What gasket is this on my 2002 cavalier the one behind the oil check thing ? its leaking
My car idled and died 3 time today ,and that gasket was leaking
52672b16-e04e-4439-8cbd-944eb5e99d89.jpg 44.66KB
OK, we have a cavalier that is slowly dying but until we find a good price on a used car we are looking at it has to keep chugging along... It started to overheat about month ago, just when you go up a hill otherwise it is fine (doesn't overheat but a few lines from the red zone!). Mechanic said it was a head gasket and we have noticed that the coolant level is down slightly... can it be a head gasket yet still drivable? Also about 2 months ago the car needed a new water pump, flushed and filled, could it just be the new water pump was bad? No other issues, heat works fine, no puddles under the car etc....
View 14 RepliesMy radiator was leaking and I accidentally boiled it dry. I put water back into the cooling system, but now my car won't start. Anything I can check to try and get it to run before I get it towed it to a mechanic?
View 1 RepliesMy 1994 chevy cavalier is overheating mainly on hot days and when I work the engine hard. My coolant level hasn't dropped in a long time and the coolant cap is usually dry. I replaced the thermostat and checked the radiator hoses. They seem to be fine. My engine is leaking coolant.
(See photo) : IMG_2308.JPG3024x4032 2.61 MB
I have a 1994 Corolla, and it's at 107,000 miles now.Recently it stalled on the freeway, and I had to put in $600 to replace the distributor. That's what they told me that it needed at Firestone.They also told me that the gasket valve cap is leaking and that the sync belts are worn out and may stall it again any time soon. I don't currently have the $ to fix those two issues, so I only paid for the distributor.
I have no knowledge of automotive maintenance, and so can't verify that the information is correct.I noticed that the car shakes much more now, but it could be just my being more sensitive and paranoid.Today, I started driving to work, but noticed that when I am stopped at a red light, the break pedal sends a strange vibration occasionally.I don't know what could be causing this, but I decided not to risk it and just return home.I am now facing a dilemma. I can either go and repair the gasket valve cap and the sync belts for another $300 or so after I get the next paycheck, or I can look for a replacement car to buy. I am not sure I can afford even a used vehicle now.
My car was just in the shop for the 30K service and the tech noticed quite a bit of oil leaking from the gasket between the CTS pcv system and the engine. He said that because the catch can lacks the ability to release the pressure coming from the engine, it started to eat at the gasket and it now leaks... he recommended that I take the catch can off. I thought the system vented pressure into the intake...
View 3 RepliesI have a 1995 GMC Sonoma pickup truck with supposedly a blown cylinder head gasket. It only has 53K original miles on it. It overheated and I had it towed to a service shop. They put in a new water pump, new coolant, new thermostat, new radiator hose and did an oil & filter change. Well, 100 miles later, I noticed my water coolant was disappearing and the oil pressure was rising. I brought it back to the same shop and after looking at it for five minutes they informed me it was a blown cylinder head gasket. They said they had no way to determine this when they were doing the repairs the first time. So, I ask the following:
1-Was it proper for the shop to do the first repair without checking for a potential head gasket leak?
2-Is there some type of testing that could have been done by the repair shop to check for coolant leaks into the engine oil? 3-Would I have saved money (labor) by having this taken care of at the time of the initial repair?
93 Hyundai Excel 1.5L, 130k miles. Oil pan gasket leaking like crazy, took pan off and cleaned everything up real nice in preparation for new gasket.
Looked in the bottom of pan and noticed this thing sitting in it (the sleeve looking thing, not the nickel) it isn't a magnet, and looking up into the bottom end of my engine I couldn't see anything that looked like it. Here's a pic: [URL] .....
The inside is smooth, no threads or anything. It is metal.
2002 Camry 4 Cylinder. 140 K miles
I am pretty sure the oil leak I spotted is from the oil pan gasket. (Interestingly I searched and didn't find many posts about this, that makes me wonder if this is not a typical issue.)
Is there anything that blocks removal? Does it just drop out after undoing the bolts?
Also can I get the felpro gasket? Do I need any sealant?
