulator I replaced it with the old one, ran the test again with same results, so i reinstalled the new regulator. I performed the fuel pressure test a few more times while moving the fuel hoses and when i moved the back supply line the vacuum loss stopped then dropped to zero when i let off of it. So I replaced the fuel line connector and O-rings on the injectors. It no longer has a vacuum leak.
I cleaned the EGR Valve out and had no luck there, then I removed the Idle Air Control Valve-pushed the pintle in, re-ionstalled it and WooHoo! it started! Although it still ran like crap with the same random misfire I was still happy to hear it start.I pulled the plugs on it to do a compression test and all 6 cylinders have between 180-190psi so the engine is in good condition mechanically. I installed new plugs before getting the car restarted and when i removed them for the test they were covered in thick black soot after running for roughly 15 minutes max.
I have (2) 2000 Chevy Impala's so I've swapped sensors from my wifes car to see if it would fix it. I've tested the following MAP, MAF, IAC, coil packs and ECM. None of these made the car change. I believe it is a timing chain because the car has never had a new timing chain and is way overdue, but I haven't had a code for a crankshaft position sensor. Can the timing chain be bad without throwing a code? It's not out of time enough to change the valve timing because I had a good compression test but its not firing right and still has the multiple random misfire. I have not checked or received a trouble code for o2 sensors, crankshaft position sensor or cam sensor. Something has the timing retarded and is dumping extra fuel into the engine because my new plugs looked like they were in the engine for a year.
Impala - Chevrolet :: 2000 - Code P1811 / Hard And Long Shifting
I have a 00 impala w 4t65e tranny I believe I have a p1811 code of hard and long shifting. I also need both cv axles replaced. If i replace the axles and have then dropped. Is it possible with the pcs going out, i would be able to drive 600 miles both way to a family thing without getting stranded.
View 3 RepliesImpala - Chevrolet :: Sputter And Jerk When Start To Accelerate Past 25 Mph And Get Around 2000 Rpms
I have a 2002 Chevy Impala driving it in the city of Chicago. It's recently had the oil changed, and the transmission fluid flushed and filter replaced. This car was mine before I went off to school, and I meticulously maintained it for three years, and then my step sister inherited it. She drove it for two years, and then it sat in the driveway for a year and a half. It's got about 175,000 miles on it.
Problem: Every time I start to accelerate past 25mph and get around 2000rpms, the car starts to give out, sputter and jerk. It starts to drop off right when it should be shifting to second gear. When on the highway, even if I floor the gas peddle, it won't accelerate normally, but instead just crawls slowly to higher speeds.
It will eventually reach the higher speeds, but it takes about 5-10 minutes for it climb up from 25mph. I don't know enough about this level of car trouble to make a diagnosis myself, and would like an estimate of the cost for repairs. Also the car is getting around 19mpg on the highway, which I need to improve if I'm going to survive the $4.50/gal of Chicago gas. I'm hoping that fixing this problem will take care of that as well.
Impala - Chevrolet :: 2000 - Security Feature Activates At Start Up And Would Have To Wait For 10 Minutes?
I have a 2000 Chevy Impala and it seems that every now and then when I try to start the car the security feature activates and I have to wait 10 mins to try to start it again. On some occasions when the 10 mins are up and I try to start it the feature reactivates and I wait another 10 mins. This actually happened on a ferry ride and I held up the offloading of vehicles. My question is, Will a remote starter installation alleviate this issue? If not. What can I do?
View 5 RepliesImpala - Chevrolet :: Engine Hot / AC Off Indicator Light Came On
2010 Chevy Impala: hat should I expect to hear from a mechanic?
View 7 RepliesImpala - Chevrolet :: 2002 - Check Engine Light Is On
my 2002 chevy impala has had the check engine light on for a while now i took it to a shop and he said my engine was bad. I asked for the codes he got he said he just told me my engine was bad why do I need codes. I talked to another mechanic this week and he said he'd look at it, that it might not be that because I should of got a print out for what I paid for. SO I got a oil change today and when i left I saw in the comments that they put class 2 oil pan leak and a class 2 transmission leak. Could that be why my check engine light is on? How bad is a class 2 transmission leak?
View 10 RepliesImpala - Chevrolet :: Code P1404 / Service Vehicle Soon Light Comes On
I got a code reading of P1404 on a 2000 Impala from the parts store, but they can't say for sure what it means. What this would be? The service vehicle soon light comes on.
View 3 RepliesImpala - Chevrolet :: Check Engine Light Coming On - Oil Leak
Went in due to the check engine light coming on and found out I had a oil leak in both oil cooler lines they wanted to charge me 350 per line and 200 for labor which brings the total to 900. Are they over charging me if not is there a cheaper fix for them? 2007 impala 3900 v6....
View 7 RepliesImpala - Chevrolet :: 2002 - Blinker Light Stopped Working?
I just installed a replacement Hazard Switch because the directional "blinker" light stopped working (after only working sporadically for a while). This particular switch is probably made in China. Hazards now working normally (with a blink rate of a little better than 1 Hz .. just like it used to work). Directional "blinker" lights - however - are also working, but at a very fast rate: probably 3+Hz. Why this might be? I'm pretty sure the directionals and the Hazards blinked at the same rate with the original switch. Maybe a side-effect of a cheap Chinese switch? I did check both tail lights and they're working for both Directionals and Hazards, but can't get over the difference in flash rate between the two. Doesn't give me a good feeling that this switch will last.
View 6 Replies