Ford - Windstar - Gasoline - Filters - Pump :: 2002 SEL - Long Crank Time
Feb 24, 2011
I have a 2002 Ford Windstar that only in the fall and winter it has a longer crank time of at least 10 seconds. In the summer it starts as it should within 3-4 seconds. I did notice that the times it did start normally in the colder air is when I turned the key on and listened to the fuel pump prime the system. All other times it doesn't do that and that's when I get the long crank time. Once it is started it runs as normal. Am I looking at a possible fuel filter or pump? I am due to replace the filter as the van has 83,000 miles on it. If this is the possible culprit, is this something that is easily replaced at home?
View 4 Replies
Advertisement
I have a 2000 Ford Focus SE with DOHC that is losing power and sputtering when it gets hot after driving for 30 min or more. If I shut the car off and right back on going down the highway it will be fine for 5-10 min and then start sputtering again. If the car is not hot this does not happen and I have a new fuel filter and coil pack as those are the two main things that I could think of. I have seen intake valve seat and fuel pump as the two most common fixes with similar circumstances.
View 7 Replies
So my 2002 ford explorer with the 4.0 L V6, has been cranking along time before it starts. I thought i had this figured out already, i put a brand new fuel pump in it from the ford dealer. That seemed to work, but the problem came back.
Especially when it is cold, it cranks a lot longer than normal to start. and when it does start RMPS go way up briefly and come back down. Seems to only act up when its cold out, say 35 degrees and lower.
So the remote start wont work because it only cranks for a few seconds and then stops. it tries this three times and it gives up. i go out there to start it and cranks for 10 seconds it seems like, sometimes i have to feather the fuel pedal.
View 7 Replies
After all my attempts, I could not fix the rough idle. I have done the gaskets of the gaskets and bolts of the intake manifold (the engine light disappeared), I have changed the bushings of the manifold too (the one one the left side), I have changes the TPS sensor, I have cleaned the MAF sensor...
The rough idle is still there (and getting worse) and there is some smell of gasoline now. I suspect that I have to change sparks and cables, but I wanted to confirm first with you because the whole thing seems complicated as some of the plugs are buried very "conveniently". You could usually feel an ascending vibration while waiting at the traffic light. You can't feel it as much when in neutral, but it is still there.
I have noticed that on the right side of the Intake manifold (under the throttle) there is some sort of greasy substance that always looks wet. I suspect that it is burnt oil, but that think's been there since I bought the car, so I am not sure if it is related in any way.
I haven't changed the oil and air filter since last summer but I doubt that would be an issue. Additionally I realized that I put pure antifreeze when I need to use 50/50. Anyways, those things I will fix this summer anyways. All I want to fix now is the rough idle because these vibrations drive me nuts.
View 5 Replies
So how long does one have to crank until it is considered an extended crank? 2 seconds, 5 seconds, 10 seconds.....?
The reason I ask is after all the motor work I did on my truck sometimes she fires up in less than 1 second of cranking and other times it take maybe 2 seconds of cranking. I do not think 2 seconds is considered and extended crank time but was just curious about what is considered extended cranking.
View 12 Replies
I have a 2006 F350. I have long crank times. No Codes. I have Autoenginuity with Enhanced Codes and everything shows fine. I replaces standpipe and dummy plugs. Glow Plugs and harness. I was hoping it not be the STC but I needed to do oil cooler so wanted to eliminate STC. Got truck apart and the STC Fitting is newer style so I'm kinda bummed out. Not sure if I'm missing something and as far as I have it torn down is there anyway to test what could be causing the problem? Or just put it back together and keep my fingers crossed that whoever put the new STC fitting in screwed it up. I'm beginning to not like my truck.
View 8 Replies
Removed my oil rail to replace standpipes/dummies (04 Wavy rail) and now I have huge crank times to start. This is after the initial Huge crank to get it started. Do I have air in the system, or did I bugger something. I did the whole deal very careful. I lifted the rail up very carefully, pipes removed. I lined up the rail nipples with the injectors and evenly pressed it back in place, and then inserted my dummies/standpipe. Tightened the rail to 120 inch lbs then the dummies/standpipe to 60 ft lb. I did my son's '06 a month ago with no troubles. (didn't remove rails though). Once running it sounds perfect, turn it off and re-start and it's a long crank (30 seconds or more). I have not monitored ICP/IPR while running, will try that today.
