Honda - Cr-v :: Loud Flapping Noise When Stopped With Brakes On
Nov 12, 2011
Today I was at a light, stopped with brakes on. Heard weird loud flapping noise like when you put a playing card against spokes of a bicycle. Smoke appeared. No warning lights so I thought it was the car ahead of me - especially since the noise stopped when I pressed the gas. Drove 11 miles home, 9 of them uphill. No problems. Parked for about an hour. Then drove about 4 miles and was again stopped, again the noise (not so loud this time) and some smoke from under the hood. I was right next to a gas station, pulled in and very nice attendant checked fluids, etc. No problems found. He spilled a bit of antifreeze when checking the radiator level. I then drove straight to a Honda dealer. They have proclaimed it a broken radiator on the basis of a brief exam and a sighting of a bit of antifreeze. No leaks anyplace, car was no overheating, the vehicle has less than 50 thousand miles and is regularly maintained.
View 9 Replies
Advertisement
I just purchased my new Elantra 2 weeks ago. A few days later, just after I started it first thing in the morning, it began making a loud flapping noise (seemed to be coming from under the hood). It's been doing it every morning since. The dealership said they couldn't hear anything unusual (after keeping it overnight, then starting it up first thing the next morning).
View 1 Replies
04 Honda CRV: I just had new rotors / pads / calibers put on my rear 2 tires because I was getting a loud creaking sound whenever I reversed or stoped at a stop sign. Most notibly I would hear it after the car had sat for a few hours as it's not happening a 100% of the time... Am I looking at joint or wheel well problems now? The loud creaking is still an issue...
View 3 Replies
The radio in my 1991 Honda Civic has been dying a slow death over the past year. First it would stop working if the weather was too hot. Then it would only work sporadically, finally it almost never worked. Whenever the radio stopped working, there would be a loud electrical "pop" sound, so I thought it might have a short. Yesterday my husband fixed the upper rear brake light (cleaned contacts) so it would pass inspection. Now the radio works perfectly! Are the brake lights and radio on the same circuit?
View 10 Replies
In February 2014 I purchased a 2011 Honda CRV. I often travel and am gone for about a week. Every time I come back the rear brake are rusted. They have a loud thumping and grinding sound. I immediately took the car back to Honda dealership (2 time) both times they 'shaved' the roaters. I then contacted Honda headquarters to report the issue. They told me to deal with the dealership and take it to a local mechanic for other opinions. Car Talk will be my second opinion. Honda dealership told me that this is just the way it is. This is my third Honda, I have NOT had this problem before.
View 8 Replies
I've noticed a few times now on my wife's car when I am driving it around 80 mph there is a some-time flapping or low-thumping noise from underneath the car. It only happens up around 80 mph. My wife says it's a feature to let me know to slow down . I originally thought maybe I had a plastic bag trapped under the car or some loose trim but looking underneath hasn't turned up anything. The only other thing I can think of is maybe it's just a strange aerodynamic quirk of the car that causes the noise.
View 5 Replies
What makes a flapping noise in the engine when car is started/restarted? It sounds like a dull slam of a fabric covered lid, slamming shut!
View 3 Replies
I picked up my car from the dealer today and driving home once I hit over 70 on the interstate the car started making a slight noise. It sounds like a piece of cardboard sort of flapping in the wind. It feels like it is coming from the engine bay around the level of the accelerator. What it might be?
I popped the hood and nothing was left inside that I can see. The only thing that seems loose is just the induction scoop. It looks like on the side there should be a clamp or something to hold it in place, but it moves freely. I can't find any good stock shots to see if there should be something.
View 7 Replies
yesterday I drove my car and as I was turning the corner (luckily very slowly), all of a sudden I heard a loud noise and the car stopped. The rack pinion, wheel housing and what ever other things there are dropped to the ground because they were rusted through. Never had a warning. Is that a problem with these Fords, of course the car is totaled. Does insurance cover this, does Ford cover this? First time in my life, never buy another Ford again. Also have a Ford focus 2008, looks rusty underneath. Should I get rid of it ?
View 19 Replies
My car is making some noise. The first problem is describing the noise. I think of it as similar to the sound one can make with a moist finger rubbing along the top of a wine glass. A passenger last night thought it sounded like those gadgets you whirl above your head to make noise. I think the noise is coming from the rear brakes. The noise goes away if I apply the brakes. It also goes away if I apply the emergency brake.
It doesn't always make the noise, but it is happening often enough, and is loud enough, that I had to switch from the news to loud music on today's drive to work. I have enough pad left on the brakes, but I don't know about the e-brake. I was under the impression that there are tiny drum brakes that are used as a mechanical emergency brake on these cars? I've never peeked inside. I do have 118k miles on the car.
Maintenance history available at [URL] .... where you can see that the rear rotors were cut at 78k. However, I can feel a ridge on the rotor which I think is where the rotor is swept by the pad. I wonder if this ridge is somehow a problem, maybe rubbing against something else (which will doubtlessly turn out to be now damaged and expensive).
View 4 Replies
Thought it was another AC flap that is playing up but it was the small plastic flap next to the tyre that was giving me the headache.
Still, could not find the rattle at the rear which i think is caused by the underfloor storage compartments. Thats for another day.
View 6 Replies
I have a 2012 and just passed 14,500 miles.
I was driving home recently and heard a flapping type noise on the drivers side and thought something was stuck in my undercarriage or even in my tire and the wind was causing it to flap. I pulled over to check, saw nothing, so I kept driving home and stopped into my local Toyota and they didn't see anything loose or out of place. We went on a test drive and of course, there was no noise.
Later that night as I was driving, it started in the middle of my drive, I parked and when I drove again, no noise and I haven't heard it since; this was 3 days ago. I thought it was just at highway speeds, but I've heard it at different speeds.