I have a 2000 Toyota corolla with about 170,000 miles and it is using about one quart of oil every 500 miles. The last couple places I took it to said the compression was bad in the number 4 cylinder. Another place said it was a leaking head gasket. Which is most likely, and is it worth getting it repaired given its age and mileage?
View 13 RepliesA year ago (to the day), my car (2006 Hyundai Sonata) died on me while I was driving it. My boyfriend came and gave me a jump. The car got home fine. The next morning, we went out to the car, and the battery had died, so we jumped the car again, and got to the battery place and bought a new battery. I was worried there was another issue with the car- but my boyfriend was all like "You are feeble woman who knows nothing about cars" (kidding, kidding) so I listened to him and drove the car off that afternoon. On my way home, car died again. So, this time, we got the car towed to a dealership to get checked out. Well, turns out the head gasket was leaking and there was oil in the alternator. SOOOO. The dealer replaced the head gasket for free because the car had a warranty on the engine, but we were SOL with the alternator. So, we bought an alternator from a friend, and had another friend install it for us.
Yesterday, I got out of work, and car wouldn't start. When my DF came to jump the car, he and I could clearly see the head gasket is leaking again and there is oil in the alternator. I have a couple questions that I need answered...
1.) What causes a leaky head gasket? My boyfriend said that either the engine block was warped or that the replacement they put in last year was faulty. Are there other ways?
2.) How the beep do you replace the alternator in the 2006 Hyundai? It is in an odd location and we don't have access to the person who did it for us last time, so I need to see if this is a job my boyfriend can do. He does work on his car all the time (an 87 BMW), but he's never done anything on this car besides change oil, etc.
A little bit about this car: We bought the car from a Hyundai dealer in June 2010. It belonged to one of the dealer investors, so it was in great condition. However, we think the car was in a front-end accident. When my boyfriend waxed the car awhile back, it was pretty obvious that the front bumper was replaced as well. The dealer refuses to give us any mechanical records about the car (will only give us verbal summary) ...
My son-in-law came by tonight and showed me his ticket from his oil change at the dealer on his '08 Azera, 108k miles. Tech remarked that both valve cover gaskets AND the oil pan gasket were leaking. I've walked through his garage many times when my daughter has the car at work and I've never noticed any oil on the floor. Should have I seen any? I told dealer I would just drive it and monitor the oil level and any other signs of oil leakage. Since he bought the car with 101k miles and a fresh oil change ticket and never checked the level over the next 7k miles I don't think it's leaking bad.
View 2 RepliesI took my 2007 Saturn Aura for a scheduled oil change. They did the change and than called me into the shop to show me an oil leak. I was told that the oil pan gasket is leaking oil onto the exhaust and I could have a fire if I didn't get it replaced. The thing is that my car has been parked in the same place on my driveway every day for 5 years and has never dripped a drop of oil on the concrete. The car has only 30,000 miles and has been well maintained. How likely is it that there is a real problem with the oil pan gasket?
View 15 RepliesI have a 1998 Subaru Forester that is leaking oil through the head gasket. Repairs for the head gasket seem to be in high range, which is at or above the value of the car. Is trying any of the head gasket sealant products such as Blue Devil worth trying? Do they have the potential to do more damage than good? I love the car, but I'm also not sure if it is worth getting if fixed or if I should be looking to sell it for parts and buy a different used car.
View 15 RepliesI brought my 2002 F150 into the shop because of a small oil leak. I thought it was coming from a leak in the gasket of the oil pan which the shop confirmed. I changed the oil and put in the Lucas oil product that can seal leaks in gaskets (sometimes). This didn't work. I continue to have a small oil drip, more annoying than anything. I am not having to add oil continuously.
To change the gasket the shop basically quoted me $1,200 because on this engine size you have to drop the engine etc.
I am looking for alternative solutions, recommendations, etc. I can live with the leak but would prefer to fix.
A couple of days ago, I was driving my car around when the oil pressure light came on. Having recently changed the oil myself, I figured I had neglected to tighten something down there and it had become loose and was leaking oil. I stopped at two different shops. Both shops told me the leak was coming from the valve cover gasket. Instead of paying $200 for them to replace it, I did it myself. I didn't use any sealant or silicone, or anything like that. The old gasket was hard as a rock and had some sort of red cement around it.
