Honda - Accord :: 2005 - Getting Engine Code P0171?
Dec 19, 2012
So I recently changed the air filter in my car. Its hard to get to and replace. Its in a tough spot and I am not sure if I secured the cover fully and completely. I am pretty sure I did. Anyway, a week later I had my check engine light come on, it stayed on for a couple hours then went off. It hasn't come back on since. However, I went to the Autozone, anyway, and had them read the code. They said it was P0171, system too lean bank 1. Is this a serious issue? What are some common ways to fix it, if it is? The car is a 2005, Honda Accord EX. 4 cyclinders. PZEV version. It has 142,000 miles on it.
View 4 Replies
Advertisement
I have a 2005 Accord 4 cylinder that has the engine light on. I have had it serviced and the code was P1009. First mechanic added oil and reset the light. It came back on, so the problem wasn't low oil. He then replaced the variable timing solenoid and changed the oil and filter. After a week or so, the light came on with same code. I then took it to a foreign car specialist well-skilled in Honda engines. He did a lot of research and confirmed the first mechanic did everything correctly, but he also changed the small screen in the oil passage (related to the VTC solenoid somehow). Light came back on today. The car only has 44,000 miles and was well-maintained, oil checked and replaced regularly, no sludge or buildup. I will return to the mechanic that did the last repair, but they all seem stumped by the return of the P1009 code. How to resolve it?
View 2 Replies
I have an 05 Toyota corolla, and have the check engine light on, I scanned it at autozone and error code is P0171 - System Too Lean (Bank 1). Which shows following possible causes: Faulty MAF, O2, fuel injectors blockage etc. On recommendation from the guy in autozone, I added fuel additive to clean the fuel line/ injectors. The check engine light went away for 9 months. But it is back on again. Tried putting in fuel additive again but the light remains on.
View 5 Replies
Periodically the engine light comes on and then when I hit the gas it "stutters" and the car jerks - similar jerking feeling when you are learning to drive a stick shift but this car is an automatic. I have to take foot off gas pedal and keep slowly applying again to building up speed. The stuttering stops as soon as I take my foot off the gas pedal. Sometimes when I stop the car, turn it off, the light will turn off and the car drives great. Sometimes that doesn't work and the light stays on for a day or two then magically is gone when I start the car again. I have noticed the light comes on most often if I haven't warmed it up enough before driving, but other times it just comes on. I have taken it to two different Honda dealers and they don't know what the issue is.
View 3 Replies
I have a 2005 honda accord. When I was driving today it started to rain, so I turned on my wipers, at first they were ok, but later I noticed the wipers speed went down, and then the check engine light came on, I was still able to use the wipers and everything looked fine. I just had someone changed my oil on Tuesday. I got a new car and I only drove less than one hour per week using this old car. Is it possible the battery or alternator is bad? I will read the code tomorrow.
View 3 Replies
Yesterday as I crawled my way through heavy traffic on my drive home from work, my car started lurching unexpectedly. When I let up on the gas, the lurching subsided. I was able to recreate the behavior multiple times on my drive home, as well as while parked in my driveway. As the RPM exceeded 2500 the engine would lose oomph/power and the RPM would start stuttering/oscillating between ~2500 and ~2800 RPM. The behavior was identical regardless of which gear I was in (D1, D2, D3, D, or N), regardless of my speed, and regardless of how aggressively I was pressing the accelerator pedal. Every time the RPM hit 2500, the engine freaked out.
This morning, it did NOT happen when I tested it briefly. I was able to rev up to 3500-4000 RPM without any issues. I did read a case online in which someone experienced a similar issue that only manifested after the engine had been running a while. My car has ~173k miles on it, and this is its first engine issue. What might be causing this?
Video attached; also located here: [URL] ....
View 7 Replies
Well my girls 2006 passat is showing the check engine light. she took it to autozone and the code was, P0171. what does the code mean and what do i need to replace?
