Ford - Windstar :: Front And Rear Alignment?
Feb 28, 2011
Are both necessary?
View 4 Replies
Feb 28, 2011
Advertisement
Ford Super Duty (1999-2016) :: 2015 - Alignment Of Front Spline On Rear Driveshaft?
Proper alignment and re-installation of the front spline on the rear driveshaft of my 2015 F350.
I removed my rear driveshaft recently (it slipped right out upon removal without any force or resistance), and I'm getting ready to re-install it again this weekend, but I've noticed that one of the grooves between the array of male splines on the shaft itself appears to be slightly different than the rest - it seems to be slightly wider. It even has a white-colored stripe of paint down the full length of the groove as if it were denoting it as being somehow different from the rest?
Problem is, when visually inspecting the splines on the inside of the receiving yoke (the part that the spline fits into), I do NOT see any such differences. In other words, it doesn't appear that there is only ONE way to properly insert the front splined-end of the driveshaft. What am I missing here?
Is the front splined-end of the rear driveshaft intended to be inserted into the yoke in ANY position around the dial? Or is there only ONE specific position or orientation that it is intended to be inserted or installed? NOTE: I've seen references elsewhere on-line that seem to indicate the need for proper alignment when there are multiple U-Joints, and maybe this is a part of it (?), but I'm not quite sure which U-Joints to consider or how to interpret such an "alignment".
Windstar :: 2002 - AC Blows Cold In The Rear But Not The Front
2002 Windstar A/C problem. Blows cold in the rear but not the front. Blend door actuator in the front is operating properly. Compressor cycles on and off but not excessively. When temp levers in full warm air blows to floor but it is not warm. Compressor runs even when the A/C on/off switch is in the off position. Indicator light is off but compressor still runs. Condensate puddles on floor in rear but none in front under vehicle.
View 8 RepliesFord Aerostar :: Pulling Slightly To Right - Front End Alignment
Had upper control arm bushings replaced in June. Van has been pulling slightly to the right. Assumed it could be the tire since the front tires were due for replacement. Took it yesterday for two new tires and it still has slight pull to the right.
Here's the rub. The chain shop that did the work has since replaced their alignment machine and the new one does not have the specs for vehicles earlier than 2000. The machine also doesn't have the capability for manual input of the specs.
The manager has found a competitor that has an older machine and has arranged to pay for the alignment which I consider over the top. Evidently this is a trend we can expect to continue because in a city the size of Tampa, he could find only one shop with an alignment machine capable of alignment on an Aerostar.
Ford - Windstar :: 1999 - Quick Grinding Noise From Front End
i have a 1999 ford windstar with 73k miles. torque converter was replaced before I got it. (about ten thousand miles ago)my van gets a quick grinding noise from the front end that lasts only a second. it only happens when i start the car and then drive about 100 feet. if I shift to park and then back to drive it won't do it. only if the engine has been stopped and restarted (even if warmed up)the transmission doesnt slip, and shifts fine. I'd love some ideas before the expensive (and only) local mechanic starts digging around.
View 19 RepliesFord - Windstar :: Ticking / Clicking Noise Coming From The Right Rear Tire
Our 2002 Ford Windstar has 78k miles. On 6/2/15 we had the brakes replaced. Soon after I noticed a ticking/clicking noise that sounded like it was coming from the right rear tire. It only happened when I braked and then only happened sometimes. It didn't seem to matter if the car was cold or had been running awhile, if I was on flat ground or on a hill, or if I had been going fast or slow. I couldn't predict when it happened. The car always stopped okay. So I took it back to the repair shop, and they made an adjustment and it was quiet. Two days later it started again, so I took it back. They machined the rear drums and the noise was gone. Five days later I hit a rough patch of pavement and when I braked the noise started again. Back to the shop. They had one of the mechanics ride with me. No noise of course. They said to bring it back when it makes the noise. Well, it has made the noise, but only a few times and I can't predict when it will happen. The car runs fine and brakes fine. I trust this repair shop. They've worked on the car in the past.
View 1 RepliesFord - Alignment - Escape - Noises :: Whom Sound Coming From Front-end Between 45 And 60 MPH
Two months ago, my 2011 Ford Escape (27,000 miles) was sounding great. I took it in for a standard oil change and tire rotation. When I picked it up they mentioned that they found a nail in what is now the passenger-front tire and patched it for me. When I drove it home, I could hear a sound like "whom whom whom whom whom" coming from the front-end between 45 and 60 MPH.
I gave them the benefit of the doubt and drove it for 2 months until yesterday when I finally had enough and took it back to have them look for a cause to the problem. They said it needed an alignment and we went ahead and did that. HOWEVER, they said that after the alignment, the car would make the same sound for 500 to 1000 miles and then it would go away. I got the car back, and at best it sounds the same, and at worst it maybe sounds worse than it did.
My question: Is there any reason the car should make the same sound for 500 to 1000 miles after the alignment? Also, was it an alignment problem or do I need new tires or something else? I suspect I have been screwed by the dealership.
Ford - Windstar :: 2000 Stopped Putting Out Heat To Any Front Vents
Ford - no front heat - 2000 Windstar - actuator
My Dad's 2000 Ford Windstar van stopped putting out heat to any front vents. I was able to hear a rhythmic thumping sound when the heat control slider was placed in the hot position. I looked for info on line, and found many posts that said the actuator was probably the issue. I also went back and asked my Dad if before the thumping sound he had heard anything else, and he confirmed he had heard some gear grinding noises, which others have reported as the actuator is starting to grind and slip its internal gears. If the actuator is not working correctly, it won't hold the heater duct door in the open position, which means you can't get any hot air.
