Honda - Accord :: Clutch Pedal Making Slight Snap Sound / Hard To Get Car To Engage In A Gear While Sitting Still
Jan 21, 2012
My clutch peddle made a slight "snap" sound last night and now it is very difficult to get the car to engage in a gear while sitting still, while moving it does ok, but not nearly as smooth as it should be. The other odd occurrence is that while the motor is running and the car is not moving, you can't shift any gears at all, but as soon as you cut the motor, all 5 gears and reverse are easily accessible. Why the sound at the peddle and the trouble in the gear shift mechanism? I am only an advanced beginner with car repair, but I think think this is really bad... 2007 Honda Accord Manual Transmission
View 8 Replies
Advertisement
My clutch peddle made a slight "snap" sound last night and now it is very difficult to get the car to engage in a gear while sitting still, while moving it does ok, but not nearly as smooth as it should be. The other odd occurrence is that while the motor is running and the car is not moving, you can't shift any gears at all, but as soon as you cut the motor, all 5 gears and reverse are easily accessible. Why the sound at the peddle and the trouble in the gear shift mechanism? I am only an advanced beginner with car repair, but I think think this is really bad...
View 1 Replies
I've test driven a used 2003 (155K) I'm considering purchasing. But the clutch is so stiff, especially compared to my 93 Accord. What makes a new clutch, pressure plate a throw out bearing so hard to engage?
View 9 Replies
I have a NEW (purchased May 18th) 2012 Honda Accord. After starting the car there is a small vibration at 16-18 mph which I feel slightly in the gas pedal. A week ago, it started making a slight click when the car reaches 30 mph. This happens only when the first time it reaches these speeds when the car is started. Once started, I can stop and start (without turning off the car) as many times as I need without the sound. However, if I turn the car off and back on, the sounds happens again.
View 7 Replies
2001 Accent 1.5 GL 165K miles.
The clutch doesn't engage until it's on the floor. I have to push real hard to allow the gear to engage. It then shifts... sometimes smoothly, sometimes it takes a hard push of the gear shifter, or it grinds until getting into gear.
I've changed the master cylinder twice in about 3 years but those times the pedal had no spring and just fell to the floor and stayed. Now, the pedal has spring (I push it to the floor and it springs back) so I assume the MC is ok. I even bled it with fresh fluid.
I'm not sure if the tranny fluid has ever been changed. Would changing the fluid fix this problem or does it sound like I need a new clutch? I'm guessing it needs a new clutch (or corresponding parts) since I've had two MC's go bad in a few years.
The pedal, even when it's shifting smoothly is pretty non-responsive and still engages a little mushy (comparing it to my 2012 Elantra 6sp).
View 4 Replies
1988 Acura Legend, 2.7L 6 cyl., 181,000 miles only do 6,500 miles a year to train station, parked inside, runs great. Last week parked out in hot sun, '90s, for 8 hours. At first, no problem. When did errand and returned to car, pushed clutch pedal and it would not return or allow gear to engage. "Jammed" into 1st, then could not shift, shifted slightly by pulling up on clutch pedal with my foot. Parked overnight, cool, next morning seemed to be fine and crept to mechanic. Mechanic road tested and found no problem and now seems to be working okay. Would parking in sun, high heat cause "clutch cylinder" to "seize" or "freeze"? Is there a "fix"? Also, increasingly hard to get parts for this car.
View 6 Replies
Had my original clutch replaced by mechanic. Had 200K on it. Car clutch petal vibrates badly when bringing clutch pedal out after shifting. Mechanic states it has to do with motor mounts that were affected when changing clutch or the clutch takes time to seal and stop vibrating in the next 500 miles. I have warranty for 12 months and 12,000 miles. Which I had no problem of vibration before having clutch replaced? What is the problem and how to proceed.
View 3 Replies
I have a 97 Honda Accord LX stick shift that's giving me some trouble. I bought it at 146k miles and now it has 151k miles.
-- Here is the symptom --I feel that I have to lift the clutch pedal higher to fully engage the clutch after driving for 20 mins. The problem showed up several times and one time the clutch was somewhat slipping and I had to park it somewhere and got towed. After sitting there for several hours or overnight, the problem would gone -- and it could show up again at some time. The strange thing is that I am not always getting this problem. The car could sometimes run over 1 hour without any unusual feeling on the clutch.
I also noticed that when the clutch is not working well, the clutch pedal is stiffer than usual (I never had problem disengaging the clutch though). When I push the pedal to the very bottom on the floor, I can hear some noise and the car even had a tendency to move a little when in 1st gear.
Once I opened the hood and looked at the position of the release fork when the car was cold. After driving about 20 minutes, I looked again and found that the fork moved a little bit away from the slave cylinder as if someone was pushing the clutch pedal gently! I think that's why the point at which the clutch engages is becoming higher. But I don't know what is the real problem. I replaced the slave cylinder last week but it did not solve the issue. Is the clutch bad again or the cylinder?
Here is the repair history --About a year and a half ago I found the clutch slipping. So I had the clutch replaced and the flywheel resurfaced by a mechanic. It was good for a few months until that problem rose again. Then I went to an auto shop. They told me that the slave cylinder was the real problem and got it replaced. I was good for about a year. Now I am still getting the trouble above.
