My '92 Ford Tempo's balancer has been making noise at idle; worse when in gear. I replaced the tensioner pulley and belt. It has a 2.3 (4cyl), with 45,000 original miles. My mechanic said it can't be replaced without pulling the engine. Is it safe to drive, especially long distance.
View 7 Repliesmy 1992 960 wagon with 332K miles today started making a moaning noise when making a significant turn at low speed. At first it seemed to be only when I was accelerating but if that was true, it now is doing it at any low-speed big turn. Tonight, turning around in the driveway, it added what I call juddering during the turn. So naturally I am concerned.If it is something as minor as power steering fluid I might trust a local gas station to fill it up, but probably not any more than that. (There used to be a dealer about 45" away, but they seem to be gone now, and the closest one is hours away. I am 250 miles and one week away from my own trusted mechanic, so I hope it is something like fluid!).I haven't noticed any puddles on the driveway where it is parked, but I suppose it could leak out only when the engine is on and the car is moving.
View 4 RepliesI have a 1992 850 Estate (wagon) which has been making a funny noise when driving. I cannot locate it. The noise only happens when driving, I have never herd it when stationary. Most often when cold but not exclusively. I have examined all the items attached to the engine driven by the serpentine belt all run smoothly. The belt was changed just after I bought it.
I have checked the wheel arches to see if the tyres rub but no. The suspension is fairly new with new anti-roll bar links fitted for last MOT. The noise sounds like a dry bearing and is a combination of a rub and a screech, there is no loss of coolant but I suspect the water pump or one of the tensioning rollers to be at fault. The last owner told me that the belt had been changed a few months before I bought the car (off Ebay) but he did not say anything about the rollers or water pump and I did not ask.
One other point is that when I bought the car I had to add a full 5 litres of oil to the sump due to their being no oil on the dip stick. Since then the engine has run well (good engineering) but this noise is happening and as I have said it is driving me nuts.
Attached File(s)
volvo_011.JPG ( 588.86K )
volvo_008.JPG ( 530.3K )
There is a recurring moan that comes from the engine compartment around 40% of the time while the vehicle is idling. Sometime it's a moaning sound and other times it's more of a grunting noise, almost sounds like the engine is reving, only the RPM guage doesn't move.
Doesn't matter if the engine is hot or cold. Car has just over 2,000 miles.
Dealer, naturally, could not reproduce the noise.
I have a '93 Ford Tempo 2.3 liter with a/c ....it OVERHEATS ... love the car, but when I sit in traffic, the temp needle goes up almost to the redline, I have to shut the car off .... it happens all year round ... if I'm driving up a hill the temp starts climbing, if I turn the heat OFF the temp climbs, in summer when I put A/C on the temp climbs ... I've put 3 Thermostats in, a new Water Pump, there are NO leaks in Radiator, I've replaced Hoses ... no I'm not a mechanic, I've brought it to garages ... other than the overheating issue it's a good lil car, uses maybe 1 QT of oil every other month ... when I lived in SC had the same car....SAME PROBLEM...had a 1995 Windstar that did the same thing, replaced radiators etc nobody could figure it out, or didn't want to....what is it with Fords!
View 7 RepliesI have an issue with a 1993 Ford Tempo. It is owned by a auto parts store and is used for deliveries so it gets a lot of use from day to day. Several different mechanics have looked at it and no one can figure out exactly whats wrong.
The issue is this - The car stalls out at about 2 or 3 oclock everyday after being used for deliveries starting at 9 oclock. It will stall while idling in park, while stopped in drive, while coasting/accelerating in drive. The temperature is normal. Is will start to idle and run very rough and the car is less responsive to the gas pedal about 10 minutes before it stalls.
Once it stalls, if it is allowed to sit for about half an hour it will start and run fine for a little longer but eventually stall again. After it sits for a few hours it is fine to run for a few hours again. If you try to start it right after it stalls the first time the engine will turn over but stall out again in a few seconds, if you keep trying to restart it it will eventually not even crank. Also it will occasionally stall like this/run rough in the first 10-20 minutes of driving.
I changed the harmonic balancer in my 93 ford tempo but the rattle came back!! Last night we tightened the bolt on it with 700 psi but it's still rattling! Could it be a bad balancer or another part that is lose? It rattles at idle and goes away while driving. It just started again the day before yesterday (I thought my husband was just looking to play with the car more) and by last night it got really loud. It's a deeper rattle then the rattle it had before we changed the balancer. Could there be something way out of balance that is causing the balancer to do this?
