Ignition - Starters :: 1997 Grand Marquis Engine Turning Over But Fails To Start
Nov 28, 2014
We have an 1997 Mercury Grand Marquis. It isn't driven very much -- only about 25,000 miles total. Lately it has been having problems when we try to start it. Sometimes it starts right up, and sometimes it needs a few tries. When it fails, we can hear the engine turning over, but don't get to ignition.
We drive this car a couple of times a month. Is it possible this issue is related to the infrequent use?
Could this be something more serious? What do we even ask the mechanic to look at?
View 7 Replies
Advertisement
2000 Grand Marquis transmission shutters when driving. It does it sporadically when about 50 mph or above. I read in a filter catalog in a parts store that a fluid change to a specific fluid would fix this problem as it was common in Crown Vic, Grand Marqs and Lincolns. I asked a couple of shops/mechanics and they had never heard this and was reluctant to change fuild saying that it may do more harm than good. Any recommendations?
View 9 Replies
What could be ready to go south and what kind of money?
View 7 Replies
I've been fixing things here and there (hub bearing, struts, etc.). My latest repair is the water pump, it was howling for a few seconds during cold starts; I just replaced it today, hopefully this unit lasts for a long time.
A few days ago, I noticed this hissing noise after I turn the engine off at normal temp. Since there was a leak from the radiator drain, I thought that was it and didn't care about it. I just installed a new o-ring on the drain cock along with the new water pump. Test drove the car and it turns out the noise is still there, is it normal or not, I didn't put much attention before.
The noise can be heard from underneath and above the engine, it kinda seems to be coming from the intake BUT I find it weird since I installed a new upper intake manifold in november of 2013. It's a Dorman unit and I followed all the instructions from the kit and the workshop manual. Lower intake manifold gaskets were replaced back in november 2009 after the engine was rebuilt because of a cracked head (not sure what type did the mechanic use, back then I didn't know much about repairs). It's hard to believe that these gaskets have failed already. I also replaced the coolant elbow almost two years ago after the belt tensioner assembly failed.
View 12 Replies
Starting one time in January, the SUV would have all ACC power but failed in every attempt to crank or turn. Nothing happened whatsoever when the key turned. No dim in the lights, the battery was fine. After about 30 minutes it started right up.
The issue started again this week, occurring twice. Both times while the vehicle had been sitting for more than 4 hours. I'm unsure what the issue is. I took it to Autozone to have them try and diagnose it to no avail.
View 10 Replies
I have a 2007 Honda Accord v6 3.0 L Coupe and I have a problem with the start up. I just bought a brand new battery for my car so I know it's not the battery. Anyway, when I turn the key in the ignition (normally) I cannot get the car to turn on, it makes an electrical screeching sound. However, when I quickly turn the key, the car turns on. I want the car to turn on normally but do not know the specific problem. I replaced the starter with a family member not too long ago, could it be that the starter was not installed correctly?
View 3 Replies
Our Honda Odyssey will have an occasional delayed start where you turn the key but no sound occurs. All the lights come on like normal and the automatic doors can all close and open without any issues. Originally we didn't know that we could eventually get the car to start by turning and holding the key in the start position. It happens every couple days to couple weeks and without holding the key in the on position it will be anywhere from 30 minutes to 3 days before the car will start normally again. We've spent about $1,000 at the Honda dealer to have the battery, battery cables, starter, and starter relay replaced but we're still having the problem.
View 2 Replies
My 3.0 L Honda Accord won't start the way it should. I've included a video of the situation. I need to figure out what I need to replace. [URL] ....
View 4 Replies
I have a 1994 F150 XLT 5.0 . The problem i am having is when I turn the ignition on I hear the fuel pump come on [both front and rear tanks] and it should stop when the system is pressurized but it does not,and the truck then fails to start. Intermittantly the pump does stop and the truck starts up.
There is fuel at the rail and there is spark,i have changed the filter ,fuel pressure regulater and the pump relay to no avail.
