Honda - Accord :: Washer Fluid Comes Out But Wipers Don't Move
Jan 18, 2014
2013 Accord Sport, 3k miles ... It's 10 degrees in WI today. This is 1st time I had this problem. I press the washer lever towards and the washer fluid comes out, but the wipers don't move. They are not stuck on the windshield because of ice or anything either. What can I check?The next question is the turn signal. What does the lever do when you push the lever towards the dash? It clicks, but I don't notice that it does anything?
View 8 Replies
Advertisement
I have an '08 Lux wagon with rain sensing wipers and automatic headlights. When I spray the windshield with washer fluid, the wipers don't come on to wipe it away. This occurred today, and the wipers would not activate no matter what position I put the control stalk in. Then, after a few seconds, they came on and cleared the windshield. I have not noticed any other issues with the wipers. What might be going on here?
View 7 Replies
Curios problem with my car. When I spray washer fluid quickly the wipers do not start. I can literally empty litres of fluid on the windshield and they still will not activate. Now on other cars I have had you can play chicken and pull quickly on the lever and this I can do a off a couple of times without activating the wipers but not constantly. I had it in for service and the mechanic said he has never seen this problem before and does not even know how to fix it. It does get annoying that you have to waste a lot more fluid to activate the wipers "auto" function by holding it on a few seconds longer than needed.
View 7 Replies
The wipers work fine, but it isn't spraying washer fluid. It's 3 degrees outside. I am not sure if there is a fuse for the washer fluid sprayer motor...
View 27 Replies
I just bought a 1998 ford f150. Wipers do not work, the wipers only work when i hit windshield washer, but no washer fluid comes out, what could it be?
View 2 Replies
I have an 05 F-150 SuperCrew XLT 4x4. I just went to use my wipers and its not spraying anything. The driver side nozzle drips a little bit out, the passenger side does nothing. I can hear the motor engage and there is fluid in the reservoir. I can't see any leaks.
View 10 Replies
Seems to work when I rotate the steering wheel somewhat...maybe this jiggers/resets that ignition switch "area" thus allowing me to fully depress the button on the transmission stick. Is it the ignition switch? Should I replace it?
NOTE: Shift Lock Override Button is missing, but I can insert a pencil in the hole which then depresses a spring which then lets me shift out of Park. WIFE says that not good enough...
View 3 Replies
Turn wipers on and motor growls but wipers do not move, checked 30 amp fuse and it is good, all other functions of the multifunction switch are good.
View 2 Replies
I have a 2011 honda accord and removed the brake fluid cap just fine to check it, in about October but I went to check it again today and the cap won't come off, I wonder if it's because of the cold weather? (36 f) It came off so easy last time I don't remember which way to turn it, and if I should press up or down when turning. The cap will rotate about a quarter inch either way, then won't go any farther. It hits these little white plastic pieces stopping it from going farther.
Here is a picture of what it looks like [URL] .... if you try to turn it left it gets caught on that little white plastic piece on the bottom and there is a similar piece stopping it from going right.
View 19 Replies
I have a 2010 Accord that started leaking power steering fluid at around 10,000 miles. In February 2011, I complained to the Honda service technician when I took the car in for an oil change about the leak. At that time, the service technician told me he did not see a leak and that I should simply continue adding power steering fluid as needed.
I took my car in for another oil change this month, now my car mileage is 46,000, and the technician informed me that the power steering fluid is linking and it is now necessary to replace the "rack" and "boots." The repair will cost about $1000. Though my car is no longer under warranty, the dealership agreed to pay for 50% of the repair. I have asked that the dealership pay for 100% of the repair, but I was told that they would not do that.
View 2 Replies
2000 Honda Accord. Power steering fluid is coming up and out of the reservoir when the car is shut off. I recently had to take the hose off and move it out of the way just to make it easier to replace the belt. Lost some fluid and put more back in. And now this. Also is whining when you turn the steering wheel. What do I do?
