2004 Honda Accord sedan, 4 cylinder, approx, 95,000 miles, uses oil rapidly at highway speeds (one quart in 90 minutes), in town driving will not use any oil over 3 to 4 months of monitoring. What the problem is and how to fix it?
View 4 RepliesMy 1993 Honda accord coupe is kicking In and out of overdrive from 55 mph and up so what's the problem?
View 19 RepliesWhen I'm driving at highway speeds and hit the brakes hard-ish (e.g., if the car in front of me stops or if I suddenly realize I'm going too fast on an exit ramp), my 1997 Honda Accord feels like it's shimmying from side to side. It only happens for a moment, but in that moment I feel like I'm on the verge of losing control of the car.
I've only noticed this in the last few months. What this might be? I'm going in for an oil change tomorrow and would like to ask my mechanic to take a look at this, but I'd like to have some theories/guesses in my back pocket before I go in.
So, for the last week or so my cars has started dieing while driving. First time it died randomly when approaching stop signs a couple years ago. Now it seems to have progressed and dies while on the highway and now has become more frequent to date. I checked for vacuum leak and spraying all visible lines that I could see from engine bay. Engine codes...the array of engine codes. P0420 catalyst system efficiency, P0706 trans solenoid 'C' clutch, and P0430 another catalyst system inefficiency to join it's brother P0420. The car starts up fine in the morning. Car does not ride rough.
Today I changed the spark plugs and noticed oil in all 4 wells and a lot of oil in the 3rd one. I changed the spark plugs because they were 20k miles and figured I might as well replace them while I'm diagnosing the car. So turned back on the car after doing the job and got a puff of smoke...go to o'reillys and new codes. P108(MAP Pressure Circuit High Input), P110(Something about coolant being high input) and still the P0420. (Shop I took it to must have removed old codes. Not sure why).
So there shouldn't be oil in the wells because my shop did head gasket job 2 years ago. I'm pretty confident in their work, so I'm thinking it must be blowby and because the amount of oil in all 4 wells. (But then again this is the cars second head gasket job, so who knows) If it is indeed the rings causing blow by, is it safe to drive around with oil in the wells? If I drain it regularly can I continue to drive it safely? Is there a test to determine if it's blowby?
I ran car for oil cap off looking for smoke, nothing. I did feel a steady stream of air though, not sure what's normal and abnormal on that front.
1999 Accord V6 randomly decelerates while on the highway. Pushing the gas peddle does not work. Hazard lights work. Check engine light on but goes away on occasion. Needs new engine mounts and O2 sensor according to diagnostics
View 5 RepliesAlright, car's overheating, but generally not at under ~55mph or so. When I hit the highway and accelerate, the thermostat climbs and hovers 3/4s of the way to red. But only sometimes. Sometimes, often when I'm going down a hill, it will swings down to normal. Once it's gotten hot, if I take it off the highway and am idling or driving in the 15-40mph range, the temp gauge will spike. But only sometimes. Sometimes I'll hear the fans kick in while it's idling/overheating. The temperature will go back to normal, and then rise again and stay there or spike (seemingly randomly). It's never reached all the way to the red, but it toes the line. And I take the darn thing into the shop and it refuses to overheat.
I've taken the radiator reservoir out and there seems to be green fluid (antifreeze/coolant?) in the water (have flushed it repeatedly)...and over the course of several weeks, the water level itself will go down. Both fans and the thermostat have been replaced in the last 6 months. Additionally, the timing belt and serpentine belt have been replaced within 5 months, as have affected pistons.((S/N--RPMs are really....low? ~2500 @ 75mph? but don't seem to correlate w/temperature. would they effect it?)
I took it into my shop and they said "we ran all the tests and couldn't find anything wrong." Cool? I'm at a loss..
My father in law gave us a car to use so my husband can get back n forth to work. Recently it started dying on him while he was on the highway and we don't know whats wrong with it. His father told us its a brand new batter that was put in it before he gave it to us. The car is a 1990 Honda Accord. The radio already doesn't work so its always off. The car dies no matter if heat/air is on or off. I don't think it could be a battery problem. There's 2 lights that come on when it dies: battery and oil. We put oil in it. The weird thing is that after it dies, we put it in park and turn key in ignition to off position and then restart it and it starts right back up with no problem. We really don't know whats wrong with it but cant afford to take it to mechanics to tell us 100 other things wrong with it..