View 4 Replies
I have a 2006 Acura RSX with an auto transmission that is having problems starting. The electronics work (ie lights, stereo, auto-locks etc) and the engine starts to crank when the ignition is engaged, but it sputters out and doesn't turn all the way over even with a jump start. The battery tested positive and none of the fuses are blown, how this could be fixed?
View 10 Replies
I have a '96 Honda Civic DX model, manual transmission. I replaced the battery, sparkplugs, distributor last summer. Yesterday, hottest day yet this spring, my car wouldn't start. When cranked, the lights came on the dash, the fuel line was running, the check engine light blinked, but then no ignition. Left it overnight, started up fine this morning. Took it to a shop,Mechanic said battery and alternator were good and a replaced starter later, I took it home. Driving home, the idle dropped way too low (no tach) and almost stalled the car (battery light came on) when I pushed in the clutch. Now when I turn it on, it starts, idles regular, then the idle drops again.
View 3 Replies
Having a little issue here with my 2000 buick regal. There is an occasional instance where my car won't start for a while, then after several attempts, itll start up. When I turn the ignition key, it will not even attempt to turn over. I can't hear any clicking noise, but the lights/radio/ac will work . I know I know, it takes a lot more to start the motor than those things. What gets me most is the randomness of it, and it will eventually work without me really doing anything. I figure if it were a bad battery then it wouldn't start up at all after several attempts. I can see a bad battery connection being an issue if I moved the car and it started working, but I can sit there and just keep turning the switch on and off and that seems to be enough most of the times.
Usually it will come on within 5-10 minutes, and if I knew it would always come on in that amount of time, it wouldn't be a big issue. But, once it took over an hour before it came on again. It usually does it during the day and after I've been driving it a while, but not always. Just last night it did it for a few minutes and I hadn't driven it all day and it was at night (temp was in the mid 70's, usually hotter than that a good amount during the days) I've checked the fuses and relays and they seem to be working.
View 14 Replies
1999 Ford Taurus V6 DOHC Battle Wagon. It will not start. It is barely turning over so I started with the battery. Battery is good so I then cleaned all connections to the starter with no change. Still turning over but only barely. Took the starter off and had it tested at O'Reilly's and the starter is also good according to them. I guess my next step would be to start replacing the wiring from battery to starter? After that I am not too sure on a direction to go. On a side note, my cousin did not think it was very funny when I told him that the title was already signed and that it was his problem now.
View 4 Replies
This question concerns starting our 1997 Dodge Grand Caravan with 170K. The problem started about a week ago. When turning the key to start the engine, nothing would happen. No click, no noise, no engine turnover. By turning the key to off and then back on several times, the starter would kick in normally. The starter has never been replaced and I don't recall any electrical work ever being done on the car. I take it to our mechanic about every 2 years for a tune up and replacement of belts and hoses as needed.I have a friend that is a good shade tree mechanic and he is willing to replace the starter.My question is: Is the problem most likely a bad starter and if so, is replacement by my friend a reasonably easy task.
View 2 Replies
My truck's been having an occasional hard start, meaning the engine cranks strong but it fails to catch and then sputters. The 2nd start attempt usually fires up with no issues and then runs perfectly otherwise.
MPG's haven't changed, fuel filter was changed 15K ago. Air filter is clean. Plugs were changed about 10K ago. I always use Shell/Chevron gas. MAF sensor looked clean when I took it out so I didn't do anything to it.
This is starting to happen more frequently, maybe once every few weeks and I get a feeling it's the start of something. I've found myself waiting a few seconds for the fuel pressure gauge to come up before turning the key to start reliably. In the past, I could simply flick the key and it fires up the first time.
I see posts talking about the fuel pump module above the spare tire. What are symptoms of that going bad? Any pending codes that might be stored?
I'm about to get myself a scanner since I need one sooner or later. Which specific PID's to check while debugging this?