View 10 Replies
2007 Camry LE 186K. Car is making a noise like a plastic panel is flapping when driving 55 mph. Sounds like its from the center or console area.
The splash pan is secured with all fasteners, the aluminum heat shield was remove due to looseness. The wheel well seems solid and the front grill panels are tight.
I have moved the heater/air controls to different setting but no change on the noise. I have ramps but that limits what I can look at.
View 1 Replies
My exlporer heat and A/C system has been making "ticking or flapping" noises for sometime. So, to make it stop I would turn fan to full blast and it would stop and the heater would function fine after that. Last week we hasd a warm spell and I switched to A/C (going through the same process to stop the noise). All was well until I tried to switch back to heat after the warm spell, and now I get nothing but cold air. The noise will only stop when I turn the temp dial to the cold side, but either way, all I get is cold air. Is this something I can fix, and if not what am I looking at for repair cost? I'm freezing!!!
View 3 Replies
2012 accent bought in February, 57k miles.
Wheel barring already went out?
The front driver wheel does his flapping noise, it sounds as if there's a rock in my tire. No tred problem, no cv boot problems.
View 4 Replies
It is finally getting hot here in Texas and I turned my AC on Max the other day. It has a sound like there is something flapping around inside the duct work or something like that. Like a flag whipping in the wind. I tried feet, defrost open and closed loop etc and the noise is always there. It is really annoying when it is on high speed. Also, I did not notice the noise during the winter. Is there some where that leaves or something like that can get into that might cause this type of noise. The truck is a 2010 FX4.
View 3 Replies
The sound system in my 2008 LS 460 suddenly stopped and a loud thumping noise comes up in all speakers even if the radio is turned off. There is no music at all only that loud noise. Bluetooth does not work as well as command voice and the GPS guiding system. I had to remove the fuse to stop the thumping sound. To answer my telephone I must pull on the side of the road and turn off the motor. Car dealership said that it is the first time they see that. The car is scheduled to be looked at in a couple of days.
View 8 Replies
I have a 2000 X 5.4... There is a loud roaring noise when releasing gas pedal or stopped (doesn't matter whether its in park or drive)...noise stops when giving gas...the noise is almost like a bull horn...there are no engine lights on so can't get a code...
View 8 Replies
I have had 2 transmissions brought to me, both complaining of no reverse. The first belongs to my nieghbor, its an 2005 F-150 4wd. He says last week it made a loud "POP" noise and reverse stopped working. This is a truck he uses for his work and its got 337K on it. A remanufactured transmission was installed at 70K.
The fluid in this transmission was very dark and dirty. I doubt it had been changed since the reman transmission was installed. Once I got the transmission apart, I found the reverse band was worn and broken. This is cast band, so it would make a rather loud "POP" when it breaks.
The sungear bushing was worn and grooved and scored the snout on the direct drum. The Over drive band was burned and pitted.
Since this is a remanfactured transmission the case is painted gray, the paint is blistering from heat. The torque converter has been so hot the paint blistered and the metal was rusting.
The sealing rings on the pump stator had cut mild grooves into the reverse drum and the snap ring that holds the intermediate one way clutch on the reverse drum was bent and about to fail.
The over drive servo snap ring was broken, which seems to be common on these trucks. The aftermarket replacement snap ring is hardened to resist breaking and is black in color
This transmission will be rebuilt with new gaskets, seals, clutches, both bands and reman torque converter. The overdrive band and low/reverse band will be upgraded with new bands that have a high carbon friction material, that will resist burning, installing a spiral snap ring and replacing the direct drum and sun gear.
The second transmission that lost reverse is from a 2006 F150 4wd. The owner of this truck removed the transmission himself and brought it to me. I am told the truck has a lift kit and larger tire. The residual fluid is clean and bright red. The owner has a drain plug installed in the pan, so I can assume the fluid is changed regularly.
Once I got the transmission part, the only damage I found was a broken reverse band. It appears this band has been broken for a while since 2 of the fingers on the band that would still engage were worn to the metal and and the friction material is burned. The band surface on planetary gear was slightly scored. Everything else in the transmission shows very little wear.
This transmission will be rebuilt with new gaskets, seals, clutches, both bands and reman torque converter. The overdrive band and low/reverse band will be upgraded with new bands that have a high carbon friction material, that will resist burning. Also installing a spiral locking ring on the intermediate one way clutch.
View 3 Replies
I have a 2008 GX and when the car is in drive and being stopped/held in place with the brakes, it makes a squealing noise, sounds like a loose belt but I don't think it is as it is coming from the transmission area, BEHIND the engine.
View 3 Replies
I have a 1995 850. About a year ago, I suddenly had a loud grinding noise coming from my brakes. It only happened in hot weather and when the brakes seemed to be hot. Also, it only happened when I was coming to a final stop, like the last 10-20 feet. I took my car to my "trusted" mechanic. They diagnosed it as being my front pads and rotors, so they replaced them (they also felt the front vibrating.) NOW the brakes seemed okay after I got it back the second time (no loud grinding noise.)
When I got the car back, the weather was starting to cool since it was nearing winter. My winter weather is like 70's during the day, and during this time, there was no grinding. It's now starting to get hot again, and sure enough, that grinding noise is back, but not as bad as the first time a year ago. Again, it is only when the brakes heat up and I come to a final stop (the last 10-20 feet.) If I break lightly, it won't make that noise, and it takes me driving for about 15 minutes for the grinding noise to start (it sounds like metal on metal and loud.) Also, I don't feel the vibration like I did a year ago. I only drive the streets, and have not been on the freeway since I got the new brakes.
View 5 Replies