View 8 Replies
The past couple of cold starts (not real cold mornings though) I have experienced long crank time to start. Once started she starts normally. No time to read but I'm getting a little worried that I'll get stuck somewhere. I'll check back with my phone when I get into an area with cel service.
View 14 Replies
So ive had a starting issue in the R32 for quite some time now. With waterfest approaching and the new S3 going into production that i ordered, it has come time to finally fix it. I have taken in to many dealerships and very talented techs, and no one has any idea. The car seems to crank for a very long time or start right up and then just completely stall and die. The second time i start it, it starts completely fine like nothing ever happened. This only happens when the car sits for a few hours. It has never done it if the car has sit overnight or during the cold months. It has to be warm and sit for a specific amount of time. Its like it catches the car transferring into a cold start but not fully cold yet, if that makes sense. Also i am now noticing a small squeak each time it starts, like a belt. I have replaced the fuel pump/spark plugs/coil packs. Nothing has changed. We thought maybe a stuck injector but were doubtful as its not constant. Im debating a cam position sensor just to see if thats the issue. There is no CEL or any codes.
View 12 Replies
I have a 2006 Sonata GLS with the 3.3L V6 and close to 230,000 miles. A few months ago I noticed that my crank time at starting was longer than typically - it has steadily gotten worse.
Now the crank time is close to 8 - 10 seconds. (Which might not seem like much but trust me, it is).
I suspected that the fuel pump was faulty, however, once started - it runs great.
I put a pressure gauge on the fuel pump outlet and found that it only kicks the pump on when the car is cranking, the fuel pump does not kick on when the key is in the "on" position. Once the vehicle starts, it seems to be drawing fuel.
The pump has all sorts of pressure, I am not worried about that.
I decided to change the Fuel pressure regulator valve thinking that maybe it wasn't holding pressure - That didn't seem to do anything.
Do I need to change the entire Fuel Pump Assembly?
View 5 Replies
I recently (in the last few months) have noticed my truck (1999 F350 duallie) seeming to be running very rich … I pull a 32' trailer with it and noticed on the art few trips the front and right side of the trailer covered with diesel fuel spots when I got home …. It also smells very rich when idling…. The last couple times I started it in the mornings it seems to crank a very long time before it starts …it still runs but its got issues evidently … it has these 3 codes :
P1280
P0475
P1670
The 1670 will clear , but the other 2 I can't clear, they are right back every time you turn the key on …
View 14 Replies
I own 2013 Mk6 GTI. I am having to over crank the engine for a period of 8 seconds or so before the car starts, especially after it has been sitting for a few hours. My thought was a faulty check valve in the fuel pump. I have heard that our fuel filter has a built in pressure regulator that may get stuck open for whatever reason and that may also cause a long crank time.
View 9 Replies
I have a 1988 Dodge pickup 1500 with a 5,9 gas engine. It used to pop right over all the time. Now, in the morning, I have to crank it forever until it starts, and if it sits for 1 hour or more, same thing (have to crank for a long time). It is my understanding there is a valve called a one day valve that holds pressure on the gas line. Is it possible this valve is not working properly? And if so, do I have to replace fuel pump to fix problem? once started it starts up with no problem until it sits for hour or more then hard to start.
View 15 Replies
Car does not have to get wet, just be in humid air. Problem going on 2 years now, mechanics tried disconnecting a (?) ground/sensor from computer, major tune up, new fuel pump. Until recently, it just took keeping it in crank position for a long time for it to finally start. Recently, in crank position for 30 seconds does nothing and has me worried I'm doing damage. In dry weather, it starts first time every time.
View 12 Replies
Little background- this is my first winter in a diesel truck. When I purchased it- it had 4 glow plug codes. Everyone around me just told me to plug it in and fix it later, that if I plugged it in, glow plugs don't matter much.
Had hard starts all last week with temps down to -20, turns out my block heater wasn't turning on due to a bad cord. Replaced cord end today. Let the oil temp get up to around 60F according to torque pro.