Ford - Windstar :: 2003 - Grinding Front Brakes On Occasion When Coming To A Stop
My 2003 windstar SEL needed new brakes and to have the rotors turned... instead I opted to buy new discs and pads online ... To my surprise the new discs were about a 16th of an inch thinner than the old.... I changed discs and pads and was happy for a few days, but now on occasion when coming to a stop the front brakes grind terribly....the next time i stop everything is fine...visa versa...dscs feel true (no pulsing) I DID APPLY BRAKE QUIET TO THE BACKS OF PADS....
View 2 RepliesPrius (Gen 2) :: Rear Toe Needs Alignment?
So my rear and front toe is off and is causing inside wear on the rear tire. I want to add a shim to fix it as the rear axle would be too costly to change.
Also how much would I need to fix the rear? I'll be getting them aligned after the rear is fixed.
Windstar :: Rear Lights Are Not Working
My rear lights are not working. (brake, signal, hazard, reverse). I get power to the bulbs... showing 12V on 2 and 2V on one for each side. Fuses are good, and front lights working (signal, hazard, daytime running, full lights). Also, sometimes the gas gauge works, sometimes doesn't.
Also, power door lock will work on the first attempt only if I leave it for awhile... if i continuously keep pressing the unlock, if seems like the power drops each time to a point where all i hear is the FEM clicking... same if i do the lock part... every time i press it, the motor gets quieter and quieter. One time the locks worked and I was able to get all the doors to open... then the back lights all worked... and then the next day, it quit again... just like before.
Prius (Gen 2) :: Rear Spoiler Alignment?
I noticed that in my car the rear spoiler is not flush with the body of the car, Is there any way to adjust it? By looking at it very briefly it seems that the rear hatch will need to sit lower for better alignment.
View 1 RepliesWindstar :: Right Side Front Clunking Sound
I'm still trying to figure out where my right side front clunking sound is coming from. The wheel feels tight right to left and top to bottom and I did the sway bar bushings and links 30K ago, and they appear to still be fine. I have come across some claims as to an issue with A/C condensation possibly causing corrosion on the subframe or right side strut mount, but no details. What this issue might be about and where to check for it?
View 9 RepliesPrius (Gen 2) :: Safety Of Shims For Rear Alignment?
I shimmed my prius this weekend to remove about 0.44 degrees of positive out of 0.60 theoretically bringing total toe down to .16.
The shims add about 3.8 mm between the hub and the suspension. The bolts are M10s I believe with 12 mm heads. There are 4 bolts per hub. I often take off ramps at a pretty good clip rather than braking when going from one freeway to another. The 4 bolts already seem like they wouldn't be enough to hold the hubs on.
When adding the shims, it moves the hub further away resulting in a little more torque at the mating surface on the opposite side of steering. Also, the bolts just barely make it to the last thread.
Golf/GTI VI :: Wheel Spacers - Bad Rear Alignment
And I have coil overs, I'm not super low but pretty low and every time I get my alignment done they say they can't so anything about the rear having so much negative camber. And it is really eating up the inside sidewalls of my tires like crazy.
View 5 RepliesGolf IV / Jetta IV :: Rear Cup Holder Alignment
I've done the center console with cup holders conversion, but I've never bothered installing the rear cup holder, until now. Is it supposed to have this gap?
View 12 RepliesGolf IV R32 :: Way To Get Rear Alignment Closer To Spec?
It's been a minute since I've been on these boards, surfing, searching posting, etc.
Anyway, I replaced my upper control arms when I replaced the suspension in '06 w/some ECS units. Since then I've run through some rear tires more quickly than than up front. It's been tolerable bc I don't drive it as much.
The last alignment, the tech said he got it close to spec, but not quite. The inside part of the rear tires is where the problem is.
If I replace the stock lower control arms solve the problem of the getting the rear alignment closer to spec? Thoughst?
Windstar :: 1998 - No Vacuum To Rear Auxiliary Unit
1998 Windstar Limited. I have no vacuum to my rear Auxiliary Unit. I am considering buying a hand vacuum pump. However, I never used one. Is there a video available.
View 9 RepliesGolf/GTI VI :: Front Passenger Door Out Of Alignment?
I just noticed on my front passenger door, when I pull the handle, the top of the door is rubbing against the rubber. It seems to be shifted a little down, especially on the top left corner of the door. What's going on with it. Doesn't open as smooth as the door once did.
View 6 RepliesWindstar :: Slight Squeak From Front End During Low Speed Driving
1999 Windstar 3.8. I heard a slight squeak noise fron front end, when low speed driving. Sounds not really horrible, but annoying, and I wish to find out the real cause before it turn worse. It's not easy to describe what the noise sounds like. I can hear it at low speed, seems not relates to steering. At higher speed, it disappears, not sure really gone or covered by other noise. And, when I just parked, and kick the tire, the same noise can be reproduced. But when I tried to kick next day, no more noise.
View 10 RepliesCamry :: Rear Left Camber Alignment Is Off Range
I have a 2004 Camry and I got an alignment at Firestone they rep told me that my rear left camber alignment is off, my right camber alignment is is within range.
Actual :-2.3 Range -2.0.-0.5
He recommended I change my struts as Toyota does not specify rear camber adjustment. Is this normal on car with 160k on it ?. I have seen several chamber kits out there should I just get one and go somewhere else for them to realign it with the kit ?