So my Honda Civic has been flashing my check engine light, which is telling my my cylinders are misfiring. I checked the ignition coils by removing them while the car was running and cylinder 2 and 3 I can remove and it doesn't change how the car runs. I put a new ignition coil In and that doesn't work so it isn't the ignition coils, what it could be?
View 8 RepliesI have a 2004 Honda Civic, and my phone and my Bluetooth unit are (sometimes) plugged into the cigarette lighter (euphemistically renamed the 12V Power Adapter). Problem is, when I shut off the car, the power adapter shuts off, depriving my phone and/or Bluetooth unit of a sometimes much-needed charge. My Suburban keeps the adapters on even when the power is shut off, and I love it.
View 9 RepliesMy car is a 1998 Honda Civic. The left turn signal blinks at double speed when the headlights are off. When the headlights are on, it blinks at half speed. Should I replace the left-sided bulbs? Or the turn signal relay? Or something else? None of the bulbs are out in the front or rear.
One other fact: If the hazards are on with headlight OFF everything blinks in synchrony. If the hazards are on with the headlight ON the front blinkers flash alternating (left-right-left etc).
1996 ford explorer xlt 4.0. One day it worked fine the next day it would not start. When I turn the key there are no dash lights or exterior lights, nothing. There is also no crank over no noise of any kind. I checked all my fuses, I had one in my power distributer. It was for my premium sound, amplifier ect. I cant check the relays I don't have the correct tools. I was thinking maybe the pcm relay has gone bad? I tried jumping the car as well and nothing happened at all either.
View 19 RepliesI plan on moving the engine/drivetrain from my 1986 F350 460 to my 1996 F250. I also want to move over the 1986's ignition system with a Duraspark 2 setup.
Although I could just cut in the easiest places to remove the wiring for later reuse I am looking for where to make the cuts, what to take and what to scrap. Alternatively I am also asking if there are aftermarket or OEM replacement sets out there are aren't a ton of money. The current harness in the 1986 has been sprayed with engine oil and cooked for 27 years so I am looking at alternative options if there are any.
I have a 1.8i golf 3.... I am Getting the ticking noise from the engine/head, not really sure what it is. I went to one mechanic who said it was the hydraulic lifters which i did change but no difference.
the noise gets louder when i accelerate even when parked, what i have noticed is when I accelerate when driving the noise gets louder and when i put my clutch in to change a gear the noise starts to drop but makes some kind of a winding noise.
I have a 1997 Toyota Hilux (unleaded, not diesel) and I'm looking for input as she keeps breaking down but no one is able to figure out the problem. While in gear and driving, the gas stops engaging and the speed slowly drops. The car stutters while slowing down but then if I switch gears or rev the engine it will stop. After some time this continues to happen more frequently (at all speeds) until the car eventually stops and dies. Try to restart and the engine will turn over but not start. After sitting for a night or so, though, she starts up and runs just fine. Thus no mechanics have been able to solve the issue!
Could be a fuel problem as the exhaust pipe makes a banging sound when this happens, but it could also be electrical.
I have a 99 Honda civic LX 4 cyl. There is an oily residue in the coolant reservoir an on the fill tube but when the radiator is opened the coolant is clean. The car is using oil but not running rough or hot. There is no tailpipe smoke or evidence of leakage. I am planning to do a compression check and look at the plugs.
View 5 RepliesI have a 2007 Honda Accord v6 3.0 L Coupe and I have a problem with the start up. I just bought a brand new battery for my car so I know it's not the battery. Anyway, when I turn the key in the ignition (normally) I cannot get the car to turn on, it makes an electrical screeching sound. However, when I quickly turn the key, the car turns on. I want the car to turn on normally but do not know the specific problem. I replaced the starter with a family member not too long ago, could it be that the starter was not installed correctly?
View 3 RepliesAny COMPLETE headlight switch wiring diagram? Everything I find online only shows 2-3 wires in each sub connector, nothing with all wires and colors, and what they do. and of course the factory service manuals no longer work on my new computer. the switch and associated wires went up in smoke 2 hours ago, and this truck is my only means of transportation rite now. what i need is headlight wiring with colors so i can temporary hook up a toggle switch to have lights until the new switch and connectors come in next week. I went to pull the switch and connectors out of the parts truck, but of course that does not have fog lights so it uses different switch and connections.