View 2 Replies
My car stalled one day like I was in a high gear at too low of a speed when i was in neutral. It now acts as if it is in a high gear all the time when I am in neutral. When I press the clutch it will idle like it is supposed to but when i let off it pushes forward slightly then stalls exactly like it would if i was in 4th or 5th gear. When I shift into 1st 2nd 3rd or reverse it dies as if it is in gear but will not move even slightly, when I shift into 4th or 5th it again dies but it but is acting just as I would expect 4th or 5t to at a complete stop i feel slightly more power in 4th which is expected being a lower gear but I also feel 5th pull just like its supposed to. I cannot get it to come out of the high gear it is in even though i can move the stick into the neutral position. It is difficult to get the shifter into 4th or 5th but it will move into the other positions like it should with the same no power result. My clutch is fairly new and i have tried inspecting my sift linkage wit no obvious problems. (1991 honda accord lx 5 spd, 2.2 sohc)
View 2 Replies
I have a 89 nissan fairladyz32 (300zx) and when i push the clutch peddle in it is very hard and i cant put it in 1 and reverse when it is running but when it is off i can just fine. but then if i put it in 1 gear before starting it and push the clutch in to start the car it lurches forward a little what could this be? and when i leave it to idle for to long it puffs smoke or at first start up? It has about 80,000 km.....
View 6 Replies
I just rolled over to 90,000 miles on my 2002 Accord. Its running beautifully, however every so often the car "rumbles" or "shudders" when I'm releasing the clutch after I shift into second gear, or sometimes it'll do it when I'm facing up a hill pulling into first gear letting out the clutch. Its almost as if the clutch rapidly grabs then slips a bunch of times, similar to if it was warped. It doesn't completely slip at all to my knowledge. The car was bought new by my family and has been driven pretty carefully since (although 2 people have learned to drive stick on it, and my dad isn't the most "gentle" driver in the universe). I know that Clutch rebuilding and replacing is a big expensive job and its something I wouldn't even consider doing myself. So, when is it time to really seriously consider dropping down the serious cash to get the clutch rebuilt? To be honest, the shuddering is really annoying (it doesn't happen all the time though) but its something I could live with for a bit.
View 8 Replies
I just got my R last week and I noticed that in first gear you can feel and also hear a creaking sound from either the clutch or gas pedal. I've read a few things and it has something to do with the Hinge of the pedal itself and I believe it can be solved with Lithium grease or something like that. Noticed this while in 1st gear?
View 7 Replies
I started having a strange clicking sound when pushing down the clutch pedal. I have 43,000 miles on it and I have driven the clutch well(I really don't believe I already worn it up). It goes away and then it comes back. There is no problem on shifting from gear to gear, it works just fine. It is only when I push the pedal that it starts clicking like it pushing against something. The car dealership was so useless, they said I need a new clutch and that warranty does not cover it because I may have been using the clutch badly. Also do you think that they have the right to tell me it is my fault even though I have the extended warranty for 100, 000 miles.
View 6 Replies
Still chugging along!!
So, I haven't been the kindest car owner to my poor little hatchback. I do my best to get regular oil changes, but other than replacing the brakes last year, I have not kept up with most of the manufacturer's suggested regularly scheduled maintenance. The car has about 130,000 miles. Manual Transmission. My clutch feels a little loose, and I have been noticing a slight grinding sound when shifting (only from neutral to first gear).
View 5 Replies
I'm a Marine about to deploy to Afghanistan for a year. What I should do for my 2007 Honda Accord before I leave? I'm not planning to have anyone start it while I'm gone and it'll be in my garage while I'm gone.
My plan right now is to detach the battery and leave it. I'm going to buy an air compressor to put air back in the tires when I get back and I'll jump start it also since I'm anticipating the battery will be dead.
How I should leave it? Any recommended repairs before I leave? I just got the oil changed, transmission flushed, and throttle body cleaned since I just passed 60k miles.
View 19 Replies
The A/C in my truck stopped working last year, and this year I intend to fix it. I believe the problem is with the compressor clutch because it was making noise as it would engage or disengage. It was making this noise for a good year or so, and then one day the noise stopped and I have no A/C. So I am only assuming its the clutch.
View 4 Replies
I have a 2001 Ford ZX2 with 170,000 miles on it. The clutch pedal doesn't engage the clutch until it is almost touching the floorboard. I thought it had a hydraulic clutch being a 2001 but I can't find a reservoir for the fluid so now I must assume now that it is a mechanical clutch.
1. Does they hide the reservoir on these ZX2's?
2. What could cause the clutch issue?
View 4 Replies
Car ran great prior to sitting for 4 months. Tried to jump it and it wouldn't turn over, so i figure the battery was dead. I replaced the batter with a new one, had fresh fuel added.
I then thought perhaps it might be the started, so I removed it and had it tested and it passed (it's working). Car still wont crank. I turn the key and there is nothing not a sound, except the fuel pump. No crank nor click? Not sure where to go from here?
View 3 Replies
I have a 95 honda accord 2.2L, 135,000 miles. One day while sitting at a light the car started vibrating due to a rough idle problem. The idle speed is ok at about 750 rpm.
View 1 Replies
Have a issue after car sits a few days and the brake pedal is really stiff when you depress it at first start up? Like it won't depress anymore then it is.
View 5 Replies
So i have a 1996 honda accord, it has 253k miles, i know, alot of miles. Well, i noticed it has been losing coolant pretty fast, i would fill it up with coolant and it would run out by the next day. I also notice that when i am sitting still, it runs hot, not sure if that goes along with it losing coolant rapidly or if that could be something else. I checked my oil dipstick the other day, it doesn't seem to have coolant mixing in with the oil, so i don't think it would be a head blown, i know i do need a gasket changed, but not an actual head for the engine. I haven't noticed any coolant in my driveway, then again I shouldn't have a leak, i just had the radiator, thermostat, water pump and the bell housing all changed a couple months ago. I also noticed that i am running low on oil more often as well. The other day, after i topped it off with oil, it was blowing out white smoke off and on and then it stopped, what could that be?
View 3 Replies
