Geo - Tracker :: 1994 / 1.6L 16V Engine Won't Start, But Cranks
Feb 28, 2015
1994 Geo Tracker 1.6L 16V engine won't start, but cranks. I have spark, compression is good, fuel (good fuel), new spark plugs, the crankshaft and camshaft are timed, the distributor is timed, there are no error codes but the ECU is fine.
I've put in new spark plugs and wires, new fuel injectors, new timing belt, new air filter. All sensors are hooked up and working. It cranks, but doesn't start. It keeps burning fuel, I can hear it and feel it in the engine, but it won't start and run.
One thing which I've noticed is weird is the crankshaft is very difficult to turn when it hits certain points. I try to turn it and it will go about a third or a turn pretty easily, but then it gets stuck and I have to turn the key to get it past that point. Then I try to turn it by hand again and it has the same problem in a different spot. It hasn't started in a month at this point, I'm planning on taking the distributor out and realigning it tomorrow, but I'm running out of things to test.
View 19 Replies
Advertisement
My kid is using my 94 Ranger with 215,000 miles. It quit while he was on his way to work. Engine cranks but won't start.
Fuel pressure at rail was 12 psi (Key on eng. off). I replaced fuel pump. Pressure at rail up to 20 psi. Still cranks, no start.
I replaced fuel filter. Pressure at rail up to 30 psi. Still cranks, no start.
Replaced distributor cap/rotor and plugs. I have spark at plugs.
Chiltons from 1994 doesn't list a rail fuel pressure. I see new fuel pressure regulators are set at 41 psi. I pulled mine and hooked air to it. It (FPR) cracks at 37 psi. I have lots of flow returning to tank, so I assume the fuel system is working correctly. I've never replaced the timing chain/sprockets. Distributor rotor spins during engine cranking. When I rotate the crank pulley to 0 Top Dead Center the rotor is pointing to #1 on the distributor, so I don't think the timing chain has skipped a tooth on the sprocket??????
View 4 Replies
1994 Caprice Classic (350 cid LT1)... Engine cranks very slowly, almost doesn't start, sometimes starter disengages/re-engages. 1year ago mechanic checked batty, alternator and starter, all ok. I had starter replaced as it seemed the most likely cause. Eventually got better but now is worse again. Also notice a lot of movement on the dash voltmeter needle, sometimes high, sometimes low, turn signal moves the needle. Ive spent hundreds of dollars on troubleshooting and the new starter. What could be causing this?
View 4 Replies
1994 geo tracker... I'm trying to get my A/C working, but I'm running into an electrical issue somewhere. The relays for the condenser fan and compressor are not activating, even though they are getting 12V when I switch on the A/C. I can run a jumper across where the relay would switch and both turn on and my A/C is cold, but it won't do it without the jumper. I've traced back from my battery to the A/C and checked my dual pressure switch, I'm slowly trying to pick out wires which may have fried.
Both relays work when connected to the battery alone. If I jump the 12V and ground on the harness for the compressor and the harness for the condenser fan, they kick on and A/C is cold. Fuses are good, dual pressure switch is good? It's almost like the relays aren't getting enough current to activate, one of them the switching signal reads only 4 V which is too low, that's for the fan. The compressor reads 12V though on the switch. When back probing them with the relay connected I only read 0.25 V, I don't know if that matters or not.
View 9 Replies
Ok so i bought a 1994 celica GT from a police auction the other week and it wouldn't start so we went ahead and put a new fuel pump in it then we put new spark plugs in it. When removing the spark plugs i saw there was oil on them. My friend suggest we do a motor swap cause he thinks its a blown head gasket. Could this be an easy fix or should i go through with the swap?
View 5 Replies
I got a caprice 94 l99 it was driving perfect. i was on my way home then it started to put put then the engine cut. gave it like 3 mins it started drove 1 block started to put then the engine cut. now doesnt start at all just cranks the gas gauge says it has 1/4 tank of gas.
View 5 Replies
94 Saab will not start in the mornings , it cranks but wont fire , runs fine later in day with no problems at all . Than next morning a repeat performance of not starting.
View 10 Replies
My 1994 850 turbo will crank but will not start. it started when the car was having trouble accelerating past 40 mph and felt like it was kicking back then it died on the freeway and now will not start. i ran the error codes and got these back, from A2 452, 455, 543, 544, 545, 552, 555 and from A7 122. I'm not sure what to do?
View 4 Replies
I have an '02 Tracker and I've noticed if I have several accessories running, that my engine will start to sputter and come to the verge of stalling when I come to a stop. It happens if I have the heat/air and radio or charging my phone on together. What is the cause and/or remedy for this? I've changed the alternator a few yrs. back, but it still continued.
View 2 Replies
The problem started several months ago. At first it would only happen once in a while and would only last about 5 mins. The first time it happened I had it towed to my shop and it ran fine when it got there. Go figure. They told me they couldn't diagnose it if it wasn't acting up while they had it. Makes sense. But it never does it when I'm there for routine maintenance. Now it's doing it for twenty minutes at a crack. It's usually fine around town unless I get stuck in stop and go traffic. When it usually acts up is when I get on the road between work and home.