View 4 Replies
Wife took truck out and turned around after going less then a mile, saying it was running very bad. We got this truck about two months ago at a state vehicle auction. It was a state used truck, 145,000 miles, 05 Ford F350, ext cab and 8' bed. Anyway at first I thought it was valve tap until research said an exhaust manifold. With a fog machine in rear exhaust pipe we confirmed it was leaking and replaced the exhaust manifold. Figured it was probably a good time to replace spark plugs too. Took truck for a ride and she still buck and farted.
Got a code machine and got P0171 and P0174. Couldn't find a vacuum leak, but your could hear the air being sucked in. went to local parts store, guys couldn't find leak, but they said truck sounded like a steam machine. today I made a homemade smoke machine and smoke came from air intake, figured the gaskets were bad. The pictures show what I saw when I took the gaskets off. The port that has melted is the same port were the exhaust manifold was leaking from. Am in deep "doo-doo". What caused this?
View 5 Replies
Yesterday, I turned on my car and got a message on my dash telling me to check my fuel cap. I did, and it was fine. The message still didn't go away, so when I got to work, I actually unscrewed my cap to check and make sure everything looked normal. At this point, I noticed that the metal flap that usually covers the opening of the gas tank was gone. After showing this to my neighbor, he said that it looks like there's actually an entire component missing from the mouth of the tank, and not just the flap.
I'm guessing that, the last time I got gas, this part of my gas tank went with the nozzle when I took it out. How I didn't notice this is beyond me. Unfortunately, the last time I got gas, I was 100 miles away from home.
My question is, am I in for a nauseatingly expensive repair here? Is it possible to just replace that one part, or am I going to end up replacing a whole lot more? I haven't taken it to a mechanic yet because I'm trying to go in armed with some knowledge about what can be done here.
View 4 Replies
I've been getting this error code recently ("Fuel Trim,Bank1 System too Lean"). I have a Scanguage, which let me get the error code, and I used it to reset the message - it came back about a week later. I took it to a local repair shop after the second time, but as I'd already cleared the message, he couldn't do anything. It came back about a week later, and this time I took the vehicle in as soon as the yellow light showed up (without connecting the Scanguage).
The mechanic said that he found both P0171 and P0172, and that the problem was a loose vacuum hose AND a failing Mass Airlow Sensor. They reattached the hose and cleaned the sensor, but said that the latter fix may not last - the light came back on two days later. I took it in again (this time, checking the codes, and found only P0171) and he said this confirms the problem with the sensor and he'll have to replace it ($280 for the part, plus labor, less a discount on the labor equivalent to the labor he put in to clean the sensor.)
View 16 Replies
P0171 system to lean.
I already replaced the MAF so what else could it be I cleared it once and the cel came right back on. I have a stasight pipe from the catback on my car and the cabin started smelling like burning plastic and eggs every time I accelerate. I'm going on a road trip tom and was wondering if I'll be fine. The car has a bit more noise coming from the engine the usual more like a swiping tapping noise
View 6 Replies
Incosistently when accelerating the car jerks (like when wheels spin out in rain). Car works just fine in Idle and has been working great, except for the occassional jerking. I would like to know what I should check and if its dangerous to drive, depending on what the problem might be.
View 5 Replies
I have been having a problem with my Honda overheating while the A/C is on, this is the thing though on any day when the weather is 85 or lower I can run my A/c all day no problem. But when it is 90 degrees out side my engine starts to over heat while the A/C is on, how ever as soon as I turn the A/c off temperature needle goes back down even in 90 degree weather.....
View 2 Replies
I have a 2005 Honda Accord EX 4-cyl with a very peculiar problem. The car will start and run fine as long as I don't have to shut it off and restart it. However, once I shut it off, it will not start back up unless I give it some gas. Once started, the car will not idle unless the gas is pressed to maintain revs. This happens when the car is shutoff for a just one second, and only when warm. Once the car cools down, it starts and idles fine.
I've tried changing the FI Main Relay and it didn't work. I've also flushed the coolant and changed the radiator cap which seemed to work a little bit. I recently cleaned the Idle Air Control Valve which didn't make any difference. The Fuel Filter has been replaced as well. There are no CELs on and the car has 267,000 miles.
