Gti - Volkswagen :: Fast Clicking From Turn Signal After Used And Returns To Neutral Position
Apr 9, 2011
This is in reply to a question I just heard on the radio show from Stash (sp?) I believe. He has a jetta and the there is a fast clicking coming from the turn signal after it is used and returns to the "neutral" position. I have a GTI of similar vintage and replacing the blinker did not work. What does work is even cheaper! Get some CRC electronics cleaner from the local auto store and spray out inside of the turn signal switch. What happens is, over the years the lube inside of the switch wears away, allowing the contacts to wear against each other, creating little metal debris that ends up completing the circuit. The CRC cleaner dissolves all of the gunk and gives the necessary clearance inside the switch to allow it to function properly.
View 1 Replies
Advertisement
So...I'm driving home yesterday and hit my left turn signal when all I get is a fast clicking sound. The light on the dash did not light up at all. Right signal is working fine.
Checked it out in the driveway -- my left signal is totally out. No front, rear or dash light when I hit the left turn signal. When I hit the hazard switch, I get only a right blinking light. The right turn signal functions as normal.
I thought this was probably a bad bulb so I replaced both the front AND the rear bulbs. Got no love - same results.
2008 Prius...
View 6 Replies
I have a 1997 vw cabrio. I'm having problems with my signal lights. They start blinking super fast or not at all. When they do work if I hit the brake they stop working until I release the brake.
View 6 Replies
My wife's '07 has that fast-blink thing going on with the left turn signal. The thing is, none of the bulbs are out. It does appear that the front ones are dimmer than the ones on the right (which work fine).
View 8 Replies
I know that the relay will make the turn signals flash fast when a bulb is out or there is a broken circuit, but I am not sure about how the brake light switch is causing this condition. I need to go and check all connections and bulbs, but I see nothing obvious at this point. When the brake pedal is NOT depressed, I get the normal interval of the turn signal. As soon as I touch the brake pedal, it begins to cycle very fast. Remove foot from pedal, and it goes back to normal.
View 5 Replies
2005 explorer just started having a fast blink on the right turn signal. Left turn and hazards work fine.
View 3 Replies
My truck is a 1999 F-250 Super Duty 7.3 diesel. My left turn signal is fine. My right turn signal is going fast. The rear blinker lights up, but the front does not. So... no brainer... change the front bulb. I did. Twice. Sylvania 3157. It did not fix the problem...
View 11 Replies
2003 SCrew, 5.4, auto, 4x4.... Yesterday my left turn signal started flashing fast; checked and the front was not flashing. Picked up a new bulb, changed it, didn't fix anything.
I've tried:
-tilt wheel up/down in all settings-no change
-checked the wiring at the top of the column; still good and solid.
-swapped the bulbs left to right and vice versa-no change.
-swapped the sockets left to right and vice versa-no change.
Other info:
-the left front is the only one not flashing with hazards on.
-all original equipment, except I removed the stock side mirrors (w/signal) and installed manual trailer towing mirrors, but that was 2 or 3 years ago.
-the dash indicator light for left turn (arrow) does not come on at all.
-last trailer tow was over a month ago and all was good.
I ran out of daylight last night and at work now so I would like know which Fuse, Flasher, Relay, etc., I should check/replace and where to find them on the truck; under the hood (1st or 2nd stack of the fuse blocks); under the dash above the pedals; steering column???
View 5 Replies
While I know this has been covered before, I could not find anything pertinent to 2011-2015 model years.
So, I changed my turn signals to LEDs, and now I have the fast-blink behavior. I realize this is because of the significantly decreased amperage and resistance of the LED modules. I did a similar mod on my 2007, and simply found a replacement low-current blinker relay (on eBay, I think), and replaced it (it was physically located behind the extra small glove box near the middle of the dash.
My questions are, 1) for a 2015, should I use the same method of replacing the blinker relay? 2) Any brand and model that will work for this application and/or where one can be purchased and 3) Where is that relay located on the 2015 model? If not, should resistors be used?
