My CR-V stalled out the other day 3 times. Then would not stay running. Now won't run at all. We have changed the Camshaft position sensors, spark plugs and air flow control valve. It has fuel pressure, spark, compression tests good and timing chains good. Running out of things to check.
View 5 Replies1992 Honda Civic Starts fine but kills as soon as you release the key. Hold the key in the position with the starter motor running and it keeps running. In the old days we would replace the resistor on the firewall. Today?
View 3 RepliesI recently replaced the transmission in my car. I put new oil pan gasket, valve cover gasket and plugs in it. Got everything back together and now it won't stay running. It starts but will not stay running . I pulled the plugs out to find they were the wring ones that a was sold So They gave me the correct ones. Still doing the same thing. I've checked every connection. All are plugged in all lines are hooked up.
View 4 RepliesThe car; 1991 Honda Civic Hatch back. Issue; Car starts but when left to idle quickly dies. Background; I just recently replaced the valve cover gasket as well as a pierced hose that was leaking coolant. Since then (ABOUT 3 DAYS) the car has taken much longer to start up; i.e. when you turn the key it tries to start from anywhere between 2-8 sec. Before doing work it started up easily and regularly. Has been driving fine for past three days otherwise. What should I trouble shoot first? I figure I would check the spark plugs when I get home and make sure they are still seated properly. Besides that, I'm not sure where to start.
View 4 Replies1984 prelude...1.8l .... I have posted previously on this vehicle and I have had some "success". The car will run with the support of starting fluid but will only stay running if the engine is kept at 2500 rpms or higher. If you let off the gas, it will bog out and die. Starting it requires another shot of starting fluid and a foot on the gas.
View 14 RepliesCame out of my house and my 04 Sante Fe will not stay running. It worked fine on the way home form work won't stay started now. You can give it gas and everything but it just dies out after a few moments. I checked most of the basics...
-Fuel pump runs when key is on
-Added gas, over 1/4 tank
-Checked engine fuses
-removed air filters and hoses
-removed mass air intake unit
-down to throttle body and such,
-to keep running by spraying gas directly into engine?
-removed fuel pump under seat
-checked mesh filter and connections
-clean no build up no visual problems with pump or filter
-checked cut off switch, not activated
-removed gas line from injector rail getting good "squirting" from rail
I have asked everyone and most think it is some kind of sensor but I have no light on and I have put it on the OBII and no error codes are found unless I un plug one of the many sensors, which i have done to a few to check them (air mass intake).
Purchased an 04 Prius with 140k miles and bad HV battery. Used torque app and pulled original codes for bad HV battery. I was able to drive/limp the car home for tear down and replacement. After installing a used HV battery that had 80k from and 08 car. It will start but shutdown after a few seconds. I was able to put it in to drive and move it but it still dies. Energy display shows no battery status and now I get the connect to air conditioner communication warning. The battery's are reading 15.2 volts each from the torque app these are read in pairs so seeing 14 readings all within .1v of each other. I am not getting any codes from the computer.
View 19 RepliesMy 05 f-150 Supercrew 5.4l, will start for a second and then die. I can sometimes feather it and rev it up, but it dies as soon as you let off. I changed the fuel filter and while we had the lines off we turned the key on and it pumped fuel but only for a few seconds. Shouldn't the pump run constantly with an open line?
View 1 RepliesThe engine cranks and turns over when I turn the key, but won't stay running unless I give it some gas. My mechanic doesn't know what's wrong with it, but I haven't starting having him replace parts. What's going wrong. Could it be the fuel filter? fuel pump?
View 9 RepliesI have a 2004 Subaru Outback. This fall I started having intermittent problems starting the car. It would run like a champ, no problems. Then every once in a while when I would try to start it, typically happens after it has sat all night, it would turn over just fine, motor would catch, then the motor would quit running (almost immediately upon start). It is kind of like the old days when your carburetor was not adjusted quite right and you would have to keep one foot on the brake the other on the gas while stopped at a stop light to keep the motor running.
The first time it happened we added "heat" as we thought it might be water in the gas line somewhere. It started, then ran just fine. This winter the problem started recurring more frequently. We added injector cleaner, it seemed to work a bit, but did not solve problem. We took it to the shop, and they could not figure out what was going on as nothing is registering on the computer and the car would start just fine for them. Brought the car home it worked OK for a week or so, then started up again.
The motor would catch then would quit running almost immediately. We were able to get it running good enough to get it to the shop (kept one foot on gas at stop lights, etc so would not kill). My car has been at the shop for two weeks now. It finally misbehaved on their watch, and they replaced a sensor, but they are not sure it fixed anything. They are keeping it so see if they can get a better diagnosis.