View 14 RepliesMy 3.0 L Honda Accord won't start the way it should. I've included a video of the situation. I need to figure out what I need to replace. [URL] ....
View 4 RepliesI'm getting a weird code on my engine it's p1298 which is electric load detector circuit high input and I'm also getting 3 misfire codes but the car runs great what can I do to fix these.
View 10 RepliesI have a 2007 e350. I installed a battery isolator and I believe I need to run a wire from the ignition circuit to the exciter post on the isolator. I found the Power Distribution Panel under the hood (drivers side) which has a fuse in slot #7 (60 amp Maxi Fuse) listed as Ignition Switch/Accessory Delay. What is the best way to tap into this?
Also, I have 8 gauge wire which I ran from the isolator to the batteries. I am second guessing this now and wondering if I should go with thicker wire?
Pulled up to customers home and took key out and engine kept running. Disconnected battery, engine and aux turned off. Then Connected battery and power came on as if the key was in. Then put key in and turned with no change in power or engine trying to turn. Disc battery, put key in first then connected battery and truck started. Last stop took key out as well as disc batt and engine stayed on this time. repeated steps above several times to get back. Looking for narrowing the problem,possible ignition key cylinder, actuator or possible bad circuit.
View 4 RepliesJust got a 66 f100. Some one cut out the ignition. It has a toggle switch that doesn't seem to do anything, turned it to on and used a screwdriver to short the solenoid and it did not crank. I think I counted 9 cut wires in the area of the ignition counting 2 for the toggle. My other 61-66 trucks seem to just have five wires? So I can remove an ignition from one of these parts trucks, but might there be a difference since the gauges are unique to 1966 ?
Started to take the ignition out of my 62 f600 but i hate to cut wires but i must since there is no remnant of an ignition in the 66 f100. If I can match the five wires i should be ok. Just putting a battery in i have headlights, tailights and dash lights. Solenoid and cable to starter look horrible so i bought a new cable. I think i have a good solenoid or two? I didn't even get a spark when i shorted the solenoid with a screwdriver....
I have a 77 ford truck with a 351 ,the ignition system keeps shorting out, killing spark. If i replace the starter solenoid, it works for a while, then goes out again. I have replaced 4 solenoids this month. What could be shorting the solenoid out? Had the truck for 8 yrs. now, never had a problem with it till now. It has a mallory dist. it was in when i bought it.
View 7 RepliesI bought a 1952 F1 that is mounted on a 1978 E350 chassis.( 351W )
It has all the 78 wiring installed. When cranking engine, it will not start, unless you release key to run position. You have to get engine turning over, and then quickly release key to start. Checked back of switch, not losing voltage at ignition post while cranking...
My 77 F150 Ranger with a 400 in it didn't wanna start up at all. It wouldn't even crank or click like if the battery was dead. Then I tried again this morning and it cranked once then melted a red wired with I think a black or gray tracer, on the ignition. (I put a new solenoid on a couple months back and the positive also melted a bit by the solenoid but didn't pay any attention to it.) I'm just wondering what could be wrong with it to make it do that and how to fix it. Also when I went to put gas in it (it's on a slight hill making it lean to the driver side) it was empty but no fuel would go down the filler neck, then it started to gurgle and spit it out some. I was told it was vapor lock but I thought vapor lock happens when it's hot.
View 3 RepliesOur Honda Odyssey will have an occasional delayed start where you turn the key but no sound occurs. All the lights come on like normal and the automatic doors can all close and open without any issues. Originally we didn't know that we could eventually get the car to start by turning and holding the key in the start position. It happens every couple days to couple weeks and without holding the key in the on position it will be anywhere from 30 minutes to 3 days before the car will start normally again. We've spent about $1,000 at the Honda dealer to have the battery, battery cables, starter, and starter relay replaced but we're still having the problem.
View 2 RepliesHaving problems with their door locks attempting to activate when turning the ignition key? If so, how can I correct it or make repairs.
View 4 Replieshere its is i have a 1986 ford f350 6.9 aftermarket turbo set up i was driving it then i went over rail road tracks lost all power to fuse box no headlights no interior lights no ignition power batteries are good so now when i turn key nothing lights up it just killed my whole truck....
View 7 Replies