View 3 RepliesMy 2007, Honda Accord, 6-speed manual, 6 cylinder EX Coupe vibrates when I accelerate between the speeds of approx. 50-65 mph and then smooths out above that speed. Slightly higher when going uphill.
It only happens when accelerating and not if I'm just cruising without applying the power. My wheels and tires have been checked for balance and are in good shape. No bent rims, tires are in balance.
I have a 92 Honda CX hatchback, 5pd with 140k on it. Since I bought the car used about a year ago it's had a low speed stumbling/bucking issue. For the most part, it's only when driving slow and steady but occasionally at highway speeds it'll do it as well. It's as though the whole engine just cuts out for a second. Giving it more gas always brings it back but it's incredibly annoying, especially in a parking lot with a cup of coffee or something in your hand.
For starters, the rotor, wires and cap are all very recent. I pulled the ECU codes and it indicated #7, Throttle Angle Sensor. Bought a new one, calibrated it, reset ECU and drove on. No change. Car still bucks and the CEL comes on occasionally. At first, I suspected the plug to the TPS since it was loose. I pulled new wire and soldered directly to the ECU and TPS. No change. Of interesting note, when the CEL would come on, it seems the TPS falls offline and the car runs great! I disconnected it for a tankful and noticed my 40mpg/hwy go down to 25mpg. Completely unacceptable for a car so painfully slow.
Another observation, the stumbling doesn't start until the car warms up. Also, if it's particularly humid/raining, sometimes it won't do it at all. A lot of people have suggested the O2 sensor, distributor, fuel pump/filter. I don't have money to just start throwing at this thing and of many similar issues I've read of others with the same car, nobody seems to have a solid fix.
I've replaced the TPS, completely cleaned the throttle body and IACV, checked for vacuum leaks and even opened up the ECU looking for cold solder joints. It looks newer than new inside. Like I said, with the TPS disconnected, car runs great but the mileage goes south.
I have a 2003 Honda Accord. I've had an issue with steering wheel vibration for the past 10 months. In that time, I've installed new hubcentric rings for my after market wheels, gotten my tires balanced, bought a whole new set of tires all together, and changed my cv axles twice. I still experience vibration in the steering wheel when I get up to 60 mph and all the way up to 80 mph. At times I have had vibration at low speeds, around 20 mph, but that was solved first when I installed the hubcentric rings, and again most recently with this second set of cv axles. Am I missing something or will I have to chase a solution to this problem until I am bankrupt?
View 2 RepliesI have a problem with vibration in steering wheel and at speeds of 50 to 60 mph. It also vibrates at idle. This problem did not start until we had new brakes and rotors turn. We also have had tires rotated and balance. They told us we needed new motor mounts. We had them replace and the shake got worse. They replaced the front axles and the transmission mount. I also bought two new tires.
This started out when we took our car to have the tires rotated and balance. The Mechanic told us we needed new brakes, so we took it to get this done. we are now having all kinds of problems as I stated above. Took it to the Honda place here and one person told us it was not worth fixing. I do not believe this. The car has a little over a 115,000 miles on it. I have been driving a Honda since 1992. This car we bought new and I know it has been service.. One person at the Honda place here said he could replace all the mounts and would not promise it would fix it. We have even had one of the new tires replace because they said it was bad.
Our 2008 Honda Accord has about 89,000 miles on it. For the last few years, it has been making a creaking/groaning sound at low speeds. Generally between 10-20 miles an hour (so you hear in more in rush hour when you are generally annoyed anyway), only when its hot (due to extensive driving or weather - we live in Texas so its awful in the summer) and it does not correlate to using the brakes. We took it to Honda and they said the "bushings" were worn but not broken so they wouldn't fix it. Our own shop has replace both front control arms. The right side they did last week and 3 days later the sound is starting up again. Its almost as if they can lube it to fix it temporarily but I'd much rather a permanent fix. My father in law suggested the struts.
View 1 RepliesI have a 2004 Honda Accord EX (4 cyl) with 102k miles. I bought it brand new and kept it completely in shape with regular service. For the past few months I start getting front end vibration at braking, mostly when slowing from high speeds and without any repair this vibration has now became common at all speed.... my diagnosis - I need to replace to turn disk/rotors....
While I have not remedy the rotor issue yet, I started getting this new vibration at 60 to 80 mph.... Below and above this range of speed i have no vibrations - the car will drive fine. This type of vibration in my experience for front wheel drives is mostly due to balancing or bad tires. so i took the easy way ..... and as i already needed tires well i dished out the dough and replaced all four with Michelin Primacy hoping that it will resolve the speed related vibration.... Well it did not?