Every time I stop for gas I have to wait for it to decide it wants to start again. All of this is putting heavy wear on my starter. I changed the oxygen sensor (position no. 01), because that was the only error code that showed up. That didn't fix it. My mechanic says he thinks the next best step might be the cam and/or crank sensor. If not that, then he thinks we should change out the brain. Somebody else said it might be the fuel pump goin out. because I travel too far for work and I can't afford to fix things that probably won't solve the problem.
View 1 Replies
I have a 98 Chevy Tracker 1.6 auto. My OBD reader shows engine load @ 25% in park at idle. What would cause this.
View 5 Replies
2003 Chevy Tracker 4 cylinder. Engine rebuilt and cannot get lifters to quiet down. Replaced 3 times. Bent valves on first install.
View 3 Replies
When I turn the key to start the engine, it makes the sound (I don't know what to call it) that it makes before the engine actually starts but it just keeps doing that. The dash has the battery light on in red so I think that might be the problem. It also flashed "STOP" at me on the dash so I stopped fiddling with it.
The dealership is only a few blocks away but they are closed until tuesday. What is usually the problem in this case? I know almost nothing about how cars work.
View 6 Replies
I drive a '99 Chevy Tracker with the 2Liter engine, a 5 speed manual transmission and 110K mi. on it. When I lift my foot from the throttle pedal in preparing to shift gears the engine takes a very long time to reduce it's RPM. This is a problem, when up shifting, as the transmission is spinning too fast for smooth gear engagement.
The engine idles normally under all other circumstances. It is only slow to decelerate whenever I lift my foot from the throttle pedal. This makes up shifting very slow and/or causes the gears to sometimes grind slightly.
View 3 Replies
I have a 99 Town car and have problems starting when it is cold (under 20 degrees). The engine cranks. If I jump it it will start after about 30 cranks then it runs fine. Looks like a lot of carbon being blown out the tail pipe. When it is warmed up it starts fine and runs fine, just won't start early in the morning when it is 10 degrees outside.
View 4 Replies
I went to start my car this morning it cranks and nothing it is not firing at all, and I do not hear the fuel pump when I open the door like I usually do. It just happened all the sudden. Is there a way to check fuel pressure in these in the W8? Also any known problems to make them do this? So irritating...
View 4 Replies
I just purchased an '01 Elantra a few days ago. The car starts and runs when the engine is cool, although it hesitates during acceleration, and when it's warm outside it bounces between 1000 and 2000 RPM in neutral and park. The last day or so it's been chilly and the idle has been steady, but low (500 RPM). Once the engine warms up, however, if you shut it off for a few minutes and try to restart it cranks but won't start until the engine cools off.
The previous owner replaced the fuel pump, cam sensor, crank sensor, spark plugs and wires, and I replaced the intake gasket and the idle air control valve, all with no effect. I can hear the fuel pump when I key it on, and I've checked for spark at each of the plugs, and even pulled the injectors and cranked it a few times to be sure that they were firing. Everything seems to be in working order.
View 24 Replies
So I bought a project golf vr6, but the head and some of the components were off, I have all the parts but I just cannot figure out why it is not wanting to start, it cranks over but does not start...
View 1 Replies
I have a 1997 GMC Safari van with 175,000 miles on it. One month ago it wouldn't start. It would crank and crank but just not fire. When I turn the key I can hear the fuel pump start. I have other transportation available, so I just tried it a couple of times a day with the same result. Some history: about 5 months ago I had the fuel pump replaced. Finally I gave up and had it towed to the shop that had replaced the fuel pump. After it was unloaded from the flatbed, the mechanic tried to start it and it started normally. Since it started, I had an oil change done and had them check all the connections. Afterwards it started normally. I drove it for a few days with no problem and then one morning the same problem- cranking but not starting. Being stubborn, and with tight finances, I tried to start it every day for a week. Same symptoms. Finally today I had it towed to a different mechanic recommended by a friend. Of course, when it was unloaded from the flatbed it started right up. Any theories?
View 2 Replies
I have an 08 2.4L Sonata with 95000mi. When turning the ignition it will crank and sound like its about to start but won't. I was able to get it to start by pushing the gas pedal a bit when it sounds like it wanted to start. Once started, it ran rough and would stall unless I revved it above 1500 RPM. Still sounded like it occasionally miss fired.
I kept it revved until it reached normal operating temp. When I took my foot slowly off the gas, rpm dropped to about 500-600 and it seemed to pulse . I think engine was raising throttle to keep from stalling. It stalls if I try to put in gear without pressing on gas to raise throttle.
The spark plugs were changed at about 70K mikes. I have not read any codes as the car is stuck in the driveway. Could it be a vacuum leak? I know the Entourages have air intake hose leaks that cause rough idle but with a 6 cyl it still runs. Fuel pump problem?
View 11 Replies
This Geo Metro 3 cyl engine cranks with spark, but won't start. I replaced the fuel pump, fuel filter and fuel pump relay. The fuel pump does not make a noise. What could it be?
View 12 Replies