My first thought was the gas pump, but they said they had never seen a subaru gas pump fail and usually when a pump goes out, it goes out. They thought it could be electrical, but not sure as the problem is so intermittent. I would like to get my car fixed and back home. It's a great car; when it is running it runs great. The shop we work with is very good, and they are reluctant to start just replacing parts if it is not going to fix the problem.
Began doing this on sunday and just finished up last night. Truck starts and runs for a bit then stalls. Here is what I did in this order:
1.) Washed truck sundday with purple power and a garden hose. I washed the wheel wells frame and underside, but DID NOT wash the engine at all.
2.) Painted the frame and wheel wells with black paint.
3.) Applied 1/2 gallon or so of fluid film all over the bottom of the truck everywhere I can. Again NOT the engine bay.
Where to start. When it stalled, I can restart every time by waiting 3-5 minutes. It was 13 degrees F last night, so i suspect fuel lines may be freezing but not sure.
I have a 1995 Chevy 2500 with a 454 engine with 72K miles. The engine won't stay running (won't idle). There is fuel spraying into the throttle body. Not sure about the pattern being correct. If I spray starting fluid into the throttle body the engine starts running fine for a short time(until the fluid is consumed). So, I'm assuming it is a fuel delivery problem. The fuel filter is O.K. Don't know about the fuel pressure.
View 1 RepliesMy car sometimes runs like a dream and then abruptly will lose power, act like it's not getting fuel, not respond to the accelerator and sputter and buck. My mechanic has rebuilt the fuel pump, cleaned fuel filter, cleaned out tank, replaced hoses. He's familiar with Porsche engines and I know he's not blowing smoke up my nose, so to speak. He's tried everything he can think of. I never know when it's going to act up. It will run smoothly, I will drive it hard, drive it slow and easy, corner hard, not hard, and it sometimes stays happy, sometimes decides it doesn't want to run. It improves when clutch is pushed in, acts like it wants to respond, then after I let the clutch out and apply gas, it starts to buck and there's no power. Haven't been able to get it out of first when it does that.
View 6 RepliesSo our battery died and after getting it jumped the Jeep would not stay running. As long as I was giving it gas it would stay running. As soon as I stopped giving it gas it would die.
View 4 RepliesMy 93 Celica GT Convertible 2.2 (5s-fe?) won't stay running at idle. It starts up fine but is loping and dies unless I give it some gas. I really don't know that much about engines, but I tried disconnecting the PCV valve and the engine began to run more or less normally. I've replaced the PCV with a new one but it didn't fix the problem. The replacement PCV valve didn't seem to fit quite as tightly as the old one but that may have been due to the age of the old one. I assume there is an air flow issue of some kind, but don't know where to look next. I just want to get it running so I can sell it.
View 2 RepliesOk so I've got a 92 Cherokee that I have replaced the plugs wires cap and rotor, fuel pump, crankshaft position sensor. I have also tried the idle air control and the throttle position sensor and put a new alternator on it but it will run for a few seconds and then die. If I keep revving it up to bout 3 to 4000 rpm it will stay running if I keep pumping throttle. What else is there I can do? I'm baffled
View 5 RepliesDrove the truck one week ago today and it ran perfectly fine. Drove it last night for about 20 minutes - ran fine. Drove it again today just 1 minute up the road - ran fine. Started it again this evening and drove it 5 minutes down the road - ran fine. Stopped and put gas in it - now it's not fine. After putting gas in it it refused to start but will turn over. Put a booster pack on it and it will start but would only stay running with the gas pedal pushed all the way to the floor, as soon as you took it off it dies. Now it will not stay running even with the gas pushed all the way down.
View 5 RepliesMy Grandfathers Thunderbird has sat for 5 years. I need to get it running again. I can hear the fuel pump build pressure, replaced fuel filter. After cranking on it, eventually it will start. When it starts to die, I give it some more gas, RPMs increase but it doesnt run much longer. I do smell gas after it dies. After a couple times of this the battery has to be recharged. I hook it up to a jump at 55amp's and it will start once more and then die. Also, I did drain the fuel and put in half a tank of new gas and 1 - bottle of gas treatment.
View 1 RepliesSo I am at a loss. My gti starts and runs great, but not for long its like the fuel just cuts off. It won't stay running long enough for the computer to even pop a code...
View 5 RepliesAfter 3rd consecutive stop, my focus will not stay running It turns over but shuts off promptly. After one hour it starts again without a problem. It does this only in the summer, but it has never overheated,and it has never left a code. I replaced the following Battery, alternator, fuel pump,fuel pump relay, themostat and housing, crank and cam sensor, oxygen sensor. What could the problem be?
View 5 Repliesi have a 2005 chevy malibu classic. a few months ago it started sputtering when we would try to crank it and would take several tries before it would run, then it stopped. So far we have replaced the fuel filter, fuel pump, fuel pressure regulator, idle air control valve and crankshaft sensor, and it still wont stay running when you try to give it the gas, it dies....
View 4 Replies