I continue to drive as-is without addressing the real problem - coz I'm not sure what is causing the vibration.... now new additional vibration started on acceleration; any time I hit the gas pedal (normal acceleration or kick-down) I get vibration very similar to when a stick shift's gearbox required replacement/repair of the worn out pressure plate's (fingers/springs gets bent or weak) or the thrust bearing needs replacements/repair/grease packing. I'm from the old school stickshift transmission, my knowledge in automatic is very little - I have repaired Acura's automatic transmission before but I don't think repairing once will make me an expert in automatic.
So to summarize my issues or current state:
Issue# 1 front end vibration on braking
Issue# 2 front end vibration 60 to 80 mph speed only
Issue# 3 front end vibration on acceleration at all speed
The list above is in sequential order as I have experienced.
I have a 2005 Honda Odyssey with over 100k miles. Recently, it has started making a loud whining noise (it reminds me of the sound my old manual transmission sedan would make when I was in second gear but needed to switch into third) when we drive at highway speeds (55 mph or more) for more than 20 minutes or so. The sound continues at lower speed and even when we go into park. It doesn't stop until we turn off the engine, but the next time we drive the sound doesn't start until we've been driving at high speeds for a while. It also intensifies when we make sharp turns. I took it to my mechanic who thought it was simply the fan coming on because our coolant was low, but we refilled that and it hasn't made a difference. Also the temp gauge doesn't show that or car is overheating.
View 8 RepliesI've saw several complaints about 2008 Honda Accord Popping at low braking speeds and start from stop only in hot weather. I've never saw a solution.
This is the other persons complaint: My Honda has a pop or clunk when braking at low speeds( below 5mph) just before coming to a stop. It will pop as I start forward again (below 5mph). It only occurs when the outside temperature is above 90-95 degrees and after driving for 10-15 minutes.
06' 5.4 screw 100K... At 55mph my truck just stopped running, I pulled over to the side of the road and after two trys the truck restarted but ran rough. Auto Zone pulled a code that said replace the throttle position sensor, I did and the same thing happened again two weeks later just as before.
View 3 RepliesI have a 2004 Ford Escape XLT, auto,V-6, with 129000 miles on it. It runs fine except for a couple of things. One is, at highway speeds the transmission will seem to shift up and down. Also sometimes at highway speeds I get what I describe as a "bump" or "shudder" I think it is coming from the transmission.
View 4 RepliesPurchased one owner Prius from Honda dealer May 2014 with 92000 miles.Now 2 months later 94000. Both service departments of Honda and a Toyota dealer said my car handles normally for a Prius.The car dips from left to right while driving at slow and highway speeds. It feels like a boat moving through water. The suspension was said to be good.Driving it feels unstable, like a Montero Sport or a stage coach. I wanted to do a lot of driving this summer, but this feels so uncomfortable.
View 5 RepliesI have a 2007 F150 King Ranch Super Crew 5.4 3v and it makes a ticking sound. I have read about the VCT solenoids and the phasers. My issue is that the ticking noise can be heard at Highway speeds. At it seems to be quicker as the engine speed increase. Not sure what to think. No rough idle. What could this be.
View 3 RepliesFirst, details about my truck. 2007 F150 SuperCrew, 2wd, 5.4, 203,xxx miles on it, leveled with Hell Bent Steel 2.5" kit last year, has been aligned professionally since then, tires are good and balanced.
The issue I have is a vibration, kind of the same feeling when driving on a road surface that has had the top level of asphalt removed before it's resurfaced. It's mostly noticable at highway speeds. Its not a violent type vibration, but you can feel it. There is also a sound, similar to tires with a deep off road type tread.
The sound and vibration more noticeable when making lane changes or when wheel turned towards left, at highway speeds, not as much to the right. I've checked front wheel bearings, they are good, zero play, no loose suspension parts, u-joints are good, no leaks anywhere.
Since it makes the noise and vibration a bit more when moving wheel, could it be a power steering pump? The pump is the original.
Just rotated my tires this weekend and noticed today that the steering wheel has a vibration in it at highway speeds, 65-70mph. It did not do this at all before I rotated the tires, why it's doing it now? Tires are fairly new and Bridgestones H/Ts.
I know my rotors are warped and need replaced but the vibration I'm referring to is when I am not braking.