Hyundai - Elantra :: Noise Coming From Front Wheel - Bearing Cracked
Oct 19, 2013
I have a 2013 Elantra, new in January, 6600 miles on it, and I took it in to the dealership today because it was making funny noises this week from the left front wheel; the noise gets faster as I drive faster. The left front tire has a bubble in it, and they're telling me the wheel is bent and the bearing is cracked, so they'll need to replace the tire, wheel, hub, bearing and do something with the alignment AND it's not covered under warranty because it is "impact damage." Is this even possible on a new car like this? For the bearing to be cracked without a big accident? I don't remember hitting a pot hole or running over a curb. Shouldn't this be covered under normal use? I'm concerned that I'm being ripped off
View 16 Replies
Advertisement
Having issues with noise from either LT or RT front wheel bearings? My 2011 Elantra has some sort of noise coming from the LT frt wheel
View 10 Replies
My car seems to make a tick tick tick sound coming from the left front wheel well, but it only occurs when I make right turns. Not left or when driving straight. Could this be a bad cv joint or wheel bearing? Again, only happens when making right turns and I believe at any speed and the sound interval I believe is shorter (faster tick tick) at higher speeds. Also, the vehicle is a 2001 manual transmission and pressing the clutch I believe (cant confirm) stops or slows the sound.
View 4 Replies
I just had front and back brakes replaced and there is noise coming from front (I think it's the front)? Any way my brother says its the wheel bearings and that my mechanic should have "caught" that they were bad. I've gone to mechanic for almost 10 years and trust him. Never had wheel bearing problems before so not sure what to think. And if it is wheel bearing can u ballpark cost to fix in Illinois ?
View 10 Replies
2011 Hyundai Elantra, 42k miles. The car is my girlfriends which I drive once every few weeks. Yesterday I noticed a rumbling noise coming from the right front tire area. The noise only comes about when turning a fairly sharp left while above 20 mph. Taking a left onto a side street etc doesn't cause any noise, but taking one while going through a big intersection etc. Where the speed is up a little bit causes the noise. The tires are original, obviously not new, but they still have a decent amount of tread left on them, they're Continental Pro Contacts.
Tire, ball-joint, brake pad rubbings? I'm going to take it to get looked at tomorrow, I did spray the area with a hose in case there was something caught in there, but that didn't change anything. The tire looks fine, no abnormal wear or bulges, the car is in alignment and makes no other noise except in the circumstance noted.
View 2 Replies
I just replaced half shaft on driver side of my 2002 elantra. I took off brake caliper and pads to get to shaft now that I've put everything back together theirs a sound like the brakes are slightly touching but not sure it's not cv shaft?
View 1 Replies
Ok at 40 mph and above I have a loud humming noise coming from my left front wheel. I replaced my rotor and pads due to normal wear. I also replaced the bearing. No fix. Tires were rotated a month ago. Could it be my CV joint? The boots are fine.
View 3 Replies
I took my car in for what to me sounded like a wheel bearing noise. Dealer thinks the culprit is brakes need to be replaced. In addition to needing brakes I was told i need a throttle body service (service agent says it's needed every 15k for carbon buildup) and also a fuel tank vent filter ("needed every 2 yrs") are these legit repairs I should perform or is this a dealer shake down?
View 15 Replies
So on my girlfriends 2000 echo I get the classic bad wheel bearing noise/vibration on the front left (driver side) wheel. Worsens under load (right turn) and goes away when unloaded (left turn). I've replaced left side bearing, CV axle, brake rotors/pads and the noise still persists. My next thought is maybe the ball joint but humming/vibration tells me something out of rotational balance. Bearing in the transmission? I don't know. I'm stuck.
View 5 Replies
Over the past few months I'd noticed an intermittent grinding noise coming from my left front wheel at low speeds. I took it in once but it refused to play along so I finally managed to catch it on camera and let the dealership listen to it. They booked me for today, saying it sounded like a wheel bearing (to which I agreed) and I dropped her off around ten, not expecting it to cooperate for the second time.
I got a call from the dealer around 2 PM saying that they were able to duplicate the noise and that when they took the left front wheel off and ran the car on the lift with the rest of the wheels off the ground, the noise went away. Even stranger still, when they put the wheel on the tire balancing machine and spun it, gronch, gronch...gronch, gronch....gronch, gronch. It was coming from inside the wheel! I gave them permission to dismount the tire from the wheel and about ten minutes later I got another call saying they'd found a handful of tiny hard rubber balls inside the mounted wheel/tire assembly that were rolling down the inside of the wheel and causing the grumbling at low speed.
Here's the kicker: they were in all four wheels! The tech even saved them for me so I could take a look and they don't look like anything mass-produced; some are larger than others, some are round and some are oval-shaped but when I dropped one on the glass advisor desk, it made a very clear 'Clink!'.