View 6 Replies
I have a 2000 Ford Explorer XLT. V6, 4x4
At very low speeds (5-10 mph), attempting to accelerate while turning (like coming out of a parking lot OR out of a curve) the transmission fails to engage. I hit the gas, the RPMs go up, but it doesn't get into gear. I will let off the gas, give it a couple seconds, hit the gas again and usually it engages. Sometimes I will have to repeat this step a second time. This problem started very slowly and has gradually gotten worse. It happens about once a day.
Concerned, I took it to the local Ford dealership and they have thus far changed/flushed the transmission fluid and replaced the filter. The mechanic said he found no metal shavings in the fluid, which might indicate grinding gears. They also said there were no codes coming up pointing to a transmission problem. It is still having the same exact issue however. The trouble now is they cannot "verify" the problem. The mechanics have put 40+ miles on it in similar driving scenarios and it will not act up for them.
After a couple weeks of back-and-forth, I'm really frustrated. My understanding is that they're "not sure" it is a transmission problem. They don't really want to open up the transmission case until they have a place to start. It should either be something mechanical with the transmission or a problem with the computer that controls the transmission, right? After getting off the phone with the mechanic today he said it might be a sticky throttle body?
View 14 Replies
My 2002 F150 Screw has been giving me issues when trying to start it for the last month. Sometimes it will start sometimes it won't. When I turn the ignition on the gauges all seem normal, the theft light turns solid then goes out, but engine will turn over but not start. Sometimes it will start if I leave the ignition on for 20 seconds then pull the key and try again. (this doesn't always work). I have disconnected the battery for about 2 minutes this usually works but not always.
Sometimes it will start first time with no issues. Once the the engine fires it runs fine. Another symptom is when I shut the engine off, pull the key and open the door, the chime telling me that the key is still in the ignition sounds. (but the key is in my hand)
I put a new battery in yesterday to rule that out and because the old one seemed to be getting weak. (starting issues didn't go away). I don't want to put 300+ into a fuel pump without being sure that's the problem.
View 1 Replies
My grand voyager 1997 plymouth 3.3 looses fuel pressure overnight... It won't start until I crank it for 5 min or longer... I checked with fuel gauge tester, and while it runs it reads 50lbs, after hours it drops to 0 ... Injectors don't leak ... What's up with this van?
View 3 Replies
I just recently picked myself up a 13' Corolla CE! Love it but have found some quirks that Im just wondering if this is normal with other 13' owners. Car has roughly 3000km on it so far.
-When I start the car, it almost sounds like my speakers 'pop' once I let off turning my ignition. Its not a extremely loud pop, but loud enough to make one think, "what the heck was that?" Have others had that issue
-Recently, its been a bit colder here (-3 Celsius). I have noticed it takes roughly 5 minutes of continued driving for the engine to warm up to normal operating temperature. Is that normal? Should it warm quicker than that? Its almost like the thermo is stuck slightly open.
View 4 Replies
I have a 97 grandam 3.1 The engine idles rough but runs fine when you give it the gas. It shows no codes.
View 6 Replies
I am a proud owner of '97 Grand Prix GTP, it has always been a great car with really low maintenance for me. A few days ago I noticed a mild fuel smell and I checked the gas cap, the external fuel filter, etc... Then I lifted the hood and I saw that one of the two fuel lines that run between the firewall and the brake fluid reservoir had a seepage leak in front of the factory loom that secures both lines before going over the supercharger and on to the fuel rail. A fuel leak needs to be repaired immediately, so this is where I am so far.
I noticed that the leaking fuel line is actual a rubber/plastic fuel hose that is covered by a plastic heat proof cover that protects the hose. It runs from the firewall to the fuel rail along side another fuel line of the same size (a supply & return line I believe). Just before going over the supercharger they both have quick connect metal ends that meet two metal fuel lines that end up at the fuel rail. My current issue is that this plastic/rubber hose section of fuel line is discontinued and no longer available to order according to my local GM parts dealer. The way I see it, hunting down this part can be Plan A and Plan B can be duplicating this hose by making it with high pressure fuel injection hoses and the appropriate quick connect fittings.
View 1 Replies