Still had a long crank despite warmer oil (15ish outside). Batteries dip to around 10V when plugs are on, then cranks at around 11V. Lots of white smoke which I know is normal.
I still had to fight with it a little bit to get it to start, as soon as she was actually going- runs flawlessly, no lope, no smoke. Runs and drives flawlessly. If I turn it off, she fires right back up instantly every time without hesitation, until she cools off again.
From what I'm seeing I'm thinking my batteries are fine, and my starter is probably fine. Are glow plugs making this big of a difference even though the truck is plugged in?
Truck has 0 codes when warm, 0 blow by, drives fantastic, Just under 300k miles. The only thing I'm thinking of is the glow plugs need swapped. I have a set of ZD11s sitting in the truck waiting for a warm day.
View 6 Replies
I have a 2002 v8 lse with 92000. When i go to start it after it has been sitting for 20 minutes or more it cranks for a long tome before starting. When it does start it idles fine but has a strong fuel smell. There are no codes and no problems once it starts. However it starts up right away in cold weather. It seems like a flooding issue. The fuel pressure is within range but it does seem to bleed off quicker than most cars i work on when the engine is no longer running..
Unfortunately I don't have the specs on on fuel pressure runoff. I suspect the fuel pressure sensor/regulator. I don't believe it would be an injector due to the fact it never runs rough or misses once started and if it was the pump it wouldn't give off a fuel smell in the exhaust once started.
View 14 Replies
I have a 2002 celica after sitting for a hour or so car has very long crank....
View 1 Replies
My wife's Pathfinder (a 2002) has developed a problem with slow starting. The car cranks well (even at -20F, so it's not a weak battery) but takes a long time to start. It might crank for 5 seconds before sputtering to life. After being driven and shut off, most of the time, it will start up instantly again, just like it used to before the problem started. The problem is intermittent in that it sometimes starts pretty quickly in the morning, although it's not the instant start that it used to be, it might only crank for 1 second or less. I know that sounds like a normal time for a car to crank before starting, but the Pathfinder used to start, almost literally, instantly after the key was turned. So, even 1 second is an uncharacteristically long time.
What I've done:
-- Replaced spark plugs
-- Swapped the starter relays with identical relays under hood
-- Replaced fuel filter
What I haven't done:
--Replaced fuel pump
--Replaced fuel pressure regulator
Both of these are somewhat big jobs (I think I can handle both of them) and more expensive than what I've already done, so I'd like to get some input on where the fault could lie before picking one. Or, am I completely off base thinking it's fuel system?
View 2 Replies
ok, i just became the proud owner of a 71 dodge dart.. fuel pump was not working, and am converting to an electric (airtex e8016s) and am told i need a relay. airtex doesn't seem to have one, is there another i can use? fairly new at this sort of thing, but have fixed a 72 honda motorbike, so not afraid of engines or whatnot.
View 19 Replies
I just got delivered a 7.3L from down south. Batteries were dead so replaced both. Fuel was a couple notches above red line (much closer to red line than 1/4 tank) so I added about 7-8 gallons.
It will crank forever and ever...Won't start.
With starter fluid it starts but not strong enough to pump the pedal and rev it up to keep it idling.
I know s-fluid is bad but if I continuously spray with key turned forward it will run but as soon as I let go of key it shuts off.
20 degree weather and it was delivered to a parking lot so I cannot plug it in.
Was told to check filter cap, turn key, and see if it fills bowl with fuel....if not then it is fuel pump. Someone else mentioned that it could be bad crank position sensor? Does this sound like fuel pump?
View 2 Replies
I have a 2002 Chevy Cavalier that stalls ever time it is fueled at the pump. It then continues to stall. I have to pump the gas like the old days when we all had carburetors and repeat the action many times. It always starts eventually, but causes unnecessary anxiety so I always fill my car at a time I don't need to be anywhere in a timely manner. It was taken to the shop but they could not reproduce the stalling, as they did not have the information that it mostly happens at the when fueling. The gas cap can be taken off for a while and it starts okay. The rpm is low after adding gas, if you give it gas, it runs then eventually idles normally.
View 6 Replies