View 11 Replies
So my turn signal stalk doesn't go back to neutral after a turn.. also, I don't hear the usually " clicking when turning the wheel that you hear when it goes far enough to re-set itself. What controls this action? Its not the clock spring thing commonly referenced to the airbag airbag is it?
View 2 Replies
I've been having an electrical issue for the past few months that I've decided to address now that the weather is getting a little warmer.
What happened is the left turn signal was blinking fast, so I assumed bad bulb, and later that day it stopped blinking fast and now I press the lever down to indicate a left turn and there is a quite loud buzzing sound. Sounds like it's coming from where the relays are, but I've replaced them and the bulbs and still nothing has changed.
I've also replaced the multifunction switch to see if that was an issue, but a new one did the same thing so I returned it.
Running lights work all around, but now there are no left blinkers, and also my left brake light doesn't come on. Pulling a trailer I have the same problem, I had the plug tested and only 3 of the pins have anything to them.
I know nothing about auto electrical systems.
View 12 Replies
What is it that is making a fast clicking sound in the back under the car every time i turn my key to on?? It last for maybe 5 minutes or so then goes off...Not a clue !!
View 4 Replies
I have a 97 Buick Regal with turn signal issues. The left side will not flash but stays lit and the right side flashes fast. I have the problem isolated to the Daytime Running Light Module. (replaced turn signal stalk, flasher and bulbs). I ran a jumper wire bypassing the module and everything works as it should. Do I need to replace this module, or can I simply bypass it without it messing anything else up. I don't want my horn going off when I change the station on the radio.
View 1 Replies
My turn signal relay clicking and stuttering randomly. When turn or warning signal used it operates normally with absolutely no problem and sounds healthy. But when not used and supposed to be quite - it goes again. When stuttering - there is absolutely no indication other than clicking sound that something is wrong.
View 11 Replies
So the other day driving to work i was driving my car to work, i put my turn signal on and after i turn it off it still kept doing the clicking noise. At first i thought i was just hearing stuff cause it was early and i was tired, so after work i checked it out again i sure enough it was doing it. It even does it sometimes without even first putting the turn signal on. My buddy and i thought it was a relay or a fuse. Is that right?
View 7 Replies
Where the flashers are located? I turned my turn signals on to find the clicking sound, but I couldn't see anything under the dash.
View 9 Replies
I installed an EP27 electronic turn signal relay and changed the tail bulbs to Sylvania red 3157Rs in our Exped and everything works fine. I installed another EP27 in our Excur and the relay starts clicking when nothing is on and nothing else has been changed - all stock bulbs and working fine before.
No lights are blinking, but the EP27 turn signal relay is clicking away. Select left turn, right turn or hazard lights and they blink fine. Deselect the lights and the relay continues to click. Swapped the relay from the Exped to the Excur and it clicks, too. Reinstalled the stock turn signal relay and all is fine. There must be some difference or problem in the wiring, it doesn't make sense.
View 14 Replies
My 05 Malibu classic is making the turn signal clicking noise constantly which then causes the warning chime to start going off. I have replaced the turn signal assembly three times and each time it fixes it for a short time then it starts again.
View 4 Replies
My wife asked me yesterday what was that "clicking" sound when I turned. I never noticed it before, now I notice it constantly.
With the wheels straight - activate either side turn signal. Now turn the whee IN the direction your signal is activated, notice a clic-clic-clic??
Then when you turn back towards straight the signal will de-activate and the clicking is gone. This an indication the multi-function switch is going?
View 10 Replies
New owner of a 2005 Passat GLS TDI.
For some reason, the Hazard switch clicks a few times after using the turn signals (randomly), or while driving it will start clicking for a few seconds. The lights do not flash. it is only the audible sound coming from the hazard switch area.
Where does that sound come from? the hazard switch? Would replacing the switch with a new one fix it?
View 9 Replies
I turned the car on this morning and my turn signals don't work, there is no clicking sound when I flip the left or right signal and when I step on the brakes the brake lights don't illuminate. Needless to say the cars behind me don't like it when I slow down to make a turn. Can't be the bulbs and the symptoms make me think it is more than a fuse.
View 3 Replies