After I had everything back together, I had a partner start the car for me. The oil leak has become much worse--probably a quart a minute. The thing is... I can't see any oil leaking from the valve cover gasket. You would think that an oil leak of that volume would be visible if it were coming from the top of the engine, no? We're going to take the gasket off again to inspect and perhaps use some gasket sealant in select spots, per some YouTube videos we watched.
I'm thinking of purchasing a 2001 GLX VR6 Jetta with lots of deferred maintenance (shocks/struts, brakes, exhaust). Most worryingly, the valve cover gasket is leaking oil. The price is pretty low, but is such a beast worthwhile at any price or is it better parted out? And the interior is about as beat up as the mechanical--screeching passenger window motor, broken glove compartment ... Is this thing worth being brought back to life?
View 6 RepliesI have a 1997 Saab 9000 CSE Turbo. It has been a great car overall. Last summer, our water pump died while cruising on the highway, leading to a major overheat, leading to warped head. We decided to roll the dice on a rebuild, which was done by a reputable import specialty shop that has worked on many Saab 9000s. Since we got the car back 5000 miles ago, we have lost a few miles per gallon, and we hear a rough noise in the engine (particularly when it's cold). In the last few thousand miles, we lost a lot of coolant, apparently because the new water pump is faulty (the shop looked at it and agreed to replace under warranty). In the last 1000 miles (but no evidence of it previously), we have begun losing oil like crazy and occasionally (but not most of the time) smelling burning oil (the heater is on, moving air around). We are now adding about a quart per 200 miles. When we inspect the block, there is some small evidence of oil leakage, but not a lot, and there are never drips on the driveway.
Where is all that oil going? I showed it to the shop, we put it on the lift, and there is no spray on the underside, leaking oil pan, etc. I suspect the new head gasket is leaking, but there is little enough residue on the block that it's hard to be certain. What other explanations are there, and is it fair for me to blame the repair shop and insist that they redo the head gasket? The shop is a 6hr drive from my house, so I can't just drop by to discuss it with them.
I am working on a friend's 2002 Camry 4-cylinder on which I recently replaced a leaking head gasket. Since that was competed the car runs fine but it has been throwing the P1346 code indicating VVT/Cam position sensor performance problem. I have a code reader and I have cleared the code a couple times and it re-appears each time after driving the car a while.
I also have a 2005 Camry with same engine, so I switched the cam position sensors between the two cars and the code showed up again on the 2002 while the 2005 still is running OK, so apparently the sensor is not the problem. The 2002 had been worked on before (some head bolt holes were stripped and I had to install inserts for all the head bolts - I used NS300L inserts) and whoever did the previous work was very rough with moving around the wire harnesses, etc, so I suspect it is a bad connection causing the error code.
My question is: can the car be driven in this condition OK, or is there a potential to damage something if the VVT is not operating? I checked the basic valve/crank timing and it is OK, and the engine feels/sounds like it is running very well. Should I be worried about this, or can I wait for a convenient time to try to find the source of the problem?
So when I had my timing belt done my mechanic showed me that I had some transmission oil leaking It didn't look like much but looked like it was coming from gasket my v6 Passat has 200k on it and I heard that transmission fluid shouldn't be changed on any car with high mileage the transmission doesn't really act up sometimes when its cold it takes a little bit of time to shift to first but when its warmed up its just fine, what are my options, a full drain and filter change, which I am skeptical about. Adding some new fluid, I just gotta know if I gotta replace the drain plug. and then just a fluid change drain and add.
View 7 Replies2001 Chevy Silverado with a 5.3 L engine and a leaking head gasket that was getting worse (at 217,000 miles). Car has rusted body (upstate NY), so not going to spend too much for repairs. Decided to try one of those "magic elixors" in a bottle. Went for the Bars Leaks head gasket repair stuff - Followed directions, etc (put it into the top radiator tube, NOT the overflow bottle). The stuff had little strings of copper-looking stuff floating in it. It worked. After a little more loss of coolant, the coolant loss has finally stopped. Amazing that something like this really worked.
View 7 Replies