View 1 RepliesFirst, the specifics: 1993 Ford Tempo 4-cyl Auto 78,000 miles (the proverbial little old lady car.) From a stop, the car will rev clear up to about 30 mph before shifting out of first into second. It will stay in second well past 60 mph, and even then, I have to kick it hard to make that happen. It's not that it won't shift; bit it seems to delay well past where it should. If I do manage to get it into 3rd, there's a pronounced thunk when it downshifts at a higher rev than it should when I slow down.
Now the background & other info: It's not my car. My B-I-L lent me this car because I ride a motorcycle all winter, & he took pity on me for the rainy & snowy days. In return, I offered to fix an annoying rattle. The problems went well past that, of course. The second day I drove it to work, it overheated and spewed clouds of steam in the parking garage. I had to have it towed home. That turned out to be a split in one of the heater hoses.
Disturbingly, however, the temp gauge on the dash never rose off of "C" on the ride in. I had expected to be replacing a water pump, but the heater hose seemed to be the only issue. Just the same, I replaced the thermostat and the temp sensor because I suspected the burst hose was a symptom, not the cause. Sure enough, after it's all put back together, the dashboard temp gauge is working better, and a short hop to the grocery store showed no overheating. At least that problem seems solved.
Prior to the coolant issue, the car drove fine (for one day); the shifting problem only surfaced afterward. As a last piece of info, I'll add that I had to add an entire quart of transmission fluid to bring the level between the marks. I didn't check that previously, so I can't say if that was a pre-existing condition. So then - what's the fix here? Could an overheated engine cause the tranny problem? Any chance this can be fixed simply? (FWIW, the rattle is the A/C pulley.)
Sometimes when my car as sitting at an idle in either drive or reverse the motor starts to make a knocking noise from the back of the motor towards the firewall side on the top of the motor. I have a video. The car has 114k I just changed the oil I thought maybe it's low but it's not and hasn't moved since it was changed.
View 4 RepliesMy 92 ranger, 2wd, 6 cyl, manual trans, is running at about 3500 rpm at idle. I was wondering what might be the cause, maybe something with the throttle or could the gauge be screwed up.
View 14 Replies1992, shory 3.0 130K MILES
On start up runs very rough, will stall if not power braked or revd a little on start up/out of the driveway.
VOLT METER STARTS GOING NUTS!!
After a mile/warm up,,, runs great. But sometimes even when its hot, it will still try to do the rough idle briefly after just a few minutes restart. Give it a few revs at that point and its good. And once in a blue moon it will do it randomly at a stop light,, out of the blue. Very rare
I've got an issue with my 92 2.3 ranger.... sitting at idle for 30 or so seconds it starts to chug and sometimes dies.... I can hit the throttle and its fine for another 30 or so seconds.... while cruising on the freeway after about 30 minutes it starts to cut out badly... let out of throttle for a few seconds and it clears up and drives fine...
Here's the part that has me confused... pulled codes yesterday using a innova scan tool...
koeo were 4, 10, and 538...
koer were 111, 10, 157, 158, 181, 327, 328, and 334....
How does it give me a 111 pass code and then still come up with all the other codes? I am thinking my ecu may be screwed.....
My 1992 Toyota, Celica had developed a really weird idle surge. The idle surges between 500 to 750 rpm. The surge goes away with the AC on and it idles steady at 900 Rpm. It also has a slight off idle bog that may just be another symptom of the weird idle.
I did the diagnostic test today and it doesn't flash any codes. I pulled the EGR valve off and cleaned the gunk out of it and it didn't make any difference. I tried to check the timing and it idles so bad the timing bounces 7-10 degrees with the surge. When I did the jumper to check the timing it would kill the engine. The plugs and wires are new with in a couple thousand miles. It runs fine above idle and pulls to redline easily in the lower gears.
Yesterday when I was messing with it I had the car running with the air boot from the air cleaner to throttle body off. I sprayed carb cleaner into throttle body and it seems to clear up a little bit. Then it went back to surging again.
I tried to pull the TPS off yesterday and of course the bottom screw stripped out. Now I will have to pull the throttle body off to get the screw out. I wish it would throw a code so I could have it give me a clue.