View 1 Replies
I picked up a really cheap Hyundai Elantra 2005 that the kid that owned it really beat up on. Right now I am trying to sort out the issues so that it can become my daily driver for the next few years.
Second issue, The check engine light is on and it is popping up a P0171 generic engine running too lean code. The car looses power sometimes and I can smell gas in the car. I have a friend that is going to be loaning me his MAC code reader so that I can see if it is one of the O2 sensors and if so which one tomorrow.
View 16 Replies
Check engine light is driving me crazy, comes and go depending on weather conditions.
When "ON" the code I get is P0441 and P0171. The engine hesitates for a second or two,then stabilizes.
View 6 Replies
2001 Honda Accord EX 2.3L 4cyl. check engine light is flashing off and on with a PO1399 code
View 2 Replies
My 2005 Honda Accord (approx 48,000 miles) has had squeaky/grinding brakes for the last few months. The brakes make a horrible grinding noise for the first few times that I brake each time that I drive it, and then as the car warms up the noise seems to go away. It also shakes a little bit when it's making the grinding noise - not a ton, but enough that I think there must be something wrong. It's worse (during those first few brakings) if I brake hard, but even if I'm really gently applying the brake it makes the same unsettling noise. The squeaking noise doesn't go away ever, but I don't think it's as serious as the grinding noise (but I could be wrong - that's why I'm here!).
I took it to a brake specialty place in November or December and they couldn't find anything wrong with it. Other than regular oil changes and tire rotations, the car hasn't had any repairs.
View 11 Replies
When it is cold outside and I want to turn my heat on in my car, it takes a loooong while for heat to be produced. I have to have the car moving at a high rate of speed before any heat is made. Even when it is turned all the way to the hottest setting it just spits out cold air. Here is the real problem. If I have the temperature on the heat and the car is idle, the temperature gauge on the instrument panel starts to move around to the RED side(meaning the engine is hot, right?)
As long as the car is moving the gauge will stay in the BLUE(engine is cool, right?) As soon as I stop the car at a red light or sit in traffic(which is usually the case) sure enough the little temperature needle begins to make its way to the RED side. As soon as I move again, it normals again. I have taken this to several mechanics and they have said that they do not know what is wrong and they think that it may just be a faulty temp gauge(this does not seem right) I do not really know if the car is in fact overheating when the gauge starts its travels or if the car is fine and I just have something that is faulty.
View 6 Replies
I own a Honda Accrod 2005 V6.
I don't know much about cars, but for the past year my clutch gradually started to just stick to the floor. I'm now at 80,000 miles, the clutch doesn't slip, and it for the most part drives fine with exception to this sticking. Sometimes when this happens, the stick shift stays in gear and I can't get the stick out of gear until the clutch has been lifted up and pushed back in. It is def getting worse. I have brought it to several mechanics.
I have been told by Honda that I need to replace the clutch set (clutch disc, pressure plate, and throw out bearing) and the clutch master and slave cylinder.After another mechanics look over, they also did confirm the same as honda but stated to get a new cut flywheel.
But after several other mechanics look-overs, they told me that the clutch is fine, so they recommended me to get the master and slave cylinders replaced.
So, trying to save money a mechanic told me to take one step at a time and see how it goes. He said he will bleed the slave and master cylinders and see if it is just an air pocket. That didn't work, so I trusted him and he replaced the master cylinder, but the problem still exists. He said the next thing to do is maybe to do a new slave cylinder. I'm now contemplating.
Another mechanic took a look after the work was done and said there is no leaking.
View 3 Replies
Honda accord( 2005), Engine lights off and on, Radio goes off a few seconds and then reboots by itself , ABS lights off and on, car still runs, power seems to be down slightly when engine lights comes on , stalled twice, but restarted right away. Relay switch replaced, PCM replaced( Diagnosis suggested) , problem continues.What should I check next ?
View 9 Replies