View 29 Replies
So after doing wheel bearings in the car. both front and back. I'm still getting the "wheel-bearing hum" sound if you will. Don't know how this can be possible with all brand new wheel bearings and hub in the front passenger side. other hubs were fine. I do need tires which will be ordered soon/ alignment im sure.
View 5 Replies
So my front right Wheel bearing is making noise and its a used Knuckle so its w/e. Guess ill use tonight to do all my bushings and fluids n stuff.
View 6 Replies
I devloped a noise in the right front wheel. I thought it was a tire going bad so I rotated the tires & still had the noise. I was told by shop it is a wheel bearing. If that is the problem is that a DIY repair ?
View 5 Replies
I have a 03 explorer with approx 160k, I am experiencing a thumping noise while driving. It gets worse on right turns and gets better on left turns. initially i thought LF wheel bearing so i ordered a hub assy and replaced LF. noise is still there. I guess, thumping noise caused by wheel bearings, i know its usually a grinding kind of whirring noise.
The noise doesn't seem to change with accel/decel so I don't think it is driveline related (diff, drive shaft etc.) should i bite the bullet and replace the rf as well??? I should also mention that there is also a shake in the steering wheel that seems to coincide with the thumping (i.e., my hand shakes along with the thumping, and the shake gets worse when the noise does)...
View 8 Replies
I recently heard a sort of clunking noise when the wheel is turn all the way to either side, going slowly, and pressing the brake. I took the car in and the guys told me it was something call the front struts and mounts. Plus, that I needed to replace the inner tie rods (described as a joint). The cost was crazy high, at around $1300 (plus the alignment). The car is a Hyundai Elantra year 2007, with an 87,000 miles.
My question is, in the event that this is not covered by the warranty, how pressing is the issue? Obviously, any issue can become pressing if left uncheck or exacerbated my another issue. But, if the noise I hear is minor, is it going to do lasting damage to the car if not corrected in the next month?
View 7 Replies
I have the dreaded front wheel bearing noise front left had a monsoon last month in orlando. Went through a puddle. Did the front right 8 months ago,everythings fine I am doing uber. Can I spray some deep creep or oil in there to tempt calm the noise?
View 1 Replies
I'm working on a 02 explorer. The front end is howling so I replaced the left side and no change. The howl goes away when braking. Is it the right side then or something else? I replaced both front brakes pads so it's not that.
View 2 Replies
My girlfriend owns a '92 Plymouth Acclaim. We noticed a few weeks ago that there was a clunk/rattle noise coming from one wheel, and since it mostly happened while cornering, thought it might be CV joints or maybe suspension. She brought it to her mechanic who inspected the brakes and found that the rear shocks were bad, but sent her away without fixing anything. The other day, on a long drive, the rattle suddenly intensified, morphed into a loud grinding noise, and then the wheel fell off.
I think I'm going to have to confront the mechanic. The bearings apparently hadn't been repacked in some time, and were surely the cause of the rattle noise. I'm less concerned with the fact that he might have overlooked an obvious problem as much as neglected to properly service the vehicle.
Are brake techs supposed to check, then tighten wheel bearings or repack them if needed?
View 18 Replies
I just bought a used hyundai santa fe sport 2.0t. i noticed it is fairly loud inside compared to my 2011 sonata. I don't know if im hearing tire noise or maybe a wheel bearing type noise. It's coming from the rear and gets louder as I go faster. I'll admit O am paranoid and probably making this sound worse than it is.
View 12 Replies
I have a 94 Explorer. I recently swapped over from auto to manual hubs. I followed a detailed write-up that I found online. During the process I repacked my outer wheel bearings. Ever since then I hear a grinding noise coming from the front wheels. Sounds like the bearings aren't seated properly. The guide that I followed instructed to torque the spindle nut that sits next the the outer wheel bearing really tight in order to seat the bearing, then loosen it back up and hand tighten it. But when I loosened the spindle nut the wheel bearing would pop back out. What is the best way to get a wheel bearing to stay seated properly?
View 2 Replies
We are working on a 97 f250 light duty 4.6 4x4 5spd. Trying to figure out where a bearing noise is coming from in front end. Replaced both front hub bearings from napa. 150 each... the noise is still there. someone said could be cv shafts... although ive never heard a cv shaft make this noise i replaced them anyway cuz one was clickin last time was in the woods. bearing noise is still there..... in a long bank turn to the left the noise goes away till start to straighten out. while replacing the half shafts I grabbed the plates the shafts bolt to and spun them and checked for slack. none found. front diff's full with no leaks. as title says.... what next?
View 6 Replies