I just bought this little car. It ticks at an idle and it burns 1/4 qt of oil a month. It doesn't stop ticking when I add oil so Im at a loss.. It isn't a loud tick either. It has 200,000 miles on it but it is in great condition besides this.
View 13 RepliesI have a gorgeous, mint 4x4 1992 Toyota pickup...that runs terribly. Sometimes, it won't start. When it does start, it often idles very, very low. (Idler tension cable was adjusted up but it didn't work.) When I drive it, the idle goes up and down between very low and 4000 RPM. Sometimes, it stalls out all together, regardless of what I do to the clutch, brake, or acceleration. In an engine diagnosis, Knock Sensor came up, but there's a new one, and the cable harness is fully gone through. It's got a new engine with 67,000 miles on it, a new fuel pump, and just about every part has been replaced. It's been to about 10 mechanics, all of whom can't figure it out.
View 11 RepliesCar has begun to idle very fast ( comes and goes ) ( 1992 240 ) ....
View 2 RepliesI have a 92 fire bird , just got it. Ran fine, idled a little high, but after a bit, it went down. Now, when it idles, it just wants to die when I come to a stop at a red light or stop sign. It dies, unless I keep one foot on the brake and another on the gas to keep it idled up.
View 4 RepliesI've got an "on- and off-going" problem with my '92 S10 Blazer.
Car specs:
Year 1992
Blazer S10 4.3 Tbi
4- doors 4WD
Mileage 200k miles
Symptoms:
As cold, every now and then it will start right up, but the idle is wery rough, and seems like its running on less than 6 cylinders. When giving gas, it revs up, but runs roughly and still seems to be running on less than 6. Won't stall though.
When engine warms up after a couple of minutes, the idle gets smooth and no issues what ever when driving.
So just to be clear, this issue is so far only happening when staring cold.
Parts (new off course) changed recently (less than 500miles on them):
Distributor
Spark plugs + wires
Alternator
Battery
IAC valve
Fuel filter
This symptom came up now and then before changing any parts. I am quite handy with cars (pure amateur though), but can't really afford solving the proble by changing loads of parts with no effect..
It's a 1992 Celica, GTS 2.2L for reference.
After driving down the highway I noticed my temp fluctuated from half way to full and bounced around until I arrived at the closest Canadian Tire/Station. I looked under the hood and noticed the stain on the coolant container wasn't the actual level of coolant. I then topped off the coolant and parked the car for about a week. When I tried to start her up, I was faced with a weak and poor idle. Almost as if the car is struggling to run. I have had times in the recent years in the summer months were I felt I had to pump the pedal on really hot days to kickstart her so she would run. Was this a warning sign? Other than this problem I face, the car runs smooth. I did a good tune up 2 years back, replacing the ignition coil, plugs, etc..
The idle goes from 0 - 500RPM in neutral and when I apply gas it struggles to gain power. The car is parked, I don't dare to take her around the block. It stutters and seems like she is struggling to get fuel. I say that because, when the key is turned to the on position I do not hear the fuel pump underneath the back seat activate. I did try jumping the terminals, something like B+ and FP.... The pump turned on and I heard fuel but when I started the car, I still had the same problem. I would need to pump gas or she would stall out. I do not know where the fuel line is to try and check the pressure or even where the relay is located.
Could it be the Fuel Pump?
Could it be the Fuel Pump Relay?
Something Else?
My guess is the Fuel Pump, but if you could take a few mins and replay that would be great. I have had my Celica for about 7 years and I would like to keep her going!
Well i have a 1992 for explorer 4.0 all lights seem to dim kinda surging at idle or coming to a stop. Has new battery, battery cables nice and tight new alternator. My Volt gauge on my cluster jumps from 12 to 14 volts. battery light flashes seems to be getting worse. Was having similar issue about 1 year ago found a injector giving up. Replaced injector and worked good for a while. Wondering is it common to have that issue with injectors causing these issues. Doesn't seem likes its missing firing.
View 1 RepliesI just bought a 92 Toyota Celica for something to play around with. It's got just over 200,000 miles and everything seems to run alright except there is a really rough vibration at idle. The vibration is so bad that it's almost visible. You can still feel the vibration in drive but it isn't nearly as bad.
Any clue at what could be causing the vibration? I'll try to get a sound clip or video uploaded ....