View 7 Replies
I have a 1991 Accord LX wagon that is leaking coolant. I figured it out b/c there is a green fluid pooled on the floor behind the passenger's seat. Why would coolant be leaking there? I bought this car in February and have been nickeled and dimed ever since. I want to sell it and get something else but I want to get the coolant problem fixed first and need to know if this is going to be expensive.
View 5 Replies
Have a 1996 Honda Accord that had a tune up ( new plugs, wires etc). also had a leak in a radiator hose fixed. About a month later, the engine started to over heat. Fluid in radiator was very low, but no physical leak. Filled it up and in 3 days radiator is low again. This time I noticed a soft brown buildup around the radiator cap. I checked the oil filler cap to see if the underside was caramel color ( head gasket leak), but the cap was clean. Now, it is running rough and will not idle when I come to a stop. Can't figure out what is going on!
View 4 Replies
I just had my right drive axle replaced on my 1992 accord today at a mechanic chain store. I have notice fluid leaking/dripping from where the axle and transmission meet. What is occurring? Could it be they didn't replaced any seals or the axle is a wrong fit. Its a manual transmission by the way.
View 6 Replies
I have a 09 Honda Accord manual transmission V6 with 59K miles. Recently, it seems to stick a little going into 3rd gear - only third. Called our local dealer's service department who said I should have done a drain and fill on my transmission fluid at 30K miles. I have driven manual transmissions for 30+ years and have never heard of this - but this is my first Honda. The owners manual is not very specific about this maintenance recommendation. Did I create unnecessary wear and tear to my transmission or is my dealers service tech just working to humble me?
View 4 Replies
The other day I noticed some brownish almost chunky looking fluid all over inside the wheel well for the front passenger side wheel. Doing some research it seems like it's probably a CV boot leak because that's where most of the fluid is concentrated. I took a few pictures. I just wanna know if this is serious???
View 6 Replies
1989 Shorty - 3.0
problem with washer fluid - the motor seems to work, but nothing comes out of the tubes...
I know the motor works, cuz there is water all over the engine compartment (near the battery) and down... soaked there...
so, my guess is that the rubber has come off the pump? where is the pump first off, and second, how do I get to all that? - just remove the cowl?
any diagrams or photos would be great!
View 14 Replies
I replaced my injectors n ficm, truck runs great. Now my wipers dont work. Turn signals, hi beams work. Got power at both fuses and they have continuity but no wipers or washer pump. Looking for a diagram for this? Is the motor located under the front cowl?
View 1 Replies
I have seen several threads concerning this. Washer does not work at all and the wipers will work only if turned on and off and only in the first intermittent setting.
View 2 Replies
Used to have the wipers move up or down about 1" at stop lights to reverse the blade and extend their life. Now, that doesn't seem to happen. I went into the convenience settings some time ago, but don't believe I changed anything relating to this.
View 4 Replies
1999 F250 5.4l base work truck. My problem is wipers, washer do not function. It all started with my wipers staying on. I removed the fuse to stop them. When i put it back in nothing. I have bench tested all relays, checked fuses, put in a new mfs, put in a new/used gem, checked all wiring i can seem to find, refreshed grounds etc. I am starting to lose my mind with this thing.
I have gone through all of section A and B of these tests [URL] .... except for the NGS scan tool.
Tonight checked the pins at the central junction box relays to see what was going on. This is where things got interesting. i have constant power at pin 5 of the run/park relay. if i jump this to pin 3 the wipers run. Pin 5 of hi/lo and washer show no voltage, however show continuity to ground. pin 5 of run/park also shows continuity to ground.
With the key on I have 12v at pin 1 of the hi/lo, run/park, and washer sockets. when cycled through the switches show i have continuity to ground on pin 2 of all sockets as they should. However, when relays are in place they do not "click" over.
What am I missing here? As much as I'd hate to do it, I may end up just throwing a switch in to "jump" the run park relay for temporary single speed wipers.
View 3 Replies
